利用新型组合填料的生物滴滤塔净化混合废气研究

建立了生物滴滤中试装置,并将前期研发的纹翼多面球和空心多面柱作为组合填料,以甲苯和乙醇混合气为废气,研究了组合填料生物滴滤塔的污染物去除性能.结果表明,装有组合填料的生物滴滤塔能在8 d内完成挂膜,稳定运行时对甲苯和乙醇的去除负荷分别为97.14 g·(m3·h)~(-1)和113.10 g·(m3·h)~(-1).空床停留时间(EBRT)和进气浓度对甲苯去除效果影响明显,当EBRT为21.11 s,甲苯和乙醇最大去除负荷分别为123.34 g·(m3·h)~(-1)和206.36 g·(m3·h)~(-1);受营养液喷淋量影响不明显,本系统最佳液气比为6.82 L·m~(-3).模拟了不稳定工况对系统处理效果的影响,用Na OH溶液减轻填料层堵塞效果明显,并可以3 d内恢复对甲苯和乙醇的去除效果;停运10 d后继续运行,净化性能可迅速恢复.     

Evaluating sulfuric acid reduction,substitution, and recovery to improve environmental performance and biogas productivity in rubber latex industry

Sulfuric acid is heavily used in concentrated rubber latex factories to coagulate rubber particles in skim latex. The resulting sulfate-rich wastewater creates the onset of toxic H₂S gas production in the wastewater holding ponds, causing severe corrosion to materials and community disturbance when dispersed to ambient air. This work identified and evaluated measures to reduce H₂S production by minimizing sulfate concentration in the wastewater. Sulfuric acid use could be cut down by pre-removal of ammonia in the skim latex as well as a stricter manipulation of acid dosing. In search of a more benign chemical, a heat sensitive polymer was identified and tested as sulfuric acid substitute. The use of hydroxypropyl methylcellulose polymer (HPMC) changed wastewater characteristics and was found to increase biogas production approximately by 2.4 times in batch assay at the initial pH 7.0 and methane yield by 2.7 times in continuous digester operation at HRT 7 days. Finally, a resource recovery option was evaluated. The remaining H₂S in the produced biogas was oxidized in the biotrickling filter to sulfuric acid that has a potential to partially supplement the fresh acid. This work demonstrated an integrated approach in waste management to improve environmental performance, safety and energy recovery in the concentrated latex industry.     

ABR+生物接触氧化法处理高浓度有毒有机废水

本文采用ABR+生物接触氧化组合工艺处理含苯酚的高COD有毒有机废水,实验研究了ABR反应器的抗毒性及对COD、苯酚和NH3-N的处理效果。实验结果表明:废水COD和苯酚的去除主要发生在厌氧阶段;在苯酚质量浓度1 000 mg/L左右时,ABR反应器和常规厌氧反应器的处理效率均出现明显的下降趋势,但ABR反应器对苯酚的耐受浓度明显高于常规厌氧反应器;相比于常规厌氧反应器,ABR反应器推流式的特性实现了产酸和产甲烷优势菌群的分离,具有较高的COD、苯酚的去除率和较强的抗毒性;对NH3-N的去除,ABR反应器的强化效果不明显。     

滤膜法测定悬浮物出现负误差原因研究

为了对滤膜法测定水中悬浮物出现负误差的情况进行研究,从滤膜的前处理到滤膜的选择进行了一系列实验,发现主要原因是滤膜在实验的过程中产生失重。对几种微孔滤膜进行了空白实验,得出有机滤膜的空白校正值为0.0000～0.0004g,低于或等于悬浮物的称量误差,此类滤膜用于水中悬浮物的测定,能减少恒重次数,缩短实验时间,提高测定结果的科学性和准确性。     

生物滴滤塔处理苯酚气体研究

采用生物滴滤塔处理苯酚气体,考察了苯酚去除性能的影响因素.结果表明,生物滴滤塔能高效处理苯酚气体,苯酚去除效率可达99.5%,长期运行平均去除效率在98%左右.适宜的运行条件为:停留时间20.6 s,循环液pH值7.0,喷淋密度1.67 m3·(m2·h)-1.采用聚合酶链式反应-变性梯度凝胶电泳(PCR-DGGE)技术研究处理苯酚气体的生物滴滤塔填料表面的微生物,结果表明,生物滴滤塔内有5种降解苯酚的优势菌种:Polaromonas sp.、Acinetobacter sp.、Acidovorax sp.、Veillonella parvula和Corynebacterium sp..采用GC-MS分析出口气样,结果表明丙酮酸(CH3COCOOH)为生物降解苯酚的中间产物,并推测了苯酚生物降解的可能途径.     

限量曝气进水时间对硝化颗粒污泥的影响特性研究

缺氧-好氧环境的交替循环对氨氧化细菌和亚硝酸盐氧化细菌具有重要影响.本研究通过逐渐增加限量曝气进水时间(从10 min至120 min)延长缺氧时段,考察柱形SBR中硝化颗粒污泥对不同缺氧-好氧环境交替循环的响应特性.整个研究过程中,硝化颗粒污泥保持着稳定的颗粒特征,粒径大于0.8 mm的颗粒污泥占总污泥量的质量分数始终在95%以上,颗粒平均沉降速率维持在125～130 m·h-1之间.尽管缺氧时段不断延长,但NH+4-N去除率和NO-2-N累积率分别稳定在(60±5)%、(85±5)%;此外,在每个周期的曝气反应时段,NH+4-N的去除速率以及NO-2-N和NO-3-N的累积速率分别保持在90mg·(L·h)-1、70 mg·(L·h)-1和15 mg·(L·h)-1左右.以上结果表明,限量进水时间的延长及其所造成的不同时间跨度的缺氧环境对硝化颗粒污泥没有较为显著的影响.     

间歇式生物反应器中PHACs的吸附降解性及动力学特性

利用间歇反应器考察了非那西丁(PNT)、吉非罗齐(GFZ)、咖啡因(CAF)、双氯芬酸(DCF)和胆固醇(CH)5种医药类污染物分别在厌氧、缺氧及好氧条件下的吸附与降解特性,并通过动力学拟合深入考察目标物的降解速率及所符合的反应级数.研究表明,PNT在4 h内就能得到100%的降解,GFZ与CH能通过吸附与降解得到部分或全部去除.好氧条件下目标物的泥水分配系数kp值与降解速率均高于缺氧与厌氧条件,好氧条件下CAF的去除率达到99%以上.5种目标物除PNT外都有不同程度的吸附,目标物的污泥吸附能力为CHDCFGFZCAF;动力学拟合结果表明,生物降解动力学一级反应速率PNTCAF,二级反应速率CHGFZ;DCF几乎不能被生物降解,但符合二级吸附动力学模型,其平衡吸附量最高可达总投加量的71%.     

Effect of alkalinity on nitrite accumulation in treatment of coal chemical industry wastewater using moving bed biofilm reactor

Nitrogen removal via nitrite （the nitrite pathway） is more suitable for carbon-limited industrial wastewater. Partial nitrification to nitrite is the primary step to achieve nitrogen removal via nitrite. The effect of alkalinity on nitrite accumulation in a continuous process was investigated by progressively increasing the alkalinity dosage ratio （amount of alkalinity to ammonia ratio, mol/mol）. There is a close relationship among alkalinity, pH and the state of matter present in aqueous solution. When alkalinity was insufficient （compared to the theoretical alkalinity amount）, ammonia removal efficiency increased first and then decreased at each alkalinity dosage ratio, with an abrupt removal efficiency peak. Generally, ammonia removal efficiency rose with increasing alkalinity dosage ratio. Ammonia removal efficiency reached to 88% from 23% when alkalinity addition was sufficient. Nitrite accumulation could be achieved by inhibiting nitrite oxidizing bacteria （NOB） by free ammonia （FA） in the early period and free nitrous acid in the later period of nitrification when alkalinity was not adequate. Only FA worked to inhibit the activity of NOB when alkalinity addition was sufficient.     

Performance and microbial diversity of an expanded granular sludge bed reactor for high sulfate and nitrate waste brine treatment

The disposal of waste brines has become a major challenge that hinders the wide application of ion- exchange resins in the water industry in recent decades. In this study, high sulfate removal efficiency （80%-90%） was achieved at the influent sulfate concentration of 3600 mg/L and 3% NaC1 after 145 days in an expanded granular sludge bed （EGSB） reactor. Furthermore, the feasibility of treating synthetic waste brine containing high levels of sulfate and nitrate was investigated in a single EGSB reactor during an operation period of 261 days. The highest nitrate and sulfate loading rate reached 6.38 and 5.78 kg/（m3-day） at SO42--S/NO3-N mass ratio of 4/3, and the corresponding removal efficiency was 99.97% and 82.26% at 3% NaC1, respectively. Meanwhile, 454-pyrosequencing technology was used to analyze the bacterial diversity of the sludge on the 240th day for stable operation of phase X. Results showed that a total of 9194 sequences were obtained, which could be affiliated to 14 phyla, including Proteobacteria, Firmicutes, Chlorobi, Bacteroidetes, Synergistetes and so on. Proteobacteria （77.66%） was the dominant microbial population, followed by Firmicutes （12.23%） and Chlorobi （2.71%）.     

ABR-MBR一体化工艺节能降耗措施优化研究

能耗高和膜污染是限制膜生物反应器(MBR)广泛应用的重要因素.为降低工艺运行能耗和延缓膜污染,以厌氧折流板反应器(ABR)-MBR工艺处理生活污水为例,对工艺结构和脱氮除磷运行条件进行优化.结果表明,通过优化ABR-MBR工艺结构,可降低43%的运行能耗,同时可保持较高的COD、NH+4-N、TN和TP去除效果,平均去除率分别为91%、85%、76%和86%.另外,添加颗粒填料可有效延缓膜污染,不过也改变了膜污染的形成过程,膜内部污染物含量显著增多,碳水化合物含量增加,而蛋白质含量减少,碳水化合物/蛋白质比明显增大.最终,增强了MBR反应器的实际应用性能.