工作竖井与隧道连接处支护结构横向地震响应

建立了工作竖井与盾构隧道、明挖隧道相连的空间交叉结构三维模型,采用FLAC3D对该复杂结构进行了横向地震响应分析,得到了工作竖井与隧道连接处支护结构关键点的位移和应力响应规律。通过对地震横向激励过程中竖井与隧道连接处支护结构收敛位移和关键点主应力峰值的分析,对该结构的横向抗震性能做出了评价。     

我国露天煤矿开采区生态恢复研究存在的问题探讨

露天煤矿的开采在带来巨大经济效益的同时,也产生了生态破坏和环境污染等一系列问题。矿区的生态恢复已经在社会上引起了广泛关注,成为当前研究的热点之一。本文概述了我国露天煤矿开采区的生态环境问题、生态恢复研究现状及实践,探讨性地提出了目前露天煤矿开采区生态恢复研究存在的问题及建议。     

Measurement and relationship between critical tube diameter and critical energy for direct blast initiation of gaseous detonations

For the explosion safety assessment in industrial setting, detonation dynamic parameters provide important information on the sensitivity and conditions whereby detonations can be favorably occurred. In this study, new measurement of the critical tube diameter and the critical energy for direct initiation of a detonation is reported for a number of hydrocarbon–oxygen mixtures. The simultaneous experimental measurement carried out in this work allows the investigation of the direct scaling between these two dynamic parameter quantities of gaseous detonations. Using the new set of data, this paper also assesses the validity of an existing semi-empirical initiation model, namely, the surface energy model by Lee, and a simplified work done model. Both phenomenological models provide a general relationship between the two dynamic detonation parameters and comparison shows a good agreement between the theoretical results and the experimental measurement. The scaling of critical tube diameter with detonation cell size in this study also confirms the results in the previous literature.     

型材压弯变形力的计算

目前角钢和型钢压弯、压凹时的变形力多根据经验确定,笔者由功的平衡原理出发,考虑其变形时的应力状态,得出型材在压弯成形时的精确变形,并对所得数学式进行试验验证,二者结果十分接近,该式有很好的推广应用价值。     

Intrauterine growth retardation and fetal transverse cerebellar diameter

In 103 small-for-gestational age (SGA) fetuses, the transverse cerebellar diameter (TCD), abdominal circumference (AC), head circumference (HC), and femur length (FL) were measured and their ratios calculated. In addition, umbilical venous blood samples were obtained by cordocentesis for measurements of fetal blood pH and erythroblast count. Compared with the AC, HC, and FL, the TCD was relatively mildly reduced. However, in the 28 fetuses with TCD >2 SDs (standard deviations) below the normal mean, the degrees of growth retardation, acidaemia, and erythroblastosis were more severe, and the incidence of perinatal death was higher than in the group with a normal sized TCD. Although in the group with TCD >2 SDs below the normal mean the TCD/AC ratio was increased, in the most severely growth-retarded fetuses this ratio was usually within the normal range. Thus, in intrauterine growth retardation (IUGR), cerebellar size is reduced in proportion to the severity of the disease and therefore the TCD cannot be used to obtain reliable information on the gestational age of small fetuses and the TCD/AC ratio does not provide reliable information as to whether or not fetuses are growth-retarded.     

Propagation Characteristics of Gas Explosion in Linked Vessels Based on DDT Criteria

To study the occurrence conditions and propagation characteristics of deflagration to detonation transition (DDT) in linked vessels, two typical linked vessels were investigated in this study. The DDT of the methane–air mixture under different pipe lengths and inner diameters was studied. Results showed that the CJ detonation pressure of the methane–air mixture was 1.86 MPa, and the CJ detonation velocity was 1987.4 m/s. Compared with a single pipe, the induced distance of DDT is relatively short in the linked vessels. With the increase in pipeline length, DDT is more likely to occur. Under the same pipe diameter, the DDT induction distance in the vessel–pipe–vessel structure is shorter than that in the vessel–pipe structure. With the increase in pipeline diameter, the length of the pipe required to form the DDT is reduced. For linked vessels in which detonation formed, four stages, namely, slow combustion, deflagration, deflagration to detonation, and stable detonation, occurred in the vessels. Moreover, for a pipe diameter of 60 mm and a length of 8 m, overdriven detonation occurred in the vessel–pipe–vessel structure.     

地质灾害能量质环理论结构模式梗概

以地质灾害能量形成致灾根源为研究导向,论表观灾害形成机理的基础上,从灾害能量质环理论到地质灾害致灾根源作进一步升华探索.运用能量质环理论有针对性地加强对于地震、洪水、泥石流等各种地质灾害能量在介质中传播规律的研究；构建灾害能量传输、聚集成无数能量质点、质点相吸形成环链、环链相交形成能量断面,各个能量断面叠加形成能量破坏体,能量破坏体不断地传输与演化直至最终诱发下一次灾害等全过程循环系统；分析灾害能量在介质中传输及演变规律；提出灾害隔断原理,对防灾减灾工程提出实质性的建议.该项目研究打破了传统的非根源防灾理念,从致灾根源探索灾害的形成及灾害隔断预警.     

基于多种测试平台喷雾粒径特性实验研究

目的 研究平台环境差异对喷雾液滴粒径造成的影响。方法 分别在喷嘴测试台、直流吸气式风洞、闭口回流式结冰风洞等3种测试平台上开展喷雾液滴粒径测量,并将测量结果进行对比分析。结果 各平台喷雾dMVD随水气压变化的规律性都较好,dMVD随着水压的增大而增大,随着气压的增大而减小。对于dMVD≤30 μm的工况,3种测试平台的dMVD测量结果接近,但粒径分布存在差异。对于dMVD>30 μm的工况,直流吸气式风洞和闭口回流式结冰风洞喷雾的dMVD都比喷嘴测试台大,粒径分布向大颗粒方向偏移。结论 气流温度、速度、环境湿度、湍流度以及平台构型等环境因素均对喷雾液滴粒径产生影响,多因素耦合作用使得闭口回流式结冰风洞液滴的蒸发、碰撞合并、破碎等行为都更强烈,从而造成了其与喷嘴测试台、直流吸气式风洞喷雾的粒径特性存在差异。     

PM1切割器性能测试系统的搭建与应用

为对PM_1切割器的性能进行准确评估,本文设计搭建了两套PM_1切割器性能测试系统.结果发现,多分散气溶胶测试系统发生的气溶胶稳定、均匀,符合对数正态分布;单分散气溶胶测试系统发生的气溶胶稳定,单分散性良好.采用上述两套系统对5种PM1旋风切割器进行了性能评价,结果表明,两套系统测试结果基本一致,5种旋风切割器的切割粒径D50均在(1.0±0.1)μm之间,sharp-cut和Stairmand两类结构设计的切割器几何标准偏差σg分别在1.2±0.1和1.4±0.1之间.