二次有机气溶胶估算方法研究进展

我国区域复合污染日趋严重,二次有机气溶胶(SOA)是细颗粒物PM2.5的重要组成之一.本研究总结了当前国内外定量估算SOA的主要方法,包括EC示踪法、WSOC法、受体模型法、示踪物产率法、数值模拟法等.通过对各种方法的原理介绍与比较,指出1)EC示踪法、WSOC法、受体模型法简单易行,与在线连续观测数据结合可估算高时间分辨率的SOA浓度,但受限于对当地源谱和特定物种的了解;2)示踪物产率法虽分析技术难度高,但可针对不同来源的SOA估算;3)数值模拟可获得大尺度SOA的空间分布.针对国内外的最新研究成果进行简单概述,不同方法的研究表明中国二次有机气溶胶是总有机气溶胶的重要部分,人为源VOCs对二次有机气溶胶发挥着重要贡献.本文旨在为未来我国二次有机气溶胶的研究提供基础信息和研究思路.     

老化过程中铜形态变化的X射线吸收精细结构谱的(XAFS)初步研究

利用X射线吸收精细结构谱(XAFS)对老化过程中土壤中铜的分子形态进行初步表征。以硫酸铜、氧化铜和硫化铜的X射线吸收扩展边结构(EXAFS)谱为参比,对土壤样品中Cu的EXAFS谱进行拟合,得到不同老化阶段与参比物质相对应的结合态Cu的百分含量,并与连续提取法表征进行比较。XAFS分析结果表明,老化阶段土壤样品中铜的主要结合形态是CuSO_4,同时还有部分CuS,基本不含有CuO。随着时间的推移,土壤中CuSO_4百分含量呈现出下降的趋势,CuS百分含量呈现出上升的趋势。这与连续提取法研究结果中其可交换态的百分比下降,残渣态上升的趋势相似。     

佛山水道及其支涌复氧试验研究

对几种曝气方式的溶解氧提升情况、充氧动力效率,及COD、氨氮的去除率进行了简单比较,得出微孔雾化曝气和橡胶坝曝气是适合佛山水道及其支涌河流人工复氧的最佳方法.     

上海城区典型空气污染过程中细颗粒污染特征研究

采集了上海城区2009年10月10~21日期间2次空气污染过程的样品,在对污染过程分析的基础上,着重分析了PM2.5及其化学组分的变化,探讨了污染源及形成机制.研究表明,14日的灰霾过程主要由本地排放的污染物二次转化形成,PM2.5占PM10比重超过60%且PM2.5中离子组分含量高.17~19日的浮尘过程中,受北方沙尘影响本市粗颗粒浓度上升,PM2.5所占比重下降,二次离子组分从细颗粒物向粗颗粒物转移且Ca2+浓度上升,同时受到长江三角洲区域秸秆焚烧的影响,细颗粒物中K+, EC和OC含量高.因此,应在控制本地源排放的同时,加强对细颗粒尤其是二次细颗粒污染及其前体物的协同控制.     

Experimental investigation into the oxidation reactivity, morphology and graphitization of soot particles from diesel/n-octanol mixtures

Aiming to investigate the impacts of n-octanol addition on the oxidation reactivity, morphology and graphitization of diesel exhaust particles, soot samples were collected from a four-cylinder turbocharged diesel engine fueled with D100（neat diesel fuel）, DO15（85% diesel and 15% n-octanol, V/V） and DO30（70% diesel and 30% n-octanol, V/V）. All tests were conducted at two engine speeds of 1370 and 2150 r/min under a fixed torque of 125 N ·m. The soot properties were characterized by thermogravimet...     

超细水雾抑制煤燃烧的模拟实验研究

为了研究超细水雾对煤燃烧的抑制效果,基于小尺寸空间抑制燃烧实验平台,研究了超细水雾对煤燃烧的抑制效果,计算在超细水雾作用下实验空间内部氧气、二氧化碳、一氧化碳体积分数的变化情况以及燃烧空间内不同部位的温度变化情况,并且与煤自由燃烧的情况做对比。研究表明超细水雾对煤燃烧的火灾发展过程有很好的抑制作用。研究结论对超细水雾应用于熄灭矿井煤炭火灾具有一定的指导意义     

大气颗粒物吸湿性研究

大气颗粒物吸湿性是反映颗粒物理化性质的重要指标,吸湿性研究对深入了解颗粒物的环境和健康效应具有重要意义. 总结了国外近年来大气颗粒物吸湿性研究进展:①典型的大气颗粒物吸湿性分析方法为H-TDMA(吸湿性串联差分电迁移率粒径分析仪)系统及其优化方法. ②大气颗粒物吸湿性呈单峰、双峰甚至多峰分布;根据G_f(吸湿性生长因子)随粒径变化的模式,可将大气颗粒物分为强吸湿性和弱吸湿性2类,也可分为纯不溶性、混合不溶性、混合可溶性和纯可溶性4类. ③城市背景点颗粒物的G_f比城市观测点高;城市观测点的颗粒物G_f分布呈夏季高、冬季低,白天高、晚上低的特征. ④颗粒物吸湿性与其化学组成和形态密切相关,纯可溶性盐颗粒物的G_f通常较高. ⑤柴油燃烧源新排放的颗粒物属于弱吸湿性颗粒物,G_f非常小,但在其表面老化后或随燃料中硫含量的增加G_f会明显变大. ⑥生物质燃烧排放颗粒物的G_f相对较高,但存在区域差异性. 针对国内大气颗粒物吸湿性研究现状,提出了未来重点研究方向.      

Transport of Sewage Sludge in a Mixed Water Column

Abstract

Sewage sludge from four publicly-owned treatment works was sampled and characterized in terms of parameters affecting transport at the 106-mile deep ocean disposal site as part of the US Environmental Protection Agency's site monitoring programme. Samples from treatment plants in Passaic Valley, Rahway, and Elizabeth, New Jersey and New York City were characterized in terms of dynamic size distribution, suspended solids and density. the transport characteristics of sludge particles were measured using a 2 metre computer-interfaced laboratory settling column. Experiments were conducted at constant salinity (35 ppt) while varying hydrodynamic mixing, sludge type and concentration using a modified factorial experimental design. Hydrodynamic power dissipation was varied so that the vertical dispersion and rms fluid shear rate ranged between 0-6 cm²S^?1 and 0-30s^?1 respectively. Results indicate that at least 80% of suspended sludge particles will eventually settle under mixed conditions. the average settling velocities ranged between 0.05-4.05 × 10^-3 cm ^s-1. Shear rates above 15 s^?1 inhibited sludge settling due to aggregate breakup and boundary effects, but at a lower shear rate, differential settling and fluid shear were the dominant transport mechanisms. Sludge dilution (1/500-1/5000) had a limited effect on the settling rate. Results from this study can be used to calibrate particle transport models to determine the fate of sludge disposed at an ocean disposal site.     

A new polystyrene-latex-based and EPS-containing synthetic sludge

Since the living microorganisms in activated sludge continuously change, it is difficult to conduct controlled experiments and achieve reproducible results for evaluating sludge characteristics. Synthetic sludge, as a chemical surrogate to activated sludge, could be used to investigate the sludge physicochemical properties, and it is desirable to prepare synthetic sludge with similar structure and properties to real activated sludge to explore the flocculation and settlement processes in activated sludge systems. In this work, a high-strength synthetic sludge was prepared with functional polystyrene latex particles as the framework and extracellular polymeric substances (EPS) to modify its surface. The flocculation and settling characteristics of the microspheres and the prepared synthetic sludge were tested. Compared with other three functional polystyrene latex microspheres, the synthetic sludge prepared with EPS-modified polystyrene latex microspheres showed good settling characteristics and a significantly higher strength. They could be used for studying the physicochemical properties of activated sludge.     

青岛大气气溶胶水溶性无机离子的粒径分布特征

为了解大气颗粒物中水溶性离子的来源及环境效应,利用安德森采样器连续采集青岛近海2008年1~12月大气颗粒物分级样品,用离子色谱法分析其中主要的水溶性离子,并讨论其粒径分布特征.结果表明, NH4+、K+、Cl-、NO3-、PO43-、SO42-主要存在于粒径小于2.1μm的细粒子中,Na+、Mg2+、Ca2+、F-则主要存在于粒径大于2.1μm的粗粒子中.各离子的粒径分布存在明显的季节变化.NH4+、K+和SO42-四季均主要分布于细粒子中,而Mg2+和Ca2+则主要分布在粗粒子中,两者均在3.3~4.7μm出现峰值;Na+在春、夏、秋3个季节主要存在于粗粒子中,集中分布在3.3~7.0μm粒径范围内,而在冬季则集中分布于0.43~1.1μm且细粒子含量高于粗粒子;春季Cl-在粗粒子中分布较多,尤以2.1~3.3μm范围内的最为突出,而其他3个季节均是细粒子比例明显偏高;NO3-春、夏两季在粗、细粒子中的含量各占50%,秋、冬季节均为细粒子占多数;PO43-夏季只出现在0.65~1.1μm以及>11μm的粒径范围内,粗粒子占95%,其他3个季节则是细粒子含量较高;春季F-在3.3~4.7μm出现峰值,夏季各粒径均未检出,而秋、冬两季粗、细粒子各占50%.K+、NH4+、F-、Cl-、NO3-、SO42-和PO43-受供暖期燃煤取暖的影响较大.K+和NH4+在供暖期和非供暖期峰值均出现在0.43~0.65μm粒径范围;F-供暖期在0.43~0.65μm和3.3~4.7μm粒径段出现峰值;供暖期Cl-的峰值出现在0.43~0.65μm粒径段,而在非供暖期,则出现在2.1~3.3μm的粗粒径段;SO42-和NO3-在供暖期和非供暖期的峰值均出现在0.43~0.65μm和3.3~4.7μm粒径段;供暖期PO43-的最大峰值出现在0.43~0.65μm粒径段,而在非供暖期其最大峰值出现在3.3~4.7μm粒径段.