高效重金属螯合剂RDTC的研制及处理含铜废水性能

以四乙烯五胺、二氯乙烷和哌嗪为主要原料研制了一种二硫代氨基甲酸盐（DTC）类重金属螯合剂RDTC,采用红外光谱对其结构进行了表征.研究了RDTC投加量、废水初始pH值和致浊物质对模拟含铜废水中Cu（Ⅱ）去除效果的影响,用测定浊度的方法研究了絮体的沉降性能,并采用溶出法对沉渣的稳定性进行了分析.结果表明,处理250 mL...     

金盆水库沉积物磷的来源及分布特征

为探究分层型水源水库沉积物中磷的来源与分布特征,以西安金盆水库为对象,针对2017年3～11月金盆水库水体、沉降颗粒及沉积物柱状样品总磷(TP)含量及形态分布特征进行研究.结果表明,金盆水库主库区表层沉积物总磷含量及形态分布受水体颗粒磷(PP)沉降作用明显,相关系数r~2=0. 877 5;同时表层沉积物总磷含量还受到沉积物内部生物地球化学的共同作用. 6～8月金盆水库水体藻类剧烈繁殖演替,繁殖过程中大量失去活性、死亡的藻类不断向底部水体沉积,形成以藻类等颗粒磷为主导的内源污染,沉降颗粒总磷含量达(753. 51±17. 11) mg·kg~(-1),表层沉积物总磷含量随之增加,以铁铝结合态非活性磷(NaOH-nrP)为主; 9～11月进入汛期,径流水体携带大量泥沙等负荷较大的污染物汇入水库,使得水体颗粒磷浓度相应增大,然而由于单位质量泥沙中总磷含量占比较小,导致径流过程中表层沉积物总磷含量逐渐降低,泥沙径流过程中颗粒磷以无机态的钙磷(Ca-P)和残渣态磷(rest-P)为主,二者约占沉积物总磷(TP) 55. 8%～66. 2%,受颗粒沉降影响相对较大.活性磷(SRP)、铁锰螯合态磷(BD-P)和铁铝结合态活性磷(NaOH-srP)这3种形态磷较活跃,在环境条件的变化(主要是氧化还原条件)下发生一系列迁移转化,受沉积物内部生物地球生物化学过程作用明显.     

加载絮体形态对短流程超滤膜污染影响效应

以聚硫酸铁（PFS）为混凝剂,微砂为载体颗粒,系统考察了采用加载絮凝-超滤联用工艺净化含高岭土、腐植酸和锑[Sb（Ⅲ）]的模拟原水过程中,不同PFS和微砂投加量条件下加载絮体形态特性以及其对超滤膜通量衰减、膜污染可逆性和宏观出水水质等的影响,并分析了膜污染机理.结果表明,PFS投加量对絮体形态及膜滤效能和膜污染影响显著,且投加量过少或过多均会产生不利影响,以30mg/L为宜;与不投加微砂的工况相比,加入微砂更易于形成大而结构较为松散的絮体,可有效削弱不可逆膜污染,并获得较为稳定的超滤出水水质;超滤末端膜比通量与絮体平均粒径呈良好的正相关性（R²=0.8774）,但因加载絮凝体系中引起分形维数变大的不同类型颗粒（包括小粒径范围絮体和未被加载絮体捕获的微砂）对超滤净水过程产生的影响各异,致使膜通量与分形维数的负相关性较差（R²=0.5760）.     

含有机氟工业废水处理工艺的研究

采用预处理-水解酸化-生物接触氧化相结合的处理工艺处理含氟代有机化合物废水。研究结果表明，水解酸化可将含氟废水的B／C比由0．258提高到0．396％；在一定浓度范围内通过物化预处理及生化处理可以脱除氟代有机化合物中的氟原子，使该有机物成为可供微生物利用的基质。含氟废水经该工艺处理后，出水中BOD5为7．5mg/L,CODcr为75mg/L，氨氮未检出，总磷小于1mg/L，氟离子浓度为8．6mg/L。     

垃圾渗滤液特性分析及Fenton预处理研究

利用Fenton—混凝沉淀法预处理广西某垃圾焚烧发电厂和垃圾填埋场的垃圾渗滤液,对Fenton试剂以及混凝沉淀进行了单因素分析,分别研究了垃圾渗滤液在不同的n[Fe2+]/n[H2O2]、H2O2投加量、FeSO4投加量、pH值、反应时间、PAC投加量等条件下的处理效果。结果表明:垃圾渗滤液经Fenton—混凝预处理,对COD、色度、SS处理效果好,对NH3—N去除效果不明显;渗滤液的可生化性有所提高,可进行后续生化处理。     

磁絮凝高效处理高浊度废水的性能及机理研究

自来水供水厂在运行过程会产生大量高浊度废水,其中富集了许多微生物、有机物及无机杂质,若直接排放会严重污染河流水体及周边土壤.采用磁絮凝工艺处理自来水厂供水过程中产生的高浊度废水,通过单因素和正交试验考察了聚合氯化铝(PAC)投加量、磁种(Fe3O4)投加量、废水初始pH值和沉降时间对废水中浊度、COD和UV254去除效...     

高色度印染废水和染料废水的脱色新技术应用

应用氧化絮凝复合新技术处理高色度印染废水和染料废水,研究了影响脱色效果的一系列物理化学因素。本技术应用于高色度印染废水和染料废水的脱色处理,可使其脱色率达99％以上,CODcr去除率也在80％以上。     

VALIDATION OF THE SWAT MODEL ON A LARGE RWER BASIN WITH POINT AND NONPOINT SOURCES1

ABSTRACT: The State of Texas has initiated the development of a Total Maximum Daily Load program in the Bosque River Watershed, where point and nonpoint sources of pollution are a concern. Soil Water Assessment Tool (SWAT) was validated for flow, sediment, and nutrients in the watershed to evaluate alternative management scenarios and estimate their effects in controlling pollution. This paper discusses the calibration and validation at two locations, Hico and Valley Mills, along the North Bosque River. Calibration for flow was performed from 1960 through 1998. Sediment and nutrient calibration was done from 1993 through 1997 at Hico and from 1996 through 1997 at Valley Mills. Model validation was performed for 1998. Time series plots and statistical measures were used to verify model predictions. Predicted values generally matched well with the observed values during calibration and validation (R²≥ 0.6 and Nash‐Suttcliffe Efficiency ≥ 0.5, in most instances) except for some underprediction of nitrogen during calibration at both locations and sediment and organic nutrients during validation at Valley Mills. This study showed that SWAT was able to predict flow, sediment, and nutrients successfully and can be used to study the effects of alternative management scenarios.     

SAMPLING FRAME FOR IMPROVING PEBBLE COUNT ACCURACY IN COARSE GRAVEL‐BED STREAMS1

ABSTRACT: Improved sampling techniques are needed to increase the accuracy of pebble‐count particle‐size distributions used for stream studies in gravel‐bed streams. However, pebble counts are prone to operator errors introduced through subjective particle selection, serial correlation, and inaccurate particle‐size measurements. Errors in particle‐size measurements can be minimized by using a gravel template. Operator influence on particle selection can be minimized by using a sampling frame, 60 by 60 cm, in which sampling points are identified by the cross points of thin elastic bands. Serial correlation can be minimized by adjusting the spacing between the cross points and setting it equal to the dominant large particle size (=D₉₅). In a field test in a cobble‐bed stream, the sampling frame developed in this study produced slightly coarser size distributions, particularly in the cobble range, than the traditional heel‐to‐toe walk that selects particles with a blind touch at the tip of the boot. The sampling frame produced more similar sampling results between two operators than heel‐to‐toe walks. The difference between the two sampling methods is attributed to an unbiased selection of fine and coarse particles when using the sampling frame.     

曝气-絮凝处理垃圾渗滤液研究

通过现场处理 ,对垃圾渗滤液的曝气 -絮凝处理进行了研究。结果表明该方法对渗滤液的色度、COD、总磷去除率达 80 %以上 ,对氨氮去除率达 60 %以上。在此基础上提出了最优综合控制指标