全文获取类型
收费全文 | 2395篇 |
免费 | 170篇 |
国内免费 | 243篇 |
专业分类
安全科学 | 303篇 |
废物处理 | 81篇 |
环保管理 | 629篇 |
综合类 | 996篇 |
基础理论 | 225篇 |
环境理论 | 19篇 |
污染及防治 | 100篇 |
评价与监测 | 27篇 |
社会与环境 | 378篇 |
灾害及防治 | 50篇 |
出版年
2024年 | 6篇 |
2023年 | 38篇 |
2022年 | 49篇 |
2021年 | 59篇 |
2020年 | 98篇 |
2019年 | 89篇 |
2018年 | 89篇 |
2017年 | 153篇 |
2016年 | 170篇 |
2015年 | 129篇 |
2014年 | 100篇 |
2013年 | 265篇 |
2012年 | 195篇 |
2011年 | 253篇 |
2010年 | 169篇 |
2009年 | 130篇 |
2008年 | 92篇 |
2007年 | 124篇 |
2006年 | 94篇 |
2005年 | 70篇 |
2004年 | 57篇 |
2003年 | 58篇 |
2002年 | 41篇 |
2001年 | 46篇 |
2000年 | 41篇 |
1999年 | 39篇 |
1998年 | 18篇 |
1997年 | 17篇 |
1996年 | 16篇 |
1995年 | 10篇 |
1994年 | 20篇 |
1993年 | 7篇 |
1992年 | 8篇 |
1991年 | 7篇 |
1990年 | 7篇 |
1989年 | 2篇 |
1985年 | 2篇 |
1984年 | 4篇 |
1982年 | 3篇 |
1981年 | 3篇 |
1980年 | 4篇 |
1979年 | 8篇 |
1978年 | 5篇 |
1977年 | 3篇 |
1976年 | 2篇 |
1975年 | 1篇 |
1974年 | 1篇 |
1973年 | 1篇 |
1971年 | 1篇 |
1969年 | 1篇 |
排序方式: 共有2808条查询结果,搜索用时 31 毫秒
111.
为研究燃料氢气泄漏、爆炸的特性和规律,预防高压储氢系统中氢气泄漏爆炸事故发生,以加氢站为背景,数值仿真45 MPa高压储罐氢气泄漏并引发爆炸事故,分析泄漏爆炸动力学性质以及爆炸波在非均匀氢气浓度中的传播机制。同时,基于泄漏爆炸事故演化的力学机理,开展氢气泄漏爆炸动态风险分析,针对氢气不同泄漏量,建立泄漏扩散形成的气云体积、气云爆炸产生的冲击波与空间x,z方向上危害距离之间关系。研究结果表明:氢气泄漏过程中,气云氢气浓度变化与流场雷诺数具有较好一致性;氢气扩散受到高压储氢罐周围装置影响,流场中氢气浓度分布不均匀;当发生燃烧爆炸事故时,冲击波参数和湍动能变化梯度大;得到复杂布局区域冲击波超压峰值与比例距离之间关系式,其相比于理论方法更精细、计算结果更准确。研究结果可为降低高压储氢系统泄漏爆炸事故后果、采取有效防护措施提供一定依据。 相似文献
112.
为提高长大隧道施工及运营通风过程中竖井通风效率,实现隧道节能通风。依托实际隧道工程,基于Fluent软件,选用RNG k-ε湍流模型,对无竖井风塔、圆柱风塔、矩形风塔和凸台状风塔4种结构、不同环境风速工况下的流场进行数值模拟,并对模拟结果进行交叉比对分析,提出最优化的竖井风塔结构形式。研究结果表明:采用风塔结构竖井出流量要远大于无风塔结构竖井出流量;对于不同竖井风塔外型结构,竖井出流量与环境风速关系呈多项式函数;当倾斜角为45°、圆心角为90°时,凸台结构对应竖井出流量最大,且受环境风影响波动较小,通风稳定性较好。建议竖井出口结构选用矩形或凸台状,实现对环境风的高效利用,提高竖井通风效率。 相似文献
113.
为响应国家节能减排和循环经济的理念,本文提出一种新的园区污水处理方式-以污治污:利用企业A废水中的碱性物质与消耗企业B废水中的氢离子,再向废水中投加石灰石去除多余的氢离子,投加液碱去除废水中的铜离子和锌离子。优化后的废水处理方式可减少盐酸、石灰石的使用量,从源头上减少了资源的浪费和排入外环境的污染物,对社会发展和生态环境均具有明显的正效益。 相似文献
114.
115.
Melike E. Bildirici 《Natural resources forum》2020,44(4):289-310
In this paper, the life span of hydro and nuclear energy generations and the relationship between hydro and nuclear energy generations, environmental pollution, and economic growth were investigated for Japan covering the period of 1960–2018 by employing the Bathtub-Weibull curve and Markov switching-vector error correcting (MSVEC) method, respectively. According to the Bathtub-Weibull curve analysis, a rising failure rate for nuclear energy was found, indicating that the life of nuclear energy has expired, but a decreasing failure rate for hydroelectric energy has been detected. Then two different MSVEC models were used. The MSVEC method, unlike traditional approaches, determines the relationship between variables under different regimes. The results of MSVEC methods indicate three important points. First, regime-dependent asymmetry and regime changes are crucial for policy recommendations. Second, the shocks to hydropower and nuclear energy generations cause temporary deviations from the long-run growth path in both regimes. Lastly, the increase in hydropower generation leads to a decrease in environmental pollution and an increase in GDP, and an increase in nuclear power generation increases pollution and growth in both regimes. 相似文献
116.
The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure Pmax, maximum rate of pressure rise (dP/dt)max and deflagration index Kst, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure Pm of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m3. The rate of explosion pressure rise (dP/dt)m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher Pmax, (dP/dt)max and Kst mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust. 相似文献
117.
实验测定了林西矿肥煤样品30~900℃煤自燃全过程热动力学特征参数,得出:TG/DTG曲线显示煤样DTG初始临界温度45℃,干裂温度122℃,活性温度195℃,增速温度265℃,质量极大值温度342℃,着火温度465℃,最大热失重速率温度515℃和燃尽温度690℃;DSC曲线显示,煤样初始放热温度60℃、最大热释放速率温度511℃。结合TG-DTG-DSC曲线综合分析可知,煤温达到510℃左右时煤样反应最剧烈。由煤自燃标志气体测定实验系统得出:煤温130℃后CO,CO 2释放量迅速增加,210℃增加速度下降;CH 4,C 2 H 6含量变化具有规律性且两者变化相近;C 2 H 4出现温度为130℃;C 2 H 4/C 2 H 6比值在190~350℃有较强的规律性,呈上升趋势且上升速度较快;350℃之后,CH 4,C 2 H 6,C 2 H 4体积分数均开始急剧增大;C 2 H 4/CO与C 2 H 4/CO 2变化趋势大致相同,在130~350℃时缓慢增长,达到350℃后比值呈指数形式上升。经拟合曲线,得到活化能的3个突变点温度:70,180,220℃,其中180℃与交叉点温度相吻合。通过以上研究,得到了肥煤自燃全过程的热力学特征参数,为实际生产中防治煤自燃提供了理论依据。 相似文献
118.
119.
ABSTRACT Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system. 相似文献
120.
Krzysztof Baszczyński 《International journal of occupational safety and ergonomics》2018,24(2):171-180
Industrial workplaces pose concurrent hazards to the upper part of the head and the eyes. Under the circumstances, workers may use protective helmets in conjunction with protective goggles or spectacles. In order to assess the compatibility of this equipment, a method and a test stand for evaluating the behavior of safety helmets and protective goggles/spectacles upon the impact of a falling weight were designed. The results of tests concerning the displacement and deformation of helmets and spectacles/goggles, the forces acting on the helmets, as well as the forces exerted by the spectacles/goggles on the headform upon falling weight impact are presented. The results revealed the ways in which the tested equipment interacted with each other. The influence of equipment construction on the test results was analyzed and inferences concerning the safety of the studied protective devices were made. Some general construction guidelines were formulated for the compatibility of the equipment. 相似文献