上流式厌氧污泥床反应器处理饮料废水

通过监测西安可口可乐饮料有限公司污水处理站的上流式厌氧污泥床(UASB)反应器,探讨饮料废水厌氧处理过程中COD去除率、沼气组分、氢分压、出水挥发性脂肪酸、产甲烷活性以及污泥形态。结果表明,UASB反应器对饮料废水中的COD去除率达到84.55%,产生的沼气中甲烷组分含量高达74.5%。反应器内的氢分压仅2.5 Pa,为水解发酵和产氢产乙酸过程创造了良好的条件。UASB反应器中污泥具有较高的产甲烷活性,以乙酸、丙酸和丁酸为基质时,最大比产甲烷活性分别为407.14、331.74和241.27 m L CH4/(g VSS·d)。UASB反应器中的污泥形态主要为絮状,甲烷菌中的优势菌为甲烷丝菌,同时存在少量甲烷杆菌。针对该厂UASB反应器中污泥的现状,提出了影响颗粒化的因素和控制措施,为后期的运行和管理提供了参考依据。     

新型低气阻高效除尘器的研究与应用

为了提高除尘器对细颗粒物的捕捉效率,制备了一种由蜂窝陶瓷、聚酰胺材质扭线刷和缚尘剂组成的除尘模块。其中填充了聚酰胺扭线刷的蜂窝陶瓷为除尘模块的主体,该主体独有的结构将拦截尘粒的滤料纤维分布在与气流方向垂直的平面上,有利于含尘气体的捕捉。缚尘剂为除尘模块的增强因子,它可以在除尘模块表面形成液膜,用来抑制除尘时的二次扬尘,提高除尘效率。通过对涂覆有缚尘剂的除尘模块的除尘效率的研究表明,含尘气体通过除尘模块,对粒径2μm的颗粒除尘效率最高可达到97.08%,表明了除尘模块去除细颗粒物的潜力;另外,在实验中设定的条件下,系统的压降保持在85 Pa以下。总体而言,该除尘模块在保持较低压降的同时对细颗粒物有较高的去除效率,有应用在工业除尘的潜力。     

家居环境PM_(2.5)控制用空气滤料

针对目前家居环境净化PM2.5的要求,在现有空气过滤材料的基础上,探讨一种适合于家居环境移动式空气净化装置用低阻、高效和长寿命的过滤材料。采用实验研究的方法对常用玻纤滤纸以及驻极体空气过滤材料进行了过滤特性、电镜、孔径测试的对比实验研究。结果表明,当过滤风速为5 cm/s时,3种驻极体滤料对粒径≤4.5μm的颗粒物的分级过滤效率要高于玻纤滤纸且都在90%以上,其过滤阻力在4.9~6.4 Pa之间,而高效滤纸的过滤阻力在57.8~78.6 Pa之间;在实验风速条件下,驻极体滤料对PM2.5的过滤效率和过滤阻力分别高于和低于高效玻纤滤纸;对驻极体滤料进行蒸馏水洗涤后,其对颗粒物的过滤效率下降,驻极体滤料静电效应具有不稳定特性;电镜测试发现,玻纤滤纸纤维层排布致密,纤维存在断裂现象,而驻极体滤料较为蓬松,无纤维断裂现象;孔径实验表明,驻极体滤料的平均孔径为玻纤滤纸的11.9~14.7倍,驻极体滤料具有良好的透气和容尘特性。     

孔道结构对柴油机微粒捕集器工作特性的影响

针对柴油机微粒捕集器中灰烬颗粒的沉积特征,设计了一种非对称孔道微粒捕集器,基于非对称孔道微粒捕集器对微粒捕集器再生模型进行修正,分析了非对称孔道对微粒捕集器再生特性的影响。研究结果表明,增大过滤体进出口截面比能减少微粒捕集器的压力损失,降低碳烟再生时过滤壁面的最大温度,且非对称孔道能减少灰烬沉积对再生时壁面最大温度的影响,因此根据过滤体壁面厚度适当增大进出口孔道截面比可以有效提升过滤体的碳烟承载量,延长微粒捕集器的车载使用寿命。     

不干胶废弃物热重分析

为了探索不干胶类包装废弃物的热解特性,采用热重分析手段分析了不同升温速率条件下不干胶类废弃物的失重特点,并且采用Ozawa法和KAS法比较分析不同转化率条件下的表观活化能分布.热重分析结果表明,不干胶类废弃物的热解主要分为3个阶段:第1阶段(室温～ 200℃)为不干胶类废弃物的干燥阶段,第2阶段(200 ～ 590℃)为热解的主要阶段,第3阶段(590 ～800℃)为热解半焦的深度热解阶段.升温速率对热解失重率有重要影响,Ozawa法和KAS法计算结果表明,2种方法计算的热解活化能比较接近,Ozawa法得到的活化能为349.9 kJ/mol,KAS法得到的活化能为336.9kJ/mol;并且不干胶类废弃物的热解表观活化能呈现出阶段性分布.     

变压吸附技术分离模拟油田火驱尾气中的CO_2

采用变压吸附技术分离模拟油田火驱尾气(CO_2-N_2-CH_4混合体系)中的CO_2。考察了吸附压力、吸附温度和气体流量对吸附效果的影响。实验结果表明:在吸附温度为25℃、吸附压力为0.6 MPa、气体流量为2 000m L/min、初始CO_2体积分数为13.01%的条件下,CO_2的穿透吸附量为60.34 m L/g,CO_2吸附率为78.92%,碳分子筛对CO_2的分离因子为8.233;在床层利用率为0.523的条件下进行降压解吸,当吸附压力降至0.1 MPa时,出口CO_2体积分数约为80%,CO_2的回收率可达96.38%。     

汽轮机回热系统安全运行与节能降耗

通过对300 MW汽轮机回热加热系统运行现状调查,分析了加热器端差异常和易发生泄漏原因,并制定了相应的对策。探索了远场涡流检测技术在高压加热器检验中的应用规律,通过高低水位调整试验确定了其最佳运行方式,对高压加热器的设计、制造及运行具有借鉴意义。     

活性焦吸附—曝气生物滤池处理煤气化废水生化出水

采用活性焦吸附—曝气生物滤池（BAF）工艺对煤气化废水生化出水进行深度处理。在活性焦投加量2 g/L、吸附时间2 h、BAF生化停留时间4 h的条件下,总COD去除率为85.4%,最终出水平均COD为45.2 mg/L,满足后续双膜法回用工艺要求（COD≤50 mg/L）。活性焦对致色的大分子有机物具有较好的吸附效果,吸附后废水的色度从300倍降至60倍,同时耗氧速率加快,可生化性提高。活性焦的吸附以物理吸附为主,吸附出水没有急性毒性。三维荧光光谱显示：各单元对于酚类的去除均有贡献,小分子组分中的酚类几乎全被去除。     

Cultivated land – a scarce commodity in a densely populated rural area in South Wollo,Ethiopia

Cultivated and settlement areas were studied in a small area (14 km2) in South Wollo, Ethiopia, by aerial photos, satellite images, field observations and interviews. Areas for cultivation/rural settlement decreased a few per cent between 1958 and 2013. Cultivated land per household slowly decreased in 1958–2003 but in 2003–2013 the annual decrease was 3–4 times higher. New farm buildings are often built on cultivated land, and abandoned buildings areas return to cultivation. Rainwater harvesting ponds have increased the areas with perennial crops that are important as a source of income. Tin roofed buildings are signs of improved livelihood. Very small farm size and rain-dependent agriculture combined with climate variability make food security vulnerable. Land-use inventories including remote sensing and local knowledge would be a valuable approach to assess livelihood needs. Further, it should involve decision makers at different levels, but local agricultural extension officers may play a central role.     

An investigation of a heat pump system using CO2/propane mixture as a working fluid

In order to decrease the heat rejection pressure of heat pump using pure working fluid, CO₂ or R744, other natural component including hydrocarbons (R290, R600a, R600, R1270, R170, R601) and dimethyl ether (RE170) is added to CO₂, respectively, and then six binary mixtures are achieved. By environmental and thermodynamic comparisons, R290 is selected to be the most appropriate component candidate to mix with CO₂, and meanwhile to weaken the flammability and explosivity for pure R290. Then, the system performances of heat pump using mixture of CO₂ and R290 were experimentally studied when R290 is added to CO₂ with a small fraction, and compared with that of the pure CO₂. The experimental test rig is designed and set up for the transcritical heat pump system. When the refrigerant charge is variable, the heating coefficient performance, optimum heat rejection pressure, compressor power, mass flow rate of refrigerant, and total heat coefficient of gas cooler were researched. The variation ratios of heating coefficient performance and heating capacity with deviation from the optimum refrigerant charge were also investigated. The optimum refrigerant charge of CO₂/R290 is obtained and the research results show that the addition of R290 to CO₂ can efficiently reduce the heat rejection pressure and improve the system performance. The results in the present work could provide useful guidelines for the design and operation of heat pump system using CO₂-based mixture.