加压气浮法处理含油废水中溶气压力对出水水质的影响与应用研究

以实际工作中的含油废水为研究对象,采用加压气浮处理工艺,通过多年的实际应用与对监测数据的分析,总结出气浮压力对气浮处理效果的影响,通过对溶气罐压力的调整,可得到最佳的出水水质。该项研究结果操作方便、处理效率高、易于控制、对今后的工作具有指导意义,有很好的推广价值。     

电袋复合除尘技术在燃煤电厂中的应用

电袋复合式除尘技术综合了电除尘和布袋除尘的收尘优点,通过除尘负荷的合理分配,实现了电除尘和布袋除尘的有机结合;采用基于表面过滤原理的新型滤料,可克服常规滤料清灰后除尘效率降低及滤袋易破损等缺点。电袋复合式除尘器在徐州坝山环保热电有限公司的应用实践表明,电袋复合式除尘器可保持高效稳定除尘同时节能,粉尘排放浓度达到了30 ...     

免烧粉煤灰陶粒作为BAF填料处理城市污水

以电厂粉煤灰为主要试验原料,辅以外加药剂(水泥、石灰、石膏、水玻璃),经混合、成球、陈化和养护等工序,制得免烧粉煤灰陶粒,并将其作为曝气生物滤池(BAF)工艺的载体填料处理城市污水.待挂膜启动成功后,考察了水力停留时间( HRT)、COD负荷、氨氮负荷对COD和氨氮去除效果的影响.实验结果表明:在温度为18～21℃、气...     

基于生态系统的水环境压力分区指标体系构建

为了科学合理的完成水环境压力分区,构建水环境压力分区指标体系是其关键和基础.鉴于水环境压力涉及因素的系统性.相互联系性,从生态系统的角度考虑选取水环境压力分区指标十分必要;由于水环境压力涉及方面的相互联系性,其表征指标之间往往存在信息量的重叠,为了避免信息的重复表达,减少不必要的工作量,同时避免冗余指标带来的干扰,需对...     

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.     

Aerobic granules cultivated and operated in continuous-flow bioreactor under particle-size selective pressure

A novel method based on the selective pressure of particle size （particle-size cultivation method, PSCM） was developed for the cultivation and operation of aerobic granular sludge in a continuous-flow reactor, and compared with the conventional method based on the selective pressure of settling velocity （settling-velocity cultivation method, SVCM）. Results indicated that aerobic granules could be cultivated in continuous operation mode by this developed method within 14 days. Although in the granulation process, under particle-size selective pressure, mixed liquor suspended solids （MLSS） in the reactor fluctuated greatly and filamentous bacteria dominated the sludge system during the initial operation days, no obvious difference in profile was found between the aerobic granules cultivated by PSCM and SVCM. Moreover, aerobic granules cultivated by PSCM presented larger diameter, lower water content and higher specific rates of nitrification, denitrifieation and phosphorus removal, but lower settling velocity. Under long term operation of more than 30 days, aerobic granules in the continuous-flow reactor could remain stable and obtain good chemical oxygen demand （COD）, NH4^＋-N, total nitrogen （TN） and total phosphorus （TP） removal. The results indicate that PSCM was dependent on the cultivation and maintenance of the stability of aerobic granules in continuous-flow bioreactors.     

曝气膜生物反应器运行过程中污泥活性特征变化及其对膜污染的影响

研究了曝气膜生物反应器运行过程中活性污泥主要活性特征变化及其对膜污染的影响.通过排出剩余污泥的办法维持活性污泥浓度在4000 mg·L-1左右,并连续运行75 d.运行期间,每日检测活性污泥的各项性质指标便于反映污泥特性的变化.结果表明,随着反应器运行时间的延长,污泥脱氢酶活性逐渐增加,其对反应器的运行有着两方面的作用,一方面会强化微生物对污染物的去除,但另一方面则导致了胞外聚合物的增加,并加速膜污染.而污泥表观产率则随着运行时间的延长先增加后有所减少,其粒径逐渐减小,且胞外聚合物呈现增加的趋势,总的出水水质情况逐渐提高,与此同时,反应器内原生动物及后生动物在运行前期较少,而在后期大量出现.膜污染分析结果表明运行后期膜污染速度明显加快,其原因在于:污泥粒径的减小以及胞外聚合物的增加导致细小颗粒及胞外聚合物堵塞或在膜表面沉积数量增加.     

鞍钢钢绳厂生产污水处理的工艺设计及运行效果

本文介绍了鞍钢钢绳厂生产废水处理工艺,包括沉淀系统、气浮系统、砂滤罐过滤系统。通过试验确定p H为11时,沉淀系统对Zn2+的去除率达到98.4%。通过正交试验确定当PAC用量为20 mg/L、PAM用量为2 mg/L、p H 7.5、气浮压力为1.2 Mpa时气浮系统对钢绳厂废水中SS、石油类、COD的去除率分别达到90%、70%、70%。经过砂滤罐过滤系统后废水中的SS为20 mg/L、石油类为2 mg/L、COD为48 mg/L,其去除率分别达到94%、78%、80%。     

模拟烹饪油烟的粒径分布与扩散

烹饪油烟颗粒物粒径分布与扩散特性研究有助于解析其对室内空气质量和居民健康的影响,采用电子低压撞击器(ELPI)实时监测了油烟机开启和关闭状态下,模拟烹饪油烟发生处和3 m外位置处,0.03~10μm范围内油烟颗粒数浓度和质量浓度随粒径分布.油烟颗粒主要以655 nm以下的细颗粒为主.油烟机能够显著降低室内油烟浓度,开启油烟机后,油烟发生处颗粒数浓度从2.8×106个·cm-3降低到2.3×105个·cm-3,PM2.5(空气动力学直径≤2.5μm的颗粒)质量浓度从85.9 mg·m-3降低到6.2 mg·m-3.油烟机对PM10的净化效率高于PM2.5.油烟迅速从发生处扩散到3 m外,无通风状态下,总颗粒数浓度衰减达65%,PM2.5质量浓度衰减达75%.计算流体动力学(CFD)模拟了油烟机对油烟PM2.5质量浓度场扩散分布影响.红外摄像仪监测了油烟温度场分布扩散,以扇形向外扩散,伴随着油烟温度梯度降低.     

L形和U形三维钝体结构绕流的数值模拟研究

采用大涡模型对L形和U形三维钝体建筑物的绕流特性和风压分布特性进行数值研究.考虑平均和脉动速度入口边界,在雷诺数为1.5×105～7×105条件下,对2种钝体的9种分析工况进行瞬态动力分析,并将计算结果与已有研究进行对比.研究表明,钝体绕流对周围流场影响的强弱程度依次为尾流区、屋顶区、来流区,影响大小随着流场与钝体之间...