固体云爆剂热分解性能研究

目的研究固体云爆剂的热分解特性。方法利用差示扫描量热(DSC)和热重分析(TG)测定该固体云爆剂的热分解过程。分别得到固体云爆剂在不同温度下的DSC和TG曲线,以及同一温度下云爆剂不同组分的DSC和TG曲线。结合线性回归分析的方法,利用Ozawa法、Starink法以及Kissinger法计算了反应活化能。结果其表观活化能为208 k J/mol左右。结论该固体云爆剂的热分解是一个连续的过程,具有良好的安定性。     

活化温度对SCAC制备过程中副产物生成规律的影响

文章研究了污泥-玉米芯活性炭(SCAC)制备过程中,活化温度对副产物(热解气和热解油)生成规律的影响。热解气和热解油分别采用气相色谱仪和气质联用仪进行分析检测。试验结果表明,随着活化温度的升高,SCAC的产量逐渐降低,热解气与热解油的产量则随之增多。不同温度条件下,热解气的主要成分均为H2和CO2,热解气中H2所占的体积百分数随着活化温度的升高而增加,而CO2则相应降低。此外,热解气中CH4的含量也会随着活化温度的上升而略有提高,说明较高的活化温度更有利于热解气的资源利用。热解油组分较为复杂,每个温度条件下的液态产物都包括上百种化合物,可分为烷烃,烯烃,苯类,酚类,腈类,杂环化合物,多环芳烃,有机酸,酰胺,酯类,甾体,醇,酮以及其他类共14大类型,其中以有机酸、腈类和甾体类有机物含量居多。随着活化温度的升高,有机酸和多环芳烃的含量有所增加,而酚类化合物的含量则有所降低;当活化温度升高至650℃以上时,甾体类有机物含量明显降低。     

Kinetics of selective catalytic reduction of NO by NH3 on Fe-Mo/ZSM-5 catalyst

The catalyst of Fe-Mo/ZSM-5 has been found to be more active than Fe-ZSM-5 and Mo/ZSM-5 separately for selective catalytic reduction (SCR) of nitric oxide (NO) with NH3. The kinetics of the SCR reaction in the presence of O2 was studied in this work. The results show that the observed reaction orders were 0.74-0.99, 0.01-0.13, and 0 for NO, O2 and NH3, respectively, at 350-450℃. And the apparent activation energy of the SCR was 65 kJ/mol on the Fe-Mo/ZSM-5 catalyst. The SCR mechanism was also deduced. Adsorbed NO species can react directly with adsorbed ammonia species on the active sites to form N2 and H2O. Gaseous O2 might serve as a reoxidizing agent for the active sites that have undergone reduction in the SCR process. It is also important to note that a certain amount of NO was decomposed directly over the Fe-Mo/ZSM-5 catalyst in the absence of NH3.     

铅在棉秆基活性炭上的吸附动力学与热力学

以棉秆与棉秆纤维为原料,利用磷酸活化法制备了低成本的高比表面微孔棉秆基活性炭,通过静态实验研究了活性炭对水溶液中铅的吸附特性,测定了溶液pH值、吸附时间、溶液温度对吸附的影响,探讨了吸附动力学、热力学及吸附机制.根据低温液氮(N2/77K)吸附测定数据,以BET方程、BJH法及H-K法对活性炭孔结构进行了表征,以Boehm滴定、FTIR、零电荷点pHPZC测定及元素分析定量表征活性炭表面含氧官能团.结果表明,以棉秆和棉秆纤维为原料制备的活性炭的比表面积分别为1570和1731m2·g-1,含氧酸官能团含量分别为1.43和0.83mmol·g-1,均高于商业活性炭ST1300.静态吸附实验表明,棉秆基活性炭对铅有较大的吸附容量和吸附效率,最大吸附量超过120mg·g-1,溶液pH对吸附有较大的影响,吸附量随时间增大而增大,在5min内可达饱和吸附量的80%;吸附动力学数据符合假二级方程,Freundlich方程能更好地描述等温吸附行为;热力学研究表明,吸附吉布斯自由能(ΔG0)0,而焓变(ΔH0)0,说明吸附为吸热的自发反应过程,升温有利于吸附,离子交换可能在吸附过程中起了重要作用.     

Antimicrobial activity of thin metallic silver flakes, waste products of a manufacturing process

The aim of the research was to develop new products and processes from a manufacturing waste from an Italian metallurgic company. The company produced thin silver metallic films and the production scraps were silver flakes. The possibility to use the silver flakes in water disinfection processes was studied. The antimicrobial activity of the flakes was investigated in batch using Escherichia coli as Gram-negative microorganism model. The flakes did not show any antimicrobial activity, so they were activated with two different processes: thermal activation in reducing atmosphere and chemical activation, obtaining, respectively, reduced flakes (RF) and chemical flakes (CF). The flakes, activated with either treatment, showed antimicrobial activity against E. coli. The kill rate was dependent on the type of activated flakes. The chemical flakes were more efficient than reduced flakes. The kill rate determined for 1 g of CF, 1.0 ± 0.2 min⁻¹, was greater than the kill rate determined for 1 g of RF, 0.069 ± 0.004 min⁻¹. This was confirmed also by the minimum inhibitory concentration values. It was demonstrated that the antimicrobial capability was dependent on flakes amount and on the type of aqueous medium. Furthermore, the flakes maintained their properties also when used a second time. Finally, the antimicrobial activities of flakes were tested in an effluent of a wastewater treatment plant where a variety of heterotrophic bacteria were present.     

微波酸活化粉煤灰吸附酸性大红染料废水实验研究

以微波酸活化改性后的粉煤灰为吸附剂,对酸性大红染料废水进行吸附脱色处理,考察了吸附时间、pH值、吸附剂投加量等对吸附脱色效果的影响。在酸性大红染料溶液初始浓度为100 mg/L、pH=5、活化粉煤灰投加量为10 g/L吸附1 h时,活化粉煤灰对酸性大红的脱色效果较好,去除率可达96%。对实验数据进行相关数学模型拟合,结果表明微波酸活化改性后的粉煤灰吸附去除酸性大红的等温吸附平衡符合Langmuir吸附等温式,改性前后的吸附过程动力学符合准二级吸附动力学模型,线性相关系数良好。     

模拟烹饪油烟的粒径分布与扩散

烹饪油烟颗粒物粒径分布与扩散特性研究有助于解析其对室内空气质量和居民健康的影响,采用电子低压撞击器(ELPI)实时监测了油烟机开启和关闭状态下,模拟烹饪油烟发生处和3 m外位置处,0.03~10μm范围内油烟颗粒数浓度和质量浓度随粒径分布.油烟颗粒主要以655 nm以下的细颗粒为主.油烟机能够显著降低室内油烟浓度,开启油烟机后,油烟发生处颗粒数浓度从2.8×106个·cm-3降低到2.3×105个·cm-3,PM2.5(空气动力学直径≤2.5μm的颗粒)质量浓度从85.9 mg·m-3降低到6.2 mg·m-3.油烟机对PM10的净化效率高于PM2.5.油烟迅速从发生处扩散到3 m外,无通风状态下,总颗粒数浓度衰减达65%,PM2.5质量浓度衰减达75%.计算流体动力学(CFD)模拟了油烟机对油烟PM2.5质量浓度场扩散分布影响.红外摄像仪监测了油烟温度场分布扩散,以扇形向外扩散,伴随着油烟温度梯度降低.     

微生物燃料电池恒电流预培养阳极生物膜分析表征

阳极性能是影响微生物燃料电池(Microbial Fuel Cells,MFCs)性能的关键因素之一,同时阳极的接种挂膜过程是影响微生物燃料电池启动效率的关键因素.因此,本课题组提出了预培养阳极作为微生物燃料电池的一种新型阳极的概念,在三电极体系下,通过外加恒定电流预培养阳极,在不同条件下对阳极表面进行电化学选择和生物膜驯化以丰富生物膜结构和厚度.结果表明,阳极的性能与预培养电流大小密切相关,预培养阳极CF-4i(外加4 A·m-2电流密度)通过循环伏安法、塔菲尔曲线、电化学阻抗谱测试,性能好于其他测试组及对照组,装配阳极CF-4i的微生物燃料电池能实现最大功率密度968.20 m W·m-2,是对照组的2.53倍.同时,通过共聚焦显微镜观察发现,生物膜大体分两层,外层的活细胞及内层的死细胞,外层活细胞长在内层死细胞之上.这种结构分布表明,阳极生物膜中的活细胞部分绝大多数都分布于生物膜的外侧,而不是均布于整个阳极生物膜中;同时这也表明不是整个阳极生物膜都具有新陈代谢活性,但死亡的细胞可以继续积累在电极表面附近,活的外层膜负责电流的产生,而内层的死细胞作为一种导电基质.     

肥煤自燃全过程热动力学特征参数研究

实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。     

电气柜疲劳强度校核及结构优化

针对多孔闭孔型发泡硅橡胶D型空心密封条的超弹性特性,通过试验找出了密封条回弹力与压缩量之间的关系,提出了密封条满足IP X5的判别方程式,同时对方程式进行了试验验证,最后对密封条进行了阿累尼乌斯图寿命推算,为变流器柜门IP防护设计提供了重要参考。