Influence of temporally variable groundwater flow conditions on point measurements and contaminant mass flux estimations

Monitoring of contaminant concentrations, e.g., for the estimation of mass discharge or contaminant degradation rates, often is based on point measurements at observation wells. In addition to the problem, that point measurements may not be spatially representative, a further complication may arise due to the temporal dynamics of groundwater flow, which may cause a concentration measurement to be not temporally representative. This paper presents results from a numerical modeling study focusing on temporal variations of the groundwater flow direction. “Measurements” are obtained from point information representing observation wells installed along control planes using different well frequencies and configurations. Results of the scenario simulations show that temporally variable flow conditions can lead to significant temporal fluctuations of the concentration and thus are a substantial source of uncertainty for point measurements. Temporal variation of point concentration measurements may be as high as the average concentration determined, especially near the plume fringe, even when assuming a homogeneous distribution of the hydraulic conductivity. If a heterogeneous hydraulic conductivity field is present, the concentration variability due to a fluctuating groundwater flow direction varies significantly within the control plane and between the different realizations. Determination of contaminant mass fluxes is also influenced by the temporal variability of the concentration measurement, especially for large spacings of the observation wells. Passive dosimeter sampling is found to be appropriate for evaluating the stationarity of contaminant plumes as well as for estimating average concentrations over time when the plume has fully developed. Representative sampling has to be performed over several periods of groundwater flow fluctuation. For the determination of mass fluxes at heterogeneous sites, however, local fluxes, which may vary considerably along a control plane, have to be accounted for. Here, dosimeter sampling in combination with time integrated local water flux measurements can improve mass flux estimates under dynamic flow conditions.     

基于超临界水氧化过程的能源环境系统设计

阐述了超临界水氧化过程的工艺路线,介绍了超临界水氧化过程的特点,提出了基于超临界水氧化过程的能源环境系统,设计了几种热量与能量回收系统程的耦合工艺,为提高超临界水氧化过程的经济性奠定了基础。     

The whole relationship between environmental variables and firm performance: Competitive advantage and firm resources as mediator variables

The examination of the possible direct link between environmental protection and firm performance in the literature has generally produced mixed results. The present paper contributes to the literature by using the resource-based view as a mediating process in this relationship. The study specifically tests whether or not the resource-based view of the firm mediates the positive relationships of proactive environmental management and improved environmental performance with competitive advantage, which also has consequences for financial performance. We also check the possible link between the adoption of a pioneering approach and good environmental management practices. Our findings support that early investment timing and intensity in environmental issues impact on the adoption of a proactive environmental management, which in turn helps to improve environmental performance. The findings also show that a firm's resources and competitive advantage act as mediator variables for a positive relationship between environmental protection and financial performance. This contribution is original because the present paper develops a comprehensive whole picture of this path process, which has previously only been partially discussed in the literature. In addition, this study clarifies a relevant point in the literature, namely that the effect of environmental protection on firm performance is not direct and can vary depending on the sector considered. Whereas competitive advantage in relation to costs influences financial performance in the IPPC law sector, the relevant influence in the hotel sector comes from competitive advantage through differentiation.     

Evaluation of a Watershed Model for Estimating Daily Flow Using Limited Flow Measurements1

Abstract: The Soil and Water Assessment Tool (SWAT) model was evaluated for estimation of continuous daily flow based on limited flow measurements in the Upper Oyster Creek (UOC) watershed. SWAT was calibrated against limited measured flow data and then validated. The Nash‐Sutcliffe model Efficiency (NSE) and mean relative error values of daily flow estimations were 0.66 and 15% for calibration, and 0.56 and 4% for validation, respectively. Also, further evaluation of the model’s estimation of flow at multiple locations was conducted with parametric paired t‐test and nonparametric sign test at a 95% confidence level. Among the five main stem stations, four stations were statistically shown to have good agreement between predicted and measured flows. SWAT underestimated the flow of the fifth main stem station possibly because of the existence of complex flood control measures near to the station. SWAT estimated the daily flow at one tributary station well, but with relatively large errors for the other two tributaries. The spatial pattern of predicted flows matched the measured ones well. Overall, it was concluded from the graphical comparisons and statistical analyses of the model results that SWAT was capable of reproducing continuous daily flows based on limited flow data as is the case in the UOC watershed.     

Physical Modeling of Emissions from Naturally Ventilated Underground Parking Garages

The dispersion of pollutants from naturally ventilated underground parking garages has been studied in a boundary layer wind tunnel. Two idealized model setups have been analysed, one was simulating pollutant dispersion around an isolated rectangular building and one was representing dispersion in a finite array of idealized building blocks. Flow and dispersion close to modelled ground level emission sources was measured. The results illustrate the complexity of the flow around buildings and provide insight in pollutant transport from ground level sources located directly on building surfaces. As a result, areas critical with respect to high pollutant concentrations could be visualized. Particularly, the results show high concentration gradients on the surface of the buildings equipped with modelled emission sources. Inside the boundary layers on the building walls, a significant amount of pollutants is transported to upwind locations on the surface of the building. The paper documents the potential of physical modelling to be used for the simulation and measurement of dispersion close to emission sources and within complex building arrangements.     

HAN阻隔防爆模型研究

通过合理简化,利用多方气体状态方程,分别建立油品储运容器内可燃混合气体定容爆炸模型和装设阻隔防爆材料的油品储运容器内可燃混合气体爆炸模型,获得了阻隔防爆性能测试装置的燃爆容器抗爆设计限值,以及其在HAN阻隔防爆测试中燃爆容器试爆压力量级的控制下限值,同时,还给出HAN工程应用中容器留空率的计算方法,具有实际指导意义。     

Combustion characteristics of Malaysian municipal solid waste and predictions of air flow in a rotary kiln incinerator

Malaysia is in dire need of alternatives to landfilling for solid waste management. Recently, landfills have faced the problems of overfilling, overflowing of leachates leading to pollution of water resources, and uncontrolled dust emissions adversely affecting the local environment. With the rising cost of urbanization coupled with the high rate of waste generation, one possible method of waste treatment that is receiving particular attention by the government is incineration. Incineration of solid waste is rather new in Malaysia, with limited usage in handling small sources of waste generation such as the municipal solid waste (MSW) of resort islands; however, its potential in ameliorating the problems associated with solid waste treatment may make it an attractive alternative to landfill. This article presents the results of test runs conducted to investigate the performance of a locally designed and manufactured rotary kiln incinerator (RKI). The test runs were conducted using MSW collected from the Shah Alam municipality. The combustion efficiency was analyzed by looking at the temperature profiles and chemical species concentrations. To complement the combustion characteristics measurements, predictions of the air flow in the incinerator during the process were also investigated. The overall performance of the RKI suggests that it is suitable for treating MSW.     

Sustainability, substance flow management and time. Part I Temporal analysis of substance flows

Flows of chemical substances need to be managed in a sustainable way. Sustainable development as a whole and the sustainable management of substance flows in particular are both time issues. These include the importance of the dynamics of substance flows and the way these interconnect with the use of resources, the avoidance of environmental pollution, and their effects on health and food production. Another prerequisite for the proper management of substance flows is justice within and between generations. This requires a systematic approach and a systematic analysis of the issues as well as of the actions to be taken. One tool for such a systematic approach is temporal analysis. It brings the temporal aspects of the substances themselves and of their intended use, as well as factors affecting the stakeholders, such as decision makers, producers and consumers, into focus. In the past, timing factors were rarely taken into account. Knowledge of the temporal dynamics of substance flows and their resultant outcomes, as well as of their interaction with ecological, economic and social systems, is a basic requirement for successful substance flow management. The need to include temporal aspects into substance flow management and how to do so is outlined here. Included are not only politicians but also practitioners and scientists who must explicitly take into account adequate time scales, points in time, breaks and other forms of time in planning and acting.     

Experimental Study of the Criteria of Flow Laminarization in Two-Dimensional Dense Gas Plumes

Laminarization of flow in a two-dimensional dense gas plume was experimentally investigated in this study. The plume was created by releasing CO₂ through a ground-level line source into a simulated turbulent boundary layer over an aerodynamically rough surface in a meteorological wind tunnel. The bulk Richardson number (Ri_*), based on negative plume buoyancy, plume thickness, and friction velocity, was varied over a wide range so that the effects of stable stratification on plume laminarization could be observed. A variety of ambient wind speeds as well as three different sizes of roughness arrays were used so that possible effects of roughness Reynolds number (Re_*) on plume laminarization could also be identified. Both flow visualization methods and quantitative measurements of velocity and intermittency of turbulence were used to provide quantitative assessments of plume laminarization.Flow visualization provided an overall picture of how the plume was affected by the negative buoyancy. With increasing Ri_*, both the plume depth and the vertical mixing were significantly suppressed, while upstream propagation of the plume from the source was enhanced. The most important feature of the flow revealed by visualization was the laminarization of flow in the lower part of the plume, which appeared to be closely related to both Ri_* and Re_*.Measurements within the simulated dense gas plumes revealed the influence of the stable stratification on mean velocity and turbulence intensity profiles. Both the mean velocity and turbulence intensity were significantly reduced near the surface; and these reductions systematically depended on Ri_*. The roughness Reynolds number also had considerable influence on the mean flow and turbulence structure of the dense gas plumes.An intermittency analysis technique was developed and applied to the digitized instantaneous velocity signals. It not only confirmed the general flow picture within the dense plume indicated by the flow visualization, but also clearly demonstrated the changes of flow regime with variations in Ri_* and Re_*. Most importantly, based on this intermittency analysis, simple criteria for characterizing different flow regimes are formulated; these may be useful in predicting when plume laminarization might occur.     

利用餐饮业废油脂制造生物柴油

世界的石油产量将会逐渐减少,石化柴油燃烧后所排放的废气是造成的城市空气污染的主要原因,生物柴油是石化柴油很好的替代能源,文章介绍了国外废油脂处理利用和甸餐饮业废油脂的概况,提出了利用餐饮业废油脂制造生物柴油的方法和工艺流程,并讨论了利用餐饮业废油脂制造生物柴油的几个问题。