用环己烷氧化副产物制备浮选剂

在固体酸催化剂作用下,用环己烷氧化制备环己酮的副产物——酸性油和轻质油进行酯化反应,制备了羧酸混合酯,酯化反应的最佳工艺条件：n（C4-C5醇）：n（有机羧酸）=1．2：1,催化剂质量分数为1．5％,反应温度为110-160℃,反应时间为5h。经应用评价结果表明,该羧酸混合酯是一种性能优异的选煤浮选剂。     

圆筒形电化学反应器中有机物电催化的传递特性研究

研究了圆筒形电化学反应器内有机物在电化学降解过程中的传递特性.假设废水以平推流方式通过圆筒形反应器,由电催化过程的质量守恒和法拉第定律导出浓度、电流强度随废水停留时间的变化规律.根据废水中有机物的电化学降解和有机物氧化分解的关系将浓度分布转换成COD分布,并考察了扩散对COD、电流强度分布的影响理论模型和实验数据表明,在传质控制条件下忽略与不忽略扩散的影响,COD、电流强度的分布遵循不同的指数关系.理论模型与实验数据的平均误差为8.6%;极限电流随电解质流量的变化而改变.     

无过氧化氢添加Fenton氧化法降解有机物的可行性研究

Fenton反应可以氧化分解有机物,在反应中的关键氧化剂羟基自由基(HO·)是通过亚铁离子与过氧化氢作用生成的,因此,传统的Fenton氧化必须由外部添加过氧化氢.研究了一种新的方法,即采用Nafion膜固定化亚铁离子,并通过光催化反应提供Fenton氧化所需的过氧化氢,使得Fenton反应在不添加过氧化氢的条件下也能够连续进行.结果表明,以甲酸为代表有机物,该方法可以在不添加过氧化氢的条件下起到分解甲酸的作用.而且,通过对负载亚铁离子Nafion膜的再生,可以使该方法的降解能力保持在稳定的范围.     

剩余污泥的电化学稳定实验研究

研究了电化学法对城市剩余污泥稳定化的影响。结果表明,以钛涂钌电极为阳极、不锈钢板为阴极,在极板间距为2cm,电压为20V,曝气量为3L/h的条件下,电解20min,其挥发性悬浮物质(VSS)去除效率可达39%,加酸调节pH值至4左右时,其电解效率则可达40%以上,同时,污泥病原体达到未检出水平。     

电解氧化处理难降解垃圾渗滤液研究

采用连续式电解槽对垃圾渗滤液进行电解催化处理,考察极板间距、电流密度、电导率[Cl-]浓度对电解效果的影响.结果表明,当添加的[Cl-]6000 mg/L,在电解60 min时,对初始COD小于3000 mg/L的中等浓度渗滤液有较好的处理效果,COD和NH3-N的去除率分别达88.9%和97.3%,能耗为2.75 kwh/m3.为中试和工业设计应用提供了参考.     

响应面法优化酸性玫瑰红B光催化氧化的影响参数

利用中心组合设计和响应面分析方法对影响UV/TiO2光催化降解酸性玫瑰红B的主要因素(初始pH值、K2S2O8浓度、TiO2浓度)进行分析.其中初始pH值、K2S2O8浓度和TiO2浓度的高、低水平分别为4-5.6,26-36mg·l-1和0.53-1.87mg·l-1,分析参数为脱色率的变化.通过使用Design-Expert 5软件可得到1个2次响应曲面模型,最佳的初始pH值、K2S2O8浓度和TiO2浓度分别为4.69,29.73mg·l-1和1.18 mg·l-1,脱色率达到最大(94.21%).     

Organic matter and concentrated nitrogen removal by shortcut nitrification and denitrification from mature municipal landfill leachate

An UASB＋Anoxic/Oxic （A/O） system was introduced to treat a mature landfill leachate with low carbon-to-nitrogen ratio and high ammonia concentration. To make the best use of the biodegradable COD in the leaehate, the denitrifieation of NOx^--N in the reeireulation effluent from the elarifier was carried out in the UASB. The results showed that most biodegradable organic matters were removed by the denitrifieation in the UASB. The NH4^＋-N loading rate （ALR） of A/O reactor and operational temperature was 0.28- 0.60 kg NH4^＋-N/（m^3-d） and 17-29℃ during experimental period, respectively. The short-cut nitrification with nitrite accumulation efficiency of 90%-99% was stabilized during the whole experiment. The NH4^＋-N removal efficiency varied between 90% and 100%. When ALR was less than 0.45 kg NH4^＋-N/（m^3.d）, the NH4^＋-N removal efficiency was more than 98%. With the influent NH4^＋-N of 1200-1800 mg/L, the effluent NH4^＋-N was less than 15 mg/L. The shortcut nitrification and denitrifieation can save 40% carbon source, with a highly efficient denitrifieation taking place in the UASB. When the ratio of the feed COD to feed NH4^＋-N was only 2-3, the total inorganic nitrogen （TIN） removal efficiency attained 67%-80%. Besides, the sludge samples from A/O reactor were analyzed using FISH. The FISH analysis revealed that ammonia oxidation bacteria （AOB） accounted for 4% of the total eubaeterial population, whereas nitrite oxidation bacteria （NOB） accounted only for 0.2% of the total eubaeterial population.     

Anaerobic ammonium oxidation by Nitrosomonas spp. and anammox bacteria in a sequencing batch reactor

A sequencing batch reactor (SBR) was inoculated with mixed nitrifying bacteria from an anoxic tank at the conventional activated sludge wastewater treatment plant in Nongkhaem, Bangkok, Thailand. This enriched nitrifying culture was maintained under anaerobic conditions using ammonium (NH(4)(+)) as an electron donor and nitrite (NO(2)(-)) as an electron acceptor. Autotrophic ammonium oxidizing bacteria survived under these conditions. The enrichment period for anammox culture was over 100 days. Both ammonium and nitrite conversion rates were proportional to the biomass of ammonium oxidizing bacteria; rates were 0.08 g N/gV SS/d and 0.05 g N/g VSS/d for ammonium and nitrite, respectively, in a culture maintained for 3 months at 42 mg N/L ammonium. The nitrogen transformation rate at a ratio of NH(4)(+)-N to NO(2)(-)-N of 1:1.38 was faster, and effluent nitrogen levels were lower, than at ratios of 1:0.671, 1:2.18, and 1:3.05. Fluorescent in situ hybridization (FISH) was used to identify specific autotrophic ammonium oxidizing bacteria (Nitrosomonas spp., Candidatus Brocadia anammoxidans, and Candidatus Kuenenia stuttgartiensis). The ammonium oxidizing culture maintained at 42 mg N/L ammonium was enriched for Nitrosomonas spp. (30%) over Candidati B. anammoxidans and K. stuttgartiensis (2.1%) while the culture maintained at 210 mg N/L ammonium was dominated by Candidati B. anammoxidans and K. stuttgartiensis (85.6%). The specific nitrogen removal rate of anammox bacteria (0.6 g N/g anammox VSS/d) was significantly higher than that of ammonium oxidizing bacteria (0.4 g N/g Nitrosomonas VSS/d). Anammox bacteria removed up to 979 mg N/L/d of total nitrogen (ammonium:nitrite concentrations, 397:582 mg N/L). These results suggest significant promise of this approach for application to wastewater with high nitrogen but low carbon content, such as that found in Bangkok.     

微曝气Fenton氧化法处理模拟双酚A废水的效果及其生物验证

研究了微曝气Fenton氧化法关键工艺参数对模拟双酚A（BPA）废水处理效果的影响,并从活性污泥性质和污染物去除率两方面,采用膜生物反应器(membrane bioreactor, MBR)对微曝气Fenton氧化法的处理效果进行了实验验证,为实现BPA废水的生物处理奠定基础。结果表明,初始pH值、反应时间、H₂O₂/COD(质量浓度比)、H₂O₂/Fe²⁺ (摩尔浓度比)、反应温度及曝气量均对预处理效果有较大影响,在最佳条件下,COD去除率可达70%,BOD/COD值则由原废水的0.02提高到0.50以上。MBR处理上述出水的结果表明,经微曝气Fenton氧化处理BPA的废水,可较好地适应后续的生化处理。     

对苯二甲酸生产废水回用实验研究

采用高级氧化工艺对对苯二甲酸生产废水进行处理,系统考察了氧化剂投加量、废水pH等对处理效果的影响,得出了最佳工艺条件。经过处理的PTA废水,水质达到了车间用水的要求。本方法具有处理效果好、操作简单和环境友好等优点。