关于医疗垃圾飞灰中二噁英在惰性气氛下的低温热脱附研究

以医疗垃圾焚烧炉布袋除尘器前管道内飞灰(BG)及布袋除尘器后飞灰(AG)为对象,研究不同温度及时间段下其在管式炉中的热脱附特性.结果表明,在低温氮气气氛下,热脱附作用较为明显,2种飞灰中的二噁英都有了不同程度的脱除,其中布袋前飞灰中二噁英的脱除率为82.9%～99.9%之间,毒性当量脱除率为77.3%～99.8%,布袋后飞灰中二噁英的脱除率为66.8%～99.8%之间,毒性当量脱除率为43.5%～99.6%.检测收集到的实验尾气,发现了二噁英的存在,且在300～350℃这个温度段生成量最多,且生成的有毒二噁英同系物中以OCDD为主.通过比较发现,当温度为400℃,加热时间为45 min时2种飞灰中的二噁英脱除效率最高.鉴于惰性气氛下的热脱附对处理飞灰中的二噁英具有较好的作用,可将其大规模应用于实际工程中.     

放射性废水的膜处理技术研究进展

核燃料的生产、核电厂的运行、同位素的生产和使用等过程都会产生着大量的放射性废水,为了保护环境和人类健康,这些废水必须经过安全、经济和有效的处理处置.放射性废水传统的处理方法主要包括过滤法、离子交换法、蒸发法或这几种工艺的组合.近年来,膜分离技术在放射性废水处理中得到了广泛的研究,发达国家已有应用膜分离技术处理放射性废水的实例,而我国规模化应用的实例还很少见.本文首先介绍了放射性废水的来源及组成,分析了各种放射性废水处理方法的优势和不足,包括化学沉淀法、过滤法、离子交换法、蒸发浓缩法、吸附法、生物还原/吸附法和膜分离法等.在此基础上,重点介绍了各种膜分离技术,包括微滤、超滤、纳滤、反渗透、膜蒸馏等在放射性废水处理中研究与应用现状,对已有的文献资料进行了较系统全面的分析、归纳和总结,对各种方法的优缺点及适用范围进行了比较,对膜技术在放射性废水处理中的应用前景及问题进行了讨论.最后,简要介绍了放射性废水处理产生的浓缩产物的最终处理处置,对放射性废水处理技术未来的研究和发展方向给出了建议.     

呼和浩特市可镇污水处理厂工程设计

呼和浩特市可镇污水处理厂近期建设规模1.0×104m3/d,远期总规模2.5×104m3/d。污水处理主体工艺采用组合式A2/O生化池+砂滤,污泥处理采用污泥贮池+带式浓缩脱水一体机,尾水采用液氯消毒,设计出水水质执行GB 18918—2002《城镇污水处理厂污染物排放标准》一级A排放标准。介绍了该工程的工艺流程、设计参数,总结分析了工艺设计的技术特点。同时阐述了针对低温条件下的运行保障措施和要求,为寒冷地区同类污水处理厂的设计提供参考和借鉴。     

乙醇处理对树脂基纳米水合氧化铁结构及其除砷性能的影响

通过考察乙醇处理对树脂基纳米水合氧化铁(D201-HFO)结构及其除砷性能的影响,评价乙醇处理在复合材料制备中的必要性.结果表明,乙醇处理后负载水合氧化铁(HFO)在D201树脂内的分散性增加,材料对砷的饱和吸附量提高约20%,且复合材料的比表面积、孔容、孔径分别增加了52%、65%、28%;但乙醇处理对复合材料的机械强度和负载HFO的晶型无影响,在pH值、离子竞争对该材料除砷性能的影响趋势方面也无明显作用,对复合材料固定床除砷性能及再生方面也无明显作用.总体而言,乙醇处理对D201-HFO复合材料实际除砷性能影响不大,从技术经济性考虑可以省略.     

Application of comprehensive two-dimensional gas chromatography with mass spectrometric detection for the analysis of selected drug residues in wastewater and surface water

Pharmaceutical residues have become tightly controlled environmental contaminants in recent years, due to their increasing concentration in environmental components. This is mainly caused by their high level of production and everyday consumption. Therefore there is a need to apply new and sufficiently sensitive analytical methods, which can detect the presence of these contaminants even in very low concentrations. This study is focused on the application of a reliable analytical method for the analysis of 10 selected drug residues, mainly from the group of non-steroidal anti-inflammatory drugs (salicylic acid, acetylsalicylic acid, clofibric acid, ibuprofen, acetaminophen, caffeine, naproxen, mefenamic acid, ketoprofen, and dicofenac), in wastewaters and surface waters. This analytical method is based on solid phase extraction, derivatization by N-methyl-N-(trimethylsilyl)trifluoroacetamide (MSTFA) and finally analysis by comprehensive two-dimensional gas chromatography with Time-of-Flight mass spectrometric detection (GC×GC- TOF MS). Detection limits ranged from 0.18 to 5 ng/L depending on the compound and selected matrix. The method was successfully applied for detection of the presence of selected pharmaceuticals in the Svratka River and in wastewater from the wastewater treatment plant in Brno-Modrice, Czech Republic. The concentration of pharmaceuticals varied from one to several hundreds of ng/L in surface water and from one to several tens of μg/L in wastewater.     

BTEX pollution caused by motorcycles in the megacity of HoChiMinh

Monitoring of benzene, toluene and xylenes (BTEX) was conducted along with traffic counts at 17 roadside sites in urban areas of HoChiMinh. Toluene was the most abundant substance, followed by p,m-xylenes, benzene, o-xylene and ethylbenzene. The maximum observed hour-average benzene concentration was 254 μg/m3 . Motorcycles contributed to 91% of the traffic fleet. High correlations among BTEX species, between BTEX concentrations and the volume of on-road motorcycles, and between inter-species ratios in air and in gasoline indicate the motorcycle-exhaust origin of BTEX species. Daily concentrations of benzene, toluene, ethylbenzene, p,m-xylenes and o-xylene were 56, 121, 21, 64 and 23 μg/m 3 , respectively. p,m-xylenes possess the highest ozone formation potential among the BTEX family.     

含铬废水的处理技术及机理简述

介绍了废水中六价铬的来源及存在形态,以及处理含铬废水的物理、物化、化学及生物等各种工艺,并对各种工艺的机理和优缺点进行分析,展望含铬废水的治理前景。     

Effect of ammonium on nitrous oxide emission during denitrification with different electron donors

Nitrous oxide(N2O) emission during denitrification is receiving intensive attention due to its high potential to cause greenhouse effects.In this study,denitrifiers were acclimated in sequencing batch reactors with methanol or acetate as the electron donor and nitrate as the electron acceptor.The effects of ammonium on N2O emission were examined in batch experiments with various electron donors.With the addition of ammonium,N2O emission increased under all the examined conditions compared to experiments without ammonium addition.With different electron donors,the highest ratio of N2O emission to the removed oxidized nitrogen was 0.70% for methanol,5.34% for acetate,and 34.79% for polyhydroxybutyrate.     

Biodegradation by bioaugmentation of dairy wastewater by fungal consortium on a bioreactor lab-scale and on a pilot-scale

A fungal consortium including Aspergillus niger, Mucor hiemalis and Galactomyces geotrichum was tested for the treatment of dairy wastewater. The bio-augmentation method was tested at lab-scale (4 L), at pilot scale (110 L) and at an industrial scale in Wastewater Treatment Plants (WWTP). The positive impact of fungal addition was confirmed when fungi was beforehand accelerated by pre-culture on whey (5 g/L lactose) or on the dairy effluent. Indeed, chemical oxygen demand (COD) removal yields increased from 55% to 75% for model medium, diluted milk. While after inoculation of an industrial biological tank from a dairy factory with the fungal consortium accelerated by pre-cultivation in a 1000 L pilot plant, the outlet COD values decreased from values above the standard one (100 mg/L) to values in the range of 50-70 mg/L. In addition, there was a clear impact of fungal addition on the ’hard’ or non-biodegradable COD owing to the significant reduction of the increase of the COD on BOD 5 ratio between the inlet and the outlet of the biological tank of WWTP. It was in the range of 451%-1111% before adding fungal consortium, and in the range of 257%-153% after bio-augmentation with fungi. An inoculated bioreactor with fungal consortium was developed at lab-scale and demonstrated successfully at pilot scale in WWTP.     

Iron and lead ion adsorption by microbial flocculants in synthetic wastewater and their related carbonate formation

Although microbial treatments of heavy metal ions in wastewater have been studied, the removal of these metals through incorporation into carbonate minerals has rarely been reported. To investigate the removal of Fe^3＋ and Pb^2＋, two representative metals in wastewater, through the precipitation of carbonate minerals by a microbial flocculant （MBF） produced by Bacillus mucilaginosus. MBF was added to synthetic wastewater containing different Fe^3＋ and Pb^2＋ concentrations, and the extent of flocculation was analyzed. CO2 was bubbled into the mixture of MBF and Fe^3＋/Pb^2＋ to initiate the reaction. The solid substrates were analyzed via X-ray diffraction, transmission electron microscopy and energy dispersive spectroscopy. The results showed that the removal efficiency decreased and the MBF adsorption capacity for metals increased with increasing heavy metal concentration. In the system containing MBF, metals （Fe^3＋ and Pb^2＋）, and CO2, the concentrated metals adsorbed onto the MBF combined with the dissolved CO2, resulting in oversaturation of metal carbonate minerals to form iron carbonate and lead carbonates. These results may be used in designing a method in which microbes can be utilized to combine CO2 with wastewater heavy metals to form carbonates, with the aim of mitigating environmental problems.