基于提升能源化工基地清洁生产水平的节能减排潜力分析

文章以榆林能源化工基地代表性的支柱产业为例,开展依靠科技进步提升清洁生产水平的节能减排潜力分析。分析结果表明,至"十二五"末期榆林能源化工基地的支柱产业分别将清洁生产水平提高至一级或二级,可减少的二氧化硫排放量是3 451.8吨/年和1 094.3吨/年,氮氧化物排放量是5 333.5吨/年和1 962.5吨/年。     

铁阳极电解脱色直接黄11染料模拟废水

研究采用铁为阳极电化学法处理直接黄11染料模拟废水脱色性能的影响进行研究。影响因素包括:电流密度、pH值、染料浓度和电解质浓度。研究结果表明,电流密度大有利于染料废水脱色,但能耗消耗大;初始溶液在中性条件下不仅取得很好的处理效果,而且脱色能耗较低;随着染料初始浓度增加脱色率和脱色能耗降低的趋势;随着电解质浓度升高染料脱色率下降的趋势,脱色能耗先减少,然后缓慢增大。在染料初始浓度50 mg/L、pH值为7.11、电流密度2.083 mA/cm2、电解质Na2SO4浓度0.01 mol/L、温度20℃、搅拌速度600 r/min、电解时间60min条件下,脱色率达到92.2%,脱色能耗1.709 kW.h/kg染料。     

城镇生活污水厂实行清洁生产途径分析

结合企业清洁生产理论,根据污水处理厂实际情况,从“节能、降耗、减排、增效”出发,详细阐述了污水厂实行清洁生产的途径。指出节约电能、新鲜水、药剂,减少污染物排放是污水处理厂清洁生产的主要出发点。并进行实例分析。     

沼液复合型杀虫剂的田间应用试验研究

通过沼液复合型杀虫剂的田间应用试验,对各种沼液复合型杀虫剂的抗病防虫性能进行了深入研究.在大田应用条件下测试了沼液复合型杀虫剂的杀虫效果.结果表明,该沼液复合型杀虫剂对蚜虫的毒杀作用均比较明显.为了推进沼液复合型杀虫剂的商业化进程,提出便于其田间应用的各种最佳配比浓度,即BP01号、BP02号、BP03号、BP04号、BP05号沼液复合型杀虫剂抗病防虫性能最佳的配比分别为9 500倍液、26000倍液、11 667倍液、22 000倍液和13 333倍液.     

Oxidation inhibition of sulfite in dual alkali FGD system

A laboratory-scale well-mixed thermostatic reactor with continuously blasting air was used to investigate the oxidation inhibition of sulfite in dual alkali flue gas desulfurization （FGD） system. The effects of operating parameters such as pH value and catalyst concentration on the oxidation were studied. Sodium thiosulfate was used in the system, and was found that it significantly inhabited the sulfite oxidation. In the absence of catalyst, sodium thiosulfate at 12.67 mmol/L had an inhibition efficiency of approximately 98%. While in the presence of catalyst, sodium thiosulfate at 26.72 mmol/L had an inhibition efficiency less than 85.0%. The oxidation reaction order of sulfite in the sodium thiosulfate was determined to be -1.90 and 4）.55 in the absence and presence of the catalyst, respectively. Apparent activation energy of oxidation inhibition was calculated to be 53.9 kJ/mol. Pilot tests showed that the consumption rate of thiosulfate agreed well with the laboratory-scale experimental results.     

Kinetics of selective catalytic reduction of NO by NH3 on Fe-Mo/ZSM-5 catalyst

The catalyst of Fe-Mo/ZSM-5 has been found to be more active than Fe-ZSM-5 and Mo/ZSM-5 separately for selective catalytic reduction (SCR) of nitric oxide (NO) with NH3. The kinetics of the SCR reaction in the presence of O2 was studied in this work. The results show that the observed reaction orders were 0.74-0.99, 0.01-0.13, and 0 for NO, O2 and NH3, respectively, at 350-450℃. And the apparent activation energy of the SCR was 65 kJ/mol on the Fe-Mo/ZSM-5 catalyst. The SCR mechanism was also deduced. Adsorbed NO species can react directly with adsorbed ammonia species on the active sites to form N2 and H2O. Gaseous O2 might serve as a reoxidizing agent for the active sites that have undergone reduction in the SCR process. It is also important to note that a certain amount of NO was decomposed directly over the Fe-Mo/ZSM-5 catalyst in the absence of NH3.     

珠江三角洲人为氨源排放清单及特征

根据收集的珠江三角洲(珠三角)人为氨源的活动水平数据,采用合理的估算方法和排放因子,建立了该地区2006年人为氨源分类别和分城市的排放清单.结果表明:①2006年珠三角地区人为氨源NH3排放总量约为194.8kt;②农业源是珠江三角洲地区人为氨源的主要排放贡献源,其中畜禽源排放的NH3占总排放量的62.1%,其次是氮肥施用源,其贡献率为21.7%;③畜禽源中肉鸡是NH3排放最大贡献源,占畜禽源NH3排放总量的43.4%,其次是肉猪,其贡献率为32.1%;④广州是珠三角地区2006年人为氨源排放量最大的城市,其次是江门,分别占NH3总排放量的23.4%和19.1%,主要的排放源均为畜禽和氮肥施用源.     

红枫湖钻孔沉积物中滴滴涕的沉积记录

采用GC/MS方法分析了红枫湖钻孔沉积物中滴滴涕的垂直分布状况,并对其来源和生态风险进行了分析和评估.红枫湖钻孔沉积物中滴滴涕的含量介于7.6～23.7ng/g之间,且从底层至表层基本上呈下降的趋势.其中,1981～1983年间有一个急剧下降的过程,随后基本上呈缓慢下降的趋势.沉积物中滴滴涕的组成以p,p′-DDTs(p,p′-DDT、p,p′-DDE和p,p′-DDD的总和)为主,p,p′-DDTs与o,p′-DDTs(o,p′-DDT、o,p′-DDE和o,p′-DDD总和)的比值在5.1～8.4之间,说明沉积物中的滴滴涕主要来源于农药滴滴涕的残留.又因为沉积物中残留的滴滴涕是以它的代谢产物为主,DDT/(DDD+DDE)的比值为0.31～0.84,所以沉积物中的滴滴涕主要源于历史的残留.此外,DDT/(DDD+DDE)和DDE/DDD比值的垂直变化特征显示,尽管我国1983年就禁止了滴滴涕在农业上的使用,但直至1990年前后,红枫湖流域内仍存在滴滴涕使用的可能.风险评价的结果显示,红枫湖表层沉积物中DDE、DDD、DDT和DDTs的含量均介于ERL和ERM值之间,可能造成潜在的生态风险,因此红枫湖沉积物中滴滴涕的污染仍值得密切关注.     

Spatial and temporal variations in groundwater nitrate at an intensive dairy farm in south-east Ireland: Insights from stable isotope data

Achievement of at least “good ecological status” in all waterbodies under the EU Water Framework Directive by 2015 will in some cases be a challenge. The twin challenge is to manage expectations of policy makers for such waterbodies as to a realistic length of time required for improvement in water quality. Hence, understanding the source, transformation processes and residence time of nitrate in a hydrological system is an essential part of meeting such challenges. On a dairy farm with 24 shallow groundwater wells, the dual isotopic composition of nitrate (δ¹⁵N and δ¹⁸O) was used to clarify nitrate sources, to assess spatial and temporal variability in nitrate concentrations and to determine if and where denitrification was occurring. Vertical travel time was estimated to correlate nitrate concentrations with management practices. Organically derived nitrogen was the predominant source contributing to groundwater nitrate concentrations. Denitrification was identified as prevalent within specific regions of the study site. The distinct low temporal variability in the isotopic data suggests constancy among nitrate sources and processes over time across the study site. Vertical travel times of up to 3 years were estimated on site indicating the influence of recent management practices on nitrate concentrations. Very slow horizontal migration of groundwater (decades) indicates a legacy of older management practices. Stable isotope techniques, together with an understanding of time lag, provide an extra mechanism to test the efficacy of monitoring and mitigation programmes.     

An environmental impact assessment of quantum dot photovoltaics (QDPV) from raw material acquisition through use

Some emerging technologies are expected to be pivotal for solving many of the environmental challenges faced today, especially those related to energy. However, many of these technologies may incur significant environmental impacts over their life cycle, while having environmental benefits during their use. This paper presents results of a Life Cycle Assessment (LCA) of a proposed type of nanophotovoltaic, quantum dot photovoltaic (QDPV) module. The LCA is confined to the stages of raw materials acquisition, manufacturing, and use. The impacts of QDPV are compared with other types of PV modules and energy sources - both renewable and nonrenewable. To provide a comprehensive comparative assessment, QDPV modules were compared with mature as well as emerging PV types for which data are available. Comparative assessment with other types of energy sources includes coal, oil, lignite, natural gas, diesel, nuclear, wind, and hydropower.QDPV modules may have the potential to overcome two current barriers of solar technology: low efficiencies and high manufacturing costs. If higher efficiencies are realized, QDPV modules could pave the way to large scale implementation of solar energy, helping nations move toward greater energy independence. On the other hand, candidate materials as quantum dots for solar cell applications are mostly compound semiconductors such as cadmium selenide, cadmium telluride, and lead sulfide which may be toxic and for which renewable options are limited. Toxic effects of these materials may be exacerbated by their nanoscale features.The LCA was carried out using the software SimaPro, and the Ecoinvent Life Cycle Inventory (LCI) database supplemented with available literature and patent information. Our results indicate that while QDPV modules have shorter Energy PayBack Time (EPBT), lower Global Warming Potential (GWP), SO_x and NO_x emissions than other types of PV modules, they have higher heavy metal emissions, underscoring the need for investigation of emerging technologies, especially nano-based ones, from a life cycle perspective. QDPV modules are better in all impact categories assessed than carbon-based energy sources but they have longer EPBT than wind and hydropower and higher GWP.