活性炭在膜生物反应器中的应用研究进展

活性炭是一种非常优良的吸附剂,具有物理吸附和化学吸附的双重特性。本文介绍了近年来向膜生物反应器中投加活性炭的应用研究进展,表明投加活性炭可以提高膜生物反应器的处理效果,同时对改善膜污染有很好的效果。     

膜生物反应器中溶解性微生物产物特性的研究进展

溶解性微生物产物是制约生物处理出水达标和回用的主要污染物,处理工艺和操作条件的不同可能造成其特性差异。阐述了溶解性微生物产物的定义和产生机制,对膜生物反应器中溶解性微生物产物的组成、分子质量分布、亲水／疏水性、螯合性和毒性进行了概述,分析了影响其产生、特性和去除的因素。由于膜的截留作用使溶解性微生物产物在膜生物反应器中积累,容易引起膜污染。可以通过优化操作条件,减少溶解性微生物产物的产生,提高出水水质,有效地抑制膜污染。     

Evaluation of environmental feasibility of steel pipe sheet pile cutoff wall at coastal landfill sites

An evaluation method that can express the local leakage of leachate from joint sections in steel pipe sheet pile (SPSP) cutoff walls is discussed in this study. In particular, the evaluation of environmental feasibility (containment of leachates containing toxic substances) considering a three-dimensional arrangement and hydraulic conductivity distribution of the joint sections in the SPSP cutoff wall is compared with an evaluation that uses the equivalent hydraulic conductivity. This equivalent hydraulic conductivity assumes that the joint section and the steel pipe are integrated; therefore, the hydraulic conductivity is substituted with a uniform permeable layer. However, in an evaluation that employs the equivalent hydraulic conductivity, it is difficult to consider the local leakage of leachate containing toxic substances from the joint sections in the SPSP cutoff wall. It was established that evaluations of the environmental feasibility of SPSP cutoff walls with joint sections must take into account the local leakage of leachates containing toxic substances from the joint sections. Also, it was clarified that technologies that lower the hydraulic conductivities of joint sections in SPSP cutoff walls and also facilitate the use of sparser joint arrangements contribute significantly to increasing the environmental feasibility of SPSP cutoff walls at landfill sites.     

陶瓷膜污染过程分析与膜清洗方法优化

采用膜孔径为50 nm的陶瓷膜错流过滤方式,对碱性高浓度有机洗涤废水进行9个周期的膜通量衰减及反向脉冲清洗再生实验研究.通过设计膜污染阻力构成实验,测算膜污染总阻力及其构成比例.实验结果表明,膜固有阻力比例较低,浓差极化污染较弱,Rt和Rc+Rirt污染阻力稳定性较高,膜堵塞形式兼有孔内堵塞和滤饼过滤;选择质量分数0.1％的稀盐酸和0.2％的草酸溶液膜清洗效果均较好,清洗时间为3 min,脉冲时间和频率为3 s/5 s.     

混凝剂品种对混凝-超滤联合工艺膜污染的影响

本实验以工业化学合成聚合硫酸铁混凝剂和自制生物聚合硫酸铁为例,考察了铁系混凝剂品种对地表水浊度、TOC和UV254的去除效果,混凝剂品种对混凝-超滤联合工艺处理地表水过程中超滤膜污染的影响。混凝实验结果表明,在10 mg/L(以Fe3+计)最佳投加量下,两类混凝剂对浊度、TOC和UV254的去除率基本相同。超滤膜污染实验结果表明,生物聚合铁预处理水样通量衰减速度略大于化学聚合铁预处理水样;膜污染阻力分析结果显示,随着循环次数的增加,工业化学合成聚合铁预处理水样造成的不可逆污染阻力逐渐增加,而生物聚合铁预处理水样造成的不可逆污染阻力却略有下降;膜污染机理分析表明,2组过滤过程的膜污染类型基本相似,由最初的膜孔堵塞过渡到最终的滤饼层污染。SEM分析表明,生物聚合铁预处理水样的膜污染较为严重。     

Fenton氧化-序批式膜生物反应器耦合处理干法腈纶废水

采用Fenton氧化-序批式膜生物反应器(SBMBR)组合工艺处理干法腈纶废水。结果表明,在废水初始pH值为3.0,H2O2投加量为90.0 mmol/L,Fe2+投加量为20.0 mmol/L,反应时间为2.0 h的条件下,Fenton氧化预处理对腈纶生产废水的COD去除率达到47.0%以上,COD由1 091 mg/L降至560 mg/L,废水的BOD5/COD由0.32升至0.69,废水的可生化性得到显著提高。Fenton处理出水与丙烯腈废水等比例混合后,采用SBMBR进行生化处理,在水力停留时间为24 h,90 min缺氧/150 min好氧交替运行的条件下,COD、NH4+-N和TN的平均去除率分别为71.7%、97.2%和47.4%,碳源不足是限制TN去除效果的主要影响因素。在无外加碳源的条件下,组合工艺处理后出水COD和NH4+-N浓度分别为117 mg/L和1.7 mg/L,出水水质可以稳定达到国家一级排放标准(GB8978-1996)。     

无机陶瓷膜处理油田采出水

针对陶瓷膜在油田采出水处理过程中操作参数的选择及污染机理进行了研究。通过现场实验,分析了不同的操作参数对膜通量的影响,陶瓷膜对含油量及悬浮物的去除效果,膜阻力组成及膜污染清洗方法。实验结果表明,在确定出水水质达到低渗透油田注水水质A1级标准条件下,陶瓷膜过滤最佳操作条件为:跨膜压差0.16 MPa、温度50℃、膜面流速5.0 m/s。同时发现,NaOH和HNO3联合清洗有助于恢复膜通量。     

MFC-MBR耦合系统运行效果

膜生物反应器(MBR)是一种高效的污水处理工艺,而微生物燃料电池(MFC)能有效降解污泥中的胞外生物有机质(EBOM)并回收电能.将MFC与MBR联用,建立了一套能够有效抑制膜污染同时回收电能的新系统——MFC-MBR耦合系统,MBR的剩余污泥经MFC处理后回流.以传统MBR为对照,对耦合系统中污水处理效果、膜污染情况和污泥混合液的性质进行研究.研究表明,耦合系统的污水处理效果没有明显恶化,COD去除率为94％,NH4+-N的去除率为92％.耦合系统能够有效减缓膜污染的发生,清洗周期延长了28％.污泥混合液的MLVSS/MLSS稳定在80％ ～ 88％,系统内几乎没有无机颗粒积累.松散结合态胞外聚合物(LB-EPS)降低了48％,使污泥混合液性质得到改善.较低的污泥比阻(2.69×1012m/kg)和标准化毛细吸水时间(1.67 s·L/g MLSS),证明耦合系统污泥混合液脱水性能提高了.     

PM2.5在线监测技术概述

针对PM2.5颗粒物监测技术和PM2.5的监测网络的建设,重点介绍了美国多年来对PM2.5的监测状况,以及采用的Beta射线法、Beta射线光浊度法、微量振荡天平法等监测技术的方法和原理;指出综合国内外多年的监测经验,PM2.5的在线监测需要经过大量手工经典方法数据作为比对和校验,才能给出有效而高质量的PM2.5监测数据。     

Effect of ingested titanium dioxide nanoparticles on the digestive gland cell membrane of terrestrial isopods

The aim of this study was to find out whether ingested titanium dioxide nanoparticles (nano-TiO₂) cause cell membrane damage by direct contact or by lipid peroxidation. We assessed lipid peroxidation and digestive gland cell membrane stability of animals fed on food dosed with nano-TiO₂. Conventional toxicity measures were completed to determine if cellular effects are propagated to higher levels of biological complexity. An invertebrate model organism (Porcellio scaber, Isopoda, Crustacea) was fed with food containing nanosized TiO₂ and the result confirmed that at higher exposure concentrations after 3 d exposure, nano-TiO₂ destabilized cell membranes but lipid peroxidation was not detected. Oxidative stress as evidenced by lipid peroxidation was observed at longer exposure durations and high exposure doses. These data suggest that cell membranes are destabilized by direct interactions between nanoparticles and cell membrane, not solely via oxidative stress.