对氯苯酚废水的电化学降解研究

实验利用电沉积法制备的不锈钢基PbO2电极,以对氯苯酚溶液为模型废水,通过静态实验研究外加电压、电解质浓度、曝气量及初始pH值对电化学氧化降解对氯苯酚效果的影响。结果表明,实验制备的PbO2电极具有较高的电催化活性,能够有效降解对氯苯酚;较低的操作电压有助于降低处理成本;随着电解质浓度和曝气量的增加,对氯苯酚去除率均呈...     

烟气NO氧化催化剂Cu-V/Ti-PILCs的制备及其硫水稳定性

采用等体积浸渍法制备了以钛交联粘土为载体,Cu与V氧化物为活性组分的烟气NO氧化催化剂(Cu-v/Ti-PILCs),并考察了各种制备条件下催化剂的活性及稳定性.结果显示,当V水/V丙酮 =1∶2,负载4%CuO和2%V2O5,并在500℃煅烧时制得的Cu-V/Ti-PILCs催化剂,在NO浓度为350 mg/m3,O...     

电化学工艺处理有机废水的研究进展

综述了目前国内外学者在二维电极和三维电极的开发和改进方面的研究成果,指出了电化学氧化技术和电极材料的主要研究方向和发展趋势.提出为解决电化学水处理技术中提高电催化效率和延长电极寿命的问题,当前研究的主要方向应集中在阳极材料、反应器结构和处理工艺方面.     

催化湿式氧化预处理造纸黑液

采用连续式固定床反应器,利用自制稀土类复合金属氧化物催化剂对草浆造纸黑液进行了催化湿式氧化(CWAO)预处理研究.通过正交实验确定了最佳工艺条件为:进水COD 40 800 mg/L,空速0.8h-1,反应温度260℃,反应压力6.5 MPa.在此最佳条件下进行实验,COD去除率达90％.经CWAO工艺处理后,草浆造纸...     

化工园区生化出水氯代烃污染物的臭氧氧化降解

以化工园区污水处理厂生化出水为背景水样,考察了臭氧氧化对2,4,6-三氯酚、氯苯、1,2-二氯苯、对硝基氯苯、四氯酞酸5种特征氯代烃污染物的降解效果,并对其降解动力学进行了分析。实验结果表明:臭氧对2,4,6-三氯酚和氯苯的降解效果最好,反应30 min时的去除率均接近100%,其次为1,2-二氯苯和对硝基氯苯,反应30 min时的去除率分别为95.7%和36.0%,最差为四氯酞酸,反应30 min时的去除率仅为8.9%;臭氧对2,4,6-三氯酚和对硝基氯苯的降解符合零级动力学方程,对氯苯和1,2-二氯苯的降解符合一级动力学方程,对四氯酞酸的降解符合二级动力学方程。     

PbO_2复合电极预处理甲苯二胺废水

通过涂覆—热分解法与电沉积法制备了β-PbO_2/α-PbO_2/SnO_2-Sb2O3/Ti复合电极(PbO_2复合电极),采用X射线衍射(XRD)、扫描电子显微镜(SEM)、循环伏安法(CV)、线性极化法(LSV)和加速寿命试验对电极进行表征。将PbO_2复合电极用于处理甲苯二胺(TDA)废水,考察了电解质浓度、电流密度对TDA降解效果的影响。实验结果表明:α-PbO_2呈梭状,β-PbO_2呈花菜状,多层结构的PbO_2电极利于提高电极的稳定性和活性;PbO_2复合电极的析氧电位(1.9 V)明显高于TDA的氧化电位(1.28 V),其使用寿命长达486 d;在电流密度为60 m A/cm2、Na2SO4质量浓度为10 g/L、电解时间为240 min的条件下,对COD为4 791.74 mg/L、TDA质量浓度为486.4mg/L的废水进行处理,TDA去除率高达97.3%,COD去除率可达88.1%。     

臭氧氧化法降解聚氯乙烯离心母液废水中3种有机物

以聚氯乙烯离心母液废水中含量较高的3种有机物(聚乙烯醇、异辛醇和α-甲基苯乙烯)作为目标物,考察臭氧氧化工艺对3种有机物的去除效果,同时考察反应时间、臭氧投加量和初始pH对处理效果的影响。实验结果表明,臭氧氧化处理3种废水的最佳反应时间和臭氧投加量分别为:聚乙烯醇25 min,136 mg/L;异辛醇60min,312 mg/L;α-甲基苯乙烯60 min,32 mg/L。在此条件下,3种有机物的去除率分别为98%、85%和95%。此外,碱性条件有助于臭氧氧化工艺对3种有机物的降解。产物分析结果表明,经臭氧氧化,聚乙烯醇断链后进一步反应生成了草酸单乙酯,异辛醇和α-甲基苯乙烯分别生成了和苯乙酮。     

The effect of alkyl chain length on the degradation of alkylimidazolium- and pyridinium-type ionic liquids in a Fenton-like system

Background, aim, and scope  Ionic liquids are regarded as essentially “green” chemicals because of their insignificant vapor pressure and, hence, are a good alternative to the emissions of toxic conventional volatile solvents. Not only because of their attractive industrial applications, but also due to their very high stability, ionic liquids could soon become persistent contaminants of technological wastewaters and, moreover, break through into natural waters following classical treatment systems. The removal of harmful organic pollutants has forced the development of new methodologies known as advanced oxidation processes (AOPs). Among them, the Fenton and Fenton-like reactions are usually modified by the use of a higher hydrogen peroxide concentration and through different catalysts. The aim of this study was to assess the effect of hydrogen peroxide concentration on degradation rates in a Fenton-like system of alkylimidazolium ionic liquids with alkyl chains of varying length and 3-methyl-N-butylpyridinium chloride. Materials and methods  The ionic liquids were oxidized in dilute aqueous solution in the presence of two different concentrations of hydrogen peroxide. All reactions were performed in the dark to prevent photoreduction of Fe(III). The concentrations of ionic liquids during the process were monitored with high-performance liquid chromatography. Preliminary degradation pathways were studied with the aid of ¹H NMR. Results  Degradation of ionic liquids in this system was quite effective. Increasing the H₂O₂ concentration from 100 to 400 mM improved ionic liquid degradation from 57–84% to 87–100% after 60 min reaction time. Resistance to degradation was weaker, the shorter the alkyl chain. Discussion  The compound omimCl was more resistant to oxidation then other compounds, which suggests that the oxidation rates of imidazolium ionic liquids by OH· are structure-dependent and are correlated with the n-alkyl chain length substituted at the N-1-position. The level of degradation was dependent on the type of head group. Replacing the imidazolium head group with pyridinium increased resistance to degradation. Nonetheless, lengthening the alkyl chain from four to eight carbons lowered the rate of ionic liquid degradation to a greater extent than changing the head group from imidazolium to pyridinium. 1H-NMR spectra show, in the first stage of degradation, that it is likely that radical attack is nonspecific, with any one of the carbon atoms in the ring and the n-alkyl chain being susceptible to attack. Conclusions  The proposed method has proven to be an efficient and reliable method for the degradation of imidazolium ionic liquids by a Fenton-like reagent deteriorated with lengthening n-alkyl substituents and by replacing the imidazolium head group with pyridinium. The enhanced resistance of 1-butyl-3-methylpyridinium chloride when the resistance of imidazolium ionic liquids decreases with increasing H₂O₂ concentration is probably indicative of a change in the degradation mechanism in a vigorous Fenton-like system. H-NMR spectra showed, in the first stage of degradation, that radical attack is nonspecific, with any one of the carbon atoms in the ring and the n-alkyl chain being susceptible to attack. Recommendations and perspectives  Since ionic liquids are now one of the most promising alternative chemicals of the future, the degradation and waste management studies should be integrated into a general development research of these chemicals. In the case of imidazolium and pyridinium ionic liquids that are known to be resistant to bio- or thermal degradation, studies in the field of AOPs should assist the future structural design as well as tailor the technological process of these chemicals     

催化湿式氧化法处理印染废水的研究

Cu-Fe和Cu-Ce/FSC是优化制备的均相和非均相催化剂,实验中将其应用于实际印染废水的CWAO法处理,考察催化剂的实用性能以及CWAO法对实际印染废水的处理效果。研究结果表明,CWAO法处理印染废水,出水COD、BOD₅均达到三级标准,色度和pH均达到一级标准,非均相的Cu溶出浓度达到三级标准;而处理出水BOD₅/COD由0.021（处理前）提高到0.423（均相）和0.307（非均相）,出水可生化性良好。     

微曝气Fenton氧化法处理模拟双酚A废水的效果及其生物验证

研究了微曝气Fenton氧化法关键工艺参数对模拟双酚A（BPA）废水处理效果的影响,并从活性污泥性质和污染物去除率两方面,采用膜生物反应器(membrane bioreactor, MBR)对微曝气Fenton氧化法的处理效果进行了实验验证,为实现BPA废水的生物处理奠定基础。结果表明,初始pH值、反应时间、H₂O₂/COD(质量浓度比)、H₂O₂/Fe²⁺ (摩尔浓度比)、反应温度及曝气量均对预处理效果有较大影响,在最佳条件下,COD去除率可达70%,BOD/COD值则由原废水的0.02提高到0.50以上。MBR处理上述出水的结果表明,经微曝气Fenton氧化处理BPA的废水,可较好地适应后续的生化处理。