The formation of aerobic granular sludge for the treatment of real landfill leachate using a granular sequencing batch reactor at a constant volume

Leachate generated in a landfill may not be treated by conventional biological treatment due to its nature and complexity. The process of forming aerobic granules in batch sequencing reactors having features such as; reducing the settling process time and saving energy consumption and high decomposition rate have been noticed by researchers. In the present study, the structure of sequencing batch reactors (SBRs) was evaluated for the formation of granules, which were subsequently utilized for the treatment of landfill leachate. The experiment was initiated by using the GSBR, containing 1200 ml with different apparatuses, to develop granular sludge, and synthetic wastewater was added to reinforcement. The selected parameters for the operational hydraulic retention time (HRT) of the wastewater (6-h cycles) included feeding, idle, aeration, settling, and discharge. Furthermore, the controlled conditions were the dissolved oxygen (DO) range of 2–2.2 mg/L, temperature range of 20–23℃, and pH of 7.5–8.3. The chemical oxygen demand (COD), mixed liquor suspended solids (MLSS), and sludge volume index (SVI) daily were measured at the influent and effluent of GSBR reactor. The main properties of aerobic granular sludge were identified during the research procedures, and the remarkable settling and potent, high-density microbial structure of the granules were confirmed. The mean size of the formulated granules was estimated at 7.46 ± 1.8 mm, and the volume of the biomass also increased from approximately 1607 to 4137 mg/L through the granulation process. Moreover, 98% of the influent chemical oxygen demand (COD) could be removed by the formulated granular sludge, and the final-stage organic loading rate was estimated at 5.65 COD/m³/day. According to the results, GSBRs could be employed for the formulation of aerobic granular sludge for the treatment of landfill leachate.     

生物裂解效应对污泥脱水减量的作用研究

从市政污水处理厂活性污泥中筛选培养出噬菌型细菌,并通过噬菌型细菌的富集与投加,探讨其对市政污泥生物裂解预处理的有效性及其所受环境影响因素与作用规律.研究结果显示,市政污泥中存在具有污泥裂解作用的广谱性噬菌型细菌,宿主菌的投加量可影响噬菌型细菌的富集浓度,但培养基营养物组成浓度对噬菌型细菌的生长增殖无明显影响.当筛选出的噬菌型细菌以10⁶ pfu/mL（污泥）与中性市政污泥在室温下共存培养24h即可有效裂解污泥细胞,污泥比阻与污泥体积较未投加任何菌剂的参照污泥降低了36%和15%.并可导致胞内营养物的释放,污泥液相中总氮与总磷浓度较参照污泥分别上升了245%和242%,溶解性COD与总COD比值（SCOD/TCOD）则提高了195%,但生物裂解作用效果并不与裂解时间始终保持正相关性,最佳污泥生物裂解时间为24h.     

NaCl对好氧颗粒污泥短程硝化反硝化的影响

利用SBR(序批式反应器)研究了不同ρ(NaCl)、曝气时间、ρ(COD_Cr)、进水ρ(NH₄+-N)对AGS(好氧颗粒污泥)短程硝化反硝化的影响. 结果表明,在pH、温度和ρ(DO)为8.0、30 ℃和3 mg/L条件下,以及ρ(NaCl)、曝气时间、ρ(COD_Cr)和ρ(NH₄+-N)为20 g/L、8 h、600 mg/L和70 mg/L时,η_A(NH₄+-N去除率)和NAR(NO₂--N积累率)达到最佳. 当进水ρ(NaCl)为10 g/L时,NOB(亚硝酸盐氧化菌)被完全抑制,AOB(氨氧化菌)能够保持正常活性. ρ(COD_Cr)较高时能够促进NAR的提高. 经过116 d的培养,AGS短程硝化反硝化的耐盐极限为50 g/L,此时η_A小于50%,AOB被严重抑制,AGS丧失硝化能力. AGS的同步硝化反硝化作用明显,SND(同步硝化反硝化率)平均值为24.2%,SNDV(同步硝化反硝化比速率)平均值为0.63 h-1,低ρ(DO)比高ρ(DO)下的SND同步硝化反硝化作用更为明显.      

氧化/膜过滤工艺处理屠宰废水研究

研究了二氧化氯(Cl O2)氧化/陶瓷超滤膜过滤工艺对屠宰废水的处理效果,对比不同Cl O2投加量、反冲条件(反冲周期、反冲时间等)对产水指标的影响,确定适宜参数。结果表明:其他条件相同,Cl O2投加量140 mg/L时,氧化单元COD去除率较高;反冲周期50 min、反冲时间50 s时渗透通量恢复较好,陶瓷膜装置运行效果最优,COD和浊度的总去除率分别达93.6%、95.8%,产水水质可达标排放,且运行总成本较低,有较好的工业推广前景。     

生物活性炭工艺深度处理丹江口水库水的中试

活性炭过滤是饮用水深度处理的重要工艺,其中滤速、炭层高度、温度和炭龄是影响活性炭滤池运行效果的关键因素. 以丹江口水库水为处理对象,以混凝-沉淀-砂滤出水作为炭滤池进水,以高锰酸盐指数和UV₂₅₄去除率为评价指标,考察2011年4月—2013年5月取自北京某水厂的新炭、1年炭、3年炭和5年炭(2011年5月时炭龄)对水中有机物的去除效果. 结果表明,随着滤速的增大,有机物去除率降低;活性炭炭柱滤速为8 m/h时,高锰酸盐指数和UV₂₅₄去除率分别为41.9%和41.2%,能够获得较好的处理效果. UV₂₅₄去除率随总炭层高度的增大而增大. 随着炭层高度的增加,单位高度活性炭滤料对UV₂₅₄的去除率降低.夏季高温期,1年炭对高锰酸盐指数和UV₂₅₄的去除率分别为44.2%~57.4%和38.5%~53.1%,高于其在冬季低温期的去除率(38.9%~51.1%和31.7%~45.5%). 活性炭在使用初期,主要依靠吸附作用去除有机物;随着使用年限的增长,活性炭的生物载体作用日益明显,生物作用占主导地位,炭龄对有机物去除效果的影响变小,不同炭龄活性炭的处理效果差异不大,可适当延长活性炭的使用年限,降低处理成本.      

电增强零价铁强化厌氧氨氧化处理高氮养猪废水

为解决ZVI(零价铁)电极表面的钝化问题,实现anammox(厌氧氨氧化)工艺稳定、高效地运行,采用EEZVI-UASB(电增强零价铁-升流式厌氧污泥床)技术处理养猪废水,研究了EEZVI电极电压、ρ(COD_Cr)及脱氮贡献率的相关性. 结果表明,在温度为(35±1)℃、pH为6.80～7.10、电极电压为0.60 V的条件下,EEZVI-UASB对NH₄+-N和NO₂--N的去除率均维持在较高的水平;NH₄+-N去除率＞90.00%,NO₂--N去除率＞96.00%,TN平均去除率>90.00%. 当EEZVI电极电压为0.60 V时,AAOB(厌氧氨氧化菌)的活性为91.10 mg/(g·d)(以NH₄+-N计);EEZVI-UASB中的优势功能菌主要为Pseudomonas属,其菌属16S rDNA的PCR扩增相似性达97%;系统中同时存在着反硝化、anammox、甲烷化等反应;其中anammox占主导作用,其对TN去除率的贡献率为54.10%~93.30%,反硝化及其他反应对TN去除率的贡献率为6.70%~45.90%.      

Granulation of gibbsite with inorganic binder and its ability to adsorb Mo(VI) from aqueous solution

In this study, we prepared a new adsorbent and evaluated its ability to adsorb Mo(VI). Gibbsite was granulated with colloidal alumina or colloidal silica. The amount of Mo(VI) adsorbed onto granular gibbsite with a binder, effect of contact time and pH on the adsorption of Mo(VI), and column experiments were investigated. The amount of Mo(VI) adsorbed was greater in the order of ST12 (colloidal silica, 12%)?相似文献   

静电纺PA6/PET复合膜的制备及其空气过滤性能

主要研究静电纺纳米/微米纤维复合膜(PA6/PET)的制备及其空气过滤性能,电纺了几种不同密集度的复合膜,研究了其对氯化钠粒子在特定条件下的过滤能力,进行了加载过滤测试,并通过扫描电子显微镜(SEM)对过滤前后纤维膜的表面形态进行观察.结果表明,对于多分散的NaCl粒子来说,过滤材料的过滤效率随着过滤时间的增加而增加.当增大过滤粒子流量时,过滤阻力与流量呈现线性增长关系,但是过滤效率变化不大.本实验中复合膜的最低过滤效率为99.990%.     

废水处理系统中生物聚集体胞外多聚物研究进展

胞外多聚物(Extracellular polymeric substances,EPS)是废水生物处理系统中生物聚集体(包括絮体污泥、生物膜、颗粒污泥等)的重要组成部分,直接包裹于微生物细胞壁外,其理化性质及所处的特殊位置决定了它在生物聚集体中的重要作用.综述了EPS对废水生物处理系统污泥沉降性能、脱水性以及膜生物反应器膜污染影响的相关研究,分析认为EPS组成与结构特性改变污泥表面电位、疏水性等,进而影响污泥沉降与脱水性能、膜污染程度;以好氧颗粒污泥为典型的生物聚集体代表,总结了EPS组分含量与分布对颗粒污泥的形成与结构稳定性的影响,并在EPS提取方法标准化、现代理化技术与分子生物学技术综合分析等方面进行了展望,进一步的研究有望揭示生物絮凝体形成过程EPS的产生与调控机制.     

砂柱对济南城市屋面雨水径流净化效果的试验

针对屋面雨水回灌裂隙岩溶含水层要求快速量大和水质要求高的特点,设计了相适宜的砂滤柱.采用室内砂滤试验研究了济南市屋面雨水径流回灌裂隙岩溶含水层之前的雨水净化效果.结果表明,砂柱对屋面雨水径流污染物有明显的去除效果,浊度的平均去除率达到87%,悬浮物的平均去除率达到70%以上,对色度、挥发酚、Pb和Zn也有一定的去除效果,对NH3-N、NO2-N的去除效果较差.浊度、色度和悬浮物等大部分污染物的去除主要集中在上层完成,因此,砂柱的上层需要定期更换.