Determination and discussion hydraulic retention time in membrane bioreactor system

Based on the microorganism kinetic model, the formula for computing hydraulic retention time in a membrane bioreactor system (MBR) is derived. With considering HRT as an evaluation index a combinational approach was used to discuss factors which have an effect on MBR. As a result, the influencing factors were listed in order from strength to weakness as: maximum specific removal rate K, saturation constant Ks, maintenance coefficient m, maximum specific growth rate ,ua and observed yield coefficient Yobs. Moreover, the formula was simplified, whose parameters were experimentally determined in petrochemical wastewater treatment. The simplified formula is θ= 1.1( 1/β -1)(Kｓ S)/KXo , for oetroehemical wastewater treatment K and Ko eaualed 0.185 and 154.2, resoectively.     

膜生物反应器在污水处理中的应用前景

介绍了膜及膜分离技术。膜生物反应器（MBR）的原理。综述了膜生物反应器在污染处理领域应用开发情况；指出了膜生物反应器在发展中存在的主要问题；展望了膜生物反应器技术的发展前景。     

生物反应器填埋场渗滤液及其处理对策

根据垃圾的降解和稳定机理分析了生物反应器填埋场渗滤液的动态变化规律，并对其处理对策进行了探讨。生物反应器填埋场前期产生的渗滤液可全部回灌，后期再根据实际情况排放处理部分过量的渗滤液。在对渗滤液水量和水质全面直观认识后，再对生物反应器填埋场渗滤液处理工艺进行针对性的选择和设计，并宜采用物化法处理方式。     

城市垃圾渗滤液场内循环处理的探讨

本文对城市垃圾渗滤液的产生量、水质特征及其影响因素进行了分析，介绍了当前国内外垃圾渗滤水场内循环处理的两大研究流派-以欧美国家为主的生物反应器填埋技术和以日本为主的循环式准好氧填埋技术。根据我国城市垃圾有机物含量高的特点，提出了适合我国国情的、将准好氧填埋技术与生物反应器填埋技术特点相结合的城市垃圾填埋场渗波液场内循环处理的设计思路。     

气浮--厌氧--生物接触氧化工艺处理屠宰废水

介绍了采用气浮-厌氧-生物接触氧化工艺处理屠宰废水的工程实例。当进水CODcr≤4500mg／L时，出水可达到国家《肉类加工工业污染物排放标准》(GB13457—1992)一级标准。     

Effect of Cross-Linking Waste Protein with Dialdehydes on Its Biodegradation Under Anaerobic Conditions

Most native polymers used in processing and application technologies are admittedly disposable from the environment in a biologic manner, but products possess low mechanical strength. One of the paths to increasing this attribute (if feasible) is their cross-linking, which may, however, affect their readiness to biodegradation. In the presented work this condition was observed on the example of waste protein (Hykol B) cross-linking by means of glutardialdehyde and glyoxal. Degree and course of cross-linking were determined through impedance spectroscopy. The objective of this work also was to obtain data for constructing a sensor capable of following the cross-linking course in real time, for potential industrial application of Hykol in continuous production. Impedance spectroscopy proved to be applicable even to this kind of material marked by considerable water content and exhibiting relatively high electric conductivity; so far it had been used only for materials of low conductivity. An aqueous environment inoculated with digested anaerobic sludge from a municipal wastewater treatment plant was selected for modeling anaerobic conditions. The relation was studied between cross-linking degree given by content of cross-linking agent (determined by impedance spectroscopy) and biodegradation degree under anaerobic conditions. It was confirmed that network density as given by quantity of added agent not only reduced breakdown degree but also slowed the course of the process. This fact is particularly obvious with cross-linking by means of glyoxal; network density is thus dependent on type of employed substance, which affect type and structure of created network. That not merely forms an obstacle during polymer swelling and dissolution but also prevents access of bacteria to source of metabolized organic carbon.     

厌氧-准好氧型填埋的渗滤液实验研究

通过室内模拟试验，在渗滤液回灌的厌氧填埋柱基本进入稳定状态后，改用准好氧运行方式。同时监测了渗滤液中有机物浓度以压温度、pH值的变化。改变模拟垃圾柱的运行方式两个月以后。氨氯浓度由2000mg／L迅速下降至101．48mg／L，试验结果显示，准好氧运行方式可以解决生物反应器填埋场进入稳定阶段后存在的氨氮浓度高的问题，加速填埋场的稳定。     

用好氧-厌氧反复耦合固定床生物反应器处理肌苷生产废水

利用由多孔微生物载体构建的好氧-厌氧反复耦合固定床生物反应器进行了高浓度肌苷生产废水处理中试研究。连续84d的运行结果表明，当进水COD为1500-2700mg／L、水力停留时间为22．1h时，出水COD可维持在150mg／L左右，COD去除率达90％～95％。装置运行稳定后，未经沉淀的出水中的固体悬浮物质量浓度小于50mg／L，表明该反应器可避免剩余污泥的产生。中试结果验证了该反应器处理高浓度肌苷废水的可行性和优势，同时为装置放大提供了理论依据。     

稠油污水生化性处理技术研究

为了探讨稠油污水能否使用生物法处理,以生活污水和农药厂生化池原菌种经过诱导驯化,分别培养了可以在稠油污水中生长的好氧菌种革兰氏阴性菌G-1和厌氧菌种革兰氏阴性菌G-2.以G-2和G-1对稠油污水进行顺序处理,可使其BOD5/CODCr达到0.26;采用SBR法对新疆稠油污水放大处理试验的结果：COD降至150 mg/L以下,各项指标达到GB8978-1998二级排放标准.     

ABR-生物接触氧化法处理果汁废水实验分析

厌氧式折流反应器(Anaerobic Baffled Reactor,简称ABR)是一种新型高效厌氧反应器,具有工艺技术简单、建设投资费用低、运行管理方便、固液分离效果好、出水水质好、运行稳定可靠、对有毒物质适应性强等优点,是一种极具开发应用前景的废水生物处理新技术。ABR最大的特点是在反应器中设置上下折流板而在水流方向上形成依次串联的隔室,从而使其中的微生物种群沿长度方向的不同隔室实现产酸和产甲烷相的分离。该反应器具有结构简单,截留污泥能力强,系统处理效果稳定,运行管理方便等优点。分析了ABR及ABR与其它工艺的联合在果汁废水处理方面的应用。