IC反应器处理制浆洗草废水的内循环状况

中试用内循环厌氧反应器处理制浆造纸厂的洗草废水,并探讨内循环系统的循环状况。试验表明,洗草水不适合进行深度厌氧处理,宜进行水解酸化。由于洗草废水的有机物浓度低,产气量小,反应器内循环系统仅产生了不连续的提升,液体提升量与产气量的比值在0.08~0.36,下降管中产生了间歇性回流,液体的流量达到了518.4~725.1 L/h。     

炭化温度对废旧布袋制备活性炭性能的影响及其表征

以水泥厂废旧除尘布袋为原料,KOH为活化剂制备了活性炭.利用热重分析法(TG-DTG)对废旧布袋热解过程进行分析;重点考察了不同炭化温度(400、450、500、550和600℃)对废旧布袋制备活性炭的产率及活性炭的碘吸附值和亚甲基蓝吸附值的影响;同时采用N2吸附等温线对最佳工艺条件制备的活性炭孔隙结构进行了表征.研究结果表明,500℃为最佳炭化温度.最佳炭化温度下制备的活性炭,碘吸附值、亚甲基蓝吸附值和产率分别为1350.72 mg·g-1、97.5 mg·g-1和20.16%.活性炭比表面积高达1228.51 m2·g-1,总孔容达0.7134 cm3·g-1,孔径分布以微孔居多,N2吸附等温线为I型.     

内循环厌氧反应器流动模型及反应过程模拟

为揭示内循环厌氧反应器放大过程中所出现的规律,本文对反应器中流动模型和反应过程进行了模拟研究,通过对主反应区的停留时间分布的实验研究,确定了主反应区流型可用一平推流与两个并联的全混流进行串联的三参数组合模型进行模拟.在实验范围内,平推流区所占的体积分数约为36%,两个全混流区所占的体积分数分别为53%和11%.结合厌氧反应动力学方程,应用组合模型模拟了实际反应器的状态,并和实验值进行了对比,发现反应器出口处CH_4体积流量最大误差为9.67%,在可允许的范围内.同时,模拟了基质初始COD和温度变化对反应器出口状态的影响.研究表明,与其它模型相比,组合模型计算简洁,同时又有较好的精度,能够满足反应器的设计需要.     

Biological removal of antiandrogenic activity in gray wastewater and coking wastewater by membrane reactor process

A recombinant human androgen receptor yeast assay was applied to investigate the occurrence of antiandrogens as well as the mechanism for their removal during gray wastewater and coking wastewater treatment. The membrane reactor (MBR) system for gray wastewater treatment could remove 88.0% of antiandrogenic activity exerted by weakly polar extracts and 97.3% of that by moderately strong polar extracts, but only 32.5% of that contributed by strong polar extracts. Biodegradation by microorganisms in the MBR contributed to 95.9% of the total removal. After the treatment, the concentration of antiandrogenic activity in the effluent was still 1.05 μg flutamide equivalence (FEQ)/L, 36.2% of which was due to strong polar extracts. In the anaerobic reactor, anoxic reactor, and membrane reactor system for coking wastewater treatment, the antiandrogenic activity of raw coking wastewater was 78.6 mg FEQ/L, and the effluent of the treatment system had only 0.34 mg FEQ/L. The antiandrogenic activity mainly existed in the medium strong polar and strong polar extracts. Biodegradation by microorganisms contributed to at least 89.2% of the total antiandrogenic activity removal in the system. Biodegradation was the main removal mechanism of antiandrogenic activity in both the wastewater treatment systems.     

Mercury adsorption characteristics of HBr-modified fly ash in an entrained-flow reactor

In this study, the mercury adsorption characteristics of HBr-modified fly ash in an entrained-flow reactor were investigated through thermal decomposition methods. The results show that the mercury adsorption performance of the HBr-modified fly ash was enhanced significantly. The mercury species adsorbed by unmodified fly ash were HgCl₂, HgS and HgO. The mercury adsorbed by HBr-modified fly ash, in the entrained-flow reactor, existed in two forms, HgBr₂ and HgO, and the HBr was the dominant factor promoting oxidation of elemental mercury in the entrained-flow reactor. In the current study, the concentration of HgBr₂ and HgO in ash from the fine ash vessel was 4.6 times greater than for ash from the coarse ash vessel. The fine ash had better mercury adsorption performance than coarse ash, which is most likely due to the higher specific surface area and longer residence time.     

土壤滤池+等离子除臭技术在污水处理厂的应用

随着区域规划的调整,苏州某污水处理厂周围环境变得较为敏感,原有除臭设施已无法满足新的环保要求,该污水处理厂的除臭工程需要进行升级改造.经综合比选后确定采用在现有除臭设施基础上增设土壤滤池+等离子除臭设施的方案.除臭工程实施后,主要臭气源得到有效控制,氨、硫化氢和二硫化碳等恶臭物质去除率均在85％以上,甚至达到99％,除臭设施处理效果良好,厂界处污染物排放满足GB 14554-93《恶臭污染物排放标准》一级标准要求.     

Some properties of a sequencing batch reactor for treatment of wastewater containing thiocyanate compounds

Thiocyanate (SCN) compounds in photo-processing wastewater (PPWW) could be treated by an SBR system without any release of thiocyanate to the atmosphere during the aeration step. An SCN loading greater than 84 g m(-3)d(-1) showed negative effects on the growth of bio-sludge and removal efficiencies of the system. The acclimatization period of the system was increased with an increase in SCN concentration or loading. The COD, BOD(5), TKN, and SCN removal efficiencies were 96.0 +/- 1.6%, 72 +/- 2%, 49 +/- 5%, and 82 +/- 3%, respectively, under an SCN loading of up to 84 g m(-3)d(-1). The removal efficiency of the system was repressed by SCN due to the repressed growth rate of nitrification bacteria. However, the removal efficiency could be increased with an increase in HRT or a decrease in SCN loading. Also, increases in HRT or decreases in SCN loading led to increased sludge age or solid retention time (SRT) and decreased the sludge volume index (SVI) value. The SRT and SVI of the system with synthetic wastewater containing 840 mg l(-1) SCN under an HRT of 3 days (SCN loading of 280 g m(-3)d(-1)) were 3.9 +/- 0.7 days and 65 +/- 4 ml g(-1), respectively, while they were 11.2+/-0.8 days and 55 +/- 6 ml g(-1), respectively under an HRT of 10 days (SCN loading of 84 g m(-3)d(-1)).     

基于平面压入技术研究焊接接头单轴应力-应变关系

目的 获取异种金属焊接接头母材和热影响区局部拉伸应力-应变关系。方法 对压水堆机组蒸汽发生器接管安全端异种金属焊接接头(20MND 5-INCONEL 52-Z2 CND 18.12控氮)进行研究,通过金相检验和显微硬度测试,研究DMWJ母材、热影响区、焊缝熔合线位置的金相组织和维氏硬度分布。采用等直圆棒拉伸试验获得DMWJ低合金钢(20MND 5)母材的应力-应变关系,采用基于能量等效理论的平面压入技术获得DMWJ低合金钢母材、热影响区和焊缝局部材料应力-应变关系。结果 DMWJ材料组织、力学性能不均匀,等直圆棒拉伸试验得到的低合金钢母材拉伸应力-应变关系与平面压入技术测得结果较为吻合。结论 基于能量等效理论的平面压入技术可精确测得DMWJ低合金钢母材、热影响区和焊缝局部材料应力-应变关系,对压水堆核电站DMWJ在役检测及结构完整性评价具有重要意义。     

纤维素降解真菌的分离鉴定及特性研究

经过实验分离到一株纤维素降解真菌CD-Q1,通过形态及分子生物学鉴定该真菌为匍匐根霉。该菌能够以滤纸、秸秆和脱酯棉为唯一碳源生长,8 d内可将26.5%的秸秆降解,可将7.5%的滤纸糖化。当以滤纸为唯一碳源时,pH=5条件下,滤纸失重及还原糖产生量最高,45 h内可将3%滤纸降解,生成0.845 mg/ml的还原糖(以葡萄糖计)。该纤维素降解真菌的分离为纤维素糖化及进一步利用提供了较好菌源,为纤维素降解性能的基因改良提供了理想的出发菌株。     

多种复合材料固定化反应器的对比研究

选用活性炭、海砺壳2种材料作为固定化载体,对改良型UASB系统去除COD的性能进行研究,结果表明选择既高柱又循环且增加载体填充体积的系统,可有效去除高浓度有机废水的COD,但当填充载体过高时,循环系统难以实现,并存在憋气的可能。