旋流分离器油水分离效率的模拟研究

采用计算流体力学的方法,探讨了操作条件和物料特性对旋流分离器分离油水效率的影响。旋流器为单锥双入口,其主直径为50 mm,锥角为5.5°。模拟过程中,采用商业用软件‘Fluent 6.3’中的雷诺应力模型和欧拉多相流模型来模拟不同条件下油水旋流分离器的分离性能。模拟结果表明,对于本研究的油水旋流分离器,最佳的分流比是10%,最佳的油滴浓度是0.5%(V/V)。在最佳的分流比和油滴浓度下,当进口流速为10.46 m/s时,油水旋流分离器可将15μm的油滴去除80%以上,油滴的分离界限粒径d50(50%的分离效率)为9.2μm。在模拟的基础上,用统计软件STATISTICA6.0对分离效率与操作条件和物料特性之间的关系进行拟合。通过拟合式预测的分离效率与实测值相吻合,误差小于15%。     

两级氧化法处理油田压裂返排液

采用两级氧化法处理油田压裂返排液。在次氯酸钠、次氯酸钙、过氧化氢、高锰酸钾4种氧化剂中,次氯酸钠的氧化效果最好。以次氯酸钠作为一级氧化剂,进行一级氧化处理;再分别采用次氯酸钙、过氧化氢、高锰酸钾进行二级氧化处理。在次氯酸钠加入量为40mL/L、一级氧化反应时间为30min、二级氧化反应时间为30min、初始废水COD为3976mg/L的条件下,二级氧化剂过氧化氢、次氯酸钙、高锰酸钾的最佳加入量分别为80,40,40mL/L,对应的COD去除率分别为82.60%,71.50%,83.50%。     

汽车镀锌板泥浆附着研究初探

介绍了镀锌板在大气和土壤中的研究结果;简要讨论了镀锌板通常出现的腐蚀形式;分析了镀锌板在泥浆状态中的腐蚀状况.其腐蚀是大气与土壤腐蚀的一个衔接过程,影响因素很多,可控性差.针对汽车板泥浆附着的腐蚀问题,设计了一种简化的研究模型,尝试性地做了一些实验室的研究,提出了几种可行的研究方法.     

Carbon capture and storage-desirability from a risk management point of view

Environmental and safety risks related to carbon capture and storage concern leakages and accidental releases during transport and geological storage. Based on principles widely accepted in the EU and beyond in the discussion about the where’s and why’s of nuclear waste repositories, this paper discusses the desirability of carbon capture and storage from a risk management point of view, focusing on environmental risks on the global level (climate change). On this basis it is concluded that, if the key energy issue of coming generations, not just in Europe but all around the world, is not the abundance of fossil resources but rather an unacceptably high probability of global warming due to greenhouse gas emissions, then the solution should not include any massive hiding of the emissions but entirely focus on the avoidance based on improved technology in power plants and other industrial installations.     

环境监测报告(记录)的审核原则和方法

从实际工作出发,提出了审核原始记录、数字型监测报告（报表）和文字型监测报告的审核原则和方法。     

新建住宅小区噪声验收监测方法初探

住宅小区噪声监测是近年来房地产验收过程中的重要环节,围绕新建住宅小区噪声验收监测方法、评价标准、布点原则等方面进行初步探讨,并根据某住宅小区噪声验收监测实例,提出了相应的建议。     

Influence of Building Density and Roof Shape on the Wind and Dispersion Characteristics in an Urban Area: A Numerical Study

The Computational Fluid Dynamics code CFX-TASCflow is used for simulating the wind flow and pollutant concentration patterns in two-dimensional wind-tunnel models of an urban area. Several two-dimensional multiple street canyon configurations are studied corresponding to different areal densities and roof shapes. A line source of a tracer gas is placed at the bottom of one street canyon for modelling street-level traffic emissions. The flow fields resulting from the simulations correspond to the patterns observed in street canyons. In particular and in good agreement with observations, a dual vortex system is predicted for a deep flat-roof street canyon configuration, while an even more complex vortex system is evidenced in the case of slanted-roof square street canyons. In agreement with measurement data, high pollutant concentration levels are predicted either on the leeward or the windward side of the street canyon, depending on the geometrical details of the surrounding buildings.     

容检规中非圆形缺陷可接受准则的安全裕度

文章以国内典型压力容器用材245R为例，采用GB／T19624~断裂力学评价方法对于《压力容器定期检验规程》表5、表6中的超标非圆形缺陷可接受准则的安全裕度进行评价，评价结果表明其中可接受准则的部分规定不够保守，就此作者给出相关的修改建议。     

On the moral acceptability of killing animals

According to a rights view it is acceptable to kill animals if they are innocent threats or shields or are in a lifeboat situation. However, according to advocates of such a view, our practices of killing animals for food or scientific research may be morally unacceptable. In this paper we argue that, even if we grant the basic assumptions of a rights view, a good deal of killing of animals for food and scientific research continues to be morally acceptable.