锅炉房电气设备运行安全应注意的几个问题

对工业锅炉房电气设备及电缆敷设的设计和运行管理安全提出应注意的问题,并提出本质安全要求。     

我国居室内空气中甲醛污染现状分析及对策研究

介绍了我国目前居室空气中甲醛污染现状,分析了居室空气中甲醛的来源及污染的成因。在实际工作中,摸索、总结了一套以在房间布局中设立衣帽间为核心的、防止因装修引起的居室空气中甲醛污染的具体办法。该办法简单、经济、适用面广,效果明显, 值得提倡和普及。     

大型锅炉房的噪声监测与治理

对大型锅炉房(燃煤、燃气、燃油)的噪声源进行测试分析．给出了隔声、吸声、消声量的计算公式．同时针对燃煤、燃油、燃气锅炉房的噪声污染．采取了不同的治理措施．取得了较好的治理效果。     

Ultrafine particle emission characteristics of diesel engine by on-board and test bench measurement

This study investigated the emission characteristics of ultrafine particles based on test bench and on-board measurements. The bench test results showed the ultrafine particle number concentration of the diesel engine to be in the range of (0.56-8.35) × 10⁸ cm^-3. The on-board measurement results illustrated that the ultrafine particles were strongly correlated with changes in real-world driving cycles. The particle number concentration was down to 2.0 × 10⁶ cm^-3 and 2.7 × 10⁷ cm^-3 under decelerating and idling operations and as high as 5.0 × 10⁸ cm^-3 under accelerating operation. It was also indicated that the particle number measured by the two methods increased with the growth of engine load at each engine speed in both cases. The particle number presented a "U" shaped distribution with changing speed at high engine load conditions, which implies that the particle number will reach its lowest level at medium engine speeds. The particle sizes of both measurements showed single mode distributions. The peak of particle size was located at about 50-80 nm in the accumulation mode particle range. Nucleation mode particles will significantly increase at low engine load operations like idling and decelerating caused by the high concentration of unburned organic compounds.     

某涡轮风扇发动机试车台的声环境研究

涡轮风扇发动机试车台空气流量大,试车噪声呈宽带强噪声,其中突出的低频域噪声可远距离传播,易造成大范围的环境污染。为掌握某型涡轮风扇发动机在室内试车时的噪声特性,并检验试车台建筑物和各项降噪设备的效果,我们对新建试车台的声环境进行了测量。通过对该试车台内、外环境噪声数据的分析,表明新建试车台的声环境满足了我国有关规范的要求。本次研究工作对今后试车台的声学设计具有重要的借鉴意义。     

成都市典型非道路工程机械排气烟度分析

采用不透光烟度计采集了成都市典型工程机械(挖掘机、装载机、叉车和压路机)排气烟度,研究了机械功率对其活动水平(燃油消耗量和年均工作时间)的影响,同时也研究了机械发动机构造和机械排放标准对其排气烟度的影响;同时,采用氮硫测定仪分析了机械油品硫含量,研究了硫含量对其排气烟度的影响.试验结果表明:机械功率越大的工程机械,燃油消耗量和年均工作时间数越高.成都典型工程机械排气烟度排放水平最低的为装载机,最高的为压路机;同时,超高排放装载机与叉车的占比较高.工程机械排气烟度受机械发动机排量、机械发动机构造、机械发动机排放标准和机械用油的综合影响,通过对工程机械装配电控发动机、提高原机排放标准和使用低硫燃油均能直观反映出机械排气烟度不同程度的改善.此外,油品中硫含量越高,机械排气烟度越大.     

排气制动下汽车制动失效的坡长临界值计算

针对连续长下坡汽车王制动器失效的现象,研究了在排气制动下汽车下坡制动失效的坡长临界值问题.根据汽车主制动器制动毂温升模型,推导出在山区不同长纵坡路段,排气制动下汽车主制动器制动失效的坡长临界值,提出r伍5%、6%坡道上,采取Ⅳ档排气制动时,维持40km/h的安全稳定车速,主制动器制动失效的坡长临界值分别为3072m和1929 m,为长下坡路段交通安全设施的设计提供了理论依据.     

室内火灾的经济性分析

本文在卧室火灾双重分析的基础上，进一步对其进行了经济性分析，更为直观给出了火灾的后果。本文提供了室内火灾经济性分析的一种可行的方法，对今后工作的深入发展具有参考价值。     

房间开门形式和走廊转角条件对人员疏散规律影响的实验研究与数值模拟分析

为了研究房间开门形式和走廊转角条件对人员疏散规律的影响,通过一系列实验并采用计算机数值模拟相结合,对比分析了不同开门形式和走廊转角条件下的人员疏散规律。结果表明:房间开门总宽度一定且出口出现拥堵条件下,只设置一道门,疏散效率最高。当房间需要满足设置两道门时,门应尽量设置在房间的两对边墙上,这样疏散效率较高。两道门设置在房间相邻边墙上时最不利于人员疏散。走廊转角角度从0°增加到90°,疏散时间先增长然后缩短最后又增长。同条件下,圆角疏散能力优于折角。圆角半径大小对人员疏散没有显著影响。研究结果为建筑房间开门形式和走廊设计提供了参考依据。     

Effects of EGR on performance and emissions of a diesel engine fuelled with balanites aegyptiaca/diesel blends

In this study, balanites Aegyptiaca (L.) Del biodiesel was blended in proportions of 10% and 20% on the volume basis with diesel fuel and tested in a single cylinder, VCR diesel engine under measured load conditions with varied EGR rates (0, 10 and 20%). The results showed that B10 and B20 blends shown a significant reduction rate in terms of NO_x emissions that were familiar with biodiesel blends. At peak load conditions, BTE increased slightly for test fuel blends compared with pure diesel fuel while the BSFC rate and EGT suffered from increasing and decreasing nature with respect to blending percentage. From the emissions point of view, with the increase in blends percentage, a significant reduction rate is observed in terms of CO and HC concentrations (up to 12.34 and 17.5%, respectively) while NOx emissions decreased at peak load conditions (up to 24.34%). HC and CO emissions decreased with increase in blends percentage. However, lower levels of NO_x and EGT (up to 21.37 and 8.47%, respectively) and the average increase in terms of BTE and BSFC (up to 2.83 and 2.9%, respectively) can be realised with B20 test fuel blend under 20% EGR rate.