Desorption of polycyclic aromatic hydrocarbons from field-contaminated soil to a two-dimensional hydrophobic surface before and after bioremediation

This study investigated environmental distributions and production mechanisms of chlorinated polycyclic aromatic hydrocarbons (Cl-PAHs) in the sediments from some tidal flats located in Asia. Cl-PAHs were found in sediments taken from Arao tidal flat, Kikuchigawa River and Shirakawa River. The range of ∑Cl-PAHs was from 25.5 to 483 pg g⁻¹ for Kikuchigawa River and Arao tidal flat, respectively.Concentrations of PAHs and Cl-PAHs showed no significant correlations (r = 0.134). This result suggests that the origins of these compounds differ. In the identified Cl-PAH isomers, the most abundant Cl-PAH isomer was 9,10-dichloroanthracene (9,10-di-Cl-ANT) in the three sites. In general, concentrations of Cl-ANTs in the coastal environment are about 3-5 orders of magnitude lower than those of anthracene (ANT). However, concentration ratios between Cl-ANTs and ANT (Cl-ANTs/ANT) in the sediments ranged from 4.1% to 24.6%. This result indicated that Cl-PAHs were not generated under industrial processes but the high concentration ratios have resulted from the contribution of photochemical production of Cl-ANTs in the sediments because ANT is known to have high photochemical reactivity.For examining this phenomenon, ANT adsorbed onto glass beads was irradiated with UV under the mimicked field conditions of tidal flats. As a result, it was noticed that, while chlorinated derivatives were negligible in a light-controlled group, production of 2-Cl-ANT, 9-Cl-ANT and 9,10-diCl-ANT on the irradiated surface were found in this study. These results suggest that photochemical reaction of PAHs can be a potential source of the occurrence of Cl-PAHs in the coastal environment.     

微波诱导AC/Cu、AC/Fe催化非均相Fenton 反应催化降解垃圾渗滤液

采用活性炭载体负载Cu、Fe为催化剂,在微波诱导作用下,对垃圾渗滤液污染物进行降解。实验结果表明,活性炭负载金属前经适当浓度硝酸浸泡处理后,催化剂对COD去除率提高可超过15%,过高硝酸盐浓度对COD去除有不利影响;催化剂对COD去除率随Cu、Fe金属负载量增加呈先增加后降低的趋势,催化剂对Cu、Fe的最佳负载量分别为质量百分比2.11%和1.12%。对于AC-Cu体系,在初始pH=3,H2O2投加量为4.98×103mg/L,催化剂用量为5.0×103mg/L,420 W功率下微波辐射10 min时,垃圾渗滤液COD去除率可达到84.13%;对于AC-Fe体系,当H2O2投加量为0.33×103mg/L,催化剂AC-Fe用量为2.0×104mg/L,420 W功率下微波作用10 min时,垃圾渗滤液COD去除率为60.16%。分析2种催化剂对COD去除差异的原因,可能是催化剂AC-Cu表面单分子分布的阈值比AC-Fe高。降解液的pH值对AC-Cu体系、AC-Fe体系COD去除影响存在拐点,最高COD去除率点对应的降解液pH值为3。微波辐射功率较低时,体系COD去除率随辐射功率增加而增加;辐射功率较高时,高温下垃圾渗滤液中有机硫化物分解成小分子硫化物,对催化剂活性存在一定抑制作用。     

建筑物基底反力的实时监测与分析

以某大楼的基底反力监测为例 ,阐述了建筑物基底反力实时监测的原理与方法。监测分析结果表明 ,对在建建筑物进行的基底反力实时监测直接反映了土体受力状态 ,可间接得出桩基的受力情况。     

UV-H_2O_2联用工艺去除水中阿特拉津的研究

采用间歇式反应器考察了UV-H2O2高级氧化技术去除水中阿特拉津的效果及其影响因素,并进行了相关的反应动力学研究。结果表明,在pH值6.9,阿特拉津初始浓度500μg/L,紫外辐照强度172μW/cm2时,H2O2投加量50mg/L,反应10min后,阿特拉津的去除率90%。UV-H2O2联用工艺对阿特拉津的降解符合一级反应动力学。H2O2在该联用工艺降解阿特拉津中具有双重作用,一方面,当H2O2投加量较小时,一级反应速率常数随H2O2投加量的增加基本呈现线性增加的趋势;另一方面,当H2O2浓度增加到一定程度(90mg/L)后,阿特拉津的降解速率随H2O2浓度的变化已不明显,而H2O2浓度为102mg/L时,则出现了抑制作用。     

油田作业废水高效处理技术中试研究

文章根据新疆油田作业废水特征及油田地处干旱区的地理特点,结合国内外含聚合物污水处理的技术现状,以及油田连续生产稳定运行的要求,在含油污水处理技术的基础上,开展了作业废水处理关键技术研究和工艺优化,采用了"隔油—絮凝气浮—深层过滤"技术。中试试验结果表明:处理后废水COD_(Cr)、石油类、SS可分别由680 mg/L、98.6 mg/L、56.2 mg/L降至98.8 mg/L、5.4 mg/L、4.5 mg/L,去除率分别为85.5%、94.5%、92.0%。     

稠油污水回用锅炉处理工艺的应用

新疆油田公司稠油污水处理普遍采用成熟的离子调整旋流反应水处理技术,污水处理后达到回用锅炉水质标准SY/T 0097-2000《稠油油田采出水用于蒸汽发生器给水处理设计规范》,供给油田专用高压注汽锅炉用水。采用相同技术建成的采油一厂稠油处理站污水回用锅炉处理工艺投用后,处理后污水回用锅炉,减少了含油污水的外排,充分利用了稠油污水的热能,取得了良好的经济和社会效益。     

烟气同时脱硫脱硝技术探讨

开发先进的烟气治理技术,控制二氧化硫和氮氧化物排放是国内外脱硫脱硝研究的一大热点。本文简述了同时脱硫脱硝技术的工作机理及其优缺点,从反应机理、技术特点和工程应用等方面,介绍了烟气同时脱硫脱硝技术的研究进展情况,并对其应用前景进行了预测。     

分光光度法测定COD_(Cr)的试验条件选择

用分光光度法测定水中化学需氧量ＣＯＤＣｒ,通过正交试验选择氧化的最佳选择。试验结果表明对ＣＯＤＣｒ值为５０～１０００ｍｇ／Ｌ的水样：氧化剂Ｋ２Ｃｒ２Ｏ７用量为０．２０～０．４０ｍｏｌ／Ｌ,催化剂Ａｇ２ＳＯ４用量为１０ｇ／ＬＨ２ＳＯ４,消解时间１０ｍｉｎ,加热温度１８０℃。用ＣＯＤＣｒ为１３８ｍｇ／Ｌ的质控标样进行验证试验,其绝对误差为０．５～３．０ｍｇ／Ｌ。与标准方法相比用分光光度法测定ＣＯＤＣｒ具有分析误差小,省时、省力,节约药剂的特点。     

COD_(Cr)测定中排除氯离子干扰的进一步探讨

废水中化学需氧量的测定采用重铬酸钾法［１］,大多数情况下都存在Ｃｌ－干扰,其排除方法用ＨｇＳＯ４掩蔽,通过实验探讨不用剧毒药品ＨｇＳＯ４掩蔽Ｃｌ－的干扰,而用ＣＯＤＣｒ总量减去Ｃｌ－的量。实验结果表明：当测定化学需氧量较低而Ｃｌ－含量高的水样时,即使采用掩蔽Ｃｌ－也会产生较大的误差,而用测定值减去０．２２６［Ｃｌ－］之值更接近真值。     

Fe-pillared clay as a Fenton-type heterogeneous catalyst for cinnamic acid degradation

Fe-pillared montmorillonite has been used as a Fenton-type heterogeneous catalyst for the removal of cinnamic acid in water. The influences of the cinnamic acid, catalyst and H2O2 concentrations and pH on the removal rate of cinnamic acid have been studied. The results show that the efficiency of Fe-pillared montmorillonite is higher than that of the Fe ions in the homogeneous phase, and less sensitive to pH.