空气质量AQI实时发布的改进探讨

针对《环境空气质量指数(AQI)技术规定(试行)》(HJ 633-2012)中对空气质量AQI实时发布存在的欠缺,从增加颗粒物1 h浓度的AQI分级浓度限值及颗粒物24 h滑动平均值计算方法改进着手,解决PM2.5和PM10的24 h滑动平均值实时延迟、1 h平均值代替24 h滑动平均值偏高等问题。     

碱片-离子色谱法测定硫酸盐化速率影响因素

采用碱片-离子色谱法测定空气的硫酸盐化速率,方法在硫酸盐质量浓度为1.00~20.0 mg/L范围内线性良好(r≥0.999 0);碱片剪碎或不剪碎对空白碱片中硫酸根离子质量浓度的测定无明显影响,且高低两种加标浓度的回收率均在80.0%~120%之间;对于碱片实际样品,碱片剪碎更有利于硫酸根离子的快速溶出;随浸泡时间的延长,碱片中溶出的硫酸根离子质量浓度呈上升趋势,7 h硫酸根离子基本溶出完全,从保证结果质量和节省时间的角度考虑,确定最佳浸泡时间为3.5 h,建议碱片全部采取剪碎处理。     

精细化工固定源废气采样时机的选择探讨

以某医药企业某产品生产过程为实例,综合各工段生产步骤、时间、废气产生情况及估算的污染物浓度等因素,绘制各污染因子排放规律图,从而确定各污染因子排放浓度(排放量)最大的1 h为最佳采样时机。     

pH值调控柠檬酸污泥厌氧发酵产酸及碳源潜力研究

以柠檬酸废水厌氧颗粒污泥为接种物,在不同pH值调控条件下开展柠檬酸生产废水剩余活性污泥厌氧发酵产酸研究.通过对发酵液挥发性脂肪酸(VFAs)、有机质、氮磷和污泥脱水性能的分析,探讨了柠檬酸污泥厌氧产酸机制.结果表明,pH≥10的碱性条件更有利于有机质的溶出从而促进VFAs的产生.三维荧光光谱分析发现在恒定pH值下腐殖酸(HA)和富里酸(FA)会大量溶出降低VFAs的产量.初始pH=10是柠檬酸污泥厌氧产酸的最佳p H值,发酵4d的VFAs浓度最高达(6681.47±126.82)mgCOD/L,是文献报道中市政污泥产酸量的近2倍,其中乙酸占比49.8%,发酵后产酸功能菌Chloroflexi、Bacteroidota的相对丰度分别由初始的9.52%、10.87%增至16.84%、14.39%,污泥归一化毛细吸水时间(nCST)为(11.34±0.27)s·L/g,脱水性能良好,发酵液TP浓度为(20.45±0.33) mg/L.研究表明,利用柠檬酸剩余活性污泥碱性厌氧发酵产酸作为污水处理过程中的外加碳源具有较大潜力.     

体育馆出口疏散能力的实验研究

为研究出口单位流量与人流时间之间的关系,以某体育馆为例,进行对某一出口常态下的人流观测实验.通过理论计算和建立Cubic回归模型对采集数据进行了统计分析.发现:单位出口流量最大值为2人/(m·s),稳定值为0.8-1.2人/(m·s),最小值为0.2人/(m·s).出口单位流量是人流时间的三次函数.研究结果表明:出口单位流量是随着时间的变化而变化,不是一个定值,而且单位出口流量稳定值分布在初期.本文对性能化防火设计有一定的参考价值.     

Penicillin fermentation residue biochar as a high-performance electrode for membrane capacitive deionization

● We have provided an activated method to remove the toxicity of antibiotic residue. ● PFRB can greatly improve the salt adsorption capacity of MCDI. ● The hierarchical porous and abundant O/N-doped played the key role for the high-capacity desalination. ● A new field of reuse of penicillin fermentation residue has been developed. Membrane capacitive deionization (MCDI) is an efficient desalination technology for brine. Penicillin fermentation residue biochar (PFRB) possesses a hierarchical porous and O/N-doped structure which could serve as a high-capacity desalination electrode in the MCDI system. Under optimal conditions (electrode weight, voltage, and concentration) and a carbonization temperature of 700 °C, the maximum salt adsorption capacity of the electrode can reach 26.4 mg/g, which is higher than that of most carbon electrodes. Furthermore, the electrochemical properties of the PFRB electrode were characterized through cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) with a maximum specific capacitance of 212.18 F/g. Finally, biotoxicity tests have showed that PFRB was non-biotoxin against luminescent bacteria and the MCDI system with the PFRB electrode remained stable even after 27 adsorption–desorption cycles. This study provides a novel way to recycle penicillin residue and an electrode that can achieve excellent desalination.     

A NEW LOOK AT FLOOD RISK DETERMINATION1

ABSTRACT: The probability distributions of annual peak flows used in flood risk analysis quantify the risk that a design flood will be exceeded. But the parameters of these distributions are themselves to a degree uncertain and this uncertainty increases the risk that the flood protection provided will in fact prove to be inadequate. The increase in flood risk due to parameter uncertainty is small when a fairly long record of data is available and the annual flood peaks are serially independent, which is the standard assumption in flood frequency analysis. But standard tests for serial independence are insensitive to the type of grouping of high and low values in a time series, which is measured by the Hurst coefficient. This grouping increases the parameter uncertainty considerably. A study of 49 annual peak flow series for Canadian rivers shows that many have a high Hurst coefficient. The corresponding increase in flood risk due to parameter uncertainty is shown to be substantial even for rivers with a long record, and therefore should not be neglected. The paper presents a method of rationally combining parameter uncertainty due to serial correlation, and the stochastic variability of peak flows in a single risk assessment. In addition, a relatively simple time series model that is capable of reproducing the observed serial correlation of flood peaks is presented.     

ANALYSIS AND MODELING OF LONG-TERM STREAM TEMPERATURES ON THE STEAMBOAT CREEK BASIN,OREGON: IMPLICATIONS FOR LAND USE AND FISH HABITAT1

ABSTRACT: Steamboat Creek basin is an important source of timber and provides crucial spawning and rearing habitat for anadromous steelhead trout (Oncorhynchus mykiss). Because stream temperatures are near the upper limit of tolerance for the survival of juvenile steelhead, the possible long-term effect of clear-cut logging on stream temperatures was assessed. Twenty-year (1969–1989) records of summer stream temperature and flow from four tributaries and two reaches of Steamboat Creek and Boulder Creek (a nearby unlogged watershed) were analyzed. Logging records for the Steamboat Creek basin and air temperature records also were used in the analysis. A time-series model of the components of stream temperature (seasonal cycle of solar radiation, air temperature, streamflow, an autoregressive term of order 1, and a linear trend variable) was fitted to the water-temperature data. The linear trend variable was significant in all the fitted models except Bend Creek (a tributary fed by cool ground-water discharge) and Boulder Creek. Because no trends in either climate (i.e., air temperature) or streamflow were found in the data, the trend variable was associated with the pre-1969 loss and subsequent regrowth of riparian vegetation and shading canopies.     

非时序加权灰色关联分析在环境质量综合评价中的应用

本文根据灰色关联分析的基本性质，提出一种环境质量综合评价的新方法。该方法用待评价样本各指标值组成参考数列，环境质量分级标准值组成被比较数列，通过计算参考数列与被比较数列的关联度，按最优关联识别原则综合评价环境质量等级。用４个实例与其它方法进行了对比，取得满意的效果。     

MFAM模型在河流水质污染模拟及预测中的应用

文中以时间序列分析为基础，介绍了均值生成函数这一崭新概念，并且经成份因子提取分析推导建立了模拟序列的数字模型（简记为MFAM），经对黄河下游花园口断面的1988-1989年实测水质污染指标溶解氧（DO），氨氧，化学耗氧量（COD），五日生化需氧量（BOD5）等序列模拟，结果表明MFAM模型能较好地模拟河流水质污染指标的变化趋势，拟合平均误差只有5.2-6.4%，MFAM模型应用于预测1990-1991年水质污染指标变化，结果表明预测精度达85%以上，文中最后得出结论：MFAM模型应用于河流污染模拟和预测，是完全可行且十分方便。