循环流化床烟气悬浮脱硫技术中试及机理分析

设计了新的循环流化床烟气悬浮脱硫中试装置,其烟气处理量达3500m³/h.首先进行了进料钙硫比(Ca/S)、过饱和温度对装置脱硫效率影响实验,进一步研究了脱硫塔内固体颗粒物循环和烟气流速等因素对脱硫装置性能的影响.对比实验研究表明:在Ca/S=1.2时,固体颗粒物的循环使系统脱硫效率提高15% 左右;脱硫塔内烟气设计流速可以偏高一些.本文同时对系统脱硫过程进行了机理分析,指出了延长脱硫剂有效停留时间的途径.     

The deflectors influence on flow complexity,bed morphology,sediment transport and water quality of urban lotic waters - A laboratory study

In this laboratory study different combinations of bed (sand, pebble gravel [gravel], and a mix of sand and gravel) and flow (typical and overtopping) were experimented with to investigate the impact of porous deflectors in flow diversity, water quality, and fish performance in prismatic open channels. Deflectors changed the gradually varied flow to a rapidly varied flow, as a sudden change in the water depth was observed at the deflectors, and this change was large for smooth beds. With the presence of gravel, the scouring near the downstream deflector was almost twice that of the sand bed, and with the scouring at its own upstream deflector, irrespective of whether the flow was typical or overtopping. This behavior was a result of sand mobilization due to shear stress and sand mobilization aided gravel transport. The mixed bed showed less gravel movement compared to the gravel-only bed. The percentage of sediment washed out was minor for all bed scenarios, indicating that sediment transport was local. Relative to the sand bed without deflectors (representing a typical urban canal), deflectors resulted in reduced and improved water quality (in terms of sediment load) for sand, and mixed bed, respectively. The fishes found refuge and were comfortable in the pool areas created by deflectors unlike in channels without deflectors where they showed exhaustion.     

The use of nanovermiculite catalyst in the study of removal of the organic load and degradation of atrazine via ozone process in RPB reactor

Abstract

The main objective of this study is the degradation of a synthetic solution of atrazine by a modified vermiculite catalyzed ozonation, in a rotating packed bed (RPB) reactor. A 0.5?L RPB reactor was used to perform the experiments, using a Central Composite Design (CCD) response surface to construct the quadratic model based on the factors: pH, catalyst concentration and reactor rotation frequency. The response variable was the removal of the organic load measured in terms of Chemical Oxygen Demand (COD). After the complete quadratic model was constructed through the response surface, the COD degradation process had an optimal removal of 41% under the following conditions: pH 8.0, rotation of 1150?rpm and catalyst concentration 0.66?g L^?1.     

厌氧氨氧化反应器研究进展

厌氧氨氧化是废水生物脱氮研究的新领域,厌氧氨氧化反应器影响厌氧氨氧化菌的富集、厌氧氨氧化过程的启动、运行的稳定性和处理效果,是其中十分重要的研究内容.本文根据厌氧氨氧化反应的基本特征,分析了反应过程对反应器的主要要求;通过对固定床反应器、流化床反应器、气提式反应器、上流式厌氧污泥床(UASB)等反应器的运行参数和运行结果的比较,分析了各种类型反应器的主要优缺点,并对反应器今后的发展方向提出了建议.表2参37     

天然沸石床处理受污染景观水体的试验

采用天然沸石滤床对富营养化景观湖水进行净化试验,结果表明,天然沸石滤床能有效地净化受污染的湖水,CODCr、氨氮、总磷和浊度的去除率分别为35.8%、95.0%、66.7%和78.0%,沸石能有效地去除水中的氨氮,其作用机理包括离子交换和生物硝化两种作用。     

复极性固定床电解槽内电极电位的分布

本文通过设计独特的测量和检验实验装置，对复极性固定床电解槽内的电极电位进行了测试。发现了槽内反应的动力就是槽内粒子与溶液的电位之差，可通过调节它的变化来控制反应的进行。     

三相内循环流化床光催化反应器及其性能

依据流态化原理,设计出一种三相内循环流化床光催化反应器,对反应器的水力特性做了推算,确定了反应器的操作影响因素.对罗丹明B的降解实验结果显示出优越的性能,依据催化剂投加量及初始光强的不同,反应半衰期在4-10.5min之间.     

全程自养脱氨氮悬浮填料床反应器性能的研究

以NH+4-N溶液为基质建立和启运了全程自养脱氨氮悬浮填料床反应器,反应器连续运行的实验结果表明在pH为8.0～8.5、溶解氧为0.7～1.0mg/L和温度为28℃的条件下.当氨氮表面负荷为2～2.5g/(m2@d)时,其表面去除速率为1.1～1.3/(m2@d),全程自养脱氮率基本稳定在55%左右;全程自养脱氮的最适pH范围为7.5～8,5,其中最佳pH为8.0左右;最适溶解氧范围为0.5～1.5mg/L,其中尤以0.8～1.0ms/L左右为最佳.     

186菌生物流化床处理甲醇废水

用三相生物流化床工艺处理甲醇废水COD_(cr)容积负荷达4.24～12.32kg/m~3·d,去除率达82.7％～93.1％;甲醇容积负荷达1.8～3.9kg/m~3·d,去除率达81.4％～98.1％。加186菌种后,甲醇的容积负荷可提高到3.02～3.36kg/m~3·d,COD_(cr)去除率可达到89.3～96.7％。     

Trace metal emissions from co-combustion of refuse derived and packaging derived fuels in a circulating fluidized bed boiler

Energy recovery from refuse derived fuels (RDF) and packaging derived fuels (PDF) is one option in integrated waste management. Nine RDF and PDF co-combustion tests with peat and coal in a circulating fluidized bed boiler were carried out in this work. Heavy metal emissions in flue gas and fly ash were measured. Multivariate data analyses were used to find out the most important parameters affecting metal emissions in the flue gas.

The results showed that total heavy metal emissions were low. Although RDF and PDF had more heavy metals than peat and coal, the multivariate data analysis showed that an increase of the RDF or PDF share in the fuel mixture up to 20% did not correlate directly with the metal emissions in the flue gas. Distribution of Cd, Cu, Zn and Sn between flue gas and fly ash correlated with each other. Injection of limestone to bind sulphur and chlorine did not have a significant effect on heavy metal emissions in the flue gas. Heavy metals concentrated on the fly ash, but all fly ashes passed the EPA-TCLP tests.