几种碳氢燃料与空气混合物相对爆轰敏感度的测定

利用矩形激波管测定了几种碳氢燃料（丁烷，石脑油，ＪＣ５，戊烯，已烯）直接起爆时形成爆轰所需的临界起爆能，并以化学当量比的乙炔氧气混合物直接起爆形成爆轰的临界起爆能为基准，定义了一个无量纲常数Ｄｈ。再利用这个常数，比较了这几种燃料的相对爆轰敏感度。     

Planar detonation structure for chain-branching kinetics with large activation energy and small initiation rate

The structure of the steady planar detonation wave is analyzed for three-step chain-branching kinetics consistent with hydrogen–air chemistry. The initiation and chain-branching steps are described by an Arrhenius rate. Both are thermally neutral, so that heat release is due to termination. The initiation rate is typically very low and very stiff. As a result, a small fraction of the reactant is consumed in the initiation region, which is very long but ends in an exponential chain-branching explosion. Next, the reactant is rapidly converted into chain-branching radicals, within a very thin zone, which ends when the concentration of the chain-branching radical reaches a peak, because of reactant depletion. Finally, the termination step consumes the chain-branching radicals and releases heat within a region thicker than the peak zone, but much thinner than the initiation region. The analysis is based upon two assumptions: that the chain-branching activation energy is high and that initiation is slow. The structure of the initiation and chain-branching zones is different for post-shock states within or outside the explosion region in the chain-branching diagram. In the former situation, chain-branching is already stronger than termination at the von Neumann point, and vice versa. In the no-explosion case, the initiation zone becomes very long, while the little chain-branching specie produced by initiation is directly converted into product by the termination step. Temperature increases slowly until reaching the explosion curve, when chain-branching becomes stronger than termination. The subsequent structure is similar to the explosion case.     

Influence of the oxide content on the ignition energies of aluminium powders

Some results of determination of ignition energies for an aluminium powder with various oxide contents are presented. Common use of processes like high-speed cutting produce explosive dust clouds, so that we focused this study on hazard of metallic powders. An industrial aluminium powder has been used for this work. An original process, based on the principle of electrochemical anodisation, has been developed to increase, under control, the oxide coating of particles.

The sensitivity study to spark ignition was performed in an Hartmann explosion tube of 1.3L. The Langlie test method was applied to evaluate the energies leading to a probability of ignition of 50% (E₅₀) of the selected samples. The results confirm that the ignition energies increase with the oxide content of the powder.     

Observed LATCH use and misuse characteristics of child restraint systems in seven states

INTRODUCTION: Although the LATCH System (Lower Anchors and Tethers for Children) holds the promise of simplifying the installation of a child restraint system (CRS) to the vehicle's seat, many drivers transporting young children have difficulties using this technology. This paper reports on an observation study of LATCH use and misuse. METHOD: Observations of approximately 1,000 children less than 5 years of age in CRSs, in the back seats of vehicles that were equipped with tether and lower anchors, in seven states. RESULTS: Tethers were used for 51% of the children when the forward-facing CRS had tether straps and the vehicle had tether anchors. Lower anchors were used for 58% of the children when the CRS had lower attachments and the vehicle had lower anchors. The most common tether and lower attachment misuses were loose tether straps (18% of cases) and loose lower attachment installation (30% of the cases), respectively. Vehicle safety belts were used in combination with lower attachments in 20% of all lower anchor installations. CONCLUSION: As more caregivers of young children drive vehicles equipped with LATCH, it will be important to promote the proper installation of CRSs using this technology. LATCH education messages must also emphasize that the lower anchors may not always be the safest choice for CRS attachment -- the safest attachment is the one that results in a tight fit and will be used correctly consistently.     

A direct observation study of nighttime safety belt use in Indiana

INTRODUCTION: Nearly all direct observation studies of safety belt use are conducted exclusively during daylight hours. Recent work has suggested that safety belt use at night may differ from daytime belt use. METHODS: An observational study of nighttime safety belt use, utilizing specialized night vision equipment, was conducted in Indiana surrounding the Click It or Ticket 2006 safety belt mobilization activities. A pre- and a post-mobilization statewide direct observation survey was conducted at night coinciding with daytime safety belt use data collection conducted by the state of Indiana. Daytime and nighttime belt use rates were compared. RESULTS: The comparisons across the mobilization period revealed a significant increase during the day, but a significant decrease at night. Comparisons between daytime and nighttime belt use revealed no overall difference during the pre wave, but a significant difference during the post wave. Finally, many common daytime trends in belt use were also found at night, with the exception of the typical age and seating position effects. DISCUSSION: The mobilization activities had a positive effect on daytime belt use, but no effect on nighttime belt use, likely resulting in the differences between daytime and nighttime belt use observed during the post wave. IMPACT ON INDUSTRY: The findings of this study suggest that safety belt mobilizations implemented only during the day do not influence nighttime safety belt use. Changes to how these programs are implemented or additional programs specifically targeting belt use at night should be considered, along with continued monitoring of nighttime belt use.     

Prompting safety-belt use in the context of a belt-use law: the flash-for life revisited

PROBLEM: Safety-belt use reduces motor vehicle crash-related morbidity and mortality, yet an estimated 18% of drivers do not consistently buckle up (NHTSA, 2005). In 1985, Geller and colleagues developed an interpersonal Flash-for-Life prompt that increased belt use among 22% of 1,087 unbuckled drivers (Geller, Bruff, & Nimmer, 1985). METHOD: The Flash-for-Life intervention was re-introduced at a large university with high safety-belt use (i.e., 80%). College students stood at parking-lot entrance/exits and "flashed" signs with the message, "Please Buckle Up, I Care" to unbuckled drivers. RESULTS: Of 427 unbuckled drivers observed, 30% of these complied with the prompt. Male drivers were significantly more likely to comply with prompts delivered by females. DISCUSSION: Compliance was higher than in the 1985 study, indicating a high baseline rate of safety-belt use does not negate potential beneficial influence of a prompting intervention. This intervention is particularly effective with college-aged males, a sub-group of the driving population least likely to buckle-up. IMPACT ON INDUSTRY: A simple behavioral prompt could be used at most industrial complexes to increase safety-belt use among vehicle occupants who are not buckled-up.     

沼液复合型杀虫剂的田间应用试验研究

通过沼液复合型杀虫剂的田间应用试验,对各种沼液复合型杀虫剂的抗病防虫性能进行了深入研究.在大田应用条件下测试了沼液复合型杀虫剂的杀虫效果.结果表明,该沼液复合型杀虫剂对蚜虫的毒杀作用均比较明显.为了推进沼液复合型杀虫剂的商业化进程,提出便于其田间应用的各种最佳配比浓度,即BP01号、BP02号、BP03号、BP04号、BP05号沼液复合型杀虫剂抗病防虫性能最佳的配比分别为9 500倍液、26000倍液、11 667倍液、22 000倍液和13 333倍液.     

新型烟囱的节能效果与分析

介绍了一座80m烟囱由径向进气方式改为弧形切向进气的工程案例。列出了烟囱改造前后引风机运行一日的能耗数据,对比分析得出采用弧形烟道具有一定的节能效果,探讨了采用弧形烟道烟囱降低能耗的基本原因。     

中国2030年CO2排放总量预测研究

我国2005年和2010年CO2排放总量分别为55亿t和81.52亿t,“十五”和“十一五”期间年均增长率分别为11.0％和8.0％.中国2011-2015年、2016-2020年、2021-2025年和2026-2030年GDP年均增长率分别为8％、7％、6％、5％的经济发展模式与对应的能源消费弹性系数分别为0.5、0.5、0.4和0.3的能源发展模式,预测2030年燃煤、燃油和天然气CO2排放量及全国CO2排放总量.提出减少CO2排放总量对策,主要包括：调整能源结构,尽量减少煤炭消费量占能源消费总量的比例,增加石油、天然气和新能源的比例,提高CO2综合利用率,完善CO2管理政策与法律法规等.     

城市煤气输配过程中的变频调速自动恒压控制系统

将河南平顶山煤气公司原煤气输配系统改造成为自动恒压控制系统,从而提高安全系数,降低煤气输配电耗。