Flue gas treatability studies: a tool for techno-economic control of industrial air pollution

Air pollution problems in developing countries have gained larger fraction in the last decade especially due to non functioning and non implementation of effective air pollutioncontrol devices in industries. In industrial wastewater management, adequate treatability studies are conducted to arrive at a techno-economic treatment option. However no suchstudies were done for reducing air pollution or emission fromindustries until now in India. Little information was availableabout such studies in other countries. This article provides information about a novel technique known asflue gas treatability studies and to undertake such studies, a pilot scale system is installed in Air Pollution Control Divisionof M/s National Environmental Engineering research Institute, NEERI, Nagpur-20, India. This study is a tool for techno-economicselection of air pollution control systems specially for small/medium scale industrial emissions.     

Multipoint source method in air pollution modelling of cold start emission

The paper presents a new method of air pollution modelling on a micro scale. For estimation of concentration of car exhaust pollutants, each car is treated as an instantaneous moving emission source. This approach enables us to model time and spatial changes of emission, especially during cold and cool start of an engine. These stages of engine work are a source of significant pollution concentration in urban areas. In this work, two models are proposed: one for the estimation of emission after cold start of the engine and another for the prediction of pollutant concentration. The first model (defined for individual exhaust gas pollutants) enables us to calculate the emission as a function of time after the cold or cool start, ambient temperature and average speed of motion. This model uses the HBEFA database. The second mathematical model is developed in order to calculate the pollutant dispersion and concentrations. The finite volume method is applied to discretise the set of partial differential equations describing wind flow and pollutant dispersion in the domain considered. Models presented in this paper can be called short-term models on a small spatial scale. The results of numerical simulation of pollutant emission and dispersion are also presented.     

城市高架道路建设对机动车尾气污染的影响分析

通过现场观测和对比，分析了城市一般道路上和城市高架道路下机动车排放污染物浓度差异的原因，分析结果表明，扩散条件对城市机动车尾气污染有着重要影响，例举日本对城市高架道路建设的有关规定，提出应重视城市高架道路建设的环境预评估等。     

用液相催化法和脱硫除尘器脱除烟气中SO_2

在由旋风水膜和两块旋流塔板组成的处理气量为７５０ｍ￣３／ｈ的二级脱硫除尘器中，进行了用含催化剂Ｍｎ￣（２＋）的水溶液吸收ＳＯ_２的扩大试验。结果表明，在确定的条件下，脱硫率达到７３％，板效率为０．２５～０．２８。在同一设备中同时完成除尘与脱硫过程，设备投资少；以水为吸收剂，运行费用低；中性条件下吸收，长期运转不结垢，可靠性高。     

钢铁企业富余煤气制甲醇与二甲醚的研究

利用钢铁联合企业的富余煤气,制甲醇与二甲醚.提出合理可行的工艺方案,进行主要物料消耗计算和成本估算,得出在工艺上和经济上可行的结论.项目的实施,能实现钢铁联合企业资源综合利用,提高企业的经济效益,同时对实现能源的多样化、发展新型清洁能源、改善生态环境都具有重要意义,其经济效益和社会效益显著.     

黄磷尾气中单质磷的测定

研究了测定黄磷尾气中单质磷的分析方法 ,该方法具有灵敏度高 ,线性好 ,操作快速、简便的特点 ,检测限 1μg 5mL ,摩尔吸光系数为 4 5× 10 4L mol·cm ,线性相关系数为 0 9998     

中国能源的现状

研究中国能源的现状，其中主要包括能源储量和能源生产以煤为主；石油和天然气在能源构成中的比例低下；煤炭储量可观，但品质不高；能源生产增长迅速；能源短缺。尤其是清洁能源短缺，清洁能源危机将会长期存在。我国如此的能源现状已造成大气环境煤烟型严重污染。我国从石油输出国已变成石油进口国，我国半个多世纪以来实施的“能源自给政策”急需调整。采用洁净煤技术开发利用清洁能源，确保经济在持续迅速发展的同时，我国大气环境免遭污染，即经济发展和大气环境保护双赢。     

Methane emission in a rice field of Thailand

ＭｅｔｈａｎｅｅｍｉｓｓｉｏｎｉｎａｒｉｃｅｆｉｅｌｄｏｆＴｈａｉｌａｎｄ￥ＲｏｎｇＸｉａｎｇ；Ｃｈｕｅｎ－ＨｏｗＮｇ（ＥｎｖｉｒｏｎｍｅｎｔａｌＥｎｇｉｎｅｅｒｉｎｇＰｒｏｇｒａｍ，ＳｃｈｏｏｌｏｆＥｎｖｉｒｏｎｍｅｎｔ，ＲｅｓｏｕｒｃｅｓａｎｄＤ...     

唐钢2×150t转炉煤气回收系统设计及运行实践

在此较详细地介绍了唐钢一炼钢厂 2× 15 0t转炉煤气回收湿法除尘工艺和系统的技术特点。该系统设计吸收了国内外大型转炉煤气回收的经验。经近 18个月的生产实践 ;认为效果良好 ,煤气回收率近 80 % ,热值近 80 0 0kJ Nm3,放散排放浓度小于 80mg m     

H酸综合废水治理工艺试验研究及工程应用

针对H酸母液及T酸一次洗水高含盐量有机废水进行系统的实验研究，结果表明：废水经冷却、结晶、过滤后，用铁屑过滤，石灰乳、PAM处理．使废水COD去除率为50％，脱色率为7O％，BOD／CODcr提高到0．2以上，预期COD去除率达60％以上，BOD去除率达85％以上，NH3—N去除率达80％以上．