液氮泡沫发生器内流动特性研究

低温液氮与泡沫混合液直接接触产生氮气泡沫是一种新型的掺混形式,利用液氮高汽化比的特点,搭建液氮泡沫可视化实验装置,进行氮气-水两相流及液氮泡沫流动特性的研究。结果表明,液氮相变产生大量氮气,其与泡沫液混合产生泡沫,温度有所回升,最终趋于泡沫混合液温度;管路沿程压降较小;液氮射流破碎及流动过程可分为6个区域:低温液氮区、向上循环翻滚区、滞留区、泡沫与泡沫混合液混合区、致密泡沫区、泡沫混合液区。流体向下游流动过程中持续发泡;为防止管路结冰,需合理控制泡沫混合液与液氮流量。     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

Effect of pyrolysis and oxidation characteristics on lauric acid and stearic acid dust explosion hazards

The effect of pyrolysis and oxidation characteristics on the explosion sensitivity and severity parameters, including the minimum ignition energy MIE, minimum ignition temperature MIT, minimum explosion concentration MEC, maximum explosion pressure P_max, maximum rate of pressure rise (dP/dt)_max and deflagration index K_st, of lauric acid and stearic acid dust clouds was experimentally investigated. A synchronous thermal analyser was used to test the particle thermal characteristics. The functional test apparatuses including the 1.2 L Hartmann-tube apparatus, modified Godbert-Greenwald furnace, and 20 L explosion apparatus were used to test the explosion parameters. The results indicated that the rapid and slow weight loss processes of lauric acid dust followed a one-dimensional diffusion model (D1 model) and a 1.5 order chemical reaction model (F1.5 model), respectively. In addition, the rapid and slow weight loss processes of stearic acid followed a 1.5 order chemical reaction model (F1.5 model) and a three-dimensional diffusion model (D3 model), respectively, and the corresponding average apparent activation energy E and pre-exponential factor A were larger than those of lauric acid. The stearic acid dust explosion had higher values of MIE and MIT, which were mainly dependent on the higher pyrolysis and oxidation temperatures and the larger apparent activation energy E determining the slower rate of chemical bond breakage during pyrolysis and oxidation. In contrast, the lauric acid dust explosion had a higher MEC related to a smaller pre-exponential factor A with a lower amount of released reaction heat and a lower heat release rate during pyrolysis and oxidation. Additionally, due to the competition regime of the higher oxidation reaction heat release and greater consumption of oxygen during explosion, the explosion pressure P_m of the stearic acid dust was larger in low concentration ranges and decayed to an even smaller pressure than with lauric acid when the concentration exceeded 500 g/m³. The rate of explosion pressure rise (dP/dt)_m of the stearic acid dust was always larger in the experimental concentration range. The stearic acid dust explosion possessed a higher P_max, (dP/dt)_max and K_st mainly because of a larger pre-exponential factor A related to more active sites participating in the pyrolysis and oxidation reaction. Consequently, the active chemical reaction occurred more violently, and the temperature and overpressure rose faster, indicating a higher explosion hazard class for stearic acid dust.     

Morphological characteristics of flashing jet throughout superheated liquid release

Many release problems involve two-phase releases of hazardous materials of superheated liquids with high energy into the atmosphere. Such accidents are accompanied by violent phase transition and form catastrophic flashing jets. In this work, experimental and theoretical analyses were conducted to investigate dynamic characteristics of flashing jet morphology and their dependence on pressure-decay dynamics under different storage pressures, superheats, and nozzle diameters. Flashing jet morphology and angle throughout two-phase releases were captured by a high-speed camera, and the corresponding source pressure in the superheated liquid tank was measured simultaneously. Results show that three typical phases, expansion, stabilization, and decay, are characterized throughout two-phase release based on the evolution of flashing jet morphology. The jet initially expands gradually due to the enhancement of phase transition intensity, and then keeps stable when the intensity reaches its maximum, and terminally decays rapidly due to the depletion of superheated liquid. Phase transition intensity at the nozzle exit is mainly controlled by the pressure-decay dynamics. Bubbles nucleation inception sites gradually move upstream of the nozzle during the pressure decay process increasing the phase transition intensity. The increase of storage pressure, superheat and nozzle diameter promotes the mechanical and thermodynamic effects on the jet breakup. The significant increase of mechanical and thermodynamic effects effectively accelerates droplets evaporation and further affects flashing jet morphology.     

基于循环经济,探索园区污水处理新思路

为响应国家节能减排和循环经济的理念,本文提出一种新的园区污水处理方式-以污治污:利用企业A废水中的碱性物质与消耗企业B废水中的氢离子,再向废水中投加石灰石去除多余的氢离子,投加液碱去除废水中的铜离子和锌离子。优化后的废水处理方式可减少盐酸、石灰石的使用量,从源头上减少了资源的浪费和排入外环境的污染物,对社会发展和生态环境均具有明显的正效益。     

生物柴油产业链分析

生物柴油是指由植物油、动物油脂等制备得到的单烷烃酯类。它是一种环境友好、清洁排放的燃料,因此是非常理想的石油柴油替代燃料。本文从生物柴油产业链中的原料来源、生产工艺、产品应用以及其效益等方面对这种新型的清洁燃料进行了简单介绍。总之,生物柴油是一种很有发展前景的生物质燃料。     

Environmental pollution,hydropower and nuclear energy generation before and after catastrophe: Bathtub-Weibull curve and MS-VECM methods

In this paper, the life span of hydro and nuclear energy generations and the relationship between hydro and nuclear energy generations, environmental pollution, and economic growth were investigated for Japan covering the period of 1960–2018 by employing the Bathtub-Weibull curve and Markov switching-vector error correcting (MSVEC) method, respectively. According to the Bathtub-Weibull curve analysis, a rising failure rate for nuclear energy was found, indicating that the life of nuclear energy has expired, but a decreasing failure rate for hydroelectric energy has been detected. Then two different MSVEC models were used. The MSVEC method, unlike traditional approaches, determines the relationship between variables under different regimes. The results of MSVEC methods indicate three important points. First, regime-dependent asymmetry and regime changes are crucial for policy recommendations. Second, the shocks to hydropower and nuclear energy generations cause temporary deviations from the long-run growth path in both regimes. Lastly, the increase in hydropower generation leads to a decrease in environmental pollution and an increase in GDP, and an increase in nuclear power generation increases pollution and growth in both regimes.     

上海市能耗与GDP大气污染的协整关系研究

采用计量经济学中的协整理论考察上海市能源消费量与经济增长、废气排放量、二氧化硫排放量之间的关系。结果显示,上海市能源消费只与经济增长、废气排放量之间存在长期协整关系,并建立了相应的长期均衡方程及误差修正模型。另外,对1978～2003年的能源消费与经济增长之间进行Granger因果关系检验,提出实现上海市经济-能源-环境和谐发展的措施。     

西藏农村能源消费及环境影响研究

西藏农村人口现有220多万,占全区总人口80％以上,农村经济落后,城乡差距很大。西藏农村能源资源主要有水力、地热、太阳能、风力、林木和畜粪等,煤炭、石油、天然气等高热值的优质能源很少。在这种经济发展水平及能源资源基础条件下,农村能源消费中高热值的现代能源比重很低,主要以生物质能如薪柴、牛粪、草皮等为主。这种低水平的能源消费结构已经对西藏脆弱的生态环境造成了巨大的破坏,西藏未来的能源发展战略迫切需要改变农村目前的消费结构,应发展太阳能、风能、农村小水电及输入高热值的化石能源替代目前生物质能的消费,减少因能源消费对西藏生态环境的破坏。     

Renewable energy in Australia: a wider policy discourse

ABSTRACT

This paper assesses the evolution of generation technology-mix in Australia, with specific emphasis on understanding how such evolution has been shaped by wider political and socio-economic influences. This assessment is predicated on the argument that the contemporary, quintessentially techno-economic, policy discourse on renewable energy is deficient, as it ignores climacteric political and socio-economic influences on generation technology-mix. The methodological framework employed in this paper is informed by the core tenets of technological change theory. The assessment suggests that generation technology-mix in Australia has historically been overwhelmingly influenced by the underlying technological paradigm of the electricity industry; and that this technological paradigm essentially draws its imprimatur from the wider political and socio-economic contexts. By implication, it suggests that a rapid uptake of renewables will have widespread ramifications, extending into political, socio-economic and cultural realms of a society. Clearly, existing policy discourse – that tends to focus on technical potentials, cost competitiveness, externalities and risks of various renewable technologies – is deficient. A much broader discourse is needed. This paper also made an attempt to develop a basis for such a discourse by reviewing broader aspects of the Australian society that would be affected by a rapid uptake of renewables.