氨对垃圾焚烧飞灰浸出特性的影响及地球化学模拟

垃圾焚烧飞灰可能因为选择性非催化还原法(SNCR)脱硝过程中氨泄漏、垃圾携带的渗滤液受热挥发等原因而吸附氨.本研究中采用人为添加氨水,在pH为3.66～12.44范围内,研究氨对飞灰中溶解性有机碳(DOC)和重金属浸出的影响,并利用地球化学模拟软件Visual MINTEQ从金属化学形态分布上分析氨对飞灰浸出的影响机制.结果表明,DOC在pH>9和有高浓度氨(≥1 357 mg·L-1)存在时,其浸出量大幅增加,而在浸出液中氨的水平不高于537 mg·L-1时则受氨的影响很小;在pH<6时,飞灰中各金属主要以自由态的金属离子和金属-氯络离子形态大量溶出,且受氨的影响较小;而在pH为8～12的碱性环境中和氨浓度较高时(≥3 253 mg·L-1),氨与金属生成了可溶性的金属-氨配合物,能显著增加Cd、Cu、Ni、Zn的浸出,且在pH=9附近时浸出量达到最大值,但氨对Al和Pb的浸出影响甚微;在pH>12时,Cd、Cu、Ni、Zn主要以羟基金属离子形式存在.在氨浓度为3 253 mg·L-1时,通过利用Visual MINTEQ模拟浸出值与试验数据的对比,发现Al、Pb、Zn的浸出主要由溶解/沉淀模型控制,而Cd、Cu、Ni由溶解/沉淀模型和表面吸附反应模型同时控制,且Visual MINTEQ模型能较好地预测飞灰中Al、Cu、Pb、Zn的浸出特性.     

Simultaneous preconcentration of cadmium and lead in water samples with silica gel and determination by flame atomic absorption spectrometry

A new method that utilizes pretreated silica gel as an adsorbent has been developed for simultaneous preconcentration of trace Cd(II) and Pb(II) prior to the measurement by flame atomic absorption spectrometry. The effects of pH, the shaking time, the elution condition and the coexisting ions on the separation/preconcentration conditions of analytes were investigated. Under optimized conditions, the static adsorption capacity of Cd(II) and Pb(II) were 45.5 and 27.1mg/g, the relative standard deviations were 3.2% and 1.7% (for n = 11), and the limits of detection obtained were 4.25 and 0.60 ng/mL, respectively. The method was validated by analyzing the certified reference materials GBW 07304a (stream sediment) and successfully applied to the analysis of various treated wastewater samples with satisfactory results.     

Application of CGP-cross route process for microstructure refinement and mechanical properties improvement in steel sheets

A modified method of severe plastic deformation (SPD) entitled constrained groove pressing-cross route (CGP-CR) was introduced for imposing a high magnitude of equivalent strain of about 2.32 per pass on the sheet form samples. The major benefit of this improved route compared to previous common route was the more homogeneity of strain in the rolling (RD) and transverse (TD) directions of sheets. In this study, low carbon steel samples were used for examination of evolutions in microstructure and mechanical properties during SPD via CGP-CR process. Mechanical properties improvement were measured by tensile and macro hardness tests. The results indicate that CGP-CR process can effectively improve tensile strength; and also, yield stress and hardness of as-received low carbon steel samples were improved up to about 100% after two deformation passes. Also, high magnitude of inhomogeneity can be observed in hardness distribution through first pass of the process which diminishes in the subsequent passes. Microstructural evolutions during process were monitored by optical microscopy observations and X-ray diffraction analysis. The results demonstrate that initial ferritic microstructure with grain size of about 30 μm was refined to a 225 nm cell structure after two passes of CGP-CR process.     

危险及可操作性分析在LNG汽车加气站的应用

利用危险及可操作性分析(HAZOP)技术对液化天然气(LNG)汽车加气站卸车、调压和加液流程进行系统的危险分析和探讨,并提出建议措施。应用实例表明,HAZOP技术可有效地辨识LNG汽车加气站的风险,可作为LNG加气站风险管理的有效工具之一。     

全氟辛烷磺酸(PFOS)对斑马鱼卵黄蛋白原mRNA水平的影响

为了研究环境低剂量全氟辛烷磺酸（perfluorooctane sulfonate,PFOS）对水生生物的内分泌干扰效应和可能的作用机制,测定了PFOS对斑马鱼（Brachydanio rerio）肝脏中卵黄蛋白原（vitellogenin,VTG）mRNA水平的影响.将斑马鱼暴露于4个PFOS的环境低剂量浓度组（0.1、1、10、100μg.L-1）中进行21d毒性试验,收集肝脏样品,提取RNA,采用荧光定量PCR（qRT-PCR）分别检测VTG1和VTG3的mRNA水平.结果表明：①PFOS暴露引起雄性斑马鱼肝脏VTG1和VTG3 mRNA水平升高,VTG1 mRNA水平升高与剂量呈正相关,在100μg.L-1暴露浓度处与对照组呈现显著性差异;VTG3的mRNA水平变化与剂量呈倒U型曲线,呈现典型的毒物刺激荷尔蒙效应,在10和100μg.L-1暴露浓度处与对照组呈现显著性差异;②PFOS暴露引起雌性斑马鱼肝脏中VTG1 mRNA水平升高,在10μg.L-1暴露浓度处与对照组呈现显著性差异,但在高浓度（10和100μg.L-1）处试验结果误差较大;VTG3 mRNA水平只在10μg.L-1暴露浓度处升高,但相比于对照组均没有显著性差异.试验结果表明PFOS暴露对斑马鱼的内分泌干扰作用明显,其毒性作用机制可能是类雌激素效应,而肝脏中VTG1和VTG3mRNA水平可能作为PFOS内分泌干扰效应评价的敏感生物标志物,但VTG1和VTG3 mRNA水平的响应曲线呈现基因亚型和性别差异.     

LCA of eucalyptus wood charcoal briquettes

This paper sets out to describe the environmental impact assessment for wood charcoal briquettes produced from eucalyptus wood in Brazil, with specific reference to those impacts associated with Global Warming Potential. To achieve that objective, the work was undertaken in accordance with ISO 14040 "Environmental management - Life cycle assessment - Principles and framework" which describes essential LCA characteristics and good practices. Charcoal briquettes are produced from two basic raw materials, charcoal fines and starch. The fines result from the production of charcoal from sustainably managed eucalyptus plantations. Starch is extracted from babaçu pulp in the Amazon region. Multi-output processes were allocated based on income from the different by-products. The results showed that more than 90% of incoming CO₂ was due to biomass production for charcoal, and the remainder to starch biomass production. Based on Brazilian data, as well as information provided by the GaBi4.3 database, it turned out that supplying the energy content of 1 kg of briquettes resulted in the sequestration of 3.9690 kg of CO₂, i.e. around 4 kg of CO₂ per kg of briquettes produced. CO₂ emissions throughout the briquette production process are totally compensated for by the environmental quality of the raw materials used.     

废弃线路板热解油中酚类物质的提取与分离

将FR-4型废弃线路板热解,并对热解油中含量最多的组分-酚类物质进行分离提取.比较研究线路板热解油的分离提取方法,探索出"碱液处理-酸化-萃取-减压蒸馏"的新方法,对分离出的组分进行GCMS(气质联用)测试.结果显示运用该方法对FR-4型线路板的热解油进行提取分离,得到的总酚占热解油的62.0%,其中苯酚的最高纯度可达...     

Debromination of decabromodiphenyl ether by organo-montmorillonite-supported nanoscale zero-valent iron：Preparation, characterization and influence factors

An organo-montmorillonite-supported nanoscale zero-valent iron material(M-NZVI) was synthesized to degrade decabromodiphenyl ether(BDE-209). The results showed that nanoscale zero-valent iron had good dispersion on organo-montmorillonite and was present as a core-shell structure with a particle size range of nanoscale iron between 30–90 nm, characterized by XRD, SEM, TEM, XRF, ICP-AES, and XPS. The results of the degradation of BDE-209 by M-NZVI showed that the efficiency of M-NZVI in removing BDE-209 was much higher than that of NZVI. The efficiency of M-NZVI in removing BDE-209 decreased as the pH and the initial dissolved oxygen content of the reaction solution increased, but increased as the proportion of water in the reaction solution increased.