爆破荷载作用下隧道中隔岩稳定性研究

为研究爆破动力荷载作用下隧道中隔岩稳定性评价标准,以福州地铁2号线为工程背景,结合强度折减动力分析法和数值模拟,同时考虑中隔岩塑性区贯通、位移超过规范值、计算不收敛3种判据,综合对隧道中隔岩进行动力安全系数分析,研究隧道不同净距、不同开挖进尺后行洞隧道爆破开挖对隧道整体安全系数的影响。研究结果表明:中隔岩塑性区贯通时特征点位移和规范中位移限值较为接近,可共同作为评价中隔岩稳定性的最终评价标准;隧道净距越大、进尺越小,隧道整体安全系数越高;对围岩质量较差且净距小于1.6 m的双线隧道进行爆破开挖时,建议将爆破进尺控制在2 m以内。研究结果可为类似工程提供理论参考依据。     

开敞空间可燃气云爆炸冲击波超压及灾害动力响应研究评述

为了进一步梳理和分析开敞空间可燃云爆炸冲击波超压传播规律及灾害动力响应方面的各项研究成果,推进可燃气体爆炸安全防控,减少人员伤亡和经济损失。在分析现有研究的基础上,总结开敞空间可燃气云爆炸冲击波超压传播规律及灾害动力响应研究等方面存在的不足,提出开敞空间多元混合气体爆炸冲击波超压传播规律研究、多影响参数下可燃气云爆炸冲击波超压传播规律定量分析、基于可燃气云爆炸冲击波超压作用下的承载体动力响应等未来研究的关键技术问题。     

空间阻塞对室内燃气泄漏爆炸影响研究

以餐饮企业的熟食操作间为例建立物理模型,通过CFD方法模拟不同空间阻塞度下天然气泄漏爆炸情形。研究结果表明:阻塞率在99.95%~100%时,燃气浓度呈现反抛物线式上升。空间阻塞率在99.982%时（开敞面积1 m2）,泄漏1 200 s,熟食操作间燃气浓度值可达6%;空间阻塞率在99.955%（开敞面积2.5 m2）~100%时,燃气爆炸后熟食操作间内产生的超压最大值均大于30 kPa;当空间阻塞率在99.991%（开敞面积0.5 m2）~100%时,设定工况下爆炸超压随空间阻塞率呈指数式增加。研究认为,空间阻塞率在99.95%以上,燃气泄漏极易形成可燃蒸汽云,发生爆炸产生冲击波超压能够毁坏建筑物,在生产和生活中,对于有燃气使用的空间,应尽可能降低空间阻塞率,以避免可能的燃气泄漏形成危险域和爆炸形成过高冲击波超压。     

惰性粉体对蔗糖粉尘最小点火能的影响研究

为了预防蔗糖粉尘爆炸,利用1.2 L哈特曼管研究了NH₄H₂PO₄与Al(OH₄对蔗糖粉尘爆炸的抑制作用。在蔗糖粉尘质量分数一定的条件下,通过改变 NH₄H₂PO₄与Al(OH)₄的粒径和质量分数,测定其对蔗糖粉尘爆炸的抑制效果。结果表明:随着NH₄H₂PO₄和Al(OH)₄质量分数的增加,粒径的减小,蔗糖粉尘的最小点火能均逐渐增大,当惰性粉体增加到一定质量时,蔗糖粉尘被完全惰化,在蔗糖粉尘中分别加入粒径为48~74,38~47,25~37 μm的NH₄H₂PO₄和Al(OH)₄,3种粒径的NH₄H₂PO₄使蔗糖粉尘完全惰化的质量分数分别为40%,35%,30%,3种粒径的Al(OH)₃使蔗糖粉尘惰化的质量分数均为60%。因此(NH₄)H₂PO₄抑制蔗糖粉尘爆炸的效果比Al(OH)₃更显著。     

陆上原油长输管道泄漏爆炸事故情景构建研究

以某陆上原油长输管道为例,设定了陆上原油长输管道泄漏爆炸事故情景背景信息及演化过程,从预防、准备、预警、响应、恢复等阶段,梳理分析了事故情景应对全过程的任务及职责主体;针对各项任务从计划预案、人员队伍、装备物资、培训演练、运行机制等方面开展了情景应对能力评估;并针对存在的差距和不足,从企业和政府2个层面提出了针对此类情景的应急能力提升对策建议。该研究可为相关政府及企业加强油气长输管道事故应急准备能力建设提供参考。     

Law of variation for low density polyethylene dust explosion with different inert gases

To reveal the effects of different inert gases on explosion characteristics during low density polyethylene (LDPE) dust explosion and optimize the explosion-proof process, eight N₂ (CO₂)/air mixed inerting conditions were experimentally studied. Typical inerting conditions with 12 L cylindrical explosive tank were used to study the characteristics on the flame propagation. The thermogravimetric analysis with related theories were used to further explain the mechanism and quantities in low density polyethylene (LDPE) dust explosion with different inert gases. The results showed that the reduction of O₂ concentration could effectively delay the progress of flame growth process and weaken the effect of dust combustion reaction. The flame growth process of condition (N₂/air (18% O₂)) was 2.05 times slower than that of the non-inert condition. The explosion strength was obviously reduced, and the characteristic parameters such as explosion pressure and flame propagation speed were also affected by the decrease of O₂ concentration. For LDPE powder, the smaller the median diameter, the greater the explosion intensity and the lower the limiting oxygen content (LOC). The LOC with CO₂ was usually higher than that with N₂ and the effect of CO₂ was significantly better than N₂ in inerting.     

Ignition temperatures of dust layers and bulk storages in hot environments

In many industrial installations, particulate solids (cereals, agri-food products, coal, plants, etc.) are stored or processed. Self-heating of these products, which can lead to fires and explosions, can occur in a variety of situations. Examples include large storage at room temperature, formation of a layer on a hot surface, layer deposited on a surface – insulating or conductive – in a hot environment or even storage of product exposed to heating on one side.The main parameters that determine the occurrence of self-heating are the size of the container, the temperature, the residence time and the characteristics of the product. Depending on the type of situation encountered and these implementation conditions, the analysis of self-heating risks must be based on specific models and/or parameters.This paper presents the different variants and combinations of the theoretical model from the theory of thermal runaway to represent self-heating, taking into account in particular the symmetry or asymmetry of heating, reagent consumption and boundary conditions. It also discusses their adaptation to the previous identified industrial situations.Nine products were chosen to be representative of those used in the different considered industrial situations. They were subjected to self-heating basket tests in isothermal ovens in order to determine the parameters for applying the described theoretical models. These results were compared with the results of self-heating tests in layers of different thicknesses in a hot environment, on an insulating or conductive plate, using a specially developed test protocol, as well as with the results of standardized tests of minimum ignition temperature in 5 mm layers.This led to the proposal of the most appropriate theoretical model to represent the self-heating phenomenon for each of the four identified industrial situations.This analysis can promote better design of industrial equipment and production conditions (temperatures, volumes or product flows …) in order to prevent fires and explosions.     

Ecological modelling of nitrate pollution in small river basins by spreadsheets and GIS

With the increasing importance and awareness of water quality in the small basins, the modelling system is developed for monitoring and predictions of surface water pollution. The compartment model deals with basin characteristics extended by land cover attributes. The parameters of the model are estimated by experimental data of water quality together with land cover types that serve as nutrient detention media or transformers. The study examines methodology to determine the potential areas of nitrate pollution from point and non-point sources by remote sensing techniques. Classification of water, agricultural, forest and urban areas is processed with satellite images (LANDSAT 7). Whereas the agricultural and urban areas act as sources of pollution, forest zones operate as sinks. The nitrate levels are decreased downstream, if the proportion of the forest inside contribution zones increases. The modelling system is used to simulate amounts of nitrates in each compartment of the stream during the monitored period of one year. The number of compartments and their lengths are estimated on the basis of morphology of the basin. Simulation of the dynamic model is carried out with the TabSim. Geographic information system (GIS) and remote sensing tools are used to manage and estimate nitrate inflows from point and non-point sources of pollution. The article presents the spatial and time variation of the nitrate (NO₃⁻) within the basin of the stream Rakovnický (the west part of Bohemia, the whole area of 368 km²). It is shown that the model approach extended by the GIS and remote sensing can support decision-making process for better management practices in the basins.     

水污染源特性查定程序

本文对水污染湖源特性查定的程序以及查定中遇到的技术问题和解决办法进行了论述，为污染源查定工作科学化，规范化进行了有益探索。     

上海市松江镇饮用水水源区的保护与环境管理方案

保护集镇饮用水河流是当前水污染防治工作的重点。本文通过现状分析，针对城乡结合部河流以面源为主的特点，找出影响饮用水河流水质的主要污染源及污水排放特征．用系统分析方法，将集镇的经济、人口、环境统计资料作为环境管理模型的主要输入信息，经计算机仿真，得出保护水源水质应采取的对策与治理方案。