被动采集大气颗粒物样品的粒径分布特征

在可同时采集气态与颗粒态大气污染物的被动采样装置中放置涂有薄层凡士林的载玻片,用于采集大气悬浮颗粒物,利用粒度粒形仪分析样品粒径分布特征,并深入探讨风速以及采样罐外壁添加300目滤网(孔径50μm)对样品粒径分布的影响.结果表明,在室内静风与室外相对封闭的条件下,添加滤网可有效阻止50μm的粗颗粒组分进入采样罐;而在室外有风的条件下,添加滤网后仍有粗颗粒进入采样罐中,但进入概率与风速大小之间无关.观察粒径10μm以下颗粒的分布曲线,室内静风条件下得到的分布曲线与主动采样得到的结果极为类似.而在有风条件下,3～5μm的颗粒组分比重有所减少,6～9μm颗粒组分比重明显增加.上述问题在被动采样器的使用中需予以考虑,结合样点具体情况判断是否添加滤网.     

应急监测空气和废气中醋酸乙烯

醋酸乙烯作为重要的有机化工原料在扬州多家化工企业使用,在此针对醋酸乙烯的理化性质,采用便携式采样器采集气体样品,参考了EPA．625方法中采样罐采样热脱附气相色谱-质谱法进行分析,但是热脱附装置和采样罐价格昂贵．质谱分析时间较长．操作要求高．不便于常规监测分析,现采用活性炭吸附气相色谱分析醋酸乙烯。通过实验总结出一套采样时间短分析速度快．灵敏度高的快速分析方法．为环境监测工作中醋酸乙烯应急监测提供分析参考。     

寒冷地区KC-1000大流量TSP采样仪技术改造

在保证KC-1000大流量TSP采样仪各项技术指标稳定的前提下,拆解仪器怕冻组件、改造室内安装方法,解决了采样仪在伊春冬季不能正常使用的难题.     

工业和交通对城市降尘中砷和5种重金属的影响研究

为了研究工业和交通对降尘中As、Cd、Cr、Cu、Pb和Zn的影响,在上海市杨浦区设置11个采样点,对采样点降尘中砷和5种重金属元素的含量进行了调查,并分析工业和交通对降尘中砷和5种重金属元素的影响.结果表明工业和交通影响区域降尘中砷和5种重金属元素的含量,相对于土壤背景值,降尘中Cd、Cu、Zn三种重金属的含量较高,...     

呼吸性粉尘个体采样器气流脉动的研究

分析了个体呼吸性粉尘采样器气流脉动的形成原因,以及其对采样性能的影响,提出了解决这一问题的方法。     

Suspended solids within sewers: an experimental study

A precise determination of the pollutant loads processed through the sewer networks is required for legal, environmental and management reasons. Such a determination requires a good evaluation of concentrations, which is not an easy task because samplers or sensors can perform measurements in a cross-sectional area of only a few locations, and this local information must then be extrapolated across the whole cross-sectional area of the sewer network. This latter step is problematical. A great deal of attention must be given to suspended solids because they are prone to settle and display heterogeneous concentration patterns. A two-dimensional sampler has been designed to measure the variation of suspended solids concentration throughout a cross-sectional area. This paper presents the principles upon which the conception of this experimental device was based and the building process. Experimental results are presented and discussed.     

大气颗粒物采样器的设计与应用

自行开发设计大气颗粒物双通道采样器,通过更换粒径切割器实现对大气总悬浮颗粒物(TSP)、可吸入颗粒物(PM10)或细颗粒物(PM2.5)样品的采集。该仪器通过流量传感器、比例阀和流量控制板精确控制每个通道的采样流量,控制系统还可实时采集大气环境温度、压力、湿度、风速和风向5个气象参数,并根据环境温度、压力的变化对采样的体积流量进行补偿计算,以确保进样口体积流量恒定,保证粒径切割准确。在2011年深圳大学生运动会期间(8月12—23日)和后期(8月24日至9月4日),利用该仪器进行了大气环境野外观测实验,并对该仪器和Thermo2300采样器的结果进行了平行性分析和对比分析,其平行结果和对比结果相关系数均大于0.99。     

Systematic Biases in Measurement of Urban Nitrogen Dioxide using Passive Diffusion Samplers

Measurement of nitrogen dioxide using passivediffusion tube over 22 months in Cambridge, U.K. areanalysed as a function of sampler exposure time, andcompared with NO₂ concentrations obtained from aco-located chemiluminescence analyser. The averageratios of passive sampler to analyser NO₂ at acity centre site (mean NO₂ concentration 22 ppb)are 1.27 (n = 22), 1.16 (n = 34) and 1.11 (n = 7) forexposures of 1, 2 and 4-weeks, respectively. Modellingthe generation of extra NO₂ arising from chemicalreaction between co-diffusing NO and O₃ in thetube gave a ratio (modelled/measured) of 1.31 for1-week exposures. Such overestimation is greatest whenNO₂ constitutes, on average, about half of totalNO_x (= NO + NO₂) at the monitoring locality.Although 4-week exposures gave concentrations whichwere not significantly different from analyserNO₂, there was no correlation between thedatasets. At both the city-centre site and anothersemi-rural site (mean NO₂ concentration 11 ppb)the average of the aggregate of four consecutive1-week sampler exposures or of two consecutive 2-weeksampler exposures was systematically greater than fora single 4-week exposure.The results indicate two independent and opposingsystematic biases in measurement of NO₂ bypassive diffusion sampler: an exposure-timeindependent chemical overestimation with magnitudedetermined by local relative concentrations of NO andO₃ to NO₂, and an exposure-time dependentreduction in sampling efficiency. The impact of theseand other potential sources of systematic bias on theapplication of passive diffusion tubes for assessingambient concentrations of NO₂ in short (1-week)or long (4-week) exposures are discussed in detail.     

A Depth‐Proportional Intake Device for Automatic Water Samplers1

Abstract: This paper describes the construction and testing of a device for pumping water samplers that collects suspended sediment samples by moving the intake vertically to keep it at the same proportion of flow depth. The device uses a simple sprocket mechanism that can be mounted vertically on the downstream side of culverts and bridge pilings to protect against damage from floating debris during storms. Suspended sediment samples collected from an urban stream with the depth‐proportional device were compared with manual samples taken with a depth‐integrated sampler. Scatter in the relationship between pumped and manual samples (R² = 0.76) are probably explained by horizontal variability in concentrations, poor mixing associated with lateral sediment inputs from construction site erosion, the downstream orientation of the intake, and the failure of the concentration at 60% of the flow depth to match the average vertical concentration.     

Sampling atmospheric pesticides with SPME: Laboratory developments and field study

To estimate the atmospheric exposure of the greenhouse workers to pesticides, solid phase microextraction (SPME) was used under non-equilibrium conditions. Using Fick's law of diffusion, the concentrations of pesticides in the greenhouse can be calculated using pre-determined sampling rates (SRs). Thus the sampling rates (SRs) of two modes of SPME in the lab and in the field were determined and compared. The SRs for six pesticides in the lab were 20.4-48.3 mL min⁻¹ for the exposed fiber and 0.166-0.929 mL min⁻¹ for the retracted fiber. In field sampling, two pesticides, dichlorvos and cyprodinil were detected with exposed SPME. SR with exposed SPME for dichlorvos in the field (32.4 mL min^-1) was consistent with that in the lab (34.5 mL min^-1). SR for dichlorvos in the field (32.4 mL min⁻¹) was consistent with that in the lab (34.5 mL min⁻¹). The trends of temporal concentration and the inhalation exposure were also obtained.