纳米Ag粒子原位杂化PVDF超滤膜的抗污染性能

以AgNO3为前驱体,聚偏氟乙烯(PVDF)为聚合物基体,聚乙烯吡咯烷酮(PVP)为分散剂和成孔剂,N,N-二甲基甲酰胺(DMF)为还原剂和溶剂,利用相转化法制备了纳米Ag粒子原位杂化PVDF超滤膜.采用扫描电镜、透射电镜、原子力显微镜及接触角测定仪对杂化膜的结构和性能进行了表征.结果表明:原位形成的纳米Ag粒子均匀地分散在聚合物基体中,纳米Ag粒子的添加改善了PVDF膜的亲水性能.以腐殖酸和牛血清蛋白作为污染物的代表,考察了Ag/PVDF膜的抗有机污染性能.以大肠杆菌、耐甲氧西林金黄色葡萄球菌及活性污泥作为微生物的代表,考察了杂化膜的抗生物污染性能.结果证实了与纯PVDF膜相比,Ag/PVDF膜通量衰减较慢,可有效抑制微生物的生长,表面受活性污泥污染程度小,具有显著的抗有机污染和抗生物污染性能.     

生物滴滤塔处理苯酚气体研究

采用生物滴滤塔处理苯酚气体,考察了苯酚去除性能的影响因素.结果表明,生物滴滤塔能高效处理苯酚气体,苯酚去除效率可达99.5%,长期运行平均去除效率在98%左右.适宜的运行条件为:停留时间20.6 s,循环液pH值7.0,喷淋密度1.67 m3·(m2·h)-1.采用聚合酶链式反应-变性梯度凝胶电泳(PCR-DGGE)技术研究处理苯酚气体的生物滴滤塔填料表面的微生物,结果表明,生物滴滤塔内有5种降解苯酚的优势菌种:Polaromonas sp.、Acinetobacter sp.、Acidovorax sp.、Veillonella parvula和Corynebacterium sp..采用GC-MS分析出口气样,结果表明丙酮酸(CH3COCOOH)为生物降解苯酚的中间产物,并推测了苯酚生物降解的可能途径.     

Gas separation using porous cement membrane

Gas separation is a key issue in various industrial fields. Hydrogen has the potential for application in clean fuel technologies. Therefore, the separation and purification of hydrogen is an important research subject. CO2 capture and storage have important roles in ＂green chemistry＂. As an effective clean technology, gas separation using inorganic membranes has attracted much attention in the last several decades. Membrane processes have many applications in the field of gas separation. Cement is one type of inorganic material, with the advantages of a lower cost and a longer lifespan. An experimental setup has been created and improved to measure twenty different cement membranes. The purpose of this work was to investigate the influence of gas molecule properties on the material transport and to explore the influence of operating conditions and membrane composition on separation efficiency. The influences of the above parameters are determined, the best conditions and membrane type are found, it is shown that cementitious material has the ability to separate gas mixtures, and the gas transport mechanism is studied.     

Effect of ozone on the performance of a hybrid ceramic membrane-biological activated carbon process

Two hybrid processes including ozonation-ceramic membrane-biological activated carbon （BAC） （Process A） and ceramic membrane-BAC （Process B） were compared to treat polluted raw water. The performance of hybrid processes was evaluated with the removal efficiencies of turbidity, ammonia and organic matter. The results indicated that more than 99% of particle count was removed by both hybrid processes and ozonation had no significant effect on its removal. BAC filtration greatly improved the removal of ammonia. Increasing the dissolved oxygen to 30.0 mg/L could lead to a removal of ammonia with concentrations as high as 7.80 mg/L and 8.69 mg/L for Processes A and B, respectively. The average removal efficiencies of total organic carbon and ultraviolet absorbance at 254 nm （UV254, a parameter indicating organic matter with aromatic structure） were 49% and 52% for Process A, 51% and 48% for Process B, respectively. Some organic matter was oxidized by ozone and this resulted in reduced membrane fouling and increased membrane flux by 25%-30%. However, pre-ozonation altered the components of the raw water and affected the microorganisms in the BAC, which may impact the removals of organic matter and nitrite negatively.     

Anoxic gas recirculation system for fouling control in anoxic membrane reactor

Anoxic gas recirculation system was applied to control the membrane fouling in pilot-scale 4-stage anoxic membrane bioreactor(MBR). In the anaerobic-anoxic-anoxic-aerobic flow scheme,hydrophilic polytetrafluoroethylene(PTFE) membrane(0.2 μm, 7.2 m2/module) was submerged in the second anoxic zone. During 8 months operation, the average flux of the membrane was 21.3L/(m2·hr). Chemical cleaning of the membrane was conducted only once with sodium hydroxide and sodium hypochlorite. Dissolved oxygen(DO) concentration in the second anoxic zone was maintained with an average of 0.19 ± 0.05 mg/L. Gas chromatography analysis showed that the headspace gas in the second anoxic reactor was mainly consisted of N2(93.0% ± 2.5%), O2(3.8% ± 0.6%), and CO2(3.0% ± 0.5%), where the saturation DO concentration in liquid phase was 1.57 mg/L. Atmospheric O2 content(20.5% ± 0.8%) was significantly reduced in the anoxic gas. The average pH in the reactor was 7.2 ± 0.4. As a result, the recirculation of the anoxic gas was successfully applied to control the membrane fouling in the anoxic MBR.     

ABR-MBR一体化工艺节能降耗措施优化研究

能耗高和膜污染是限制膜生物反应器(MBR)广泛应用的重要因素.为降低工艺运行能耗和延缓膜污染,以厌氧折流板反应器(ABR)-MBR工艺处理生活污水为例,对工艺结构和脱氮除磷运行条件进行优化.结果表明,通过优化ABR-MBR工艺结构,可降低43%的运行能耗,同时可保持较高的COD、NH+4-N、TN和TP去除效果,平均去除率分别为91%、85%、76%和86%.另外,添加颗粒填料可有效延缓膜污染,不过也改变了膜污染的形成过程,膜内部污染物含量显著增多,碳水化合物含量增加,而蛋白质含量减少,碳水化合物/蛋白质比明显增大.最终,增强了MBR反应器的实际应用性能.     

固定化曝气生物滤池处理采油废水

采用一种特殊载体固定复合微生物B350M在曝气生物滤池反应系统中处理采油废水.废水中的盐度>0.5%,N、P营养缺乏,有机物浓度较低.在HRT为4h、COD容积负荷为1.07 kg/(m³·d)的条件下,小试反应装置稳定运行142d,处理效果良好,石油类、TOC、COD和H₂S的平均降解效率分别达到90.5%、74.4%、85.6%和100%.GC-MS分析表明,进水中含有机物27种,其中烷烃类23种,芳烃类4种.此反应系统可以将大分子量烷烃类物质(C₁₈H₃₈至C₂₈H₅₈),尤其是其中的支链烷烃切碎形成小分子量物质,并有效地处理菲等多环芳烃.反应系统中,生态多样性丰富,载体为微生物提供了良好的水、气环境,抵御盐度、有机污染物的毒害作用,并可以固定丝状菌,因而避免出现污泥膨胀,出水SS过高等影响出水水质的情况.     

膜生物反应器中膜过滤特征及膜污染机理的研究

以膜生物反应器处理市政污水,通过对活性污泥进行终端过滤来反映膜污染机理,实验表明,最初很短时间内膜污染受膜孔堵塞模型控制,之后受沉积层阻力模型控制,后一阶段是膜污染的主要控制阶段;膜的相对通量随过滤时间呈指数衰减趋势,压力越大,通量衰减越快;污泥沉积层存在压密过程,这一过程中的污泥比阻随压力增大而增大,并得到处理市政污水的污泥压密指数为0.807 8;阻力分布实验表明沉积层阻力占总阻力的90%以上,是膜过滤污染阻力的主要组成部分;活性污泥各组分对膜污染均有贡献,其中悬浮固体、胶体颗粒和溶质产生的阻力分别占87.98%、6.20%和5.82%;根据实验和计算结果,探讨了MBR处理市政污水过程中可能的膜污染机理.     

净水厂滤池反冲洗水回用的贾第鞭毛虫和隐孢子虫的泄漏问题研究

采用美国EPA1623方法,研究滤池反冲洗水回用的贾第鞭毛虫和隐孢子虫泄漏问题.通过检测某水厂原水、出厂水和滤池反冲洗水中贾第鞭毛虫和隐孢子虫数量,表明该厂水源未受到贾第鞭毛虫和隐孢子虫的污染,但输送过程易造成水质的污染.滤池反冲洗水中只检出贾第鞭毛虫,出厂水中未检出贾第鞭毛虫和隐孢子虫,说明该厂滤池反冲洗水直接回用未造成"两虫"泄漏问题.     

升流式膨胀滤池的数学模型及设计参数

讨论了升流式膨胀滤池的反应过程，导出物料消耗，出水水质及反应时间等在有关理论公式，并根据物料流化理论确定了滤池几何尺寸及工艺提高参数的计算方法。