细水雾中雾滴和高温环境的热质交换研究

由雾滴的表面的组分方程和能量方程入手,探讨雾滴在静止的高温环境中的热质交换及生存时间。应用折算薄膜理论,通过特征时间的比较,提出雾滴与高温环境主要通过沸腾机制实现热质交换;考虑滴径与速度变化的耦合作用,应用数值方法研究雾滴在强迫对流环境中与高温环境的热质交换情况。结果表明:对于滴径较小的雾滴不可能达到火焰区或可燃物表面实施火焰冷却和表面冷却,其灭火作用主要依赖于汽化吸热。     

Preparation and Characterization of Cellulose/Polypropylene Composite Using an Oxidatively Degraded Polypropylene

In this work, an oxidatively degraded polypropylene (DgPP) was studied as a novel coupling agent for fibrous cellulose (FC)/polypropylene (PP) composite. An optimal preparation time of PP thermal oxidative degradation was 18 h at 130 °C, and the DgPP had functional groups such as γ-lactone and acid groups. The spherulite observation of the DgPP suggested miscibility for the undegraded PP. The addition of the DgPP presented the transparency improvement of FC/PP composite, and this behavior was found to be originated from the grafted DgPP, which was produced by the esterification reaction between the of FC and the DgPP. The scanning electron microscope (SEM) observation showed that the grafted DgPP coated the FC surface, and the tensile strength of the FC/PP composite increased by an appropriate amount of the DgPP addition. These results suggested that the DgPP was suitable for the coupling agent of FC/PP composite.     

浅谈环境监测社会化的质量监管新思路

分析了现阶段社会环境检测市场的发展现状及存在的问题,探讨了从环境检测上岗能力、专业技能再教育、从业履历和信用等方面对社会环境检测从业人员进行管理的必要性,提出在机构环境监测能力、检测人员结构流动性、仪器设备在用状态和更新频率、从事环境监测业务信用等方面建立评估机制,推动环境监测市场健康发展。     

CO2和ABC干粉灭火剂扑灭火旋风火焰实验对比分析

为了分析2种灭火剂扑灭火旋风效果,采用实验室自制装置生成稳定的火旋风火焰,喷射CO₂或ABC干粉灭火剂,获取火焰温度场及光电信号数据。研究结果表明:在CO₂灭火剂或ABC干粉灭火剂作用下火旋风火焰温度场呈“下凹”型指数衰减;受灭火剂喷射位置影响,火焰根部、中部及顶端不同区域的灭火剂影响系数不同;基于火焰降温速率和光信号变化,相较于CO₂灭火剂,对火焰起抑制作用的ABC干粉灭火剂降温效率更高、扑灭效果更好。     

SGA对垃圾焚烧飞灰中重金属的固化性能研究

根据EPA1311、HJ／T299—2007、HJ／T300—2007和HJ557—2009等国内外不同标准,研究了深圳某垃圾焚烧发电厂垃圾焚烧飞灰的浸出毒性,探讨了六硫代胍基甲酸（sixthioguanidineacid,SGA）、二甲基二硫代氨基甲酸盐（sodiumdimethyldithiocarbamate,SDD）和Ca（OH）2浓度对垃圾焚烧飞灰中重金属的固定性能的影响。研究结果表明,随着浸提液pH的降低,该厂焚烧飞灰中大部分金属元素的浸出量增大,焚烧飞灰浸出液中的cd、Ni、Ph和zn浓度分别超过国家危险废物鉴别标准（GB5085．3—2007）规定值的4．75倍、1．47倍、6．72倍和2．20倍,属于危险废弃物,必须进行稳定化处理。当固化剂SGA加入量为0．1mol／kg时,稳定化后的重金属浸出浓度已经低于危险废物鉴别标准,且对Cd、Cr、Cu和Pb的固化性能优于SDD和Ca（OH）2;当固化剂SGA、SDD和Ca（OH）2加入量为0．5mol／kg时,稳定化后的焚烧飞灰重金属浸出浓度均低于国家危险废物鉴别标准（GB5085．3-2007）中的规定值。与SDD和Ca（OH）：相比,SGA对垃圾焚烧飞灰中重金属的固化处理更具有优势。     

快腐剂对畜禽粪便堆肥过程中腐熟度的影响

以牛粪、菌糠和鸡粪等为材料按照两种比例调配为混合基质,在添加或不添加快腐剂的条件下在发酵桶中进行为期38 d的堆肥发酵实验,通过对发酵产物的温度、p H值、总有机碳、C/N、硝铵态氮含量和种子发芽指数等指标变化的研究,揭示了快腐剂对发酵过程的影响。结果表明,虽然快腐剂对有机物料的温度、C/N比无显著的影响,但可以促进铵态氮向硝态氮的转化,在16 d时使发酵产物NH+4-N/NO-3-N比值降为0.15,达到腐熟标准(0.16);提升种子发芽指数,在腐解29 d时使种子发芽指数达到82.76%,达到完全腐熟指标(0.8),比不添加快腐剂的处理提前了4 d左右。快腐剂的作用效果受腐解物料配比的影响。     

石英砂滤料表面润湿改性

采用硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂对石英砂进行表面改性,以制备亲油疏水性滤料。研究得出,钛酸酯偶联剂改性石英砂的最佳工艺条件为:偶联剂用量15%,反应温度90℃,搅拌时间15 min;硅烷偶联剂和铝酸酯偶联剂改性石英砂的最佳工艺条件均为:偶联剂用量15%,反应温度110℃,搅拌时间15 min。水对钛酸酯偶联剂改性石英砂滤料的润湿重量由改性前的1.5589 g降低到0.0282 g,水对硅烷偶联剂改性石英砂滤料的润湿重量降低到0.0607 g,水对铝酸酯改性石英砂滤料的润湿重量降低到0.2664 g。静态吸附实验表明,硅烷偶联剂、钛酸酯偶联剂和铝酸酯偶联剂改性石英砂滤料对油的吸附容量分别增加了33.67%、42.87%和22.30%。XPS和FT-IR分析表明,偶联剂均以化学键的方式包覆在石英砂滤料表面,结合稳定。     

石墨气体扩散电极的制备与性能优化

电极的制备工艺及参数直接影响电极材料的活性。主要考察了C/PTFE质量比、碾压压力、煅烧温度、造孔剂NH4HCO3及稀土掺杂等因素对电极产出H2O2的影响规律。研究结果表明,电极最佳制备条件为:石墨和PTFE质量比为2∶1、石墨、造孔剂和稀土元素质量比为6∶1∶1、碾压压力10 MPa、煅烧温度330℃。在pH=3、电解质Na2SO4浓度为0.05mol/L条件下,电解2 h后,改性电极产生的H2O2从95 mg/L提高到350 mg/L,提高了268.4%。     

直接投菌法在城市重污染河流治理中的应用研究

在无截污和清除内源的情况下,对深圳市甘坑河采用梅花式接种法将本源微生物菌剂分两次直接接入河流水体及底泥中。结果表明,第1次接种后的4 d内各项水质指标都不稳定,4 d后,悬浮物、COD、TP和NH3-N等浓度下降,水质明显改善;但从第8天开始,COD、NH3-N和TP的去除率同时下降,本源微生物的处理效率开始降低,需进行第2次接种;第2次接种后,DO浓度提升至2.0 mg/L以上,COD、TP和NH3-N的去除率分别保持在40%、30%和40%以上。结果表明,直接投菌法在城市重污染河道治理中可以初步消除河道的黑臭现象,修复水质。     

Chemical oxidation of sulfadiazine by the Fenton process: Kinetics,pathways, toxicity evaluation

This paper investigated sulfadiazine oxidation by the Fenton process under various reaction conditions. The reaction conditions tested in the experiments included the initial pH value of reaction solutions, and the dosages of ferrous ions and hydrogen peroxide. Under the reaction conditions with pH 3, 0.25 mM of ferrous ion and 2 mM of hydrogen peroxide, a removal efficiency of nearly 100% was achieved for sulfadiazine. A series of intermediate products including 4-OH-sulfadiazine/or 5-OH-sulfadiazine, 2-aminopyrimidine, sulfanilamide, formic acid, and oxalic acid were identified. Based on these products, the possible oxidation pathway of sulfadiazine by Fenton's reagent was proposed. The toxicity evaluation of reaction solutions showed increased antimicrobial effects following the Fenton oxidation process. The results from this study suggest that the Fenton oxidation process could remove sulfadiazine, but also increase solution toxicity due to the presence of more toxic products.