膨润土接枝丙烯酸高吸水性树脂的抑尘性能研究

在微波辐射下制备了膨润土接枝丙烯酸高吸水性树脂(SAP)(一种加入聚乙烯醇(PVA),另一种不加入PVA)。结果表明:(1)红外光谱图表明,PVA与聚合网络形成了半互穿网络结构;X射线衍射图表明,膨润土与PVA、丙烯酸形成了具有无定形结构的复合产物。(2)不论是沙土堆还是尘土堆,喷洒膨润土接枝丙烯酸SAP溶液的抑尘效果明显比喷洒自来水好;喷洒膨润土接枝丙烯酸SAP溶液的尘土堆的抑尘效果好于沙土堆。(3)在温度为15℃时,考虑到节约成本的问题,首选不加入PVA的膨润土接枝丙烯酸SAP做抑尘剂;在温度为45℃时,加入PVA的膨润土接枝丙烯酸SAP适合做抑尘剂。(4)膨润土接枝丙烯酸SAP浓度越高,其耐蒸发性越高。     

电厂袋式除尘器滤袋故障分析及处理

以北京高井热电厂为对象,运用故障树分析的方法,对袋式除尘器及滤袋失效进行了故障树分析,并将之演变为成功树,提出了防止滤袋失效的措施。     

袋式除尘器在沥青混凝土搅拌设备上的应用

分析了沥青混凝土搅拌设备的构成以及生产沥青混凝土的工艺及烟尘特点;通过应用工程实例,指出袋式除尘器是沥青混凝土搅拌设备最理想的除尘系统之一。     

基于元素毒性赋值的模糊数学环境质量评价

利用模糊数学方法,根据元素毒性的大小进行权重赋值,对成都经济区近地表大气尘进行地球化学环境质量评价。结果显示：不同城市中,成都、乐山、眉山的大气环境质量较好,处于一级清洁级别;眉山、雅安的大气环境质量处于二级安全级别;德阳的大气环境质量已经处于三级警戒级。不同地区中,绵阳和眉山的大气环境质量较好,处于一级清洁级别;德阳和雅安处于二级安全级别,成都和乐山处于三级警戒级.     

Robustness testing of a free-fall triboelectric separation process for plastic waste recovery

Among the separation techniques used in industries, the triboelectric separation of insulating particles using a rotary tube is an effective way employed in the waste recovery of plastic and mineral products. This process, also called free-fall triboelectric separation, is widely used for the sorting of granular mixtures resulting from industrial plastic wastes. Given that the robustness of such a separation process is an important issue, a standard procedure is used for determining the set point and for minimising the process sensitivity of sorting mixed particles of different polymers to changes in the values of some critical factors. The aim of this paper was to analyse the efficiency of the triboelectric separation process of polymers with respect to any slight variation in the values of the most significant factors. Experiments with a sample of high-density polyethylene and polyvinyl chloride plastic granules were carried out on a laboratory experimental bench. Several one-factor-at-a-time experiments, followed by two factorial designs (one composite and the other fractional), were performed based on the following experimental procedure: (1) determination of the variation limits of the input variables; (2) identification of the set point and (3) robustness testing of the process, i.e. testing whether the performance of the system remains high even when the factors vary slightly around the set point.     

电除尘器电源交流分量对PM_(2.5)等细微颗粒物除尘效率的影响

除尘器对颗粒物的除尘效率与颗粒物的荷电量密切相关,PM2.5等细小颗粒物由于其荷电量不足而导致其吸收效率较低,对环境造成危害。为了增加粒子的荷电量,以粒子荷电原理为理论依据,从离子电流密度和通过电凝并扩大尘粒中位径2个方面研究了电除尘电源中交流电压分量对PM2.5等细小颗粒物荷电特性的影响,得出了电除尘器电源中交流电压分量可从以上2个方面提高装置对PM2.5等微小颗粒物的荷电量,且频率越高,幅值越大,荷电效果越好,从而可以提高装置对细小颗粒物的除尘效率。     

Identification of magnetic particulates in road dust accumulated on roadside snow using magnetic, geochemical and micro-morphological analyses

The aim of this study is to test the applicability of snow surveying in the collection and detailed characterization of vehicle-derived magnetic particles. Road dust extracted from snow, collected near a busy urban highway and a low traffic road in a rural environment (southern Finland), was studied using magnetic, geochemical and micro-morphological analyses. Significant differences in horizontal distribution of mass specific magnetic susceptibility (χ) were noticed for both roads. Multi-domain (MD) magnetite was identified as the primary magnetic mineral. Scanning electron microscope (SEM) analyses of road dust from both roads revealed: (1) angular-shaped particles (diameter ∼1-300 μm) mostly composed of Fe, Cr and Ni, derived from circulation of motor vehicles and (2) iron-rich spherules (d ∼ 2-70 μm). Tungsten-rich particles (d < 2 μm), derived from tyre stud abrasion were also identified. Additionally, a decreasing trend in χ and selected trace elements was observed with increasing distance from the road edge.     

固定床中粒状脱硫剂除尘效率的研究

建立了非稳态过滤下的固定床颗粒层除尘效率模型.该模型尽可能地包含了影响固定床颗粒层除尘的参数,反映了沉积粉尘对除尘效率的影响;研究了以粒状脱硫剂为滤料的固定床在不同颗粒层厚度、空床气速、粒径下的除尘效率.结果表明,在颗粒层厚度为400～800 cm、空床气速≤0.4 m/s的条件下,颗粒层的除尘效率可达90％以上.     

防风抑尘网设计要点及参数的确定

介绍了堆场起尘、防风抑尘网抑尘的机理和国内外防风抑尘网研究结果,结合实际工程设计的经验,分析了防风抑尘网设计要点和主要参数,提出防风抑尘网设计的意见和建议。     

Leaching of copper and zinc from spent antifouling paint particles

Leaching of Cu and Zn from a composite of spent antifouling paint particles, containing about 300 mg g⁻¹ and 110 mg g⁻¹ of the respective metals, was studied in batch experiments. For a given set of simulated environmental conditions, release of Cu was independent of paint particle concentration due to attainment of pseudo-saturation, but Zn was less constrained by solubility effects and release increased with increasing particle concentration. Leaching of Cu increased but Zn decreased with increasing salinity, consistent with mechanisms governing the dissolution of Cu₂O in the presence of chloride and Zn acrylates in the presence of seawater cations. Because of complex reaction kinetics and the presence of calcium carbonate in the paint matrix, metal leaching appeared to be greater at 4 °C than 19 °C under many conditions. These findings have important environmental and biological implications regarding the deliberate or inadvertent disposal of antifouling paint residues.