厌氧折流板反应器在制药废水处理中的研究

将厌氧折流板反应器控制在酸化水解阶段处理高浓度乙酰螺旋酶素制药废水,经过长时间的运行表明：该反应器结构简单,启动时间短,有效地提高了废水中挥发酸的浓度,缩小了pH值的变化范围,稳定了水质,改善了废水的可生化性．确保了甲烷发酵阶段的长期稳定运行。     

Biological removal of selenate in saline wastewater by activated sludge under alternating anoxic/oxic conditions

Removal of selenate in saline wastewater by activated sludge was examined. Sequencing batch reactor was operated under alternating anoxic/oxic conditions. Above 97% removal of soluble selenium (Se) was achieved continuously. Major Se removal mechanism varied depending on the length of aeration period. Various Se-reducing bacteria likely contributed to coordinately to Se removal. Selenium (Se)-containing industrial wastewater is often coupled with notable salinity. However, limited studies have examined biological treatment of Se-containing wastewater under high salinity conditions. In this study, a sequencing batch reactor (SBR) inoculated with activated sludge was applied to treat selenate in synthetic saline wastewater (3% w/v NaCl) supplemented with lactate as the carbon source. Start-up of the SBR was performed with addition of 1–5 mM of selenate under oxygen-limiting conditions, which succeeded in removing more than 99% of the soluble Se. Then, the treatment of 1 mM Se with cycle duration of 3 days was carried out under alternating anoxic/oxic conditions by adding aeration period after oxygen-limiting period. Although the SBR maintained soluble Se removal of above 97%, considerable amount of solid Se remained in the effluent as suspended solids and total Se removal fluctuated between about 40 and 80%. Surprisingly, the mass balance calculation found a considerable decrease of Se accumulated in the SBR when the aeration period was prolonged to 7 h, indicating very efficient Se biovolatilization. Furthermore, microbial community analysis suggested that various Se-reducing bacteria coordinately contributed to the removal of Se in the SBR and main contributors varied depending on the operational conditions. This study will offer implications for practical biological treatment of selenium in saline wastewater.     

活性碳纤维电极-生物膜反应器对废水的强化脱氮性能

利用自制的活性碳纤维电极-生物膜反应器对低碳氮比(碳元素与氮元素的质量比)废水进行了脱氮实验.实验结果表明:当进水COD和碳氮比较低时,碳氮比和电流密度均对反应器的脱氮性能有很大影响;当碳氮比小于3.0时,出水的ρ(NO3--N)随进水碳氮比的增大而减小;当进水COD为70 mg/L,ρ( NO3--N)为35 mg/L、碳氮比为2.0、电流密度为0.025 mA/cm2、反应时间为8h时,出水的ρ(NO3--N)达到最低值11.2 mg/L,NO3--N去除率为68.0％.在适宜的碳氮比条件下,电极-生物膜反应器具有显著的强化脱氮作用,其对NO3--N的去除率与单纯生物膜反应器相比可提高6.0～15.0个百分点.保持碳氮比不变,提高进水COD会导致所需电流密度的提高和脱氮能力的下降.     

接触氧化污水处理技术的研究现状与展望

本文简述了污水处理中生物接触氧化技术的工艺特点及其发展历史，综述了国内外研究及应用现状，为进一步开展该技术的研究和新工艺的开发提供参考。接触氧化技术将是未来我国水处理的主要发展方向之一，文中展望了该技术的一些发展方向。     

Biological mine drainage treatment

Drainage from sulphur mines contains a high concentration of ferrous iron and it is strongly acidic. The mechanism of acid mine drainage formation was briefly explained. As a case study, successful measures taken at the abandoned Matsuo mine, Iwate Prefecture, Japan, for preventing the pollution in receiving rivers was presented in this paper. The measures consisted of the construction works against pollution sources and the construction of a drainage treatment plant in which Thiobacillus ferrooxidans oxidizes ferrous iron under a low pH condition, and produced ferric iron is removed by sedimentation. Then, a laboratory-scale fluidized bed reactor using anion exchange resin as attaching material for the bacteria was examined in order to improve the efficiency of biological oxidation of ferrous iron. More than 90% of oxidation had been maintained for 2 months at 1 h of HRT, which suggests that the size of the oxidation tank could be reduced.     

AEB反应器反硝化处理高浓度硝酸盐废水

采用缺氧膨胀床(AEB)反应器处理高浓度硝酸盐废水,研究了反应器的快速启动和挂膜特性,以及在反硝化连续流运行条件下对废水的处理效果。实验结果表明:采用自然挂膜方式,填料层从下至上生物膜厚度逐渐增加;AEB的快速启动8 d可完成,COD去除率由44.9%升至92.3%,NO_3~--N去除率由39.8%升至98.4%;稳定运行阶段(进水COD 4 628～5 548 mg/L、ρ(NO_3~--N) 1 339～1 505 mg/L),COD去除率稳定在95%左右,NO_3~--N去除率稳定在98%～99%,COD和NO_3~--N的容积负荷去除量最高可达27.8 kg/(m~3·d)和7.3 kg/(m~3·d)。     

浅析热冲击对自增强反应器的影响

自增强反应器在服役期间，其残余应力会因开停车循环载荷作用，温度、压力的波动及管内介质发生超温分解反应引起的热冲击等因素的作用而衰减，为了比较系统地探讨热冲击引起的自增强残余应力衰减机理和管材损伤机理，本从研究管式反应器受热冲击作用时的应力响应出发，建立相应数学模型，得到了应力随时间变化曲线，应力随半径变化曲线，通过分析得出了热冲击发生时产生的动态应力和异常高温是引起残余应力松弛和材质发生相变和老化的主要原因。     

生物膜反应器脱氮性能及其硝化细菌的研究

采用模拟含氮废水对自行设计制作的A/O生物膜反应器进行脱氮性能研究。研究结果表明：在水温为20～23℃、水力停留时间为18h、进水总氮质量浓度为61～78m g/L、曝气量为25L/min、进水COD分别为110～165m g/L和205～272m g/L的条件下,废水的COD去除率均在90%以上,硝化率分别为98%和95%,总氮去除率分别为50%和78%。采用荧光原位杂交技术对反应器各区域中的硝化细菌进行了检测。结果表明,反应器中的硝化菌主要为亚硝化螺菌属和硝化螺菌属,有少量亚硝化单胞菌属和硝化杆菌属存在。亚硝化菌和硝化菌在好氧区数量相对较多,在缺氧区数量相对较少。     

常温厌氧流化床处理高浓度有机废水实验研究

本文对常温(25℃±3℃)条件下低密度载体厌氧流化床(AFB)反应器处理高浓度有机废水进行了研究。实验结果表明:采用好氧预挂膜快速排泥法可加快反应器的启动,低密度载体可有效降低反应器运行能耗,有机物去除效果良好。     

嵩屿电厂烟气SCR脱硝工艺及特点分析

介绍了厦门嵩屿电厂4×300MW燃煤机组烟气选择性催化还原法(SCR)脱硝工程所选用的工艺,分析了SCR脱硝系统的主要技术特点,为日益增多的同类型脱硝装置的工艺设计与设备选型提供一定的借鉴。