Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

Investigating the bacterial community and amoebae population in rural domestic wastewater reclamation for irrigation

Reclamation of domestic wastewater for agricultural irrigation is viewed as a sustainable option to create an alternative water source and address water scarcity. Free-living amoebae(FLA), which are amphizoic protozoa, are widely distributed in various environmental sources. The FLA could cause considerable environmental and health risks. However, little information is available on the risk of these protozoa. In this study, we evaluated the feasibility using rural domestic wastewater for agricultural irrigation, and analyzed dynamic changes of the microbial community structure and FLA populations in raw and treated wastewater, as well as the phyllosphere and rhizosphere of lettuce production sites that were irrigated with different water sources. The bacterial community dynamics were analyzed by terminal restriction fragment length polymorphism(T-RFLP). The bacterial community structures in the influent were similar to that in the effluent, while in some cases relative abundances varied significantly. The populations of Acanthamoeba spp. and Hartmannella vermiformis in the anaerobically treated wastewater were significantly higher than in the raw wastewater. The vegetables could harbor diverse amoebae, and the abundances of Acanthamoeba spp. and H. vermiformis in the rhizosphere were significantly higher than in the phyllosphere. Accordingly, our studies show insight into the distribution and dissemination of amoebae in wastewater treatment and irrigation practices.     

Relationship between PM10 and PM2.5 levels in high-traffic area determined using path analysis and linear regression

The objective of this study was to determine the relationship between PM_(10) and PM_(2.5) levels as related to meteorological conditions and traffic flow using both a linear regression analysis and a path analysis. The Particulate matter(PM) samples were collected from Sukhumvit road, Bangkok, Thailand, at both open(104 samples) and covered(92 samples)areas along the road. Fifteen percent of all samples were separated before the statistical models were run and used for model validation. The results from the path analysis were more elaborate than those from the linear regression, thus indicating that meteorological conditions had a direct effect on the particulate levels and that the effects of traffic flow were more variable in open areas. The model also indicated that meteorological conditions had an indirect effect and that traffic flow had a direct effect on particulate levels in covered areas. The model validation results indicated that for open areas, the R~2 values were not very different between the path analysis and the linear regression model, but that the path analysis was more accurate than the linear regression model at very low PM concentrations. At high PM concentrations, the path analysis model also had a better fit than did the linear regression, so the predictions from the path analysis model were more accurate than those from the linear regression.     

可靠性强化试验技术在某型伺服作动器研制中的适用性探索

目的探索可靠性强化试验技术在典型机电液一体化产品伺服作动器研制过程中的适用性。方法以某型伺服作动器为研究对象,从故障激发的角度对可靠性强化试验技术的应用进行可行性分析,在响应调查和应力分析的基础上,结合产品的工作特点设计适用于该类伺服作动器的可靠性强化试验方案,包含低温步进应力试验、高温步进应力试验、快速温度循环试验10个循环、振动步进应力试验(包含气锤式三轴向六自由度超高斯随机振动方式及电磁振动台随机振动方式)及综合环境应力试验5个循环,并依此进行试验。结果在快速温度循环试验及综合环境应力试验过程中,均有效地激发出了产品的漏油故障,与相似产品外场暴露的漏油故障模式相吻合。结论可靠性强化试验技术可有效地应用于典型机电液一体化产品伺服作动器的研制过程,设计的可靠性强化试验方案可有效地激发外场出现频率较高的故障,可作为该类产品研制的试验手段之一。     

空间站控制力矩陀螺微振动测试技术

目的分析控制力矩陀螺的微振动扰动特性。方法通过获取陀螺连接点对结构的扰振力输出、关键部位的微振动响应来获取产品的微振动扰动特性,通过隔振的方式对外部环境的干扰进行隔离,进而降低测试的背景噪声,通过运用高精度测试传感器来实现微小扰动力信号、加速度信号的测量,利用结构有限元法及单点激励多点响应的模态分析方法校核系统刚度,进而确定测试频率范围是否满足需求。结果可同时获得空间站控制力矩陀螺连接点处的输出扰振力、质心处的输出扰振力合力、合力矩以及关键部位的微振动响应,可有效隔离外部干扰,扰振力背景噪声的时域信号最大值可控制在0.07 N以内,RMS值在0.02 N以内,加速度信号的时域背景噪声最大值可控制在1.5 mg以内,RMS值在0.1 mg以内。可识别微小扰振信号,加速度传感器分辨率为5×10-5 grms,力传感器的测量分辨率为1×10-2 N,力矩测量分辨率小于1×10-2 N·m。测试频带在320 Hz以内。结论满足型号需求,并投入型号使用。     

典型铅锌矿化区不同土地利用类型土壤重金属污染特征与评价

选取云南者海典型铅锌矿区周边冶炼区（A）、粮食主产区（B）、保护区（C）三个区域土壤为研究对象,分析三个区域内林地（LD）和耕地（GD）土壤pH、总碳（TC）、总氮（TN）、总磷（TP）和5种重金属（Hg、Cd、Pb、Zn、Cu）含量,利用典范对应分析（CCA）研究不同土地利用类型下它们之间的关系,基于系统熵值与重金属生物毒性改进灰色聚类评价法对研究区重金属污染程度进行评价。结果表明,A、B、C三区土壤的5种重金属均超过云南省土壤背景值,且含量A区 > B区 > C区,所有土壤样品Hg、Cd、Pb、Zn、Cu平均含量分别为7.24、1.53、1 794、2 892、210 mg/kg;LD土壤重金属含量普遍高于GD。研究区土壤pH总体呈弱酸性,但A区土壤受矿业活动影响呈弱碱性。TC、TN含量和C/N值均表现出LD大于GD,但TP含量表现为GD显著大于LD （P<0.05）。CCA分析表明LD和GD土壤pH与Cd和Cu呈负相关,与Zn和Pb呈正相关,且pH对重金属含量的影响最大;TC、TP与重金属Cd和Cu在LD土壤中呈正相关,在GD土壤中呈负相关。改进灰色聚类评价结果表明重金属污染程度均表现为LD大于GD;A区污染最严重且均呈重度污染,B区次之,C区污染程度最轻。经比较本文改进的灰色聚类评价法在准确性和灵敏度方面优于传统方法。     

Desert Water Harvesting to Benefit Wildlife: A Simple, Cheap, And Durable Sub-Surface Water Harvester for Remote Locations

A sub-surface desert water harvester was constructed in the sagebrush steppe habitat of south-central Idaho, U.S.A. The desert water harvester utilizes a buried micro-catchment and three buried storage tanks to augment water for wildlife during the dry season. In this region, mean annual precipitation (MAP) ranges between about 150–250 mm (6″–10″), 70% of which falls during the cold season, November to May. Mid-summer through early autumn, June through October, is the dry portion of the year. During this period, the sub-surface water harvester provides supplemental water for wildlife for 30–90 days, depending upon the precipitation that year. The desert water harvester is constructed with commonly available, “over the counter” materials. The micro-catchment is made of a square-shaped, 20 mL. “PERMALON” polyethylene pond liner (approximately 22.9 m × 22.9 m = 523 m²) buried at a depth of about 60 cm. A PVC pipe connects the harvester with two storage tanks and a drinking trough. The total capacity of the water harvester is about 4777 L (1262 U.S. gallons) which includes three underground storage tanks, a trough and pipes. The drinking trough is refined with an access ramp for birds and small animals. The technology is simple, cheap, and durable and can be adapted to other uses, e.g. drip irrigation, short-term water for small livestock, poultry farming etc. The desert water harvester can be used to concentrate and collect water from precipitation and run-off in semi-arid and arid regions. Water harvested in such a relatively small area will not impact the ground water table but it should help to grow small areas of crops or vegetables to aid villagers in self-sufficiency.     

用EXCEL进行精密度-偏性分析质控数据处理

利用EXCEL强大的数据处理功能，可以方便地对精密度—偏性分析质控数据进行处理，具有较高的推广价值。     

CTL-12型化学需氧量速测仪与标准法测定CODCr之比较

使用CTL—12型化学需氧量速测仪分析废水化学需氧量，简便、快速，且方法可行，完全能满足环境监测技术要求。     

Trace Metal Concentration in Roadside Surface Soil and Tree Back: A Measurement of Local Atmospheric Pollution in Abuja, Nigeria

Cadmium, copper, lead, nickel and zinc concentrations were analysed by atomic absorption spectrophotometry in surface soil and tree bark from different districts of Abuja, Nigeria, in order to determine the atmospheric trace metal input in the area.Elevated concentrations of some of the studied metals were observed in the soil and tree bark samples from the commercial/high traffic areas of the city compared to backgroundvalues. In soil samples, the average concentration of the metals were 0.6±0.4, 18.0±4.0, 281±39, 16±4 and66±23 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively, whilst the average concentrations in tree bark were 0.3±0.2, 12±4, 133±32, 13±3 and 61±10 g g^-1 dry weight for Cd, Cu, Pb, Ni and Zn, respectively. The trend in trace metal levels suggested that automobile emissions are a major source of these metals as the highest concentrations of Pb and Zn were recorded in the commercial areas of the city known for their high traffic densities. The levels of metal in the study area were relativelylow compared to levels found in some larger and older cities in various countries worldwide.