水溶性有机物对草萘胺在土壤中吸附与迁移的影响

采用批次吸附试验和土柱淋洗试验,研究了绿肥和污泥中水溶性有机物(DOM)对除草剂草萘胺在黄棕壤和石灰性潮土上吸附和迁移影响.结果表明,供试DOM均能明显降低草萘胺在2种土壤上的吸附,促进草萘胺的迁移,在黄棕壤上效果更明显.在所研究的草萘胺和DOM浓度范围内,绿肥DOM(GM)都比污泥DOM(SS)作用显著.草萘胺的吸附等温线可用Freundlich方程定量描述.绿肥DOM和污泥DOM可分别使黄棕壤中草萘胺吸附量比对照处理(不加DOM)减少22.9%和11.3%,使迁移出土体的草萘胺总量提高了73.42%和26.87%,而使潮土中草萘胺的吸附量减少了9.5%和6.5%,迁移出土体的草萘胺总量增加了43.54%和28.29%.因此,农业土壤中溶解性有机物对农药环境行为有一定影响.     

某市给水管网中铁释放现象影响因素与控制对策分析

针对某市管网水中铁浓度的变化规律进行了系统的研究,确定了管垢向管网水中释放出的铁是管网水中铁超标的主要原因.研究中发现铸铁管和镀锌钢管中管垢的主要化学组分为铁.在给水管网中,管网水的溶解氧和余氯浓度低时,对应的管网水中铁释放现象严重,其原因是还原条件使管垢表面的致密钝化层被破坏,造成二价铁的大量释放.根据试验结果提出了给水管网中铁释放和“红水”现象的控制对策.     

应用XAD系列树脂分离和富集天然水体中溶解有机质的研究进展

溶解有机质(dissolvedorganicmatter,DOM)是一类由腐殖质和非腐殖质构成的非均质混合物,广泛存在于土壤、煤炭和水体中,产生重要的生态环境效应。溶解有机质中相似组分的分离一直是有机质研究的难点。近年来,随着XAD树脂分离技术在DOM分离中的广泛应用,腐殖质和非腐殖质的分离取得了很大进展,文章对这些方法进行了详细的综述,并做了进一步的展望。     

基于ZIF-L的微固相萃取技术测定地表水中痕量典型多环芳烃

制备类沸石咪唑酯骨架ZIF-L材料,将其用作微固相萃取吸附剂,处理水中萘、苊、苊烯、芴、菲、蒽、荧蒽、芘等8种痕量典型多环芳烃,再用HPLC测定。试验表明,ZIF-L对上述多环芳烃的萃取效率明显高于商品化萃取材料C 18和多壁碳纳米管。方法在0.100μg/L^200μg/L范围内线性良好,方法检出限为0.02μg/L^0.03μg/L,标准溶液5次测定结果的RSD为4.7%~9.5%,实际水样加标回收率为84.5%~115%。将该方法用于北太湖5个点位水样的测定,测定值为未检出~3.40μg/L。     

液氮泡沫发生器内流动特性研究

低温液氮与泡沫混合液直接接触产生氮气泡沫是一种新型的掺混形式,利用液氮高汽化比的特点,搭建液氮泡沫可视化实验装置,进行氮气-水两相流及液氮泡沫流动特性的研究。结果表明,液氮相变产生大量氮气,其与泡沫液混合产生泡沫,温度有所回升,最终趋于泡沫混合液温度;管路沿程压降较小;液氮射流破碎及流动过程可分为6个区域:低温液氮区、向上循环翻滚区、滞留区、泡沫与泡沫混合液混合区、致密泡沫区、泡沫混合液区。流体向下游流动过程中持续发泡;为防止管路结冰,需合理控制泡沫混合液与液氮流量。     

屏蔽服冷却系统对人体表面温度影响的研究*

为科学有效地论证多种方式组合的冷却屏蔽服在不同环境条件下对人体表面温度控制的效果,需要对冷却系统及人体敏感部位发热量进行客观评估。通过对5名健康男性的高温测试,探究人体在不同环境温度下体表温度的变化,得出胸部、背部及额头为热量最高部位,并构建以“人体-降温屏蔽服-外界环境”为主体的冷却系统数值模型,对不同环境中的屏蔽服冷却效果展开研究,分析穿戴冷却屏蔽服时人体躯干部分的温度分布及影响。结果表明:在屏蔽服中靠近胸部、背部部位引入相变材料和风扇,均可帮助人体降低体温,提高舒适度。     

碘量法测定水中溶解氧有关问题的探讨及改进

碘量法测定溶解氧时,采用NH3·H2O—KI代替NaOH(KOH)—KI固定溶解氧,用H2SO4—H3PO(41+1)混合酸代替H2SO4溶解沉淀,使沉淀沉降速度加快,分界线明显,沉淀溶解也更完全。同时做样品空白实验,校正了氧化还原性物质产生的干扰,对废水有明显的抗干扰能力。通过对蒸馏水、自来水、池塘水、废水进行溶解氧测定,结果均非常满意。     

Predicting Water Quality Impaired Stream Segments using Landscape-Scale Data and a Regional Geostatistical Model: A Case Study in Maryland

In the United States, probability-based water quality surveys are typically used to meet the requirements of Section 305(b) of the Clean Water Act. The survey design allows an inference to be generated concerning regional stream condition, but it cannot be used to identify water quality impaired stream segments. Therefore, a rapid and cost-efficient method is needed to locate potentially impaired stream segments throughout large areas. We fit a set of geostatistical models to 312 samples of dissolved organic carbon (DOC) collected in 1996 for the Maryland Biological Stream Survey using coarse-scale watershed characteristics. The models were developed using two distance measures, straight-line distance (SLD) and weighted asymmetric hydrologic distance (WAHD). We used the Corrected Spatial Akaike Information Criterion and the mean square prediction error to compare models. The SLD models predicted more variability in DOC than models based on WAHD for every autocovariance model except the spherical model. The SLD model based on the Mariah autocovariance model showed the best fit (r² = 0.72). DOC demonstrated a positive relationship with the watershed attributes percent water, percent wetlands, and mean minimum temperature, but was negatively correlated to percent felsic rock type. We used universal kriging to generate predictions and prediction variances for 3083 stream segments throughout Maryland. The model predicted that 90.2% of stream kilometers had DOC values less than 5 mg/l, 6.7% were between 5 and 8 mg/l, and 3.1% of streams produced values greater than 8 mg/l. The geostatistical model generated more accurate DOC predictions than previous models, but did not fit the data equally well throughout the state. Consequently, it may be necessary to develop more than one geostatistical model to predict stream DOC throughout Maryland. Our methodology is an improvement over previous methods because additional field sampling is not necessary, inferences about regional stream condition can be made, and it can be used to locate potentially impaired stream segments. Further, the model results can be displayed visually, which allows results to be presented to a wide variety of audiences easily.     

金属粉尘湿法处理系统的设计和除尘效果分析

为改善金属抛光操作人员的工作环境、降低抛光金属粉尘的爆炸风险,设计一种金属粉尘湿法处理系统,并通过建立多相流动数值模型,探究其内部流场特征与金属粉尘运动规律,分析金属粉尘湿法处理系统的除尘效率。研究结果表明:大粒径的金属粉尘直接重力沉降至水槽中;小粒径(PM10)的金属粉尘易随气流进入风道,进而通过水雾脱除;采用洁净进气源,可以有效降低工人操作环境的粉尘浓度;增加细水雾,可以有效提高金属粉尘湿法处理系统的除尘效率,对PM10的除尘效率从30%提升至82%。     

气相色谱-串联质谱法测定沉积物中多环芳烃

采用ASE法提取沉积物中16种多环芳烃,以固相萃取法净化提取液,用气相色谱-串联质谱法测定。通过优化测定条件,使方法在5.00μg/L~1 600μg/L范围内线性良好,方法检出限为0.15μg/kg~0.66μg/kg。空白石英砂的加标回收率为61.9%~121%,7次测定结果的RSD为2.6%~11.1%。