Comparison of Two Manual Methods of Nitrogen Dioxide Determination in Ambient Air

Sodium arsenite (modified Jacobs and Hochheiser method; hereafter referred as SA), the most widely used manual monitoring method for determination of nitrogen dioxide (NO₂) in ambient air, particularly in developing countries has been evaluated and compared with US EPA recommended equivalent method of TGS-ANSA (hereafter referred as ANSA). NO₂ concentrations generated from laboratory test atmosphere were analyzed by these two methods and were compared statistically. Laboratory evaluations showed that SA method has high sensitivity to different sampling conditions, which normally vary during actual field monitoring. Hence, correction factors for absorption efficiency were estimated for SA and ANSA methods. Absorption efficiency of NO₂ in SA method was found to be much lower (64%) as against the reported value of 82% at the method recommended sampling conditions, whereas for ANSA method, it was found 1.0 as against the reported value of 0.93. After applying derived correction factors, both the methods produced almost similar concentration values of NO₂.     

强酸型离子交换纤维富集-火焰原子吸收测定水中痕量铜、铅、镉、镍

通过强酸型离子交换纤维柱,在同一水样中同时富集和洗脱了铜、铅、镉、镍,采用火焰原子吸收光谱法测定,并对富集条件及洗脱条件、干扰因素进行了探讨。该方法简便易行,回收率在96.1%~105.5%之间,测定的相对标准偏差小于5.0%。     

Monitoring of Butter and Ghee (Clarified Butter Fat) for Pesticidal Contamination from Cotton Belt of Haryana, India

Butter (45) and ghee (55) samples were collected from rural and urban areas of cotton growing belt of Haryana and analysed for detecting the residues of organochlorine, synthetic pyrethroid and organophosphate insecticides. The estimation was carried out by using multi residue analytical technique employing GC-ECD and GC-NPD systems equipped with capillary columns. Butter samples were comparatively more contaminated (97%) than ghee (94%), showing more contamination with organochlorine insecticides from urban samples. About 11% samples of butter showed endosulfan residues above MRL value and 2% samples had residues of synthetic pyrethroids and organophosphates each above their respective MRL values. In ghee, residues of HCH & DDT both and of endosulfan exceeded the MRL values in 5 and 20% samples, respectively. Among organophosphates, only chlorpyriphos was detected with 9% samples showing its residue above MRL value. Irrespective of contamination levels, residues above the MRL values were more in ghee. More extensive study covering other agricultural regions/zones of Haryana has been suggested to know the overall scenario of contamination of milk products.     

Air Pollution and Heat Exposure Study in the Workplace in a Glass Manufacturing Unit in India

Air pollution in the workplace environment due to industrial operation have been found to cause serious occupational health hazard. Similarly, heat stress is still most neglected occupational hazard in the tropical and subtropical countries like India. The hot climate augments the heat exposure close to sources like furnaces. In this study an attempt is made to assess air pollution and heat exposure levels to workers in the workplace environment in glass manufacturing unit located in the State of Gujarat, India. Samples for workplace air quality were collected for SPM, SO₂, NO₂ and CO₂ at eight locations. Results of workplace air quality showed 8-hourly average concentrations of SPM: 165–9118 μg/m³, SO₂: 6–9 μg/m³ and NO₂: 5–42 μg/m³, which were below the threshold limit values of workplace environment. The level of CO₂ in workplace air of the plant was found to be in the range 827–2886 μg/m³, which was below TLV but much higher than the normal concentration for CO₂ in the air (585 mg/m³). Indoor heat exposure was studied near the furnace and at various locations in an industrial complex for glass manufacturing. The heat exposure parameters including the air temperature, the wet bulb temperature, and the globe parameters were measured. The Wet Bulb Globe Temperature (WBGT), an indicator of heat, exceeded ACGIH TLVs limits most of the time at all the locations in workplace areas. The recommended duration of work and rest have also been estimated.     

基于颗粒物浓度的沙尘天气分级标准研究

沙尘天气在近年对我国城市空气质量造成明显影响。目前我国沙尘天气分级仍然按照气象标准 ,主要是以水平能见度进行分级。文章参考国外的有关标准 ,通过统计近年来我国沙尘天气过程中的颗粒物浓度 ,结合我国沙尘天气的发生情况和特点 ,提出了基于沙尘浓度的沙尘天气分级标准     

固相萃取富集高效液相色谱法测定环境水样中的重金属元素

研究了用固相萃取富集高效液相色谱法测定环境水样中痕量重金属镍、铜、银、铅、镉和汞的方法。环境水样中的镍、铜、银、铅、镉和汞用四 -(对二甲氨基苯基 ) -卟啉 (T4 -DMAPP)柱前衍生 ,用C18固相萃取小柱萃取富集镍、铜、银、铅、镉和汞的T4 -DMAPP络合物 ,富集倍数为 1 0 0倍 ,然后用甲醇和四氢呋喃梯度洗脱为流动相 ,WatersXter raTMRP18( 3 9mm× 1 5 0mm)色谱柱为固定相分离 ,用二极管矩阵检测器检测。镍、铜、银、铅、镉和汞的检测限分别为3、2、4、3、1 5ng/L和 3ng/L。方法相对标准偏差为 1 8%— 3 2 % ,标准回收率为 92 %— 1 0 7%。该方法用于测定环境水样中的痕量重金属 ,结果令人满意     

冷凝吸附法测定痕量挥发性含硫气体

采用冷凝吸附法对痕量挥发性含硫气体的测定进行了研究 ,结果表明自行设计的冷凝吸附装置对于痕量挥发性含硫气体的富集有着良好的效果 ,富集效率可达 94%以上     

Cu、Pb、Zn火焰原子吸收多谱线分析在环境监测中的应用

对铜的 3条谱线 (2 49.2 nm、2 61 .4nm,3 2 4.8nm ) ,铅的 2条谱线 (2 83 .3 nm、2 1 7.0 1 nm )以及锌的 2条谱线(3 0 7.6nm、2 1 3 .9nm ) ,共 7条谱线的灵敏度、检测限、线性范围进行了归纳性总结 ,并对多种共存元素可能存在的干扰情况进行了研究 ,认为利用元素不同分析谱线的分析灵敏度差异 ,根据被测元素在样品消解液中含量 ,选择合适的谱线进行分析 ,既降低工作强度 ,又能获得满意结果     

固相萃取-气相色谱法测定水中硝基苯类有机污染物的方法研究

建立了固相萃取、毛细柱气相色谱-电子捕获检测器定量分析水中硝基苯类化合物的分析方法。通过对固相萃取柱的选择、固相萃取条件(样品溶液的pH值、上样速度、上样体积、洗脱液选择及配比)的优化,得出了最佳实验条件。穿透体积可达1.5L,回收率在80%~105%,最小检出浓度在0.00037~0.072μg/L之间,均大大低于GB13194-91的规定。相对标准偏差在0.7%~5.3%之间。该方法准确、简单,重现性好、回收率高,污染小。     

水中呋喃丹气相色谱-质谱的测定方法研究

建立了气相色谱-质谱联用法测定水中呋喃丹的方法。用二氯甲烷萃取酸性水样中的呋喃丹,浓缩后加入内标苊-d10,采用气-质联用仪中选择离子检测(SIM)模式进行监测,提取目标化合物的特征离子进行定量,该方法灵敏度高,水中呋喃丹的最低检测浓度可达0.05μg/L;准确度好,样品添加回收率在100.5%-111.0%之间;平行5次进行精密度试验,相对标准偏差低于6.21%。结果表明,方法简便、快速、准确、重现性好,适合各种水中呋喃丹的测定。