Advanced treatment of wet-spun acrylic fiber manufacturing wastewater using three-dimensional electrochemical oxidation

A three-dimensional electrochemical oxidation(3D-EC) reactor with introduction of activated carbon(AC) as particle micro-electrodes was applied for the advanced treatment of secondary wastewater effluent of a wet-spun acrylic fiber manufacturing plant. Under the optimized conditions(current density of 500 A/m~2, circulation rate of 5 mL/min, AC dosage of 50 g, and chloride concentration of 1.0 g/L), the average removal efficiencies of chemical oxygen demand(COD_(cr)), NH3–N, total organic carbon(TOC), and ultraviolet absorption at 254 nm(UV_(254)) of the 3D-EC reactor were 64.5%, 60.8%, 46.4%, and 64.8%, respectively; while the corresponding effluent concentrations of COD_(cr), NH_3–N, TOC, and UV_(254) were 76.6, 20.1, and42.5 mg/L, and 0.08 Abs/cm, respectively. The effluent concentration of COD_(cr) was less than 100 mg/L, which showed that the treated wastewater satisfied the demand of the integrated wastewater discharge standard(GB 8978-1996). The 3D-EC process remarkably improved the treatment efficiencies with synergistic effects for COD_(cr), NH_3–N, TOC, and UV_(254) during the stable stage of 44.5%, 38.8%, 27.2%, and 10.9%, respectively, as compared with the sum of the efficiencies of a two-dimensional electrochemical oxidation(2D-EC) reactor and an AC adsorption process, which was ascribed to the numerous micro-electrodes of AC in the 3D-EC reactor. Gas chromatography mass spectrometry(GC–MS) analysis revealed that electrochemical treatment did not generate more toxic organics, and it was proved that the increase in acute biotoxicity was caused primarily by the production of free chlorine.     

三维电极处理腈纶聚合废水的条件优化研究

采用填充粒状活性炭的三维电极处理腈纶聚合废水,考察实验条件对污染物去除效果的影响以及废水处理前后可生化性的变化.阳极为Ti/SnO₂-Sb₂O₃网状极板,阴极为网状钛电极,分别考察了停留时间、 电解电压、 pH值、 曝气量对废水中污染物去除效果的影响.结果表明,电解电压和pH值对废水有机物的去除率影响较大,在最优实验条件：电解电压为15V,pH值为3,曝气量400 mL/min的条件下电解120 min,腈纶聚合废水的COD、 TOC和丙烯腈的去除率分别为32.59%、 22.17%和89.70%,并且经过电解处理,废水BOD₅/COD值从0.02上升至0.42,可生化性显著提高,为生物处理提供了条件.     

CO还原NO海泡石铜族金属催化剂的研究

以改性海泡石为载体,负载IB族金属(Cu,Ag,Au),制备CO还原NO的催化剂.用正交实验确定载体海泡石的改性条件.研究考察该催化剂在有氧条件下的催化还原性能,并用XRD、TGA、H2 TPR、BET等对该催化剂进行表征.研究发现,在有氧条件下,IB族金属(Cu,Ag,Au)催化剂中,Cu 海泡石对CO还原NO反应的催化活性最好;Cu负载量为5%、灼烧温度为400℃的催化剂表现出较高的活性;Cu 海泡石催化剂中加入Ce和Sm可以改善催化剂的性能.在实验条件基本相同的情况下,Cu 海泡石的催化活性好于Cu ZSM 5催化剂.     

微等离子弧放电催化水处理技术的研究

采用钛为阳极的微等离子弧放电技术,研究了在模拟废水处理中放电催化效应及其机理,发现该技术对甲基橙有好的放电催化处理效果.甲基橙的脱色程度与峰值电压、脉冲频率、占空比、阳极电极面积等有关.在0.3mol·L-1的H3PO4电解液中,在峰值电压为550V、脉冲频率200Hz,占空比1∶180、阳极电极面积50mm×50mm条件下,20min内600mL、20mg·L-1的甲基橙溶液脱色率达90%.实验结果表明,该放电催化体系具有协同效果好、能效高、反应器设计要求简单等特点,是一种有发展前景的水处理新技术.     

Pd/C气体扩散电极用于电生成H2O2降解苯酚的研究

采用自制的Pd/C气体扩散阴极和Ti/IrO2/RuO2阳极,在无隔膜电解槽中对苯酚模拟废水降解效果及机制进行了研究,采用电子自旋共振法(ESR)对电解体系中产生的羟自由基(·OH)进行了检测.结果表明,在Pd/C气体扩散体系中掺杂Pd催化剂可以促进H2 O2的生成(H2 O2的稳定浓度是7.5 mg/L),有利于·OH的产生.经电化学氧化处理120 min后,苯酚和COD的去除率分别达到97.2%和50%,表明在电催化氧化过程中苯酚被氧化生成了大量低分子量中间产物.废水的BOD5/COD值达到0.73是处理前的9.1倍,苯酚废水的可生化降解性通过电化学氧化处理后显著提高.在该电化学体系中苯酚的降解是在阳极直接、间接氧化及阴极产生的H2 O2、·OH的氧化共同作用下完成的.通过对紫外扫描光谱图的分析推断出苯酚在电解过程中有醌类物质生成;由GC-MS检测到了邻苯二酚、对苯二酚、苯醌等芳香族化合物和己二酸、顺丁烯二酸、反丁烯二酸、丁二酸、丙二酸、乙二酸等短链羧酸,据此提出了苯酚降解的可能历程.     

铜合金实验室试验与实海挂片结果的比较与分析

目的比较实验室试验结果与实海挂片结果对B10和H62两种铜合金腐蚀性能评价的异同之处。方法采用线性极化、电化学阻抗、显微形貌观察等,比较两种铜合金在实验室模拟海水中的的腐蚀速率、点蚀倾向,结合反应机理、腐蚀形貌、环境等外部因素,分析导致实验室与实海环境下出现差异的原因。结果除榆林海域外,实海挂片与实验室结果都表明,B10试样的平均腐蚀速率小于H62。B10和H62两种铜合金随温度升高腐蚀速率增大,在实验室和实海情况下表现出一致性,且平均腐蚀速率都随浸泡时间的延长而降低。结论在实海环境中,温度不是影响点蚀的主要因素,微生物等其他环境因素会对点蚀产生较大影响。     

Electrochemical degradation of Acid Red I dye and its treatment by UV light

Degradation of Acid Red I (ARI) dye by electrochemical treatment and UV light irradiation was studied in this work. The effect of the current density and the concentration of NaCl and dye on the decoloration and degradation efficiency were studied and optimized. The UV irradiation was monitored by UV-Vis spectrophotometry and chemical oxygen demand. The kinetic constants for decoloration and degradation were calculated. Degradation of 86% was achieved in 160?min and the first-order kinetic constant was 0.013?min^?1. Degradation products were identified by gas chromatography/mass spectrometry. The mechanism for the degradation of ARI was proposed.     

基于T-Hg2+-T结构的Hg2+生物传感器研究进展

Hg²⁺不仅污染环境,还会引发多种疾病,危害人体健康.因此,实现对Hg²⁺的快速灵敏检测十分必要.传统的Hg²⁺检测方法存在一定的局限性,而基于T-Hg²⁺-T结构的汞离子生物传感器具有高特异性、高稳定性的优势,近些年得到广泛研究和应用.本文简要介绍了T-Hg²⁺-T结构的概念和特点,并从荧光型、比色型和电化学型3个方面综述了基于T-Hg²⁺-T结构的汞离子生物传感器的研究进展,对未来的发展前景进行了展望.     

萃取-催化氧化光度法测定生物体中H2O2含量研究

提出萃取-催化氧化光度法测定生物体中H2O2含量的新方法.用稀土催化H2O2产生羟基自由基以氧化二苯基碳酰二肼,生成红色二苯基碳酰腙,其最大吸收波长为563.0nm;当二苯基碳酰二肼浓度一定时,△A563与H2O2含量呈量效关系.在0～30μmol/L H2O2 含量范围内,该法能简单、快速、精确地测定生物样品中H2O2实际含量.     

水中重金属在线监测技术发展概述

近年来重金属污染事件层出不穷,重金属污染的监测已经成为国家和人民关注的重点问题。介绍了水中重金属在线监测仪器的主要应用技术,并指出技术的适用范围和优劣点,同时对水质重金属在线监测仪的发展前景提出几点意见。