强化除磷曝气生物滤池反冲洗优化及其污泥特性

为探讨BAF(曝气生物滤池)最佳反冲洗强度及其选择依据,以某处理石化二级出水的强化除磷BAF为研究对象,采取不同的反冲洗强度进行气-水联合反冲洗,探讨反冲洗过程中出水污泥量峰值出现时间、污泥的SOUR(比好氧呼吸速率)变化、反冲洗前后微生物量和微生物脱氢酶活性(DHA)的变化以及反冲洗后的恢复效果,并对反冲洗强度参数的选择进行了优化. 结果表明:在该研究条件下,采用气洗〔强度为12 L/(m2·s)〕4 min,气-水联合洗〔气洗强度为12 L/(m2·s),水洗强度为6 L/(m2·s)〕5 min,最后用清水漂洗9 min的反冲洗方式,排水中污泥的ρ(SS)可在最短时间(3 min)达到峰值;反冲洗排水中污泥的SOUR较低,平均值为0.5 mg/(mg·h);距离底端进水口1.3和2.2 m处的滤料层微生物的量损失较小,分别为4.4%和5.3%,其相应微生物的活性有所增加. 研究显示,该条件下反冲洗可有效清除滤料颗粒间所截留及滤料表面脱落的老化生物膜,并可保留适量活性较高的生物膜,强化了传质条件,反冲洗后对污染物的处理能力能恢复迅速.      

曝气强化非离子表面活性剂洗涤法修复柴油污染土壤

采用异位修复法,利用非离子表面活性剂洗涤柴油污染土壤,并在洗涤过程中曝气强化。考察了洗涤效果的影响因素,并通过表面张力和接触角的测定探讨了洗涤机理。实验结果表明:曝气对污染土壤中柴油的洗脱有强化作用,可提高洗脱率10%~20%;3种非离子表面活性剂的洗脱效果优劣次序为聚氧乙烯月桂醚(Brij-35)曲拉通X-100(TX-100)吐温-80(Tw-80);在表面活性剂浓度为1倍临界胶束浓度、曝气量为7.5 L/min、洗涤时间为60 min、洗涤液pH为11.0的优化条件下,Brij-35对柴油的洗脱率达77.4%,污染土样的含油率从7.0%降至1.6%,接触角从24.12°降至6.65°,可基本恢复土壤的亲水性;洗涤液的表面张力随表面活性剂浓度的增加而降低,但不受洗涤液pH的影响。     

水动力条件对全程自养脱氮工艺启动研究

CANON工艺需要部分短程硝化提供亚硝酸盐,所以CANON工艺存在溶解氧难控制的问题,特别是在反应器较小的情况。本文采用设有挡板的改良SBR,通过机械搅拌形成剧烈水流搅动,精确控制溶解氧,研究了不同搅拌速率对CANON工艺启动的影响。结果表明,机械曝气能成功启动了CANON工艺,且获得平均总氮去除率达79.40%,剪切应力的提高有利于脱氮性能的提升,机械曝气启动方式相比于鼓风曝气更加容易控制。     

强化曝气对潜流人工湿地堵塞物分布规律的影响

构建曝气及未曝气潜流人工湿地小试实验系统,研究曝气对人工湿地堵塞物组分及分布规律的影响.结果表明:两系统中堵塞物组成均以无机物为主,曝气对堵塞物累积总量影响不大,但对堵塞物化学组分影响较大,使堵塞物中有机物组分比例降低.未曝气及曝气系统堵塞物平均累积量分别为5.18 mg·g~(-1)及5.21 mg·g~(-1),有机物所占比例分别为28.4%和15.6%.曝气对堵塞物在水平及深度方向的分布影响不大,两系统均表现为底层累积物含量略高于表层,出水端累积物含量略高于进水端.电镜及能谱分析结果显示,受溶解氧因素的影响,两系统中表层填料元素种类均较底层丰富,且曝气系统较未曝气系统丰富.     

Numerical simulation of landfill aeration using computational fluid dynamics

The present study is an application of Computational Fluid Dynamics (CFD) to the numerical simulation of landfill aeration systems. Specifically, the CFD algorithms provided by the commercial solver ANSYS Fluent 14.0, combined with an in-house source code developed to modify the main solver, were used. The unsaturated multiphase flow of air and liquid phases and the biochemical processes for aerobic biodegradation of the organic fraction of municipal solid waste were simulated taking into consideration their temporal and spatial evolution, as well as complex effects, such as oxygen mass transfer across phases, unsaturated flow effects (capillary suction and unsaturated hydraulic conductivity), temperature variations due to biochemical processes and environmental correction factors for the applied kinetics (Monod and 1st order kinetics). The developed model results were compared with literature experimental data. Also, pilot scale simulations and sensitivity analysis were implemented. Moreover, simulation results of a hypothetical single aeration well were shown, while its zone of influence was estimated using both the pressure and oxygen distribution. Finally, a case study was simulated for a hypothetical landfill aeration system. Both a static (steadily positive or negative relative pressure with time) and a hybrid (following a square wave pattern of positive and negative values of relative pressure with time) scenarios for the aeration wells were examined. The results showed that the present model is capable of simulating landfill aeration and the obtained results were in good agreement with corresponding previous experimental and numerical investigations.     

Landfill aeration in the framework of a reclamation project in Northern Italy

In situ aeration by means of the Airflow technology was proposed for landfill conditioning before landfill mining in the framework of a reclamation project in Northern Italy. A 1-year aeration project was carried out on part of the landfill with the objective of evaluating the effectiveness of the Airflow technology for landfill aerobization, the evolution of waste biological stability during aeration and the effects on leachate and biogas quality and emissions.The main outcomes of the 1-year aeration project are presented in the paper.The beneficial effect of the aeration on waste biological stability was clear (63% reduction of the respiration index); however, the effectiveness of aeration on the lower part of the landfill is questionable, due to the limited potential for air migration into the leachate saturated layers.During the 1-year in situ aeration project approx. 275 MgC were discharged from the landfill body with the extracted gas, corresponding to 4.6 gC/kgDM. However, due to the presence of anaerobic niches in the aerated landfill, approx. 46% of this amount was extracted as CH₄, which is higher than reported in other aeration projects. The O₂ conversion quota was lower than reported in other similar projects, mainly due to the higher air flow rates applied.The results obtained enabled valuable recommendations to be made for the subsequent application of the Airflow technology to the whole landfill.     

Nitrogen and phosphorus removal for swine wastewater by ammonium crystallization and intermittent aeration process

Abstract

A process on crystallized precipitation of ammonium by adding magnesium salt and phosphate was carried out to improve C/N ratio in swine wastewater. After completion of crystallized precipitation of ammonium, an intermittent aeration process with aeration and non‐aeration periods alternated at interval of 1:1 hr day^‐1 is used for the improved swine wastewater (T‐N/BOD=0.14: BOD=8200 mg/liter and T‐N=1166 mg/liter). The results obtained from the experiment show that the removal ratios of T‐N and NH₄‐N are 91% and 99%, respectively. T‐P is not removed, while the removal ratio of PO₄‐P is 60% as 3% of CaCl₂ liquid is added. The results also indicate that dilution with water is effective to improve the removal of phosphorus even if raw swine wastewater contains high concentrations of T‐N, T‐P, BOD, and TOC.     

壬基酚聚氧乙烯醚在碱性印染废水中的降解

通过静态和动态连续降解实验,揭示了壬基酚聚氧乙烯醚(NPEO,Nonylphenol ethoxylates,浓度6.25~12.5 mg·L-1)在碱性牛仔布印染废水中的去除规律.批式活性污泥实验表明,厌氧环境下,随着p H值的增加,壬基酚(NP,Nonylphenol)产生受到抑制,短链NPEO(环氧乙烯加成数1~3,NP(1~3)EO)总浓度水平虽然只有500~900μg·L-1,却呈现增加趋势;好氧环境下,尽管NPEO总量降解率超过85%,但产生的各种短链NP(1~3)EO和短链壬基酚聚氧乙烯醚酸酯(NPEC,Nonylphenol polyethoxycarboxylate)浓度区间为10~110μg·L-1,碱性环境下两类物质总量最低,不足100μg·L-1.耦合厌氧水解和好氧曝气的连续实验表明,增设填料的厌氧折板水解池出水中短链NP(1~3)EO的总浓度增至4000~5000μg·L-1,这与厌氧环境下一部分NPEO附着在废水杂质和厌氧污泥上,在污泥龄较长的附着型污泥作用下,生成了大量的NP(1~3)EO有关;好氧段出水中NP(1~3)EO浓度降至230~610μg·L-1,短链NPEC(NP(1~3)EC)总量上升到800~1000μg·L-1,NP(1~3)EC由NP(1~3)EO转化来的可能最大.印染出水中NP及NP(1~3)EO受厌氧段出水中NP及NP(1~3)EO浓度影响明显.     

曝气诱导内波破坏水库水温分层的过程与效果

针对传统的水库破坏分层技术的低效率、高能耗等普遍问题,研制了能模拟基于自然对流而形成水温分层的中试模型水库,研究了曝气诱导形成内波混合破坏水温分层的可行性,过程和效果.扬水曝气产生的周期性出流能作为扰动源,在分层水环境中诱导形成内波.内波频率及波幅与曝气量有关.在曝气量0.07~0.28m3/(m2·h),跃温层温度梯度0.29~0.48℃/m的中试条件下,内波破坏分层过程主要以减小表层和底层水温差别、驱使跃温层下潜、等温层变薄为特征,破坏分层的速度与曝气量正相关、与温度梯度负相关.内波通过垂向振荡和横向传播,促进不同温度的水层之间的热交换.相对传统的循环水流混合,在温度梯度约0.32℃/m和0.46℃/m的条件下,当曝气量从0.07m3/(m2·h)逐渐增加到0.28m3/(m2·h)时,内波混合可分别将破坏分层效率提高25.0%~40.0%和41.2%~60.0%.     

微孔曝气国内外研究进展及趋势分析

分析比较了国内外微孔曝气研究和应用实例,指出了目前微孔曝气技术的研究重点。同时,综合国内外研究人员的研究成果,分别叙述了曝气量、安装水深、安装面积、孔径、水质和气孔堵塞状况对微孔曝气充氧性能的影响,对不同影响因素的作用效果做了总结,并指出目前研究存在的问题。以期对污水处理厂曝气系统的优化提供借鉴,对拟采用微孔曝气法进行生态修复的研究提供参考。