混凝-膜过滤中滤饼层对双酚A的去除强化作用研究

以聚合氯化铝(PAC)和氯化铁(FeCl3)为混凝剂,分析了双酚A(BPA)在1g/L高岭土溶液混凝过程中的特征.并借助循环错流过滤强化污染层累积的方法,评价产生滤饼层的微滤(MF)膜对BPA的截留效果.结果表明:清洁的微滤膜过滤BPA溶液在短时间内达到截留吸附饱和,之后其对BPA的吸附截留作用显著降低;混凝絮体混合液经膜过滤时产生的污染层有利于BPA的去除,且单独混凝对BPA去除率最高的混凝剂投加量下进行膜过滤时的阻力较小.PAC混凝—膜过滤后BPA去除率比单独混凝提高了34.30%;FeCl3混凝—膜过滤后BPA去除率比单独混凝提高了28.38%.初始BPA浓度对混凝-膜过滤去除率有一定影响,BPA浓度为100μg/L时,比BPA浓度为5mg/L时采用2种混凝-微滤膜过滤方式去除率均有提高.     

三层滤料高速过滤应用于再生水生产的研究

试验在传统混凝—沉淀—三层滤料过滤工艺的基础上,通过对滤料级配的改进,将三层滤料高速过滤工艺应用于再生水的生产,对其可行性进行分析研究。结果表明:在最佳工艺条件下出水浊度的去除率可达97.5%～98.5%,COD去除率在43%左右。同时研究发现,在高速过滤条件下,通过絮凝剂在滤床中发挥的微絮凝作用,可以起到良好的除污效果且出水水质稳定。     

Effect of iron addition on the performance of anoxic-oxic membrane process and biological phosphorus removal北大核心CSCD

In order to solve the problem of poor treatment of phosphorus in membrane bioreactor (MBR) with long sludge retention time (SRT), a ferric salt was added to enhance phosphorus removal; FeCl36H2O (Fe/P = 2.0) was added to the reactor. The removal efficiency of nitrogen, organic matters, and phosphorus in the MBR was investigated systematically. Moreover, this study focused on the membrane performance, the change of active sludge flora, and the effect of adding a ferric salt on membrane fouling before and after the addition. It was seen that adding the ferric salt could not affect the removal of COD and NH4 +-N and the removal rate of COD and NH4 +-N reached over 90%. However, the average removal rate of phosphorus was 52%, while the removal rate increased by nearly 40% after adding the ferric salt. The effects of adding ferric salts on the dominant bacteria and biological phosphorus removal of activated sludge were further studied. The results showed that the addition of ferric salt (Fe/P = 2.0) decreased the diversity of active sludge flora and relative abundance of some phosphorusaccumulating organisms and had a negative effect on biological phosphorus removal. The analysis of transmembrane pressure difference (TMP) recording revealed that the concentration of iron salts did not exacerbate membrane fouling. The results showed that the concentration of iron salts entering the membrane bioreactor would reduce the relative abundance and phosphorus removal efficiency of the activated sludge in the system to a certain extent, but it had no obvious effect on membrane fouling. It allowed the effluent to attain acceptable standards, especially with respect to phosphorus removal efficiency. © 2018 Science Press. All rights reserved.     

Energy reduction of a submerged membrane bioreactor using a polytetrafluoroethylene (PTFE) hollow-fiber membrane

The fiber length and packing density of the PTFE membrane element were increased. The MBR was stably operated under an SAD^m of 0.13 m³·m^-2·hr^-1. Specific energy consumption was estimated to be less than 0.4 kWh·m^-3. In this study, we modified a polytetrafluoroethylene (PTFE) hollow-fiber membrane element used for submerged membrane bioreactors (MBRs) to reduce the energy consumption during MBR processes. The high mechanical strength of the PTFE membrane made it possible to increase the effective length of the membrane fiber from 2 to 3 m. In addition, the packing density was increased by 20% by optimizing the membrane element configuration. These modifications improve the efficiency of membrane cleaning associated with aeration. The target of specific energy consumption was less than 0.4 kWh·m^-3 in this study. The continuous operation of a pilot MBR treating real municipal wastewater revealed that the MBR utilizing the modified membrane element can be stably operated under a specific air demand per membrane surface area (SAD_m) of 0.13 m³·m^-2·hr^-1 when the daily-averaged membrane fluxes for the constant flow rate and flow rate fluctuating modes of operation were set to 0.6 and 0.5 m³·m^-2·d^-1, respectively. The specific energy consumption under these operating conditions was estimated to be less than 0.37 kWh·m^-3. These results strongly suggest that operating an MBR equipped with the modified membrane element with a specific energy consumption of less than 0.4 kWh·m^-3 is highly possible.     

吸收液对中空纤维膜接触器回收尿液中氨氮的影响

采用中空纤维膜接触器（Hollow Fiber Membrane Contactor, HFMC）回收尿液中的氨氮,系统研究了吸收液类型（H₃PO₄、H₂SO₄和HNO₃）对氨回收效能、水蒸气的跨膜通量和所获液体肥料的影响.结果表明,使用H₂SO₄作为吸收液时氨氮回收效能最优,其次是H₃PO₄和HNO₃.当采用H₂SO₄为吸收液时,氨氮回收率、氨跨膜通量和传质系数分别为84.49%±0.01%、22.92 g·m^-2·h^-1和2.37×10^-6 m·s^-1.HNO₃的挥发性使其从吸收液侧反向跨膜至料液侧,导致氨跨膜传质驱动力变小;此外,NH₃和HNO₃会在膜孔中反应并生成NH₄NO₃气溶胶,增加氨在膜孔中的传质阻力,导致氨氮的回收效能降低.对采用不同吸收液时膜两侧的水的活度差和理论水通量进行了计算,结果表明,随着氨氮的不断跨膜吸收,膜两侧的活度差和水通量逐渐增大,实验结束时水通量分别为7.44×10^-2 kg·m^-2·h^-1（H₃PO₄）、9.06×10^-2 kg·m^-2·h^-1（H₂SO₄）和2.00×10^-2 kg·m^-2·h^-1（HNO₃）.肥料组分分析表明,以H₂SO₄和HNO₃为吸收液可以获得仅含N素的单一液体肥料,以H₃PO₄作吸收液可获得N-P复合肥,（NH₄）₂HPO₄和NH₄H₂PO₄所占的比例分别为88.33%和11.67%.     

离子交换膜应用于光/电/化学协同催化反应器

在光/电/化学协同催化反应器中,以离子交换膜代替盐桥连通阴、阳两室,以30 mg/L的甲基红溶液为目标降解物,考察了不同连通方式、初始pH和阴极电位对反应的影响. 结果表明:甲基红在阳离子膜型反应器中的表观反应速率常数明显高于盐桥型及阴离子交换膜型反应器,这是由于阳离子交换膜可以及时有效地将阳极室中产生的H+转移至阴极室中参与阴极反应. 甲基红在阳离子膜型反应器中的去除率随溶液初始pH的增高而降低,随阴极电位的增加先增大后减小,最佳反应条件为pH=2.0～3.0,阴极电位(-E_c)=0.6 V.      

草浆造纸黑液无污染排放治理新方案——双极膜电渗析法回收碱

介绍碱法草浆黑液采用膜技术处理的各种方案,着重介绍了碱法草浆黑液资源化全回收技术并提出了新的技术方案,该方案是先用硫酸中和酸析黑液中的木质素,或用纳滤方案回收木质素,然后采用双极膜电渗析法回收已去除木质素的黑液中的酸和碱,最后经蒸发和喷雾干燥回收其中的糖、其他营养成分及大部分水,达到无污染排放的目的。该方案碱回收率在50%～80%,取决于黑液中碱的浓度,回收1 t碱的耗电量低于2 500 kW.h。该法的基本投资比同规模碱回收法节省60%以上,具有较好的经济效益。     

UASB+A/O+UF+NF工艺处理生活垃圾焚烧厂渗滤液

采用"UASB+A/O+UF+NF"工艺处理生活垃圾焚烧厂渗滤液,工程规模为150 m3/d,工程总投资500万元,运行成本为25元/t;污泥处理工艺过程为:(剩余污泥+厌氧污泥)浓缩→脱水→焚烧。工程设计进水水质指标为ρ(COD)=50000 mg/L,ρ(BOD5)=25 000 mg/L,ρ(NH3-N)=600 mg/L,ρ(TP)=15 mg/L,ρ(SS)=9000 mg/L,出水主要水质指标为ρ(COD)≤50 mg/L,ρ(BOD5)≤15 mg/L,ρ(NH3-N)≤10 mg/L,ρ(TP)≤0.27 mg/L,ρ(SS)≤4 mg/L,补充到电厂循环冷却水中回用,不但实现了垃圾焚烧污水零排放,还有着较好的经济和环境效益。     

数字滤波法在点源和非点源污染负荷分割中的应用

以分辨流域点源和非点源污染负荷为研究目标,在傅立叶分析的基础上,提出了从污染负荷时间序列中分辨点源和非点源污染负荷的新方法——数字滤波法,探讨了数字滤波方程的参数与滤波次数的关系,并将该方法应用到东江流域COD_Mn负荷的分割上. 应用实例表明,分割的点源和非点源负荷系列曲线符合点源和非点源负荷的产生特点,使用者能够在污染负荷分割过程中通过滤波参数的选取比较方便地加入自己的经验. 一般取较大滤波参数时,只需要3次滤波就能得出较满意的结果.      

模拟酸雨对薇甘菊种子萌发和幼苗生长的影响

薇甘菊是入侵性杂草,已在我国华南地区及云南部分地区造成严重危害。我国华南地区同时也是强酸雨分布区域。采用不同pH值的模拟酸雨对薇甘菊种子及幼苗进行处理,测定其对种子萌发和幼苗生长的影响。测定了不同pH值下薇甘菊幼苗叶绿素含量、丙二醛含量、脯氨酸含量、超氧阴离子产生速率、超氧化物歧化酶和过氧化物酶活性。结果表明,薇甘菊种子具有较强的耐酸能力,pH≥3．5时均能正常萌发,pH≤3．0时不能萌发。不同pH值模拟酸雨对薇甘菊幼苗叶绿素含量影响不显著。随着模拟酸雨pH值下降,超氧阴离子产生速率上升,丙二醛含量、脯氨酸含量、超氧化物歧化酶活性和过氧化物酶活性呈先上升后下降。pH3．5时,丙二醛含量、脯氨酸含量、过氧化物酶活性均达最大值;pH4．0时超氧化物歧化酶活性达最大值。结果表明薇甘菊对华南地区酸雨胁迫表现出适应。