Synthesis of malachite@clay nanocomposite for rapid scavenging of cationic and anionic dyes from synthetic wastewater

Synthesis of malachite@clay nanocomposite was successfully carried out for the removal of cationic (Methylene Blue, MB) and anionic dyes (Congo Red, CR) from synthetic wastewater. Nanocomposite was characterized by TEM, SEM, FT-IR, EDS analysis and zeta potential. TEM analysis indicated that the particle diameter of nanocomposite was in the range of 14 to 23 nm. Various important parameters viz. contact time, concentration of dyes, nanocomposite dosage, temperature and solution pH were optimized to achieve maximum adsorption capacity. In the case of MB, removal decreased from 99.82% to 93.67% while for CR, removal decreased from 88.55% to 75.69% on increasing dye concentration from 100 to 450 mg/L. pH study confirmed the higher removal of CR in acidic range while MB removal was higher in alkaline range. Kinetic study revealed the applicability of pseudo-second-order model for the adsorption of both dyes. Negative values of ΔG⁰ for both systems suggested the feasibility of dye removal and support for spontaneous adsorption of CR and MB on nanocomposite. Nanocomposite showed 277.77 and 238.09 mg/g Langmuir adsorption capacity for MB and CR respectively. Desorption of dyes from the dye loaded nanocomposite was easily carried out with acetone. The results indicate that the prepared malachite@clay nanocomposite is an efficient adsorbent with high adsorption capacity for the aforementioned dyes.     

分散染料neocron black(NB)的生物降解特性

在好氧、厌氧、好氧/厌氧交替条件下,采用活性污泥系统生物处理分散染料neocron black(NB),研究分散染料NB在需氧或者厌氧状态下的生物降解特性以及外加碳源对其生物降解特性的影响,并全波段扫描和气相色谱-质谱联用(GC-MS),初步探讨该染料的生物降解过程.结果表明,NB染料在好氧条件下降解效率最高,厌氧/好氧交替条件次之,厌氧条件下染料降解效率最低.随着NB染料浓度的增加,由于染料和中间代谢产物的抑制作用,微生物对染料的降解效率逐渐下降.添加易生物降解碳源可以促进NB染料的生物降解过程,并改变生物降解过程的动力学特征.全波段扫描和GC-MS测定结果显示,NB染料经过生物降解作用后,发色基团得到较彻底降解,NB染料生物降解中间产物有2,4-二硝基苯胺、2-氰基-4-硝基苯胺、对硝基苯胺等.     

Fe~0-C-Clay陶粒用于亚甲基蓝模拟废水处理的研究

针对传统微电解工艺存在的填料板结问题,烧制了一种新型微电解材料——Fe0/C/Clay陶粒,并将其应用于亚甲基蓝模拟废水的处理。单因素试验筛选的最佳试验参数为:亚甲基蓝浓度为1 000 mg/L,pH=5,A/L=1.5,HRT=4 h,此时色度去除率和COD去除率分别为90%和58%。紫外可见光谱扫描分析表明:可见光区的吸收明显减少。连续运行试验发现,出水水质稳定时间较长,运行中陶粒填料没有发生板结。     

CuO-TiO2/导电聚合物纤维复合材料的制备及其光催化性能

利用高压静电纺丝技术,制得含羧基的导电聚合物纤维(聚偏氟乙烯/苯乙烯-马来酸酐共聚物/纳米石墨).水热条件下在纤维表面原位合成了纳米级的TiO2,再通过水热法在TiO2表面制备了微米级的球形CuO颗粒,得到CuO-TiO2/导电聚合物纤维复合材料.运用扫描电子显微镜(SEM)、X射线衍射仪(XRD)、紫外-可见吸收光谱仪(UV-Vis)和热失重分析(TGA)对复合材料的结构与性能进行表征,并利用氙灯模拟太阳光进行光催化降解次甲基蓝实验.结果发现,CuO-TiO2/导电聚合物纤维复合材料的降解效率高于CuO-TiO2/非导电聚合物纤维、CuO-TiO2粉体和Degussa P25,光催化降解3.5h时,次甲基蓝的残留率为4.7％.     

改性石墨烯对水中亚甲基蓝的吸附性能研究

对十六烷基三甲基溴化铵(CTAB)改性石墨烯用于水中亚甲基蓝(MB)的去除进行了研究.用扫描电子显微镜(SEM)、透射电子显微镜(TEM)、X射线衍射分析仪(XRD)、傅里叶红外光谱分析仪(FTIR)和热重分析仪(TGA)对石墨烯和改性石墨烯性能进行表征.探讨了反应时间、pH、温度、剂量对石墨烯和改性石墨烯去除MB的影响.结果表明,在石墨烯制备过程中添加CTAB可以明显增大比表面积,提高MB的去除率.反应过程在前15 min内反应速率很快,并约在120 min内达到吸附平衡.吸附动力学符合伪二级动力学模型.最佳反应温度为293 K,吸附剂投加量的最适浓度为2 g·L-1,且吸附量的大小与溶液的初始pH值无关.通过Langmuir等温吸附方程得到改性石墨烯的最大吸附量86.43 mg·g-1,且为放热反应.     

新生态型聚硅酸铁锰处理染料废水的优化

为了提高混凝剂对染料废水的净化效率,本文利用硅酸钠、硫酸亚铁和高锰酸钾为原料合成了新型复配混凝剂聚硅酸铁锰(PSFM),分别以直接大红、分散蓝和活性黄染料废水为处理对象进行混凝模拟实验,研究了碱度和浊度等因素对PSFM混凝去除染料性能影响.结果表明,PSFM对直接大红和分散蓝染料废水具有较好的混凝净化效能,其色度和TOC去除率分别可达99.2%、95.4%和98.5%、93.8%,效果优于聚硅酸铁(PSF)、Al2(SO4)3和Fe Cl3等常规混凝剂,PSFM对活性黄染料废水色度和TOC去除率分别为56.3%和51.3%.浊度对PSFM混凝效能无明显影响.在碱度分别为50、0和75 mg·L~(-1)时,PSFM对直接大红、分散蓝和活性黄去除率分别达到最高.此外,利用扫描电子显微镜(SEM)、傅里叶红外(FTIR)和X射线衍射仪(XRD)等高级表征手段对PSFM进行了表征,对混凝过程中的混合液和絮体分别进行Zeta电位和絮体粒径在线监测,探索得PSFM混凝主要机制为Fe+与Mn+水解产生的带正电的多核配合物和聚硅的桥联聚合,同时还包括新生态水合二氧化锰和羟基氧化铁的吸附助凝作用.     

杭州湾南岸滩涂湿地多年蓝碳分析及情景预测

选取2003年、2017年杭州湾南岸遥感数据,利用ENVI软件和ArcGIS进行空间校正和图像处理,获得海岸带湿地数据,基于InVEST模型研究杭州湾南岸15年间滩涂湿地蓝碳及其价值的变化.结果显示:(1)2003~2017年总碳储存量和单位面积碳储量最大值均呈上升趋势,总碳储存量由0.223亿t上升到0.765亿t,增加0.542亿t.单位面积碳储量最大值也由451.27t/hm²上升到1775.42t/hm²,湿地碳汇潜力增加.(2)2003~2017年研究区域无碳损失,总体表现为碳积累,蓝碳总量为0.543亿t,单位面积净碳固定最大值为1324.12t/hm².(3)2003~2017年15年间杭州湾南岸海岸蓝碳总价值为4761.3亿元,单位面积蓝碳最大值为148.8万元,具有十分可观的生态价值.(4)滩涂蓝碳的储量同植被类型关系密切,研究区域芦苇作为优势种类,在提高本区域固碳能力中作用最大.(5)在预设的退塘还湿情景下,预测至2030年研究区固碳量和蓝碳价值增加明显.     

Fenton改性多壁碳纳米管对亚甲基蓝的吸附性能研究

通过催化裂解法制备多壁碳纳米管,利用Fenton试剂对多壁碳纳米管改性,研究了Fenton改性对多壁碳纳米管表面物理化学特性的影响和对亚甲基蓝的吸附特性.投射电镜(TEM)、比表面积(BET)分析表明,Fenton改性多壁碳纳米管纯度高,孔隙均匀,外径为30nm左右,比表面积为120m2/g;且表面引入了大量含氧基团,等电点为1.8.未改性和Fenton改性多壁碳纳米管对亚甲基蓝的吸附动力学均符合Langergren模型,其平衡吸附量分别为24.5,36.4mg/g;吸附等温线均符合Freundlich模型,未改性和Fenton改性多壁碳纳米管的kF分别为7.92和25.37;温度和pH值升高均有利于Fenton改性多壁碳纳米管对亚甲基蓝的吸附.     

增蓝剂抑制藻类生长效果及对斑马鱼的急性毒性

增蓝剂溶水后降低水下光照度,减弱入射光中370~440nm和530~680nm波段透射光.分析增蓝剂在0.1,1,5mg/L浓度及0.4,0.7,1m水深条件下,对自然水体原生藻类生长抑制效果,并测定其生物毒性.结果表明:在增蓝剂作用下水下光照度衰减明显,衰减系数(k)从0.25m-1增至0.7m-1.水深为0.4,0.7m时,增蓝剂抑藻效果显著(P<0.05),0.1,1,5mg/L浓度对藻类抑制率在第6d后迅速上升,在15d后稳定在65%以上,增蓝剂在0.4m水深抑藻效果较好.当水深至1m时,21d抑藻效果较差.急性毒性试验表明,增蓝剂对斑马鱼96hLC50为442.8 mg/L.     

Seven years from the first application of polyaluminium chloride in the Czech Republic – effects on phytoplankton communities in three water bodies

This study determines the efficiency of polyaluminium chloride application on phytoplankton species as a consequence of five reservoir restorations in the Czech Republic during the years 2005 and 2008, including the first ever large-scale application. Although polyaluminium chloride has been used in water treatment plants across the world, information about its application toward cyanobacterial blooms in nature is poor. Although the application of polyaluminium chloride did not cause any fundamental long-term changes in the composition of phytoplankton species or phosphorus load, instead causing fast and acute removal of the phytoplankton community, it may act as an algicidal compound with fast removal efficiency. All treated water bodies described in our study remained unaffected by cyanobacterial blooms and the hygienic limit for the purposes of recreation was not exceeded in any particular season. This article should serve as notice of the advantages and disadvantages of polyaluminium chloride application, and also warn against the uniform usage of this chemical as a method of reducing phytoplankton species in all types of water bodies where cyanobacteria are present. Moreover, data about the effects on non-target (invertebrates) species and microcystin release from cyanobacterial cells are also mentioned.