植物体超氧阴离子自由基不同检测方法的比较

应用顺磁共振波谱仪(EPR)自旋捕获法、羟胺氧化法、二氢乙锭(DHE)荧光探针和硝基四氮唑蓝(NBT)原位显色法,分别检测了暴露于梯度镉(Cd)溶液2 d后的水稻幼苗根叶组织超氧阴离子自由基(O.-2)的变化水平.结果表明,0—60 mg.L-1Cd诱导了O2.-随着Cd剂量的增加而升高,高于此剂量范围则呈现下降趋势.4种方法的检测结果基本一致,但前两种方法更适用于定量O2.-的生成水平,而后两种显色方法仅能反映O2.-的变化趋势,难以精确定量.因此,可以选择性地应用4种方法揭示暴露于污染物的植物组织O2.-的响应水平.     

Submerged arc plasma system combined with ozone oxidation for the treatment of wastewater containing non-degradable organic compounds

• Submerged arc plasma was introduced in terms of wastewater treatment. • Ozone oxidation was coupled with submerged arc plasma system. • Ozone was converted into O and O₂ by submerged arc plasma. • Decomposition rate was accelerated by submerged arc plasma. • Introduction of ozone led to significant increase in mineralization. Submerged arc plasma technology was assessed for the removal of phenols from wastewater. The OH radicals generated from the boundary between the plasma and waste solution were considered as a significant factor on the degradation reaction. In this study, the effects of highly energetic electrons released from the submerged arc plasma were mainly studied. The highly energetic electrons directly broke the strong chemical bond and locally increased the reaction temperatures in solution. The effects of the submerged-arc plasma on the decomposition of phenol are discussed in terms of the input energy and initial concentration. The single use of submerged arc plasma easily decomposed the phenol but did not increase the mineralization efficiency. Therefore, the submerged arc plasma, coupled with the ozone injection, was investigated. The submerged arc plasma combined with ozone injection had a synergic effect, which led to significant improvements in mineralization with only a small increase in input energy. The decomposition mechanism of phenol by the submerged arc plasma with the ozone was analyzed.     

武汉城市污水中微塑料的分离、鉴定及其微观特征分析

为研究武汉城市污水中微塑料的分布特点及其表面形貌特征,采用以连续浮选分离装置为基础进行改进设计的微塑料提取装置对污水中微塑料进行分离,通过用65%硝酸和30%过氧化氢混合液（体积比为1:3）对污水样品进行消解,并采用筛网（300、600、1 000目）（100目=0.147 mm）和滤膜（1 μm玻璃纤维滤膜和20 nm氧化铝滤膜）分离技术建立起对水体微塑料和纳米塑料的分离富集方法.通过傅里叶变换红外光谱（FTIR）、扫描电镜-X射能谱分析联用（SEM-EDS）等方法对所提取微塑料颗粒的组成成分、赋存特征、表面形貌特征进行分析.结果表明:①提取装置的平均回收率在92%以上.②污水中微塑料类型主要为碎片类、泡沫类、薄膜类和纤维类.③FTIR结果证实,该方法所提取的微塑料颗粒中有聚乙烯、聚丙烯等成分,且发现了羰基、聚酯类物质存在,说明提取到的微塑料中可能有可降解塑料颗粒.④SEM-EDS结果显示,各类微塑料表面粗糙、撕裂程度不同,存在不同程度的风化痕迹,并在其表面发现Si、Cu、O、Al、Na、Ca、Ba等元素的富集.研究显示:改进的微塑料分离方法能够实现对污水中微塑料的高效提取;同时,明确了武汉城市污水微塑料的表面形貌特征及赋存特征,为未来武汉城市污水中微塑料污染的针对性治理提供理论依据.      

Characterisation and Nanomechanical Properties of Ink-Jet Media Using Atomic Force Microscopy

Commercial inkjet media is increasingly used in daily life; this use ranges from offices to digital photography. The impact that the development of this technology has had on the paper industry has been phenomenal. However, an increasing amount of paper is discarded and it is often after the introduction of complex chemical ink within its substrate. The understanding of the interactions between the layer of coated media and ink can be used to further understand and develop technology for the use of recycling office and photo papers. This paper presents the innovative concept in characterizing the surface of the inkjet media by atomic force microscopy (AFM) and scanning electron microscopy (SEM). Comparisons are made between the data obtained from both atomic force microscopy and scanning electron microscopy of the receptive layer and surface analysis software that was used to obtain surface characteristics. In this study the hardness and force of interaction has also been examined by the means of nanoindentation measurements using silicon nitride cantilever tips and forces of interaction between a selection of colloid probes and the receptive layer of the inkjet media. The effect of loading force on indentation was studied in terms of approach of impact and type of media tested.     

新疆环境保护网站建设的现状与发展探讨

1997年建成的＂新疆环境保护＂网站是全国第一家环保门户网站,也是新疆第一家政府类网站,新疆环保网站建设与发展已经历风雨兼程的10a,现在正进入一个崭新的发展阶段.回顾、总结和展望新疆各级环保网站的发展,吸取发展中的经验与教训,探索新疆各级环保网站建设中的规律,对新疆环保电子政务的＂理性建设、快速推进＂大有裨益.     

苯胺水溶液的电子束辐照降解

以苯胺类化合物中的苯胺为具体对象,进行了苯胺水溶液受到电子束辐照后的降解过程和特性研究,分别考察了吸收剂量、溶液初始浓度、溶液初始pH和过氧化氢加入量等因素对苯胺辐照降解效果的影响.实验结果表明,电子束辐照可以有效降解水溶液中的苯胺,当苯胺初始浓度为70 mg·L-1,吸收剂量为23.7 kGy时,苯胺降解率可达91%,COD去除率可达27%.过氧化氢的加入能够明显地提高苯胺的降解效果,COD去除率最高可达98%.溶液初始pH在2.0～11.0范围内,pH对苯胺的辐射降解影响较小.     

数字图像技术结合小岛法在煤分形特征中的应用

为探究煤的孔裂隙结构分形特征,以贵州富煤区4个煤层的煤样为研究对象,基于扫描电镜和低温液氮实验综合表征煤样的孔裂隙发育程度及连通性,应用Photoshop,Image-Pro-Plus图像处理技术对煤的SEM图像进行二值化处理及主要参数提取;结合小岛法计算煤样的孔裂隙分形维数值,并与扫描电镜、低温液氮实验分析结果进行对...     

两株产电菌电子介体介导的胞外电子传递机理研究

构建了Klebsiella oxytoca d7和Shewanella sp.F1 2种纯菌燃料电池，探究了产电菌在产电过程中电子介体传递电子机制.结果表明：K.oxytoca d7只有作产电呼吸时，才会产生电子介体，而Shewanella. sp.F1在好氧呼吸、厌氧呼吸、产电呼吸下均能产生介电体，说明电子介体的产生与产电菌种类有关.两种菌介电体氧化还原电位相当（-250，210mV），且介于呼吸链NADH和辅酶Q之间.其介电体在胞内呼吸链上截获的电子均源于NADH，说明电子“逸出”位点只取决于介电体本身.K.oxytoca d7在碳源充足和不足时，电子介体产电量分别占总电量的60%和41%；Shewanella. sp.F1分别是57%和50%，说明在碳源充足时，2种菌的产电呼吸都以电子介体机制为主.介电体传递电子过程直接影响了阳极底物的转化和燃料电池的产电性能.     

投加颗粒活性炭和二氧化锰对剩余污泥厌氧消化的影响

厌氧系统添加碳和金属纳米材料是强化厌氧消化的有效策略.为考察投加GAC和MnO₂对剩余污泥厌氧消化过程的影响,设置了空白组(R0)、GAC组(R1)、MnO₂组(R2)以及GAC/MnO₂组(R3)4组间歇实验,研究GAC和MnO₂的投加对剩余污泥厌氧消化效率、微生物活性和微生物群落结构的影响.结果表明,反应器运行28 d后,与R0相比,R1和R3的产CH₄速率分别提高了68.18%和51.35%,R2的产CH₄量降低了21.25%.GAC和MnO₂的单独或者混合投加,对厌氧发酵过程均有促进作用.Mn²⁺与剩余污泥释放的磷酸盐生成磷酸盐沉淀对厌氧代谢通道的阻塞作用,造成R2产CH₄效率变低.GAC优良导电性、吸附能力和MnO₂/Mn²⁺的催化作用是R3产CH₄效率增强的主要原因.正常代谢条件下,投加GAC、MnO_2<...     

氧化还原介体调控亚硝酸盐反硝化特性研究

采用实验室驯化的亚硝酸盐反硝化菌群作为菌种,优化亚硝酸盐降解条件,探究在氧化还原介体蒽醌-2-磺酸钠(AQS)存在条件下亚硝酸盐反硝化的特性.结果表明,反硝化菌群降解亚硝酸盐的最适条件为:温度35℃,pH为8,丁二酸钠为碳源,碳氮比4∶1,初始亚硝酸盐浓度100 mg.L-1;AQS的最佳投加量为0.16 mmol.L-1,介体调控的反硝化体系氧化还原电位略有降低,维持在-400～-500 mV之间,pH随亚硝酸盐降解速率增加而增大,最终稳定到9～10之间;通过分析反硝化中间代谢产物,推测AQS在亚硝酸盐反硝化过程中不仅起到辅酶CoQ的作用而且加速了细胞色素传递电子的全过程.本研究可为氧化还原介体调控亚硝酸盐反硝化实际应用提供理论基础和优化参数.