Evaluation of Water Quality in the Chillán River (Central Chile) Using Physicochemical Parameters and a Modified Water Quality Index

The Chillán River in Central Chile plays a fundamental role in local society, as a source of irrigation and drinking water, and as a sink for urban wastewater. In order to characterize the spatial and temporal variability of surface water quality in the watershed, a Water Quality Index (WQI) was calculated from nine physicochemical parameters, periodically measured at 18 sampling sites (January–November 2000). The results indicated a good water quality in the upper and middle parts of the watershed. Downstream of the City of Chillán, water quality conditions were critical during the dry season, mainly due to the effects of the urban wastewater discharge. On the basis of the results from a Principal Component Analysis (PCA), modifications were introduced into the original WQI to reduce the costs associated with its implementation. WQI_DIR2 and WQI_DIR, which are both based on a laboratory analysis (Chemical Oxygen Demand) and three (pH, temperature and conductivity), respectively, four field measurements (pH, temperature, conductivity and Dissolved Oxygen), adequately reproduce the most important spatial and temporal variations observed with the original index. They are proposed as useful tools for monitoring global water quality trends in this and other, similar agricultural watersheds in the Chilean Central Valley. Possibilities and limitations for the application of the used methodology to watersheds in other parts of the world are discussed.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

Environmental benchmarks vs. ecological benchmarks for assessment and monitoring in Canada: Is there a difference?

Environmental benchmarks are widely used in Canadian environmental assessment as a standard against which to monitor air or water quality in response to human activities in the environment. Recent work in Canada has developed the concept of ecological benchmarks as a complement to environmental benchmarks. However, implementation of ecological benchmarks may be challenging. This paper presents an analogy between ecological benchmarks and the more commonly used environmental benchmarks, as an attempt to increase understanding and use of ecological benchmarks in resource management, assessment, and monitoring. Ecological benchmarks, and their corresponding indicators, will be challenging to identify and use. However, through the use of the principles of adaptive management, effective ecological indicators and benchmarks can be established. Although it is essential that ecological benchmarks are site-specific, the analogy and general principles outlined here are applicable to assessment and monitoring in any part of the world.     

基于颗粒物浓度的沙尘天气分级标准研究

沙尘天气在近年对我国城市空气质量造成明显影响。目前我国沙尘天气分级仍然按照气象标准 ,主要是以水平能见度进行分级。文章参考国外的有关标准 ,通过统计近年来我国沙尘天气过程中的颗粒物浓度 ,结合我国沙尘天气的发生情况和特点 ,提出了基于沙尘浓度的沙尘天气分级标准     

固相萃取富集高效液相色谱法测定环境水样中的重金属元素

研究了用固相萃取富集高效液相色谱法测定环境水样中痕量重金属镍、铜、银、铅、镉和汞的方法。环境水样中的镍、铜、银、铅、镉和汞用四 -(对二甲氨基苯基 ) -卟啉 (T4 -DMAPP)柱前衍生 ,用C18固相萃取小柱萃取富集镍、铜、银、铅、镉和汞的T4 -DMAPP络合物 ,富集倍数为 1 0 0倍 ,然后用甲醇和四氢呋喃梯度洗脱为流动相 ,WatersXter raTMRP18( 3 9mm× 1 5 0mm)色谱柱为固定相分离 ,用二极管矩阵检测器检测。镍、铜、银、铅、镉和汞的检测限分别为3、2、4、3、1 5ng/L和 3ng/L。方法相对标准偏差为 1 8%— 3 2 % ,标准回收率为 92 %— 1 0 7%。该方法用于测定环境水样中的痕量重金属 ,结果令人满意     

Cu、Pb、Zn火焰原子吸收多谱线分析在环境监测中的应用

对铜的 3条谱线 (2 49.2 nm、2 61 .4nm,3 2 4.8nm ) ,铅的 2条谱线 (2 83 .3 nm、2 1 7.0 1 nm )以及锌的 2条谱线(3 0 7.6nm、2 1 3 .9nm ) ,共 7条谱线的灵敏度、检测限、线性范围进行了归纳性总结 ,并对多种共存元素可能存在的干扰情况进行了研究 ,认为利用元素不同分析谱线的分析灵敏度差异 ,根据被测元素在样品消解液中含量 ,选择合适的谱线进行分析 ,既降低工作强度 ,又能获得满意结果     

Prediction of Leachate Level in Kimpo Metropolitan Landfill Site by Total Water Balance

Kimpo metropolitan landfill has received various kinds of wastessince January 1992. The leachate level was measured to be 10.3 m in May 1995 and the level increased to 12.2 m in August 1996. Therefore, to prove the reason for the increasing leachate level, we calibrated hydraulic conductivity of each waste andintermediate layer using the HELP (Hydrologic Evaluation ofLandfill Performance) model. The leachate generation data measured from February 1993 to October 1995 was used in the model calibration. As a result of a model calibration, we obtained anaverage infiltration ratio and used this in analysis of the total water balance to predict elevation of leachate level. Main causes of the elevation of the leachate level were the high water content of the waste and the degradation of the leachate-drainage system caused by the subsidence of a naturalbarrier layer.     

Monitoring of Seasonal Vegetables for Pesticide Residues

Market samples (60) of six seasonal vegetables were monitoredduring 1996–1997 to determine the magnitude of pesticidalcontamination. The estimation of insecticide residuesrepresenting four major chemical groups i.e. organochlorine,organophosphorous, synthetic pyrethroid and carbamate, was doneby adopting a multiresidue analytical technique employingGC-ECD and GC-NPD systems with capillary columns. The testedsamples showed 100% contamination with low but measurableamounts of residues. Among the four chemical groups, theorganophosphates were dominant followed by organochlorines,synthetic pyrethroids and carbamates. About 23% of the samplesshowed contamination with organophosphorous compounds abovetheir respective MRL values. More extensive studies coveringdifferent regions of Haryana state are suggested to get a clearidea of the magnitude of vegetable contamination with pesticideresidues.     

evaluation of a measurement method for forest vegetation in a large-scale ecological survey

We evaluate a field method for determining species richness andcanopy cover of vascular plants for the Forest Health MonitoringProgram (FHM), an ecological survey of U.S. forests. Measurementsare taken within 12 1-m² quadrats on 1/15 ha plots in FHM.Species richness and cover are determined for four height classes(strata) within each quadrat and aggregated by stratum over the entireplot. We estimated (1) the agreement between experienced trainers andinexperienced technicians who collected the data on this survey(accuracy) and (2) the agreement among the technicians (precision) forresults on species richness and cover from 3 test plots at 3 timeintervals. The methods appear to be highly precise, although somediscrepancies with the values obtained by the trainers were found.Trainers found significantly more species in the ground stratum (0–0.6 m) and measured significantly more cover in the uppermost stratum(>4.9 m). The proportion of variation due to measurement error andtemporal variability was less than 13% for species richness (all strata)and cover (all but one stratum). This indicates that the method issuitable for monitoring changes in species richness and canopy coverfor a large-scale synoptic monitoring project such as FHM.     

用工业废水排放量预测地面水CODMn灰色方法研究

ＧＰＭ（１）灰色生长曲线常被用于等距时序环境系统的分析建模、非等距摆动空间序列方面的应用尚未报道。本文研究提出了将非等距摆动空间序列经过等距化处理的ＧＰＭ（１）线性回归优化建模方法采用该方法所建的非等距ＧＰＭ（１）模型用于工业废水量预测地面水ＣＯＤＭｎ的实例表明，该方法简捷，方便、精度高于回归分析，有较大实用价值。