A／O膜生物反应器处理生活污水的试验研究

根据传统脱氮除磷工艺——好氧硝化缺氧反硝化原理,设计并制作了一种分置式A／O膜生物反应器,并且对其曝气方式进行合理改进,利用射流曝气强大的复氧能力和混合能力,使好氧区的泥水能更加均匀地混合以及能提供充足的氧气。并就其对生活污水中污染物的去除效果及其机制进行了试验研究,结果表明,该改进后的膜生物反应器在连续运行60天内,系统不排泥,水力停留时间为16h时,对COD、总氮、氨氮有良好的去除效果,平均去除率分别达到94％,70．7％,98．4％,出水CODCr、总氮、氨氮浓度分别在50mg／L,15mg／L,1mg／L以下。     

胞外聚合物对MBR中改性无纺布过滤性能的影响

采用统计分析方法研究了胞外聚合物(extra-cellular polymeric sub6tances, EPS)对浸渍式膜生物反应器(submerged membrane bioreactor, SMBR)中聚乙烯醇改性聚丙烯无纺布过滤性能的影响.结果表明,无纺布膜组件表面污泥的溶解性EPS(soluble EPS, EPSs)、EPSs,组成(protein/carbohydrate, P/C)以及相对疏水性(relative hydrophobicity, RH)对膜的过滤性能有显著影响,与膜污染阻力的皮尔逊相关系数(rp)分别为:0.868、0.840、0.890;改性无纺布膜组件能有效抑制EPSs,的吸附、降低EPSs组分中P/C的比率、减少活性污泥的沉积.表明聚丙烯无纺布通过亲水改性后,过滤性能得到明显改善,表现出一定的耐污染性.     

两种膜生物反应器处理印染废水的对比试验研究

针对印染废水成分复杂、色度大、浓度高且生物难降解物质多等特点,采用了混凝沉淀法对印染废水进行预处理,而后分别采用新型海藻式膜生物反应器(MBR)和传统帘式膜生物反应器对印染废水进行活性污泥法处理试验研究。通过对化学需氧量(COD)、生化需氧量(BOD)、氨氮(NH3-N)、总氮(TN)、总磷(TP)、色度、浊度等水质指标连续进行测定、分析与处理,考察两种膜生物反应器对印染废水的降解效果,并观察系统运行情况和膜组件污染状况。试验结果表明:海藻式MBR对印染废水的处理效果良好,出水浊度低于0.3NTU,对COD、BOD、色度、氨氮、总氮的去除率分别可达90%、94%、91.4%、87.8%、86.4%。海藻式MBR在各项指标上均明显优于传统帘式MBR,且能够降低MBR膜丝根部的污染,清洗更方便、更有效。     

反渗透用于APT离子交换废水的处理与回用

试验分别研究了反渗透膜Duraslick RO2540和RE2540-TE对APT冶炼离子交换废水的处理效果。研究结果表明,在最佳压力条件下,Duraslick RO2540膜对Cl-的截留率为91.4%,产水率为16.9%;RE2540-TE膜对Cl-的截留率为93.4%,产水率为17.2%。在压力为1.7MPa,温度为25℃时,浓缩实验结果表明,产水中Cl-浓度和膜的截留率随着时间变化而逐渐增加,但膜通量逐渐减小,且RE2540-TE膜通量下降幅度较大。清洗后,RE2540-TE膜通量损失达到6%,而Duraslick RO2540膜通量恢复幅度为98%。     

乳状液膜分离法预处理垃圾渗滤液氨氮的试验研究

用span-80表面活性剂制作的乳状液处理垃圾渗滤液中氨氮,考察了表面活性剂span-80用量、膜内相硫酸浓度、膜增强剂用量、油内比、乳水比、外相水pH值因素对氨氮去除率的影响。结果表明,在最佳反应条件下,用乳状液膜分离法预处理垃圾渗滤液中的氨氮,分离速度快,处理效果达到87%以上。     

Pollutants removal and simulation model of combined membrane process for wastewater treatment and reuse in submarine cabin for long voyage

A laboratory scale test was conducted in a combined membrane process (CMP) with a capacity of 2.91 m3/d for 240 d to treat the mixed wastewater of humidity condensate, hygiene wastewater and urine in submarine cabin during prolonged voyage. Removal performance of chemical oxygen demand (COD), ammonia nitrogen (NH4 +-N), turbidity and anionic surfactants (LAS) was investigated under di erent conditions. It was observed that the e uent COD, NH4 +-N, turbidity and LAS flocculated in ranges of 0.19–0.85 mg/L, 0.03–0.18 mg/L, 0.0–0.15 NTU and 0.0–0.05 mg/L, respectively in spite of considerable fluctuation in corresponding influent of 2120–5350 mg/L, 79.5–129.3 mg/L, 110–181.1NTU and 4.9–5.4 mg/L. The e uent quality of the CMP could meet the requirements of mechanical water and hygiene water according to the class I water quality standards in China (GB3838-2002). The removal rates of COD, NH4 +-N, turbidity and LAS removed in the MBR were more than 90%, which indicated that biodegradation is indispensable and plays a major role in the wastewater treatment and reuse. A model, built on the back propagation neural network (BPNN) theory, was developed for the simulation of CMP and produced high reliability. The average error of COD and NH4 +-N was 5.14% and 6.20%, respectively, and the root mean squared error of turbidity and LAS was 2.76% and 1.41%, respectively. The results indicated that the model well fitted the laboratory data, and was able to simulate the removal of COD, NH4 +-N, turbidity and LAS. It also suggested that the model proposed could reflect and manage the operation of CMP for the treatment of the mixed wastewaters in submarine.     

When signal meets noise: immunity of the frog ear to interference

Sound stimulates the tympanic membrane (TM) of anuran amphibians through multiple, poorly understood pathways. It is conceivable that interactions between the internal and external inputs to the TM contribute to the nonlinear effects that noise is known to produce at higher levels of the auditory pathway. To explore this issue, we conducted measurements of TM vibration in response to tones in the presence of noise in the frog Eupsophus calcaratus. Laser vibrometry revealed that the power spectra (n = 16) of the TM velocity in response to pure tones at a constant level of 80 dB sound-pressure level (SPL) had a maximum centered at an average frequency of 2,344 Hz (range 1,700–2,990 Hz) and a maximum velocity of 61.1 dB re 1 μm/s (range 42.9–66.6 dB re 1 μm/s). These TM-vibration velocity response profiles in the presence of increasing levels of 4-kHz band-pass noise were unaltered up to noise levels of 90 dB SPL. For the relatively low spectral densities of the noise used, the TM remains in its linear range. Such vibration patterns facilitate the detection of tonal signals in noise at the tympanic membrane and may underlie the remarkable vocal responsiveness maintained by males of E. calcaratus under noise interference.     

低温时污泥膨胀对MBR中膜污染的影响

通过一体式膜生物反应装置考察了在低温条件下发生污泥膨胀过程中反应器的运行效果和膜污染的情况,并从微生物角度分析了引起膜污染的因素.结果表明,低温时COD上清液和出水平均去除率分别为85%和92%,发生丝状菌污泥膨胀后去除率变化不大.MBR中丝状菌污泥膨胀形成的过程中,污泥沉降性变差,丝状菌丰度（FI）由2增加到5,丝状菌伸出絮体形成网状结构.低温时膜操作压力随时间呈直线变化,膜组件的水力清洗周期为15 d.在丝状菌大量繁殖时缩短到7 d,膜污染严重.通过测定活性污泥的特性,发现膨胀污泥的胞外聚合物（EPS）总量是正常污泥的3倍,污泥絮体相对疏水性（RH）随FI的提高而增大.EPS和RH增大后会引起更多物质沉积到膜表面,使膜污染速率提高,膜的运行周期变短.进一步的分析表明,混合液粘度、Zeta电位、污泥絮体形态也是影响膜污染的因素.     

泥水预分离MBR膜污染缓减效能研究

通过长期运行实验,进行了泥水预分离膜生物反应器（sludge/water pre-separation membrane bioreactor, S/W-MBR）与传统淹没式膜生物反应器（submerged membrane bioreactor, SMBR）对比研究,考察了污泥浓度、胞外聚合物含量（extracellular polymeric substances, EPS）及过膜阻力（trans-membrane pressure, TMP）随运行时间的变化规律及其对膜污染的缓减作用.结果表明,S/W-MBR与SMBR生物区的污泥浓度基本一致,而S/W-MBR膜区的污泥浓度较SMBR有显著降低.两者生物区的EPS含量均随运行时间的延长而增加,而S/W-MBR膜区的单位质量污泥的EPS含量始终保持在15 mg/g左右的较低水平.S/W-MBR比SMBR具有更好的缓减膜污染能力,在近90d的连续运行过程中,前者的膜组件仅需清洗2次,后者的膜组件清洗了5次.     

膜生物反应器亚硝化性能的影响因素研究

利用膜生物反应器成功启动了亚硝化工艺处理人工合成废水.为了确定影响亚硝化工艺效果的因素,先后对温度和溶解氧浓度进行了研究,结果表明,在温度35℃并且NH4+-N负荷平均0.45 kg.(m3.d)-1和溶解氧0.5 mg/L的条件下,可使出水中NO3--N的浓度低于20 mg.L-1,而ρ(NO2--N)∶ρ(NH4+-N)接近1.0.同时发现反应器运行期间,在低溶解氧的情况下,膜组件的污染并不严重.荧光原位杂交分析发现,在膜生物反应器中氨氧化菌成为优势菌种,亚硝酸盐氧化菌的活性受到了抑制.微生物群落分析则进一步提供了实现亚硝化工艺所必需的生物信息.