稀释接种法测BOD5考核样品的一些注意点

用稀释接种法测定BOD5时,由于操作繁琐,全部实验时间需要5d,任一环节出现问题都会影响实验结果。在进行考核实验时,由于时间紧,样品量有限,因此每个实验操作步骤都要谨慎仔细。通过实践经验,就BOD,考核实验总结了一些注意点。     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

重金属阳离子荧光传感器合成及光谱性研究

通过亚胺缩合的反应制备出阳离子荧光传感器（Cation Fluorescent Sensors,CFSs）,并对其结构、光谱性能检测、荧光量子产率等进行了详细的研究.通过荧光化学传感器产生的荧光光谱一直是高效的分析方法,因此合成了新的基于席夫碱的荧光化学传感器,并研究了对各种金属离子的结合特性.在CH3CN溶液中测试了阳离子荧光传感器时不同阳离子的选择性响应,发现对Cu2＋有较好的选择性,可用于Cu2＋的检测.该类阳离子荧光传感器是基于2,2-联噻吩-5-乙醛的荧光发射基团和邻氨基苯甲醚为识别基团的一类阳离子荧光传感器.     

北京雾霾天气生物气溶胶浓度和粒径特征

近年来北京雾霾天气频发,空气颗粒物聚集是导致雾霾天气发生的主要原因之一.作为一种重要的空气颗粒物,生物气溶胶对人体健康存在危害.本研究调查了雾霾天气时,生物气溶胶浓度和粒径分布规律;对其同空气质量指数PM2.5(AQI),环境温度和湿度间的Spearman’s相关性进行了研究;分析了冬夏两季重度雾霾天气时,生物气溶胶粒径分布规律.结果表明,生物气溶胶浓度与PM2.5(AQI)呈负相关,与环境温度呈正相关.环境湿度与细菌气溶胶浓度呈负相关而与真菌气溶胶浓度呈正相关.在冬季,最大浓度细菌和真菌气溶胶分别在4.5~7.0μm和2.1~3.3μm粒径范围内检测到,而夏季最高浓度细菌和真菌气溶胶均分布在3.3~4.5μm范围内.本研究结果将为不同雾霾天气下,评价生物气溶胶对人类健康造成的危害提供基础数据.     

浅谈“5S”在环境监测业务管理中的应用研究

将“5S”管理概念应用到环境监测业务管理工作中.将“5S”针对企业管理的方法引入环境监测业务工作中,从工作环境、工作纪律、工作方法、工作安全方面进行一系列的应用.引入“5S”概念改进环境业务管理要求、提高环境监测工作效率、提升环境监测人员素质、加强环境监测的规范性和有效性,以一流的设备、技术、人才和管理,为用户提供高效优质的服务.“5S”管理理念应用于环境监测业务管理有助于环境监测业务工作的建设和提升.     

移动通信技术发展对安全生产影响研究*

为了深入揭示安全生产水平同移动通信技术发展的内在联系,提出安全生产信息技术能力的概念及其监控管理连接、救援响应监测、定位导航追踪3方面子能力的定义,进而通过构建3方面子能力同移动通信主要性能指标之间的关系模型（SPITCMC）,并对其进行深入分析和研究。研究结果表明:SPITCMC模型可以准确诠释过去移动通信技术发展对安全生产水平产生的影响,同时可用于预判未来移动通信技术发展对安全生产可能产生的影响程度,从而为后续相关工作的开展提供参考和借鉴。     

化学解耦联剂对活性污泥产率的控制作用

采用3,3',4',5-四氯水杨酰苯胺(TCS)作为代谢解耦联剂添加到活性污泥工艺中,进行连续曝气分批培养实验.结果表明:在TCS总投加量相同的情况下,采用一次性大剂量投加的污泥减量化效果好于分次小剂量投加.每d投加 12 mg TCS,污泥产量比对照下降了33%,而每2 d一次性投加24 mg TCS,污泥产量比对照下降了55%.污泥的CODCr去除能力有所下降,当一次性投加12 mg时,CODCr去除率比对照下降了12%,但出水氨氮及总氮质量浓度均未受影响.污泥的SVI有所上升,但沉降性能未见有明显变化.      

催化超临界水氧化处理1,5-萘二磺酸

采用Mn2O3/γ-AL2O3和V2O5/γ-Al2O/为催化剂,在一连续流固定床反应器中进行了超临界水氧化1,5-萘二磺酸实验.实验结果表明,在380～440℃,24 MPa条件下,Mn2O3/γ-Al2O3和V2O5/y-Al2O3催化剂对1,5-萘二磺酸的氧化降解具有显著的促进作用,TOC去除率达到90%以上;催化剂的催化效果随反应温度的升高而增强,随pH值的降低而增强,随停留时间的延长先增强后趋于平缓.     

24个CMIP5模式对长江流域模拟能力评估

根据1961~2005年长江流域气象站点的实测月降水量和气温数据,采用第5期全球耦合模式比较计划CMIP5(the Fifth Phase of Coupled Model Intercomparison Project)中24个全球气候模式(GCM)的模拟结果,通过计算模拟变量和观测变量平均值的相对误差、归一化的均方根误差、时间和空间相关系数,采用M-K趋势分析方法,分别选用在长江流域模拟气温和降水较好的5个模式进行集合平均,从时间的演变规律和空间的分布特征两方面,检验该模式集合对长江流域模拟气温和降水的能力。研究结果表明:各个模式模拟气温的能力要明显好于模拟降水的能力,但模拟气温较好的模式模拟降水的能力并不一定突出;模式集合的结果表明:在时间尺度上,模式集合平均结果与观测值拟合程度较好,且模式集合的结果振荡幅度较观测值小;在空间尺度上,模式集合的空间分布趋势与观测值大致相同,说明采用的模式集合结果用于预估未来长江流域降水的时空分布特征和演变规律是可行的。     

Gas/particle partitioning of atmospheric PCDD/Fs in a satellite town in Eastern China

Gas/particle partitioning of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in ambient air was investigated in a satellite town in Eastern China from April 2007 to January 2008 comprehending large temperature variations (from 3 to 34 °C, daily average). Molecular weight, molecular structure and ambient temperatures are the three major factors that govern the gas/particle partitioning of atmospheric PCDD/Fs throughout the year. Generally, good agreements were obtained (except for winter) between measured particulate fractions and theoretical estimates of both the Junge–Pankow adsorption model and Harner Bidleman absorption model using different sets of subcooled liquid vapor pressure and octanol–air partition coefficient (K_oa), respectively. Models utilizing estimates, derived from gas chromatographic retention indices (GC-RIs), are more accurate than that of entropy-based. Moreover, during winter, the K_oa-based model using the GC-RIs approach performs better on lower chlorinated PCDD/Fs than that of -based. Furthermore, possible sources of mismatch between measured and predicted values in winter (3–7 °C) were discussed. Gas adsorption artifact was demonstrated to be of minor importance for the phenomena observed. On the other hand, large deviations of slopes (m_r) and intercepts (b_r) in logK_p vs. plots from theoretical values are observed in the literature data and these are found to be linearly correlated with ambient temperatures (P<0.001) in this study. This indicates that the non-equilibrium partitioning of PCDD/Fs in winter may be significantly influenced by the colder temperatures that may have slowed down the exchange between gaseous and particulate fractions.