排气制动下汽车制动失效的坡长临界值计算

针对连续长下坡汽车王制动器失效的现象,研究了在排气制动下汽车下坡制动失效的坡长临界值问题.根据汽车主制动器制动毂温升模型,推导出在山区不同长纵坡路段,排气制动下汽车主制动器制动失效的坡长临界值,提出r伍5%、6%坡道上,采取Ⅳ档排气制动时,维持40km/h的安全稳定车速,主制动器制动失效的坡长临界值分别为3072m和1929 m,为长下坡路段交通安全设施的设计提供了理论依据.     

不同运行规则下区间列车运行安全性及效率研究

列车区间运行安全是列车运行安全中极为重要的部分,而列车在区间运行的安全性及效率与运行规则密切相关。将闭塞分区及与其配套的通过色灯信号机结合在一起,建立区间模型,给出列车在区间运行的安全性要求,定义列车在区间连续追踪运行的安全度,介绍列车在区间运行的全部3种运行规则及相应的区间阻塞状态。在此基础上,定量计算3种规则的安全度。基于安全性和效率,对列车运行规则进行深入研究,结果表明,3种规则效率相当,规则1安全性最优。     

“8·29”充装台充装现场氧气瓶爆炸事故原因分析

介绍了较为少见的充装台充装过程中氧气瓶爆炸事故,描述了事故爆炸后的现场。对爆炸气瓶碎片进行化学成分分析、机械性能、金相试验、内壁附着物化学成分分析和能谱分析。通过分析认定,由于误操作油脂混进氧气瓶,高压氧气和油脂接触发生剧烈的自燃氧化放热,使瓶内的氧气迅速升温升压,超出气瓶承压极限导致气瓶爆炸。结合工作经验,提出要严格气瓶充装前的检验,加强气瓶使用和经销单位的安全监管等防范措施和建议,对氧气瓶的安全管理具有参考价值和实际意义。     

液化石油气钢瓶爆炸事故分析与思考

我国液化气钢瓶使用量大而广,液化气钢瓶事故时有发生。由于使用者安全意识不强,气瓶违法充装、超期不检、违规检验或修理改造报废气瓶等问题导致的气瓶事故仍居高不下,是造成我国液化气钢瓶事故的主要原因。另外,违法将二甲醚掺入液化石油气钢瓶,液化石油气钢瓶管理混乱也是事故发生的主要原因。该文在分析事故原因的基础上,提出调换液化石油气钢瓶,在使用时有人看管,液化石油气钢瓶必须直立使用,放置位置不要靠近热源等几条液化石油气安全使用要点分析与事故处置。以加大对液化石油气钢瓶事故灾害预防、隐患治理工作,加大对用户安全使用常识的宣传教育工作,杜绝事故的发生。     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.     

A nonparametric procedure for analyzing repeated measures of spatially correlated data

Many agricultural, biological, and environmental studies involve detecting temporal changes of a response variable, based on data observed at sampling sites in a spatial region and repeatedly over several time points. That is, data are repeated measures over time and are potentially correlated across space. The traditional repeated-measures analysis allows for time dependence but assumes that the observations at different sampling sites are mutually independent, which may not be suitable for field data that are correlated across space. In this paper, a nonparametric large-sample inference procedure is developed to assess the time effects while accounting for the spatial dependence using a block bootstrap. For illustration, the methodology is applied to describe the population changes of root-lesion nematodes over time in a production field in Wisconsin.     

福建中奥陶世——晚侏罗世地层的古地磁学研究

福建古生界至中生界部分地层古地磁研究认为,华南地块的主体部分首先于中奥陶世时期即已拼合,作为一个整体由南纬23.8°向北移动,二叠纪之后越过赤道,继续北移,直至侏罗纪末到达北纬19.6°的位置.而华南地块同扬子地块的拼合是在加里东末期开始的,至少可以认为是在早石炭纪之前两地块就靠近了。这一时期,华南地块和扬子地块的地质构造运动十分活跃.     

用柠檬酸废渣生产蒸压加气砼砌块

本文介绍了用柠檬酸废渣代替天然石膏生产蒸压加气砼砌块，从而解决了长期以来柠檬酸生产厂家因排放柠檬酸废渣所造成的环境污染问题，开创了柠檬酸废渣直接运用的新途径。环境效益和经济效益都较明显。     

La1-xCexFe0.7Co0.3O3-δ网状多层纳米纤维对碳烟催化燃烧性能研究

采用静电纺丝法制备了一系列钙钛矿催化剂La_(1-x)Ce_xFe_(0.7)Co_(0.3)O_(3-δ)(x=0、0.1、0.2、0.3和0.4),并采用XRD、SEM、FT-IR、H2-TPR和O_2-TPD等技术分析了Ce掺杂量对催化剂结构、微观形貌及理化特性的影响.同时,采用程序升温氧化(TPO)技术评价了催化剂对碳烟的催化燃烧活性,探讨了催化剂对碳烟的催化燃烧机理.结果表明:在La_(1-x)Ce_xFe_(0.7)Co_(0.3)O_(3-δ)中掺杂适宜的Ce有助于提高催化剂活性,改善催化剂比表面积和孔容积.在催化剂与碳烟松散接触条件下,当Ce掺杂量(质量百分比)为0.3时,所制备的La_(0.7)Ce_(0.3)Fe_(0.7)Co_(0.3)O_(3-δ)对碳烟的起燃温度(T_(ig))、最大燃烧温度(T_m)和燃尽温度(T_f)分别为329.5、409.8和421.1℃,呈现良好的催化氧化活性.碳烟最大转化效率为98.7%,平均活化能为123 kJ·mol~(-1),CO_2选择率为98.2%,实现了对柴油机碳烟排放污染物有效"过滤+催化燃烧"的双重目标.     

异质结型SnO2-TiO2纳米纤维光催化降解柴油机多环芳烃

采用同轴静电纺丝法制备了SnO_2-TiO_2纳米纤维,用X射线衍射仪(XRD)、扫描电子显微镜(SEM)、红外光谱仪(FTIR)和紫外-可见光谱能谱仪(UV-Vis),表征了SnO_2-TiO_2纳米纤维相组成和微观形貌,评价了催化剂表面化学形态和吸光特性,研究了SnO_2含量、光源条件、温度和催化稳定性对降解萘污染物的影响规律.结果表明,催化剂Sn25对萘降解效率最高.在暗光、可见光和紫外光条件下,萘降解效率分别为13.8%、37%和98%.Sn25对萘降解稳定率(标准差率)为0.36%.利用催化剂Sn25对柴油机尾气中多环芳烃(PAHs)排放污染物光催化降解应用发现,Sn25对低苯环PAHs、中苯环PAHs和高苯环PAHs的平均催化降解效率分别为80.2%、75.4%和60.2%.表明SnO_2-TiO_2纳米纤维具有较强光催化降解多环芳烃污染物能力.