次氯酸钙预处理对污泥厌氧发酵合成中链脂肪酸的影响研究

探究了次氯酸钙(Ca(ClO)₂)预处理对活性污泥厌氧发酵合成中链脂肪酸(MCFAs)的影响,结果表明Ca(ClO)₂能显著提高污泥的降解性能,且发酵液中可溶性有机物增量与Ca(ClO)₂浓度梯度呈正相关.当预处理浓度为80 mg·g^-1时,产出MCFAs浓度达到峰值(5691.9 mg·L^-1),是空白组的2.6倍.然而,更高Ca(ClO)₂(240 mg·g^-1)预处理浓度下其对污泥中的微生物过程(水解、酸化过程)的抑制作用导致MCFAs产出浓度有所降低.本研究为拓展污泥高值化处理技术提供了新思路.     

水中微量甲基膦酸类化合物的树脂富集与GC／MS分析

本文使用三种阴离子交换树脂（即大孔弱碱型Ｄ－３０１－Ｒ,强碱型Ｄ－２９６,２０１Ｘ７）柱对水中微量甲基膦酸类化合物的富集方法进行了研究。含磷毒剂降解产物的水样用气相色谱／质谱法进行定性定量分析。结果表明,Ｄ－３０１－Ｒ阴离子交换树脂柱对甲基膦酸的富集回收率高于６０％。     

Determination of total organic halogen (TOX) in humic acids after microwave-induced combustion

Chemically chlorinated organic matter as well as natural background humic acids contain significant amounts of organically bound halogens that must be determined for assessment of environmental pollution. In this work the use of ion chromatography (IC) and inductively coupled plasma mass spectrometry (ICP-MS) is proposed for the determination of total organic Cl, Br and I concentration in humic acids extracted from various forest soil horizons after a single digestion by microwave-induced combustion (MIC). Samples were pressed as pellets and combusted using 20 bar of oxygen and ammonium nitrate solution as igniter. Analytes were absorbed in diluted alkaline solution (50 mM (NH₄)₂CO₃) and a reflux step was applied after combustion to improve analyte recoveries (5 min, microwave power of 1400 W). The accuracy was evaluated using certified reference materials (CRM) and spiked samples. Using MIC the agreement with CRM values and spike recoveries was higher than 97% for all analytes. As an advantage over conventional procedures, using MIC it was possible to digest up to eight samples in only 25 min, obtaining a single solution suitable for all halogens determination in humic acids samples by different techniques (IC and ICP-MS). The limit of detection (3σ) for Cl, Br and I obtained by IC was 1.2, 2.5 and 4.3 μg g⁻¹ and by ICP-MS it was 1.4, 0.03 and 0.002 μg g⁻¹, respectively.     

Parathion degradation and its intermediate formation by Fenton process in neutral environment

The purpose of this study is to investigate parathion degradation by Fenton process in neutral environment. The initial parathion concentration for all the degradation experiments was 20 ppm. For hydrogen ion effect on Fenton degradation, the pH varied from 2 to 8 at the [H₂O₂] to [Fe²⁺] ratio of 2-2 mM, and the result showed pH 3 as the most effective environment for parathion degradation by Fenton process. Apparent degradation was also observed at pH 7. The subsequent analysis for parathion degradation was conducted at pH 7 because most environmental parathion exists in the neutral environment. Comparing the parathion degradation results at various Fenton dosages revealed that at Fe²⁺ concentrations of 0.5, 1.0 and 1.5 mM, the Fenton reagent ratio ([H₂O₂]/[Fe²⁺]) for best-removing performance were found as 4, 3, and 2, resulting in the removal efficiencies of 19%, 48% and 36%, respectively. Further increase in Fe²⁺ concentration did not cause any increase of the optimum Fenton reagent ratio for the best parathion removal. The result from LC-MS also indicated that hydroxyl radicals might attack the PS double bond, the single bonds connecting nitro-group, nitrophenol, or the single bond within ethyl groups of parathion molecules forming paraoxons, nitrophenols, nitrate/nitrite, thiophosphates, and other smaller molecules. Lastly, the parathion degradation by Fenton process at the presence of humic acids was investigated, and the results showed that the presence of 10 mg L⁻¹ of humic acids in the aqueous solution enhanced the parathion removal by Fenton process twice as much as that without the presence of humic acids.     

Naphthenic acid biodegradation by the unicellular alga Dunaliella tertiolecta

Naphthenic acids (NAs) are a major contributor to toxicity in tailings waste generated from bitumen production in the Athabasca Oil Sands region. While investigations have shown that bacteria can biodegrade NAs and reduce tailings toxicity, the potential of algae to biodegrade NAs and the biochemical mechanisms involved remain poorly understood. Here, we discovered that the marine alga Dunaliella tertiolecta is able to tolerate five model NAs (cyclohexanecarboxylic acid, cyclohexaneacetic acid, cyclohexanepropionic acid, cyclohexanebutyric acid and 1,2,3,4-tetrahydro-2-naphthoic acid) at 300 mg L⁻¹, a level which exceeds that of any single or combination of NAs typically found in tailings ponds. Moreover, we show that D. tertiolecta can metabolize four of the model NAs. Analysis of NA-amended cultures of D. tertiolecta via low resolution gas chromatography-mass spectrometry allowed us to quantify decreasing NA levels, identify metabolites, and formulate putative mechanisms of biodegradation. Degradation of cyclohexanebutyric acid and cyclohexanepropionic acid proceeded via β-oxidation and resulted in the transient accumulation of cyclohexaneacetic acid and cyclohexanecarboxylic acid, respectively. Cyclohexanecarboxylic acid was metabolized via 1-cyclohexenecarboxylic acid suggesting that further degradation may occur by step-wise β-oxidation. When D. tertiolecta was inoculated in the presence of oil sands tailings water from the Athabasca region, biodegradation of single-ring NAs was observed relative to controls. This result corroborates the trend we observed with the single-ring model NAs.     

Parameters affecting the stability of the digestate from a two-stage anaerobic process treating the organic fraction of municipal solid waste

This paper focused on the factors affecting the respiration rate of the digestate taken from a continuous anaerobic two-stage process treating the organic fraction of municipal solid waste (OFMSW). The process involved a hydrolytic reactor (HR) that produced a leachate fed to a submerged anaerobic membrane bioreactor (SAMBR). It was found that a volatile solids (VS) removal in the range 40-75% and an operating temperature in the HR between 21 and 35 °C resulted in digestates with similar respiration rates, with all digestates requiring 17 days of aeration before satisfying the British Standard Institution stability threshold of 16 mg CO₂ g VS⁻¹ day⁻¹. Sanitization of the digestate at 65 °C for 7 days allowed a mature digestate to be obtained. At 4 g VS L⁻¹ d⁻¹ and Solid Retention Times (SRT) greater than 70 days, all the digestates emitted CO₂ at a rate lower than 25 mg CO₂ g VS⁻¹ d⁻¹ after 3 days of aeration, while at SRT lower than 20 days all the digestates displayed a respiration rate greater than 25 mg CO₂ g VS⁻¹ d⁻¹. The compliance criteria for Class I digestate set by the European Commission (EC) and British Standard Institution (BSI) could not be met because of nickel and chromium contamination, which was probably due to attrition of the stainless steel stirrer in the HR.     

Effects of carboxylic acids on nC60 aggregate formation

The discovery that negatively charged aggregates of C₆₀ fullerene (nC₆₀) are stable in water has raised concerns regarding the potential environmental and health effects of these aggregates. In this work, we show that nC₆₀ aggregates produced by extended mixing in the presence of environmentally relevant carboxylic acids (acetic acid, tartaric acid, citric acid) have surface charge and morphologic properties that differ from those produced by extended mixing in water alone. In general, aggregates formed in the presence of these acids have a more negative surface charge and are more homogeneous than those produced in water alone. Carboxylic acid identity, solution pH, and sodium ion concentration, which are all intricately coupled, play an important role in setting the measured surface charge. Comparisons between particle sizes determined by analysis of TEM images and those obtained by dynamic light scattering (DLS) indicate that DLS results require careful evaluation when used to describe nC₆₀ aggregates.     

The effects of LMWOAs on biodegradation of multi-component PAHs in aqueous solution using dual-wavelength fluorimetry

Biodegradation of dissolved fluorene (Flu), phenanthrene (Ph) and pyrene (Py), three polycyclic aromatic hydrocarbons (PAHs), singly or as a mixture of the three, by two bacterial strains, MEBIC 5140 (Mycobacterium flavescens) and MEBIC 5141 (Mycobacterium scrofulaceum), as well as the effects of low molecular weight organic acids (LMWOAs), e.g. malic acid, citric acid and butyric acid on biodegradation of the three PAHs in mineral salts medium aqueous solution were investigated using a newly established dual-wavelength fluorimetric method. The results showed that biodegradation processes can be monitored simultaneously, quickly and simply by dual-wavelength fluorimetry. Both co-metabolism and inhibitory effects were found during the biodegradation of the three PAHs by MEBIC 5140 and MEBIC 5141. Positive effects of butyric acid and negative effects of citric acid on biodegradation of the three PAHs in a mixture were observed.     

剩余污泥超声预处理后水解酸化特性

为探讨剩余污泥超声预处理后的水解酸化特性,考察了0.6 W/mL、5 min和1 W/mL、5 min 2种超声预处理条件下污泥水解酸化过程有机质、氮、磷的释放情况。实验结果表明,2种超声预处理均可促进污泥水解酸化,并且0.6 W/mL比1 W/mL的超声预处理更有利于SCOD的释放、VFAs的产生以及氮和磷的释放;水解酸化初期,超声预处理比未经超声预处理的污泥在有机质、氮、磷释放率上差异非常明显,随着水解酸化的进行,有机质和氮释放率差异仍很明显,而磷释放程度逐渐接近;经0.6 W/mL超声预处理,污泥水解酸化3 d后,SCOD释放率、VFAs浓度、TN释放率和NH4+-N释放率分别是未经处理污泥的1.85、2.63、1.85和1.41倍,而TP和PO43--P释放率较未经处理污泥仅分别多2.44和1.23个百分点。研究表明,控制适宜的声能密度、超声时间和水解酸化进程是超声预处理强化剩余污泥水解酸化效果的关键。