不干胶废弃物热解与燃烧动力学特性

采用热重分析方法对不干胶废弃物(PSAs)进行了热解和燃烧失重分析,并采用Doyle法拟合计算了PSAs热解和燃烧动力学参数。结果表明:当温度低于200℃或高于600℃,PSAs的热解和燃烧失重过程具有性;300~600℃时,PSAs热解过程具有3个失重峰,而其燃烧过程具有2个失重峰。动力学分析结果表明:PSAs的热解是由多阶段复杂的热裂解反应组成,其热解过程可用4个一级反应来描述,随着升温速率的提高热解阶段第1峰区表观活化能降低;而第2、3峰区以及半焦深度裂解阶段的第4峰区活化能逐渐升高;PSAs燃烧过程可用3个一级反应来描述,随着升温速率的提高,PSAs燃烧过程的表观活化能均逐渐降低,并且燃烧表观活化能均低于热解表观活化能。     

Wood-Specific Polycyclic Aromatic Hydrocarbon (PAH) Patterns in Soot Using Gas Chromatography-Atmospheric Pressure Laser Ionization-Mass Spectrometry (GC-APLI-MS)

If organic matter is burnt, the combustion of wood produces the highest amounts of polycyclic aromatic hydrocarbons (PAHs) compared with other fossil energy sources such as oil, coal, or gas. Emissions from wood combustion are increasingly of special interest due to the rising use of wood as a renewable energy source in residential heating in Europe. To the authors' knowledge, reproducible wood-specific PAH patterns in soot were identified for the first time by use of a sampling interval of only 5 min in this study. The short sampling interval was enabled by the very sensitive analytical method of gas chromatography–atmospheric pressure laser ionization–mass spectrometry (GC-APLI-MS) applied. The analysis of 40 PAH of soot from wood logs of spruce, pine, larch (softwood) and beech, birch, oak (hardwood), and wood pellets, as well as wood briquettes, showed 13.46–250.62 mg/kg for ∑40 PAH and 10.75–177.94 mg/kg for the U.S. Environmental Protection Agency PAH standard (without acenaphthylene and anthracene). Highest concentrations occurred in the samples from birch with bark, beech, and wood briquettes. Indeno[1,2,3-cd]pyrene, naphthalene, and alkylated naphthalenes were also detected. Significant concentrations of the very toxic dibenzopyrenes (up to 11.30 mg/kg) are reported. Softwood soot contained highest amounts of 2–4-ring PAH, followed by hardwood which is in accordance with the presence of highest amounts of abietic acid in softwood, a known precursor of retene and phenanthrene. PAH in soot from five spruce samples from different locations show a mean ∑40 PAH concentration of 13.46 mg/kg (n = 5, minimum 8.03, maximum 23.32 mg/kg, SD = 5.65) and exhibited a typical pattern that differed from all other wood soot samples. The distributions of alkylated naphthalenes of the spruce samples show a bell-shape distribution in contrast to the alkylated phenanthrenes/anthracenes of all samples (except the wood pellets), showing a slope distribution. The data indicate that wood-specific PAH patterns exist and under the applied conditions, spruce logs produced the least toxic soot.     

Treatment of wastewater from red and tropical fruit wine production by zeolite anaerobic fluidized bed reactor

A study of the anaerobic treatment of wastewaters derived from red (RWWW) and tropical fruit wine (TFWWW) production was carried out in four laboratory-scale fluidized bed reactors with natural zeolite as bacterial support. These reactors operated at mesophilic temperature (35°C). Reactors R1 and R2 contained Chilean natural zeolite, while reactors R3 and R4 used Cuban natural zeolite as microorganism support. In addition, reactors R1 and R3 processed RWWW, while reactors R2 and R4 used TFWWW as substrate. The biomass concentration attached to zeolites in the four reactors studied was found to be in the range of 44–46 g volatile solids (VS)/L after 90 days of operation time. Both types of zeolites can be used indistinctly in the fluidized bed reactors achieving more than 80%–86% chemical oxygen demand (COD) removals for organic loading rates (OLR) of up to at least 20 g COD/L d. pH values remained within the optimal range for anaerobic microorganisms for OLR values of up to 20 and 22 g COD/L d for RWWW and TFWWW, respectively. Toxicity and inhibition levels were observed at an OLR of 20 g COD/L d in reactors R1 and R3 while processing RWWW, whereas the aforementioned inhibitory phenomena were not observed at an OLR of 24 g COD/L d in R2 and R4, treating TFWWW as a consequence of the lower phenolic compound content present in this substrate. The volatile fatty acid (VFA) levels were always lower in reactors processing TFWWW (R2 and R4) and these values (< 400 mg/L, as acetic acid) were lower than the suggested limits for digester failure. The specific methanogenic activity (SMA) was twice as high in reactors R2 and R4 than in R1 and R3 after 120 days of operation when all reactors operated at an OLR of 20 g COD/L d.     

Investigation of the propensity of sulfide concentrates to spontaneous combustion in storage

Spontaneous combustion of sulfide concentrates can cause many serious problems during storage. In this study, two representative samples (sulfur-rich sulfide concentrate and iron-rich sulfide concentrate) were investigated for the self-heating behavior using the crossing-point temperature (CPT) method. The corresponding apparent activation energies were determined, 13.7366 kJ/mol for iron-rich sulfide concentrate and 21.3817 kJ/mol for sulfur-rich sulfide concentrate. Furthermore, the surface temperatures of sulfide concentrate stockpiles in different seasons were also measured by a thermal image apparatus. It was found the temperature for iron-rich sulfide concentrate stockpile was higher than that for rich-sulfur sulfide concentrate stockpile. These research results show iron-rich sulfide concentrate exhibits stronger propensity to spontaneous combustion than sulfur-rich sulfide concentrate. Particular attention should be paid to the fire hazard of iron-rich sulfide concentrate in daily safety check work. The combination of the CPT method with the infrared thermal image measurement provides a new approach for the risk assessment on the propensity of sulfide concentrates to spontaneous combustion during the production, storage and transportation. The useful data and experience achieved in this investigation can be also referenced in similar cases later.     

污泥掺烧技术在煤粉炉上应用的试验研究

通过污泥掺烧技术在煤粉炉上的应用试验,得出污泥的含水率对锅炉制粉系统的影响.掺烧前后对炉膛温度没有大的影响,随着污泥比例的增加,燃烧效率下降,烟尘浓度和SO2浓度降低.     

催化燃烧处理有机废气及催化剂中毒的防止

研究了在Ｐｔ、Ｐｄ、Ｃｅ多组分蜂窝状催化剂上乙醇、环己烷和苯的氧化性能及水蒸气对催化剂活性的影响,探讨了如何防止硫化氢和甲硫醇引起的催化剂中毒。     

燃煤电厂排放颗粒物中重金属形态的研究

本文分析用模拟酸雨浸提和Ｔｅｓｓｉｅｒ形态分离法，对燃煤电厂排放颗粒物中重金属形态进行了研究。结果表明，痕量金属绝大部分以稳定态存在，微米级飞灰中有较大活性的形态高于灰渣，煤燃烧高温条件使颗粒物中活性较大的形态含量减小。     

三相生物流化床处理含油废水的试验研究

我国油田含油废水利用传统的隔油、混凝、过滤（老三套）处理工艺,出水指标达不到国家的二级排放标准。为提高含油废水处理水平,在“老三套”基础上添加了生物处理部分,即三相生物流化床。为强化生物处理,采取了投加漂浮填料和悬浮填料的强化处理措施,出水能达到国家二级排放标准。     

Emission control for precursors causing acid rain (V): Improvement of acid soil with the bio-briquette combustion ash

The bio-briquette technique which mixes coal, biomass and sulfur fixation agent and bio-briquettes under 3-5 t/cm^2 line pressure has aroused people‘s attention in view of controlling the air pollution and the acid rain. In this paper, the physicochemical properties of bio-briquette and its ash were investigated. And the acid soil was improved by the bio-briquette combustion ash, which contained nutritive substances such as P, N, K and had the acid-neutralizing capacity(ANC). The pH, EC, effective nutrient elements(Ca, Mg, K, P and N), heavy metal elements(AI, Cu, Cd, Cr, Zn and Mn) and acid-neutralizing capacity change of ash-added soils within the range of 0-10%, were also studied. Specially, when 5% bio-briquette combustion ash was added to the tested soil, the content of the effective elements such as Ca, Mg and K rose by 100 times, ? times and twice, respectively. The total nitrogen also increased by about twice. The results showed the oxyanions such as that of AI, Cu, Cd, Cr, Zn and Mn were not potentially dangerous, because they were about the same as the averages of them in Chinese soil. It is shown that the ANC became stronger, though the ANC hardly increases in the ash-added soil. On the basis of the evaluation indices, it is concluded that the best mixture ratio is to add 2.5%--8% of the bio-briquette combustion ash to the tested soil.     

Control of chlorinated aromatic compounds from a municipal solid waste incinerator using limestone addition

In this study, limestone powder was directly added to synthetic MSW, which was fed into a small‐scale fluidized bed incinerator. The concentration of CBzs and CPs in the flue gas were measured before and after a secondary combustion air injection. Finally, the PCDDs and PCDFs concentrations were also measured in the flue gas after the secondary combustion zone. The CaCO₃ added to synthetic MSW not only controls HCl in the flue gas, but suppresses the formation of chlorinated aromatic compounds like CBzs, CPs, PCDDs, and PCDFs. The main mechanisms to control the formation of chlorinated aromatic compounds was more likely related to the suppression of catalytic capability of flyash than the HCl reduction in the flue gas. However, the NO concentration was increased by catalytic reaction of limestone in the fluidized bed.