NETWORK AND SUBWATERSHED PARAMETERS EXTRACTED FROM DIGITAL ELEVATION MODELS: THE BILLS CREEK EXPERIENCE1

ABSTRACT: An automated extraction of channel network and sub-watershed characteristics from digital elevation models (DEM) is performed by model DEDNM. This model can process DEM data of limited vertical resolution representing low relief terrain. Such representations often include ill-defined drainage boundaries and indeterminate flow paths. The application watershed is an 84 km² low relief watershed in southwestern Oklahoma. The standard for validation is the network and subwatershed parameters defined by the blue line method on USGS 7.5–minute topographic maps. Evaluation of the generated and validation networks by visual comparisons shows a high degree of correlation. Comparison of selected network parameters (channel length, slope, drainage density, etc.) and of drainage network composition (bifurcation, length, slope, and area ratios) shows that, on the average, the generated parameters are within 5 percent of those derived from the validation network. The largest discrepancies were found for the channel slope values. The results of this application demonstrate that DEDNM effectively addresses network definition problems often encountered in low relief terrain and that it can generate accurate network and subwatershed parameters under those conditions.     

PARALLEL DRAINS FROM THE LAPLACE STANDPOINT1

Where natural drainage is inadequate for keeping the water table below the root zone of the crops being grown, drains are often employed to control water table levels. Such drains are commonly installed in parallel lines at depths and spacings adapted to the needs of the area. Formulas used for determining drain spacings are generally based upon Dupuit-Forchheimer concepts. These developments postulate a saturated, permeable aquifer underlying the irrigated area and an impermeable barrier underlying the aquifer. The basic differential equation expresses the requirement that the flow out through the sides of a vertical column of infinitesmal cross sectional area must be supplied by a corresponding drop of the water table at the top of the column. If variations of transmissivity due to variations of water table level are taken into account the second order differential equation obtained is nonlinear. To avoid the mathematical difficulties posed by this nonlinearity it is customary to neglect the effects of changes of transmissivity due to changes of water table levels. This imposes a restriction that the formulas derived from these linearized differential equations suffer a loss of accuracy if the change of water table levels becomes a considerable portion of the initial saturated depth. Offsetting these difficulties is the tactical advantage that the linearized differential equations are of types long studied in older developments concerned with conduction of heat in solids. The advantages conferred by the possibilities for exploiting the results of investigations in the older discipline are many. An alternative approach is based upon a requirement that there can be no accumulation of water in any elementary cubical volume located in the zone of complete saturation below the water table. The differential equation obtained on this basis, if the aquifer is homogeneous and isotropic, is the one which bears the name of Laplace. It will be the purpose of this paper to explore the possibilities afforded by this approach for evaluating the flow to parallel drains and to compare the results with those obtainable by the Dupuit-Forchheimer method.     

POTENTIALS FOR REUSE OF WASTEWATER IN NORTH CENTRAL TEXAS1

ABSTRACT There are several possible ways in which wastewater from municipalities may be reclaimed and reused so as to minimize the need for imported water in North Central Texas. The rationale for reuse is enhanced by the fact that new water quality requirements in the Trinity River system will necessitate a very high degree of treatment at municipal sewage plants, just for discharge to surface streams. The largest potential market for municipal effluent is the steam-electric power industry. Within the next decade the generating capacity for electric power in North Central Texas will have to be more than doubled to meet increasing demand. Adequate supplies of condenser cooling water for such expansion will be difficult to obtain and assure. New large power stations might advantageously be located adjacent to municipal wastewater treatment plants, to utilize effluent as make-up water for cooling towers. Experience elsewhere has shown that well-treated wastewater can be used for cooling tower make-up with a minimum of trouble, with a considerable saving in overall cost, and with conservation of pristine water for other uses.     

CRITICAL EVALUATION OF CERTAIN METHODS OF UNSTEADY GROUNDWATER HYDRAULICS1

The basic theories and fundamental assumptions usually employed in the solution of unsteady groundwater flow problems are reviewed critically. The best known method of analysis for such problems is based on the Dupuit-Forchheimer approximation and leads to a nonlinear parabolic differential equation which is generally solved by linearization or numerical methods. The accuracy of the solution to this equation can be improved by use of a different approach which does not employ the Dupuit Forchheimer assumption, but rather is based on a semi-numerical solution of the Laplace equation for quasi-steady conditions. The actual unsteady process is replaced by a sequence of steady-state conditions, and it is assumed that the actual unsteady flow characteristics during a short time interval can be approximated by those associated with “average” steady state flow. The Laplace equation is solved by a semi-discretization method according to which the horizontal coordinate is divided into subintervals, while the vertical coordinate is maintained continuous. The proposed method is applied to a typical tile drainage problem, and, based on a comparison of calculated results with experimental data, the method is evaluated and practical conclusions regarding its applicability are advanced.     

A MODELING APPROACH FOR OPTIMUM SEDIMENT DETENTION POND DESIGN1

ABSTRACT: A design procedure to determine optimum size for a sediment detention pond is presented. The procedure is based on simulating the sediment removal efficiency of the pond in conjunction with temporal variations in rainfall and potential land use and/or management options. The simulation procedure is based on a combined probabilistic-deterministic modeling approach. The probabilistic model generates daily rainfall with hourly increments for a selected site. The deterministic model simulates sediment yield and concentration for drainage area (pond inflow) and sediment trapping efficiency of the pond. The sediment yield and concentration in pond effluent is estimated from the difference between sediment inflow to the pond and sediment trapped by the pond. As an example, the procedure is applied to determine optimum design for a sediment detention pond in a surface mined area using several pond design options and alternative mining operation/land reclamation strategies.     

Mineralogical compositions of aquifer matrix as necessary initial conditions in reactive contaminant transport models

Mineralogical compositions and their spatial distributions are important initial conditions for reactive transport modeling. However, popular Kd-based "reactive" transport models only require contaminant concentrations in the pore fluids as initial conditions, and minerals implicitly represent infinite sources and sinks in these models. That situation results in a general neglect of mineralogical characterization in site investigations. This study uses a coupled multi-component reactive mass transport model to predict the natural attenuation of a ground water plume at a uranium mill tailings site in western USA. Numerous ground water geochemistry data are available at this site, but mineralogical data are sketchy. Even given the well-defined pore fluid chemistry, variations of secondary mineral species and mineral abundances in the aquifer resulted in significantly different modeling outcomes. Results show that the amount of calcite in the aquifer determines the distances of plume migration. The possible presence of jurbanite, an aluminum sulfate phase, can store acidity temporarily but cause more severe contamination on a later date. The surfaces of iron oxyhydroxides can store significant amounts of sulfate and protons and serve as a second source for prolonged contamination. These simulations under field conditions illustrate that mineralogical compositions are an essential requirement for accurate prediction of contaminant fate and transport.     

涝渍地暗管排水示范工程建设有关问题研究

结合中日专项技术合作四湖项目的具体实践,指出了暗管工程规划中排水调查的内容和重点,就如何评判暗管排水的必要性和确定暗管设计排水量进行了探讨,分析了暗管排水与规划单元排灌系统的关系。排水调查是农田基本建设实施过程中不可缺少的一个环节,就涝渍地治理改造而言,调查的重点是要弄清排水不良的原因和取得解决问题的基础资料。为了制定符合实际的农田排水规划实施方案,可从土壤类型、土壤承载力、降雨后地表积水状况、土壤透水性和地下水位等对规划单元内的农田是否需要暗管排水作出判断。对水田而言,在田面水排除后,领先暗管要排除地表残留水和过剩的土壤重力水,据此决定暗管设计排水量。对于旱田,渗入土壤中以重力水存在的过乘水需要通过暗管排除,据此决定暗管设计排水量。暗管工程适于江河中下游地势低洼、排水不良的农田,当明排不能有效地降低地下水位满足作物生长时,有必要采取暗管排水。     

THE IMPACT OF HIGH INTEREST RATES ON OPTIMUM MULTIPLE OBJECTIVE DESIGN OF SURFACE RUNOFF URBAN DRAINAGE SYSTEMS1

ABSTRACT. This research examines the impact of high rates of interest upon the least cost system design for urban drainage systems when water quality is a critical parameter. Results of examination of twelve alternative system designs in a case study watershed indicate the least cost study design is highly sensitive to the rate of interest, but not sensitive to the water quality parameters. When the high rates of interest currently prevalent are introduced into the model those systems which contain open channel collection components are selected as the least cost system. At low rates of interest pipeline collection components are selected as the least cost system. Holding pond components of system design are cost effective at several levels of water quality. They are neutral to the rate of interest so they are incorporated in least cost systems at all the levels of interest rates. The results of the study indicate that at the current high rates of interest open channel collection systems and holding ponds are cost effective system components to achieve selected levels of water quality in urban drainage system design.     

COMPARATIVE EVALUATION OF THREE URBAN RUNOFF MODELS1

ABSTRACT: Three urban runoff models, namely, the Road Research Laboratory Model (RRLM), the Storm Water Management Model (SWMM) and the University of Cincinnati Urban Runoff Model (UCURM), were examined by comparing the model simulated hydrographs with the hydrographs measured on several instrumented urban watersheds. This comparison was done for the hydrograph peak points as well as for the entire hydrographs using such statistical measures as the correlation coefficient, the special correlation coefficient and the integral square error. The results of the study indicated that, when applying the three selected non-calibrated models on small urban catchments, the SWM model performed marginally better than the RRL model and both these models were more accurate than the UCUR model. On larger watersheds, the comparisons between the SWM model and the other two models would be likely even more favourable for the SWM model, because it has the most advanced flow routing scheme among the studied models.     

STORM WATER MANAGEMENT: THE CONCEPT AND ITS APPLICATION1

ABSTRACT: Storm water management is a concept being applied in many urban areas to deal with the increasing problems of storm runoff control and flood damage prevention. This paper introduces the concept and describes the recently completed storm water management program in Columbus, Georgia. Columbus has spent five years and over $200,000 in the development of their problem which includes several basic elements: soils inventory and analysis, hydrologic data collection, sediment and erosion control ordinance, storm water management handbook, urban flood simulation model, interdepartment coordination study, drainage problem categorization study, and a pilot basin study. The results of the pilot basin study are presented including example output from the urban simulation model. The computer output illustrates both the hydrologic-hydraulic and economic capabilities of the model.