广州夏季办公室内细颗粒中多环芳烃污染特征研究

大部分的都市办公人群每天在办公室至少度过8 h。而室外环境的渗透、办公室内吸烟、办公设备使用和中央通风系统均可能导致细颗粒物及多环芳烃(PAHs)在室内积聚而造成微环境污染。2015年5—6月,在广州市3种不同功能区(商住区、高新产业区、工业区)共选取了14间不同类型的办公室,对其室内外PM_(2.5)和多环芳烃进行同步监测。结果表明,(1)14间中有12间办公室内的PM_(2.5)浓度水平高于世界卫生组织(WHO)的推荐值25μg·m-3;(2)与国内外类似研究相比,办公室内外∑16PAHs及Ba P-eq的监测浓度水平均较低,并呈现一致规律:文印>室外>吸烟>多人>单人>无窗(无人),其中Ba P-eq低于欧盟规定的安全限值1 ng·m-3;(3)文印工作和吸烟行为与室内PM_(2.5)和PAHs浓度升高有密切关系,分别对5环和4环PAHs贡献明显;(4)其他无明显内源的办公室的细颗粒中PAHs污染在监测期间主要来源于室外贡献。     

电除尘器电源交流分量对PM_(2.5)等细微颗粒物除尘效率的影响

除尘器对颗粒物的除尘效率与颗粒物的荷电量密切相关,PM2.5等细小颗粒物由于其荷电量不足而导致其吸收效率较低,对环境造成危害。为了增加粒子的荷电量,以粒子荷电原理为理论依据,从离子电流密度和通过电凝并扩大尘粒中位径2个方面研究了电除尘电源中交流电压分量对PM2.5等细小颗粒物荷电特性的影响,得出了电除尘器电源中交流电压分量可从以上2个方面提高装置对PM2.5等微小颗粒物的荷电量,且频率越高,幅值越大,荷电效果越好,从而可以提高装置对细小颗粒物的除尘效率。     

村镇供水管网优化设计探讨

如何合理确定村镇供水管网敷设方案,关系到整个供水系统的安全性和可靠性。通过生成树变化法,将环状管网转化成树状管网,确定供水管网中最短供水路线,再计算最短供水路线下的最低综合费用、供水系统的经济管径,以确定最优管道敷设方案。根据该方法对四川省某镇供水系统进行了设计。     

HPLC测定川楝子不同采收期及不同部位中川楝素的含量

通过测定不同采收期和不同部位川楝子中川楝素的含量,为确定川楝子最佳采收期提供依据。采用高效液相色谱法,色谱柱Agilent Zorbax SB-C18（4.6mm×150mm,5μm）,流动相乙腈—水（28∶72）,流速1.0mL/min,检测波长210nm,柱温35℃。不同采收期川楝子中川楝素以1—2月间采收的含量最高;同一采收期的川楝子果核和果肉中川楝素含量最高,外果皮次之,种子中未检出川楝素。     

Potential effects of particulate matter from combustion during services on human health and on works of art in medieval churches in Cyprus

Indoor and outdoor particulate matter (PM_0.3-10) number concentrations were established in two medieval churches in Cyprus. In both churches incense was burnt occasionally during Mass. The highest indoor PM_0.5-1 concentrations compared with outdoors (10.7 times higher) were observed in the church that burning of candles indoors was allowed. Peak indoor black carbon concentration was 6.8 μg m⁻³ in the instances that incense was burning and 13.4 μg m⁻³ in the instances that the candles were burning (outdoor levels ranged between 0.6 and 1.3 μg m⁻³). From the water soluble inorganic components determined in PM₁₀, calcium prevailed in all samples indoors or outdoors, whilst high potassium concentration indoors were a clear marker of combustion. Indoor sources of PM were clearly identified and their emission strengths were estimated via modeling of the results. Indoor estimated PM_0.3-10 mass concentrations exceeded air quality standards for human health protection and for the preservation of works of art.     

Appraisal of measurement methods, chemical composition and sources of fine atmospheric particles over six different areas of Northern Belgium

Daily and seasonal variation in the total elemental, organic carbon (OC) and elemental carbon (EC) content and mass of PM_2.5 were studied at industrial, urban, suburban and agricultural/rural areas. Continuous (optical Dustscan, standard tapered element oscillating micro-balance (TEOM), TEOM with filter dynamics measurement system), semi-continuous (Partisol filter-sampling) and non-continuous (Dekati-impactor sampling and gravimetry) methods of PM_2.5 mass monitoring were critically evaluated. The average elemental fraction accounted for 2-6% of the PM_2.5 mass measured by gravimetry. Metals, like K, Mn, Fe, Cu, Zn and Pb were strongly inter-correlated, also frequently with non-metallic elements (P, S, Cl and/or Br) and EC/OC. A high OC/EC ratio (2-9) was generally observed. The total carbon content of PM_2.5 ranged between 3 and 77% (averages: 12-32%), peaking near industrial/heavy trafficked sites. Principal component analysis identified heavy oil burning, ferrous/non-ferrous industry and vehicular emissions as the main sources of metal pollution.     

pH对活化前后废弃铁铝泥吸附不同种磷动力学的影响

实验研究了300℃热活化前后的给水厂废弃铁铝泥（R-FARs和H300-FARs）对正磷酸盐、聚磷酸盐和有机磷酸盐的吸附动力学特性,并考察pH对不同磷吸附动力学的影响。结果表明,pH对不同磷吸附动力学过程的影响趋势相似,即低pH有利于吸附。准二级动力学模型能够更真实地反映不同磷在R-FARs和H300-FARs的吸附动力学行为,由拟合结果可知焦磷酸盐和六肌醇磷酸盐的初始吸附速率相对较大,而甘油磷酸盐最小;且活化作用明显提高了不同磷的初始吸附速率,并减弱了pH对初始吸附速率的影响。不同磷的吸附速率受到液膜扩散、颗粒内扩散和吸附反应三者共同控制,其中吸附反应是主要的控制步骤。     

接种不同污泥源条件下厌氧氨氧化菌的特性

2组ASBR接种污泥源分别为好氧硝化污泥、好氧硝化污泥和厌氧氨氧化污泥按2：1比例}昆合的混合污泥。在相同条件下,经过驯化培养均实现了厌氧氨氧化的稳定运行。接种好氧硝化污泥的反应器的适应期为29d,经过105d的培养反应器成功启动;接种混合污泥的反应器的适应期为13d,经过49d反应器启动成功。从2组ASBR污泥中提取细菌总DNA,经过厌氧氨氧化菌特异引物Pla46rc／Amx820对污泥样品进行PCR扩增、克隆和测序等分析。实验结果表明,接种不同污泥源条件下的反应器中厌氧氨氧化菌的特性存在差异,接种污泥源为好氧硝化污泥的反应器中存在的厌氧氨氧化菌种为CandidatusKuenenia,而接种混合污泥的反应器中存在的厌氧氨氧化菌种为CandidatusAnammox—oglobus,与最初接种的混合污泥中的厌氧氨氧化菌相同。当接种污泥中存在厌氧氨氧化菌时,该菌株经过长时间的驯化可成为优势菌种,而当接种污泥中无厌氧氨氧化菌存在时,CandidatusKueneniasp．可以在反应器中占主导,具有更强的竞争优势。     

湿法净化黑烟中添加剂对炭黑沉降性能的影响

湿法净化黑烟中炭黑颗粒物的关键在于降低吸收液的表面张力并以高性能絮凝剂使其从溶液中絮凝、沉降以利于分离。选用十六烷基三甲基溴化胺(CTAB)为主要表面活性剂,使之与十二烷基苯磺酸钠(SDBS)和月桂醇聚氧乙烯(9)醚(AEO-9)进行复配实验,研究了复配液的表面张力,再向最低表面张力的复配表面活性剂溶液中投加絮凝剂聚合氯化铝(PAC)和聚丙烯酰胺(PAM),探讨絮凝剂的添加对黑烟颗粒沉降和絮凝的影响.实验结果表明:同时添加表面活性剂CTAB,SDBS和PAC,并使之浓度分别为0.5 mmol/L,0.4 mmol/L和200 mg/L时,炭黑颗粒的沉降效果最好,沉降率高达94%,且絮凝体较大,沉降时间仅为2 min。     

Robustness testing of a free-fall triboelectric separation process for plastic waste recovery

Among the separation techniques used in industries, the triboelectric separation of insulating particles using a rotary tube is an effective way employed in the waste recovery of plastic and mineral products. This process, also called free-fall triboelectric separation, is widely used for the sorting of granular mixtures resulting from industrial plastic wastes. Given that the robustness of such a separation process is an important issue, a standard procedure is used for determining the set point and for minimising the process sensitivity of sorting mixed particles of different polymers to changes in the values of some critical factors. The aim of this paper was to analyse the efficiency of the triboelectric separation process of polymers with respect to any slight variation in the values of the most significant factors. Experiments with a sample of high-density polyethylene and polyvinyl chloride plastic granules were carried out on a laboratory experimental bench. Several one-factor-at-a-time experiments, followed by two factorial designs (one composite and the other fractional), were performed based on the following experimental procedure: (1) determination of the variation limits of the input variables; (2) identification of the set point and (3) robustness testing of the process, i.e. testing whether the performance of the system remains high even when the factors vary slightly around the set point.