CuO强化MFC活化过硫酸盐降解偶氮染料废水及同步产电研究

利用CuO强化微生物燃料电池(MFC)活化过硫酸盐(PDS),提高MFC对偶氮染料的降解率及同步产电性能.考察初始pH、CuO浓度、PDS浓度等因素对降解率及同步产电的影响.实验结果表明,最佳反应条件:初始pH为3.0,CuO浓度为0.6 mmol·L~(-1),PDS浓度为2 mmol·L~(-1)时,反应4 h后MO降解率达到99.3%.比未投加CuO时MO降解率提高12.8%;MFC最大输出功率密度从53.0 mW·m~(-2)增大到103.5 mW·m~(-2),输出功率密度提高1.95倍;对应的表观内阻从484.1Ω减小到318.6Ω,下降幅度达到34.1%.降解机理研究表明,MO降解过程中的主要活性物质为SO~-_4·和少量·OH.反应前后水样的紫外-可见光谱对比显示,MO降解过程中偶氮键率先断裂,然后生成含苯环类的中间产物,最终得到矿化.     

农地开发整理新增耕地价格评估

有序的农地流转市场需要有价格体系支持.以国家投资的一个重点农地整理项目为例,探讨了农地整理新增耕地价格的内涵、特点、价格评估的必要性、原则和估价方法的选择,并运用成本法评估了新增耕地的价格,旨在为目前我国全面开展的农地开发整理新增耕地入市价格评估提供实践依据.     

Institutional constraints to adaptive capacity: adaptability to climate change in the Norwegian electricity sector

This article contributes to the understanding of adaptive capacity within national sectors by utilising two perspectives from institutional theory. Resting on data from 21 interviews the paper analyses the Norwegian electricity sector and the influence on adaptive capacity to climate change from changes in formal structure and institutional culture. The sector underwent transformational change between the beginning of the 1980s and mid-2000s, with the reform from 1991 as a watershed, and gradual consolidation from about 2000. From a self-regulated vertically integrated sector with an emphasis on robustness of supply the sector changed into a liberalised and unbundled structure, with economic efficiency as the guiding principle. These changes reduced adaptive capacity to climate change. After 2000, gradually adaptive capacity has increased somewhat. The paper argues that also social contextual factors need to be taken account of, both to understand adaptive capacity to climate change and to provide practitioners with an ability to increase it.     

Fuel poverty and vulnerability in the EU low-carbon transition: the case of renewable electricity

The European Union (EU) and member states alike are following a tradition of addressing fuel poverty and vulnerability at the point of purchase by final consumers by seeking to influence the impact of income, energy price and the built environment on the ability of household consumers to access the energy that they need. By focusing on the conditions of energy transmission in the most rapidly growing renewable electricity sector in the UK – offshore wind – this paper aims to question whether the regulatory socio-technological framing of renewable electricity transmission is reproducing conditions for fuel poverty and vulnerability in the UK. By drawing a comparison with renewable electricity transmission in Bulgaria, this paper argues that the problem might be symptomatic of the EU as a whole. While not arguing against the proliferation of renewable electricity and its importance in meeting the 2020 targets, this paper calls for expanding the scope of fuel poverty alleviation policy throughout the whole renewable electricity supply chain, building on Helm's argument that energy companies at the middle of the supply chain are better suited to deliver fuel policy.     

GIS技术在土地资源估价中的应用分析

本文主要分析了GIS技术的功能、概念、发展及基于该技术的土地估价信息系统的组成、功能和优越性。为土地估价提供了强有力的技术支持和科学依据     

城市规划区农用地价格评估的实证研究--以江苏泰兴市为例

城市规划区农用地价格的评估既不同于城市建成区各类用地价格评估，也不同于基本农田保护区的农用地的价格评估，是农用地价格评估中的热点和难点，其区别于其他土地评估的特点主要表现在：一是城市规划区农用地价格是一种农用地转用价格，其实质是农用地所有权价格；二是城市规划区农用地用途将发生变更；三是城市规划区农用地存在着预期收益及其收益年限问题。在此基础上，以江苏泰兴市为例，对城市规划区农用地价格的评估思路进行了探讨，思路之一是运用投入产出法将城市规划区农用地的未来预期净收益还原为无限年期的所有权价格；思路之二是运用假设开发法求取“剩余之数、即为地价；思路之三是运用征购价格法从农用地价格构成角度探讨了规划区农用地的价格，并对三种估价思路及其估价结果进行了比较分析。     

电凝聚去除微污染源水中浊度的试验研究

用电凝聚对微污染水中浊度的去除效果进行试验，得到比较明显的处理效果；对电凝聚去除浊度的机理进行了探讨．在此基础上对实验数据进行了数学分析。     

Assessment of explosion risks caused by cone discharges when filling silos and containers with pellets

It is well known that during the filling of silos and containers with bulk material, so-called cone discharges can occur because of electrostatic charges. Whether or not cone discharges occur at all depends on whether the breakdown field strength of air under atmospheric conditions of 3 MV/m is reached at the silo and container inner wall. This in turn depends on the charge to mass ratio of the bulk, the bulk resistivity, the bulk density, the relative permittivity of the bulk material, the silo or container diameter and the filling rate. If cone discharges can't be avoided, the energy of cone discharges can be estimated according to the equation given in the relevant guidelines TRGS 727 (2016) and IEC/TS 60079-32-1 (2013). Therefore, the coarse fraction must be considered. As soon as the energy of the cone discharge is greater than or equal to the minimum ignition energy of the bulk material introduced, there is a risk of dust explosion. Here the fine fraction of the bulk material is relevant.The investigations described are a practical example how computer models can be used to assess the occurrence of cone discharges. It is calculated for which silo and container diameters and filling rates the critical field strength of 3 MV/m is reached. In these calculations the charge relaxation during pneumatic filling with bulk material is taken into account. The results of the computational modelling together with operational boundary conditions serve as a decision basis whether exclusion of incendive ignition sources is an adequate safety measure or whether further explosion protection measures must be considered. Finally, a brief overview of other possible explosion protection measures is given.     

Viability of solar photovoltaics as an electricity generation source for Jordan

Viability of solar photovoltaics as an electricity generation source for Jordan was assessed utilising a proposed 5 MW grid‐connected solar photovoltaic power plant. Long‐term (1994–2003) monthly average daily global solar radiation and sunshine duration data for 24 locations – distributed all over the country – were studied and analysed to assess the distribution of radiation and sunshine duration over Jordan, and formed an input to the RetScreen Software for evaluation and analysis of the proposed plant's electricity production and economic feasibility. It was found that depending on the geographical location, the global solar radiation on horizontal surface varied between 1.51 and 2.46 MWh/m²/year with an overall mean value of 2.01 MWh/m²/year for Jordan. The sunshine duration was found to vary, according to the location, between 8.47 and 9.68 hours/day, with a mean value of 9.07 hours/day and about 3311 sunshine hours annually for Jordan. The annual electricity production of the proposed plant varied depending on the location between 6.886 and 11.919 GWh/year, with a mean value of 9.46 GWh/year. The specific yield varied between 340.9 and 196.9 kWh/m², while the mean value was 270.59 kWh/m². Analysis of the annual electricity production of the plant, the specific yield, besides the economic indicators, i.e. internal rate of return, simple payback period, years to positive cash flow, net present value, annual life cycle saving, benefit/cost ratio, and cost of energy – for all sites – showed that Tafila and Karak are the most suitable sites for the solar photovoltaic power plant's development and Wadi Yabis is the worst. The results also showed that an average of 7414.9 tons of greenhouse gases can be avoided annually utilising the proposed plant for electricity generation at any part of Jordan.     

The private and social economics of bulk electricity storage

The ability to store excess intermittent renewable electricity is increasingly being seen as a key option for integrating large quantities of renewable capacity. However, intermittent energy sources currently account for very small amounts of total generation. Despite this fact, policymakers have begun implementing requirements that will dramatically increase the amount of bulk storage capacity. This paper examines the social benefits provided by bulk storage in the Texas electricity market, which has a large amount of renewable capacity relative to other states, but still quite limited renewable penetration. We focus on the impact of arbitraging electricity across time—a major service of bulk storage. Using current storage technologies, we demonstrate that electricity arbitrage will increase daily CO₂ emissions by an average of 0.19 tons for each MWh stored. In addition, daily SO₂ emissions will increase by an average of 1.89 pounds/MWh while NO_X emissions will fall by an average of 0.15 pounds/MWh.