一株抗Cd~（2＋）菌株的筛选及其吸附性能

Cd2＋为一种毒性金属元素,为了实际解决污水中低浓度重金属污染,实现污水达标排放,通过12C6＋重离子束辐照诱变技术筛选到一株耐受Cd2＋的菌株C2,研究其对Cd2＋的抗性和低浓度Cd2＋的吸附性能表明,Cd2＋浓度≤100 mg/L时,C2菌株可以生长繁殖,但随Cd2＋浓度升高受到抑制;SEM分析表明,受到Cd2＋胁迫时,C2产生大量胞外产物与Cd2＋形成络合物;吸附过程中菌粉表面空隙得到填充,形成凸起;红外光谱分析表明,吸附过程中的主要作用基团为醇羟基O—H键、氨基和酰胺基团;C2菌粉和固定化菌球都对Cd2＋有较好的吸附能力,菌粉吸附效果比固定化菌球稍好;菌粉和固定化吸附剂的最佳吸附初始pH值为5~6.0,最佳投加量分别为1.0 g/L和10 g/L（实际含菌量为1.0 g/L）;Cd2＋浓度在2~20mg/L时,在最佳吸附条件下,菌粉和固定化吸附剂对Cd2＋的吸附率均在90%左右;2种吸附剂吸附过程与Langmuir等温模型和拟二级动力学模型拟合最佳;热力学研究表明吸附反应均能自发进行。以上研究结果表明,C2菌粉和固定化吸附剂均可用于污水中低浓度Cd2＋的去除。     

电渗透脱水污泥干燥特性曲线及干燥模型

通过电渗透脱水技术及自然风干技术两种预处理方式降低污泥含水率,当污泥初始含水率相近时,研究经两种方式处理后污泥的干燥特性曲线,并对电渗透脱水污泥干燥特性曲线的优势情况进行探讨。在40—120℃的低温条件下,研究电渗透脱水污泥（泥饼厚度为3．5mm）的干燥特性曲线并分析其干燥特性。通过所得电渗透脱水污泥的干燥特性曲线,引人薄层污泥干燥模型进行数值分析。结果表明,在实验条件下,电渗透脱水污泥的干燥速率要优于自然风干污泥的干燥速率。随着温度的升高,电渗透脱水污泥的干燥速率随之升高,干燥到所需含水率的时间则随之减少。Logarithmic模型比其他模型更适合描述薄层电渗透脱水污泥在低温条件下的干燥特性。     

ABR处理硫酸盐有机废水的BP神经网络建模

通过厌氧折流板反应器(ABR)处理硫酸盐有机废水的实验数据对BP神经网络进行训练,建立了ABR处理硫酸盐有机废水的BPNN模型,通过测试对比,找出了较优训练函数为traingda,较优训练次数为1 900.利用分割连接权值法(PCW)对影响出水SO42-和COD的主要因素进行分析,结果显示进水COD、SO42-、pH、COD/SO42-和HRT对出水SO42-和COD均产生一定影响,其中进水pH对出水SO42-和COD的影响最大,相对重要性(RI)指数分别为30.79％和23.44％;并通过样本试验数据分别建立了对SO42-和COD去除率的限制因子仿真模型,为预测硫酸盐有机废水的厌氧处理过程提供指导.     

CNTs/TiO2/CS光降解苯的动力学

综合光催化氧化苯的动力学过程、光辐射场模型和质量守恒定律,采用平板型反应器建立了碳纳米管/二氧化钛/壳聚糖(CNTs/TiO2/CS)催化薄膜光催化氧化气相苯的数学模型;该模型考虑了光强、相对湿度、初始浓度与气体流速对气相苯光降解的影响。结果表明,建立的数学模型与实验结果吻合较好。     

螯合树脂去除丙烯酸丁酯废水中的二价阳离子

采用氨基膦酸螯合树脂C-900去除丙烯酸丁酯废水中的二价阳离子,考察了吸附温度和废水流量对树脂动态吸附性能的影响,并用Thomas模型进行动态吸附数据的拟合分析。实验结果表明,在吸附温度为35℃、废水流量为15SV的条件下,处理后出水中3种二价阳离子总质量浓度为1.0mg/L时的穿透体积为240BV,达到穿透体积时树脂对Ca²⁺,Mg²⁺,Cu²⁺的去除率分别为100%,99.2%,99.8%。     

Kinetics study of fermentative hydrogen production from liquid swine manure supplemented with glucose under controlled pH

Kinetics of H₂ production from liquid swine manure supplemented with glucose by mixed anaerobic cultures was investigated using batch experiments under four different pH conditions (4.4, 5.0, 5.6, and uncontrolled). The temperature for the experiments was controlled at 37 ± 1°C and the length of experiments varied between 50 and 120 hours, depending upon the time needed for completion of each individual experiment. The modified Gompertz model was evaluated for its suitability for describing the H₂ production potential, H₂ production rate, and substrate consumption rate for all the experiments. The results showed that the Gompertz model could adequately fit the experimental results. The effect of pH was significant on all kinetic parameters for H₂ production including yield, production rate and lag time, and the substrate utilization rate. The optimal pH was found to be 5.0, at which a maximum H₂ production rate (0.64 L H₂/h) was obtained, and deviation from the optimal pH could result in substantial reductions in H₂ production rate (0.32 L H₂/h for pH 4.0 and 0.43 L H₂/h for pH 5.6). The results also showed that if pH was not controlled for the batch fermentation process, the substrate utilization efficiency could steeply decrease from 98.8% to 33.7%.     

QSPR prediction of chromatographic retention times of pesticides: Partition and fractal indices

The high‐performance liquid‐chromatographic retentions of red‐wine pesticide residues are modeled by structure–property relationships. The effect of different types of features is analyzed: geometric, lipophilic, etc. The properties are fractal dimensions, partition coefficient, etc., in linear and nonlinear correlation models. Biological plastic evolution is an evolutionary perspective conjugating the effect of acquired characters and relations that emerge among the principles of evolutionary indeterminacy, morphological determination and natural selection. It is applied to design the co‐ordination index that is used to characterize pesticide retentions. The parameters used to calculate the co‐ordination index are the molar formation enthalpy, molecular weight and surface area. The morphological and co‐ordination indices barely improve the correlations. The fractal dimension averaged for non?buried atoms, partition coefficient, etc. distinguishes the pesticide molecular structures. The structural and constituent classification is based on nonplanarity, and the number of cycles, and O, S, N and Cl atoms. Different behavior depends on the number of cycles.     

城市居民交通方式选择及其影响因素分析——以南京市为例

随着我国城市化水平的提高,城市交通能源消费占总能源消费的比重逐渐增大,交通方式选择及其影响因素研究引起广泛关注。本研究通过调查南京居民出行交通方式,并通过多项logit模型(multinomial logit model),探究影响居民交通选择的关键因素,为城市交通政策的制定提供科学依据,并根据估算结果分析不同政策下交通方式改变带来的节能减排效应。结果显示:出行特性(如出行距离)、出行者的个人特征(如性别、年龄、职业)与出行者的家庭特征(如是否有私家车,是否有小孩)都对交通方式选择有显著影响。如果通过有效的交通政策引导,使私家车出行转变为轨道交通出行,南京每天大约可减少1573.5吨碳排放。     

成都市餐厨垃圾产量分析预测及监管体系建设研究

整理汇总了成都市中心城区及郊县餐厨垃圾产生和收运现状,对其产量作出预测;在此基础上提出适合成都市自身情况的餐厨垃圾监管体系构建设想。     

安徽省省内人口流动空间选择研究

安徽省省内流动人口空间选择主要体现为省会优先、邻近区域优先和高工资区域优先的特征。省内形成以首府合肥为第一层次,以芜湖和淮南为第二层次,以蚌埠、淮北、安庆、马鞍山和铜陵为第三层次,其余城市为第四层次的空间选择格局。合肥是省内人口流入最大的辐合场,淮南、芜湖是次级辐合场,淮北、淮南、六安、巢湖等城市是对流场,流入人口规模与流出人口规模大体相当。